A vulnerability in the Two-Way Active Measurement Protocol (TWAMP) server feature of Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause the affected device to reload, resulting in a denial of service (DoS) condition. For Cisco IOS XR Software, this vulnerability could cause the ipsla_ippm_server process to reload unexpectedly if debugs are enabled.
This vulnerability is due to out-of-bounds array access when processing specially crafted TWAMP control packets. An attacker could exploit this vulnerability by sending crafted TWAMP control packets to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition.
Note: For Cisco IOS XR Software, only the ipsla_ippm_server process reloads unexpectedly and only when debugs are enabled. The vulnerability details for Cisco IOS XR Software are as follows: Security Impact Rating (SIR): Low CVSS Base Score: 3.7 CVSS Vector: CVSS:3.1/AV:N/AC:H/PR:N/UI:N/S:U/C:N/I:N/A:L
A vulnerability in the IPv6 DHCP version 6 (DHCPv6) relay and server features of Cisco IOS and IOS XE Software could allow an unauthenticated, remote attacker to trigger a denial of service (DoS) condition. This vulnerability is due to insufficient validation of data boundaries. An attacker could exploit this vulnerability by sending crafted DHCPv6 messages to an affected device. A successful exploit could allow the attacker to cause the device to reload unexpectedly.
A vulnerability in the SSH implementation of Cisco IOS Software and Cisco IOS XE Software could allow an authenticated, remote attacker to cause an affected device to reload. This vulnerability is due to improper handling of resources during an exceptional situation. An attacker could exploit this vulnerability by continuously connecting to an affected device and sending specific SSH requests. A successful exploit could allow the attacker to cause the affected device to reload.
Multiple vulnerabilities in the Cisco IOx application hosting environment on multiple Cisco platforms could allow an attacker to inject arbitrary commands into the underlying host operating system, execute arbitrary code on the underlying host operating system, install applications without being authenticated, or conduct a cross-site scripting (XSS) attack against a user of the affected software. For more information about these vulnerabilities, see the Details section of this advisory.
A vulnerability in the TrustSec CLI parser of Cisco IOS and Cisco IOS XE Software could allow an authenticated, remote attacker to cause an affected device to reload. This vulnerability is due to an improper interaction between the web UI and the CLI parser. An attacker could exploit this vulnerability by requesting a particular CLI command to be run through the web UI. A successful exploit could allow the attacker to cause the device to reload, resulting in a denial of service (DoS) condition.
A vulnerability in the Link Layer Discovery Protocol (LLDP) message parser of Cisco IOS Software and Cisco IOS XE Software could allow an attacker to trigger a reload of an affected device, resulting in a denial of service (DoS) condition. This vulnerability is due to improper initialization of a buffer. An attacker could exploit this vulnerability via any of the following methods: An authenticated, remote attacker could access the LLDP neighbor table via either the CLI or SNMP while the device is in a specific state. An unauthenticated, adjacent attacker could corrupt the LLDP neighbor table by injecting specific LLDP frames into the network and then waiting for an administrator of the device or a network management system (NMS) managing the device to retrieve the LLDP neighbor table of the device via either the CLI or SNMP. An authenticated, adjacent attacker with SNMP read-only credentials or low privileges on the device CLI could corrupt the LLDP neighbor table by injecting specific LLDP frames into the network and then accessing the LLDP neighbor table via either the CLI or SNMP. A successful exploit could allow the attacker to cause the affected device to crash, resulting in a reload of the device.
A vulnerability in the Internet Key Exchange Version 2 (IKEv2) support for the AutoReconnect feature of Cisco IOS Software and Cisco IOS XE Software could allow an authenticated, remote attacker to exhaust the free IP addresses from the assigned local pool. This vulnerability occurs because the code does not release the allocated IP address under certain failure conditions. An attacker could exploit this vulnerability by trying to connect to the device with a non-AnyConnect client. A successful exploit could allow the attacker to exhaust the IP addresses from the assigned local pool, which prevents users from logging in and leads to a denial of service (DoS) condition.
A vulnerability in Address Resolution Protocol (ARP) management of Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, remote attacker to prevent an affected device from resolving ARP entries for legitimate hosts on the connected subnets. This vulnerability exists because ARP entries are mismanaged. An attacker could exploit this vulnerability by continuously sending traffic that results in incomplete ARP entries. A successful exploit could allow the attacker to cause ARP requests on the device to be unsuccessful for legitimate hosts, resulting in a denial of service (DoS) condition.
A vulnerability in the dragonite debugger of Cisco IOS XE Software could allow an authenticated, local attacker to escalate from privilege level 15 to root privilege. The vulnerability is due to the presence of development testing and verification scripts that remained on the device. An attacker could exploit this vulnerability by bypassing the consent token mechanism with the residual scripts on the affected device. A successful exploit could allow the attacker to escalate from privilege level 15 to root privilege.
A vulnerability in the web UI of Cisco IOS and Cisco IOS XE Software could allow an unauthenticated, remote attacker to conduct a cross-site request forgery (CSRF) attack on an affected system. The vulnerability is due to insufficient CSRF protections for the web UI on an affected device. An attacker could exploit this vulnerability by persuading a user of the interface to follow a malicious link. A successful exploit could allow the attacker to perform arbitrary actions with the privilege level of the targeted user. If the user has administrative privileges, the attacker could alter the configuration, execute commands, or reload an affected device.