Linux: >> Linux Kernel >> 2.6.12.3 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
inet: RAW sockets using IPPROTO_RAW MUST drop incoming ICMP
Yizhou Zhao reported that simply having one RAW socket on protocol
IPPROTO_RAW (255) was dangerous.
socket(AF_INET, SOCK_RAW, 255);
A malicious incoming ICMP packet can set the protocol field to 255
and match this socket, leading to FNHE cache changes.
inner = IP(src="192.168.2.1", dst="8.8.8.8", proto=255)/Raw("TEST")
pkt = IP(src="192.168.1.1", dst="192.168.2.1")/ICMP(type=3, code=4, nexthopmtu=576)/inner
"man 7 raw" states:
A protocol of IPPROTO_RAW implies enabled IP_HDRINCL and is able
to send any IP protocol that is specified in the passed header.
Receiving of all IP protocols via IPPROTO_RAW is not possible
using raw sockets.
Make sure we drop these malicious packets.
CVSS Score
9.1
EPSS Score
0.001
Published
2026-06-03
In the Linux kernel, the following vulnerability has been resolved:
ipmi: Add limits to event and receive message requests
The driver would just fetch events and receive messages until the
BMC said it was done. To avoid issues with BMCs that never say they are
done, add a limit of 10 fetches at a time.
In addition, an si interface has an attn state it can return from the
hardware which is supposed to cause a flag fetch to see if the driver
needs to fetch events or message or a few other things. If the attn
bit gets stuck, it's a similar problem. So allow messages in between
flag fetches so the driver itself doesn't get stuck.
This is a more general fix than the previous fix for the specific bad
BMC, but should fix the more general issue of a BMC that won't stop
saying it has data.
This has been there from the beginning of the driver. It's not a bug
per-se, but it is accounting for bugs in BMCs.
CVSS Score
7.5
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
usb: usblp: fix uninitialized heap leak via LPGETSTATUS ioctl
Just like in a previous problem in this driver, usblp_ctrl_msg() will
collapse the usb_control_msg() return value to 0/-errno, discarding the
actual number of bytes transferred.
Ideally that short command should be detected and error out, but many
printers are known to send "incorrect" responses back so we can't just
do that.
statusbuf is kmalloc(8) at probe time and never filled before the first
LPGETSTATUS ioctl.
usblp_read_status() requests 1 byte. If a malicious printer responds
with zero bytes, *statusbuf is one byte of stale kmalloc heap,
sign-extended into the local int status, which the LPGETSTATUS path then
copy_to_user()s directly to the ioctl caller.
Fix this all by just zapping out the memory buffer when allocated at
probe time. If a later call does a short read, the data will be
identical to what the device sent it the last time, so there is no
"leak" of information happening.
CVSS Score
5.5
EPSS Score
0.0
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
hfsplus: fix uninit-value by validating catalog record size
Syzbot reported a KMSAN uninit-value issue in hfsplus_strcasecmp(). The
root cause is that hfs_brec_read() doesn't validate that the on-disk
record size matches the expected size for the record type being read.
When mounting a corrupted filesystem, hfs_brec_read() may read less data
than expected. For example, when reading a catalog thread record, the
debug output showed:
HFSPLUS_BREC_READ: rec_len=520, fd->entrylength=26
HFSPLUS_BREC_READ: WARNING - entrylength (26) < rec_len (520) - PARTIAL READ!
hfs_brec_read() only validates that entrylength is not greater than the
buffer size, but doesn't check if it's less than expected. It successfully
reads 26 bytes into a 520-byte structure and returns success, leaving 494
bytes uninitialized.
This uninitialized data in tmp.thread.nodeName then gets copied by
hfsplus_cat_build_key_uni() and used by hfsplus_strcasecmp(), triggering
the KMSAN warning when the uninitialized bytes are used as array indices
in case_fold().
Fix by introducing hfsplus_brec_read_cat() wrapper that:
1. Calls hfs_brec_read() to read the data
2. Validates the record size based on the type field:
- Fixed size for folder and file records
- Variable size for thread records (depends on string length)
3. Returns -EIO if size doesn't match expected
For thread records, check against HFSPLUS_MIN_THREAD_SZ before reading
nodeName.length to avoid reading uninitialized data at call sites that
don't zero-initialize the entry structure.
Also initialize the tmp variable in hfsplus_find_cat() as defensive
programming to ensure no uninitialized data even if validation is
bypassed.
CVSS Score
5.5
EPSS Score
0.0
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
ALSA: pcm: oss: Fix data race at accessing runtime.oss.trigger
Currently the runtime.oss.trigger field may be accessed concurrently
without protection, which may lead to the data race. And, in this
case, it may lead to more severe problem because it's a bit field; as
writing the data, it may overwrite other bit fields as well, which
confuses the operation completely, as spotted by fuzzing.
Fix it by covering runtime.oss.trigger bit fled also with the existing
params_lock mutex in both snd_pcm_oss_get_trigger() and
snd_pcm_oss_poll().
CVSS Score
7.8
EPSS Score
0.0
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
KVM: arm64: Fix pin leak and publication ordering in __pkvm_init_vcpu()
Two bugs exist in the vCPU initialisation path:
1. If a check fails after hyp_pin_shared_mem() succeeds, the cleanup
path jumps to 'unlock' without calling unpin_host_vcpu() or
unpin_host_sve_state(), permanently leaking pin references on the
host vCPU and SVE state pages.
Extract a register_hyp_vcpu() helper that performs the checks and
the store. When register_hyp_vcpu() returns an error, call
unpin_host_vcpu() and unpin_host_sve_state() inline before falling
through to the existing 'unlock' label.
2. register_hyp_vcpu() publishes the new vCPU pointer into
'hyp_vm->vcpus[]' with a bare store, allowing a concurrent caller
of pkvm_load_hyp_vcpu() to observe a partially initialised vCPU
object.
Ensure the store uses smp_store_release() and the load uses
smp_load_acquire(). While 'vm_table_lock' currently serialises the
store and the load, these barriers ensure the reader sees the fully
initialised 'hyp_vcpu' object even if there were a lockless path or
if the lock's own ordering guarantees were insufficient for nested
object initialization.
CVSS Score
5.5
EPSS Score
0.0
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
usb: usblp: fix heap leak in IEEE 1284 device ID via short response
usblp_ctrl_msg() collapses the usb_control_msg() return value to
0/-errno, discarding the actual number of bytes transferred. A broken
printer can complete the GET_DEVICE_ID control transfer short and the
driver has no way to know.
usblp_cache_device_id_string() reads the 2-byte big-endian length prefix
from the response and trusts it (clamped only to the buffer bounds).
The buffer is kmalloc(1024) at probe time. A device that sends exactly
two bytes (e.g. 0x03 0xFF, claiming a 1023-byte ID) leaves
device_id_string[2..1022] holding stale kmalloc heap.
That stale data is then exposed:
- via the ieee1284_id sysfs attribute (sprintf("%s", buf+2), truncated
at the first NUL in the stale heap), and
- via the IOCNR_GET_DEVICE_ID ioctl, which copy_to_user()s the full
claimed length regardless of NULs, up to 1021 bytes of uninitialized
heap, with the leak size chosen by the device.
Fix this up by just zapping the buffer with zeros before each request
sent to the device.
CVSS Score
5.5
EPSS Score
0.0
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
8021q: delete cleared egress QoS mappings
vlan_dev_set_egress_priority() currently keeps cleared egress
priority mappings in the hash as tombstones. Repeated set/clear cycles
with distinct skb priorities therefore accumulate mapping nodes until
device teardown and leak memory.
Delete mappings when vlan_prio is cleared instead of keeping tombstones.
Now that the egress mapping lists are RCU protected, the node can be
unlinked safely and freed after a grace period.
CVSS Score
5.5
EPSS Score
0.0
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
usb: image: mdc800: kill download URB on timeout
mdc800_device_read() submits download_urb and waits for completion.
If the timeout fires and the device has not responded, the function
returns without killing the URB, leaving it active.
A subsequent read() resubmits the same URB while it is still
in-flight, triggering the WARN in usb_submit_urb():
"URB submitted while active"
Check the return value of wait_event_timeout() and kill the URB if
it indicates timeout, ensuring the URB is complete before its status
is inspected or the URB is resubmitted.
Similar to
- commit 372c93131998 ("USB: yurex: fix control-URB timeout handling")
- commit b98d5000c505 ("media: rc: iguanair: handle timeouts")
CVSS Score
5.5
EPSS Score
0.0
Published
2026-05-08
In the Linux kernel, the following vulnerability has been resolved:
USB: core: Limit the length of unkillable synchronous timeouts
The usb_control_msg(), usb_bulk_msg(), and usb_interrupt_msg() APIs in
usbcore allow unlimited timeout durations. And since they use
uninterruptible waits, this leaves open the possibility of hanging a
task for an indefinitely long time, with no way to kill it short of
unplugging the target device.
To prevent this sort of problem, enforce a maximum limit on the length
of these unkillable timeouts. The limit chosen here, somewhat
arbitrarily, is 60 seconds. On many systems (although not all) this
is short enough to avoid triggering the kernel's hung-task detector.
In addition, clear up the ambiguity of negative timeout values by
treating them the same as 0, i.e., using the maximum allowed timeout.
CVSS Score
5.5
EPSS Score
0.0
Published
2026-05-08
Page 1