In the Linux kernel, the following vulnerability has been resolved:
tty: n_gsm: fix possible out-of-bounds in gsm0_receive()
Assuming the following:
- side A configures the n_gsm in basic option mode
- side B sends the header of a basic option mode frame with data length 1
- side A switches to advanced option mode
- side B sends 2 data bytes which exceeds gsm->len
Reason: gsm->len is not used in advanced option mode.
- side A switches to basic option mode
- side B keeps sending until gsm0_receive() writes past gsm->buf
Reason: Neither gsm->state nor gsm->len have been reset after
reconfiguration.
Fix this by changing gsm->count to gsm->len comparison from equal to less
than. Also add upper limit checks against the constant MAX_MRU in
gsm0_receive() and gsm1_receive() to harden against memory corruption of
gsm->len and gsm->mru.
All other checks remain as we still need to limit the data according to the
user configuration and actual payload size.
In the Linux kernel, the following vulnerability has been resolved:
net: tulip: de4x5: fix the problem that the array 'lp->phy[8]' may be out of bound
In line 5001, if all id in the array 'lp->phy[8]' is not 0, when the
'for' end, the 'k' is 8.
At this time, the array 'lp->phy[8]' may be out of bound.
In the Linux kernel, the following vulnerability has been resolved:
ethernet: hisilicon: hns: hns_dsaf_misc: fix a possible array overflow in hns_dsaf_ge_srst_by_port()
The if statement:
if (port >= DSAF_GE_NUM)
return;
limits the value of port less than DSAF_GE_NUM (i.e., 8).
However, if the value of port is 6 or 7, an array overflow could occur:
port_rst_off = dsaf_dev->mac_cb[port]->port_rst_off;
because the length of dsaf_dev->mac_cb is DSAF_MAX_PORT_NUM (i.e., 6).
To fix this possible array overflow, we first check port and if it is
greater than or equal to DSAF_MAX_PORT_NUM, the function returns.
In the Linux kernel, the following vulnerability has been resolved:
sata_fsl: fix UAF in sata_fsl_port_stop when rmmod sata_fsl
When the `rmmod sata_fsl.ko` command is executed in the PPC64 GNU/Linux,
a bug is reported:
==================================================================
BUG: Unable to handle kernel data access on read at 0x80000800805b502c
Oops: Kernel access of bad area, sig: 11 [#1]
NIP [c0000000000388a4] .ioread32+0x4/0x20
LR [80000000000c6034] .sata_fsl_port_stop+0x44/0xe0 [sata_fsl]
Call Trace:
.free_irq+0x1c/0x4e0 (unreliable)
.ata_host_stop+0x74/0xd0 [libata]
.release_nodes+0x330/0x3f0
.device_release_driver_internal+0x178/0x2c0
.driver_detach+0x64/0xd0
.bus_remove_driver+0x70/0xf0
.driver_unregister+0x38/0x80
.platform_driver_unregister+0x14/0x30
.fsl_sata_driver_exit+0x18/0xa20 [sata_fsl]
.__se_sys_delete_module+0x1ec/0x2d0
.system_call_exception+0xfc/0x1f0
system_call_common+0xf8/0x200
==================================================================
The triggering of the BUG is shown in the following stack:
driver_detach
device_release_driver_internal
__device_release_driver
drv->remove(dev) --> platform_drv_remove/platform_remove
drv->remove(dev) --> sata_fsl_remove
iounmap(host_priv->hcr_base); <---- unmap
kfree(host_priv); <---- free
devres_release_all
release_nodes
dr->node.release(dev, dr->data) --> ata_host_stop
ap->ops->port_stop(ap) --> sata_fsl_port_stop
ioread32(hcr_base + HCONTROL) <---- UAF
host->ops->host_stop(host)
The iounmap(host_priv->hcr_base) and kfree(host_priv) functions should
not be executed in drv->remove. These functions should be executed in
host_stop after port_stop. Therefore, we move these functions to the
new function sata_fsl_host_stop and bind the new function to host_stop.
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/amdgpu: fix potential memleak
In function amdgpu_get_xgmi_hive, when kobject_init_and_add failed
There is a potential memleak if not call kobject_put.
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/amdkfd: Fix kernel panic when reset failed and been triggered again
In SRIOV configuration, the reset may failed to bring asic back to normal but stop cpsch
already been called, the start_cpsch will not be called since there is no resume in this
case. When reset been triggered again, driver should avoid to do uninitialization again.
In the Linux kernel, the following vulnerability has been resolved:
HID: bigbenff: prevent null pointer dereference
When emulating the device through uhid, there is a chance we don't have
output reports and so report_field is null.
In the Linux kernel, the following vulnerability has been resolved:
nfsd: fix use-after-free due to delegation race
A delegation break could arrive as soon as we've called vfs_setlease. A
delegation break runs a callback which immediately (in
nfsd4_cb_recall_prepare) adds the delegation to del_recall_lru. If we
then exit nfs4_set_delegation without hashing the delegation, it will be
freed as soon as the callback is done with it, without ever being
removed from del_recall_lru.
Symptoms show up later as use-after-free or list corruption warnings,
usually in the laundromat thread.
I suspect aba2072f4523 "nfsd: grant read delegations to clients holding
writes" made this bug easier to hit, but I looked as far back as v3.0
and it looks to me it already had the same problem. So I'm not sure
where the bug was introduced; it may have been there from the beginning.
In the Linux kernel, the following vulnerability has been resolved:
btrfs: free exchange changeset on failures
Fstests runs on my VMs have show several kmemleak reports like the following.
unreferenced object 0xffff88811ae59080 (size 64):
comm "xfs_io", pid 12124, jiffies 4294987392 (age 6.368s)
hex dump (first 32 bytes):
00 c0 1c 00 00 00 00 00 ff cf 1c 00 00 00 00 00 ................
90 97 e5 1a 81 88 ff ff 90 97 e5 1a 81 88 ff ff ................
backtrace:
[<00000000ac0176d2>] ulist_add_merge+0x60/0x150 [btrfs]
[<0000000076e9f312>] set_state_bits+0x86/0xc0 [btrfs]
[<0000000014fe73d6>] set_extent_bit+0x270/0x690 [btrfs]
[<000000004f675208>] set_record_extent_bits+0x19/0x20 [btrfs]
[<00000000b96137b1>] qgroup_reserve_data+0x274/0x310 [btrfs]
[<0000000057e9dcbb>] btrfs_check_data_free_space+0x5c/0xa0 [btrfs]
[<0000000019c4511d>] btrfs_delalloc_reserve_space+0x1b/0xa0 [btrfs]
[<000000006d37e007>] btrfs_dio_iomap_begin+0x415/0x970 [btrfs]
[<00000000fb8a74b8>] iomap_iter+0x161/0x1e0
[<0000000071dff6ff>] __iomap_dio_rw+0x1df/0x700
[<000000002567ba53>] iomap_dio_rw+0x5/0x20
[<0000000072e555f8>] btrfs_file_write_iter+0x290/0x530 [btrfs]
[<000000005eb3d845>] new_sync_write+0x106/0x180
[<000000003fb505bf>] vfs_write+0x24d/0x2f0
[<000000009bb57d37>] __x64_sys_pwrite64+0x69/0xa0
[<000000003eba3fdf>] do_syscall_64+0x43/0x90
In case brtfs_qgroup_reserve_data() or btrfs_delalloc_reserve_metadata()
fail the allocated extent_changeset will not be freed.
So in btrfs_check_data_free_space() and btrfs_delalloc_reserve_space()
free the allocated extent_changeset to get rid of the allocated memory.
The issue currently only happens in the direct IO write path, but only
after 65b3c08606e5 ("btrfs: fix ENOSPC failure when attempting direct IO
write into NOCOW range"), and also at defrag_one_locked_target(). Every
other place is always calling extent_changeset_free() even if its call
to btrfs_delalloc_reserve_space() or btrfs_check_data_free_space() has
failed.