In the Linux kernel, the following vulnerability has been resolved:
agp/amd64: Fix broken error propagation in agp_amd64_probe()
A NULL pointer dereference was observed in the AMD64 AGP driver when
running in a virtualized environment (e.g. qemu/kvm) without a physical
AMD northbridge. The crash occurs in amd64_fetch_size() when attempting
to dereference the pointer returned by node_to_amd_nb(0).
The root cause of this crash is broken error propagation in
agp_amd64_probe(): When no AMD northbridges are found, cache_nbs()
correctly returns -ENODEV. However, the probe function erroneously
checks the return value against exactly -1, rather than < 0.
As a result, the hardware absence error is masked, allowing the driver
to improperly proceed with initialization. It eventually calls
agp_add_bridge(), which invokes amd64_fetch_size(). Since the hardware
does not exist, node_to_amd_nb(0) returns NULL, leading to a General
Protection Fault (GPF) when accessing its ->misc member.
Fix the issue by correcting the error check in agp_amd64_probe() to
abort properly when cache_nbs() returns any negative error code. This
prevents the driver from erroneously proceeding without hardware, thereby
avoiding the subsequent NULL pointer dereference at its source.
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7921: Place upper limit on station AID
Any station configured with an AID over 20 causes a firmware crash.
This situation occurred in our testing using an AP interface on 7922
hardware, with a modified hostapd, sourced from Mediatek's OpenWRT
feeds.
In stock hostapd, station AIDs begin counting at 1, and this
configuration is prevented with an upper limit on associated stations.
However, the modified hostapd began allocation at 65, which caused the
firmware to crash. This fix does not allow these AIDs to work, but will
prevent the firmware crash.
This crash was only seen on IFTYPE_AP interfaces, and the fix does not
appear to have an effect on IFTYPE_STATION behavior.
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7925: prevent NULL pointer dereference in mt7925_tx_check_aggr()
Move the NULL check for 'sta' before dereferencing it to prevent a
possible crash.
In the Linux kernel, the following vulnerability has been resolved:
nilfs2: reject zero bd_oblocknr in nilfs_ioctl_mark_blocks_dirty()
nilfs_ioctl_mark_blocks_dirty() uses bd_oblocknr to detect dead blocks
by comparing it with the current block number bd_blocknr. If they differ,
the block is considered dead and skipped.
However, bd_oblocknr should never be 0 since block 0 typically stores the
primary superblock and is never a valid GC target block. A corrupted ioctl
request with bd_oblocknr set to 0 causes the comparison to incorrectly
match when the lookup returns -ENOENT and sets bd_blocknr to 0, bypassing
the dead block check and calling nilfs_bmap_mark() on a non-existent
block. This causes nilfs_btree_do_lookup() to return -ENOENT, triggering
the WARN_ON(ret == -ENOENT).
Fix this by rejecting ioctl requests with bd_oblocknr set to 0 at the
beginning of each iteration.
[ryusuke: slightly modified the commit message and comments for accuracy]
In the Linux kernel, the following vulnerability has been resolved:
io_uring/napi: cap busy_poll_to 10 msec
Currently there's no cap on the maximum amount of time that napi is
allowed to poll if no events are found, which can lead to kernel
complaints on a task being stuck as there's no conditional rescheduling
done within that loop.
Just cap it to 10 msec in total, that's already way above any kind of
sane value that will reap any benefits, yet low enough that it's
nowhere near being able to trigger preemption complaints.
In the Linux kernel, the following vulnerability has been resolved:
ocfs2/dlm: fix off-by-one in dlm_match_regions() region comparison
The local-vs-remote region comparison loop uses '<=' instead of '<',
causing it to read one entry past the valid range of qr_regions. The
other loops in the same function correctly use '<'.
Fix the loop condition to use '<' for consistency and correctness.
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Avoid NULL dereference in dc_dmub_srv error paths
In dc_dmub_srv_log_diagnostic_data() and
dc_dmub_srv_enable_dpia_trace().
Both functions check:
if (!dc_dmub_srv || !dc_dmub_srv->dmub)
and then call DC_LOG_ERROR() inside that block.
DC_LOG_ERROR() uses dc_dmub_srv->ctx internally. So if
dc_dmub_srv is NULL, the logging itself can dereference a
NULL pointer and cause a crash.
Fix this by splitting the checks.
First check if dc_dmub_srv is NULL and return immediately.
Then check dc_dmub_srv->dmub and log the error only when
dc_dmub_srv is valid.
Fixes the below:
../display/dc/dc_dmub_srv.c:962 dc_dmub_srv_log_diagnostic_data() error: we previously assumed 'dc_dmub_srv' could be null (see line 961)
../display/dc/dc_dmub_srv.c:1167 dc_dmub_srv_enable_dpia_trace() error: we previously assumed 'dc_dmub_srv' could be null (see line 1166)
In the Linux kernel, the following vulnerability has been resolved:
padata: Put CPU offline callback in ONLINE section to allow failure
syzbot reported the following warning:
DEAD callback error for CPU1
WARNING: kernel/cpu.c:1463 at _cpu_down+0x759/0x1020 kernel/cpu.c:1463, CPU#0: syz.0.1960/14614
at commit 4ae12d8bd9a8 ("Merge tag 'kbuild-fixes-7.0-2' of git://git.kernel.org/pub/scm/linux/kernel/git/kbuild/linux")
which tglx traced to padata_cpu_dead() given it's the only
sub-CPUHP_TEARDOWN_CPU callback that returns an error.
Failure isn't allowed in hotplug states before CPUHP_TEARDOWN_CPU
so move the CPU offline callback to the ONLINE section where failure is
possible.
In the Linux kernel, the following vulnerability has been resolved:
f2fs: protect extension_list reading with sb_lock in f2fs_sbi_show()
In f2fs_sbi_show(), the extension_list, extension_count and
hot_ext_count are read without holding sbi->sb_lock. If a concurrent
sysfs store modifies the extension list via f2fs_update_extension_list(),
the show path may read inconsistent count and array contents, potentially
leading to out-of-bounds access or displaying stale data.
Fix this by holding sb_lock around the entire extension list read
and format operation.
In the Linux kernel, the following vulnerability has been resolved:
scsi: sg: Resolve soft lockup issue when opening /dev/sgX
The parameter def_reserved_size defines the default buffer size reserved
for each Sg_fd and should be restricted to a range between 0 and 1,048,576
(see https://tldp.org/HOWTO/SCSI-Generic-HOWTO/proc.html). Although the
function sg_proc_write_dressz enforces this limit, it is possible to bypass
it by directly modifying the module parameter as shown below, which then
causes a soft lockup:
echo -1 > /sys/module/sg/parameters/def_reserved_size
exec 4<> /dev/sg0
watchdog: BUG: soft lockup - CPU#5 stuck for 26 seconds! [bash:537]
Modules loaded:
CPU: 5 UID: 0 PID: 537 Command: bash, kernel version 6.19.0-rc3+ #134,
PREEMPT disabled
Hardware: QEMU Standard PC (i440FX + PIIX, 1996), BIOS version
1.16.1-2.fc37 dated 04/01/2014
...
Call Trace:
sg_build_reserve+0x5c/0xa0
sg_add_sfp+0x168/0x270
sg_open+0x16e/0x340
chrdev_open+0xbe/0x230
do_dentry_open+0x175/0x480
vfs_open+0x34/0xf0
do_open+0x265/0x3d0
path_openat+0x110/0x290
do_filp_open+0xc3/0x170
do_sys_openat2+0x71/0xe0
__x64_sys_openat+0x6d/0xa0
do_syscall_64+0x62/0x310
entry_SYSCALL_64_after_hwframe+0x76/0x7e
The fix is to use module_param_cb to validate and reject invalid values
assigned to def_reserved_size.