Espressif: >> Esp-Idf >> 5.1.6 Security Vulnerabilities
ESF-IDF is the Espressif Internet of Things (IOT) Development Framework. In versions 5.5.2, 5.4.3, 5.3.4, 5.2.6, and 5.1.6, a use-after-free vulnerability was reported in the BLE provisioning transport (protocomm_ble) layer. The issue can be triggered by a remote BLE client while the device is in provisioning mode. The vulnerability occurred when provisioning was stopped with keep_ble_on = true. In this configuration, internal protocomm_ble state and GATT metadata were freed while the BLE stack and GATT services remained active. Subsequent BLE read or write callbacks dereferenced freed memory, allowing a connected or newly connected client to trigger invalid memory acces. This issue has been patched in versions 5.5.3, 5.4.4, 5.3.5, 5.2.7, and 5.1.7.
CVSS Score
6.3
EPSS Score
0.004
Published
2026-02-04
ESF-IDF is the Espressif Internet of Things (IOT) Development Framework. In versions 5.5.2, 5.4.3, 5.3.4, 5.2.6, and 5.1.6, an out-of-bounds read vulnerability was reported in the BLE ATT Prepare Write handling of the BLE provisioning transport (protocomm_ble). The issue can be triggered by a remote BLE client while the device is in provisioning mode. The transport accumulated prepared-write fragments in a fixed-size buffer but incorrectly tracked the cumulative length. By sending repeated prepare write requests with overlapping offsets, a remote client could cause the reported length to exceed the allocated buffer size. This inflated length was then passed to provisioning handlers during execute-write processing, resulting in an out-of-bounds read and potential memory corruption. This issue has been patched in versions 5.5.3, 5.4.4, 5.3.5, 5.2.7, and 5.1.7.
CVSS Score
6.3
EPSS Score
0.004
Published
2026-02-04
ESF-IDF is the Espressif Internet of Things (IOT) Development Framework. In versions 5.5.2, 5.4.3, 5.3.4, 5.2.6, and 5.1.6, a vulnerability exists in the WPS (Wi-Fi Protected Setup) Enrollee implementation where malformed EAP-WSC packets with truncated payloads can cause integer underflow during fragment length calculation. When processing EAP-Expanded (WSC) messages, the code computes frag_len by subtracting header sizes from the total packet length. If an attacker sends a packet where the EAP Length field covers only the header and flags but omits the expected payload (such as the 2-byte Message Length field when WPS_MSG_FLAG_LEN is set), frag_len becomes negative. This negative value is then implicitly cast to size_t when passed to wpabuf_put_data(), resulting in a very large unsigned value. This issue has been patched in versions 5.5.3, 5.4.4, 5.3.5, 5.2.7, and 5.1.7.
CVSS Score
6.3
EPSS Score
0.004
Published
2026-02-04
ESF-IDF is the Espressif Internet of Things (IOT) Development Framework. In 5.5.1, 5.4.3, 5.3.4, 5.2.6, 5.1.6, and earlier, when AVRCP is enabled on ESP32, receiving a malformed VENDOR DEPENDENT command from a peer device can cause the Bluetooth stack to access memory before validating the command buffer length. This may lead to an out-of-bounds read, potentially exposing unintended memory content or causing unexpected behavior.
CVSS Score
2.7
EPSS Score
0.006
Published
2025-12-02
ESF-IDF is the Espressif Internet of Things (IOT) Development Framework. An integer underflow vulnerability has been identified in the ESP-NOW protocol implementation within the ESP Wi-Fi component of versions 5.4.1, 5.3.3, 5.2.5, and 5.1.6 of the ESP-IDF framework. This issue stems from insufficient validation of user-supplied data length in the packet receive function. Under certain conditions, this may lead to out-of-bounds memory access and may allow arbitrary memory write operations. On systems without a memory protection scheme, this behavior could potentially be used to achieve remote code execution (RCE) on the target device. In versions 5.4.2, 5.3.4, 5.2.6, and 5.1.6, ESP-NOW has added more comprehensive validation logic on user-supplied data length during packet reception to prevent integer underflow caused by negative value calculations. For ESP-IDF v5.3 and earlier, a workaround can be applied by validating that the `data_len` parameter received in the RX callback (registered via `esp_now_register_recv_cb()`) is a positive value before further processing. For ESP-IDF v5.4 and later, no application-level workaround is available. Users are advised to upgrade to a patched version of ESP-IDF to take advantage of the built-in mitigation.
CVSS Score
7.2
EPSS Score
0.009
Published
2025-06-24