In the Linux kernel, the following vulnerability has been resolved:
net/packet: fix a race in packet_set_ring() and packet_notifier()
When packet_set_ring() releases po->bind_lock, another thread can
run packet_notifier() and process an NETDEV_UP event.
This race and the fix are both similar to that of commit 15fe076edea7
("net/packet: fix a race in packet_bind() and packet_notifier()").
There too the packet_notifier NETDEV_UP event managed to run while a
po->bind_lock critical section had to be temporarily released. And
the fix was similarly to temporarily set po->num to zero to keep
the socket unhooked until the lock is retaken.
The po->bind_lock in packet_set_ring and packet_notifier precede the
introduction of git history.
In the Linux kernel, the following vulnerability has been resolved:
vsock: Do not allow binding to VMADDR_PORT_ANY
It is possible for a vsock to autobind to VMADDR_PORT_ANY. This can
cause a use-after-free when a connection is made to the bound socket.
The socket returned by accept() also has port VMADDR_PORT_ANY but is not
on the list of unbound sockets. Binding it will result in an extra
refcount decrement similar to the one fixed in fcdd2242c023 (vsock: Keep
the binding until socket destruction).
Modify the check in __vsock_bind_connectible() to also prevent binding
to VMADDR_PORT_ANY.
In the Linux kernel, the following vulnerability has been resolved:
tls: stop recv() if initial process_rx_list gave us non-DATA
If we have a non-DATA record on the rx_list and another record of the
same type still on the queue, we will end up merging them:
- process_rx_list copies the non-DATA record
- we start the loop and process the first available record since it's
of the same type
- we break out of the loop since the record was not DATA
Just check the record type and jump to the end in case process_rx_list
did some work.
In the Linux kernel, the following vulnerability has been resolved:
eventpoll: Fix semi-unbounded recursion
Ensure that epoll instances can never form a graph deeper than
EP_MAX_NESTS+1 links.
Currently, ep_loop_check_proc() ensures that the graph is loop-free and
does some recursion depth checks, but those recursion depth checks don't
limit the depth of the resulting tree for two reasons:
- They don't look upwards in the tree.
- If there are multiple downwards paths of different lengths, only one of
the paths is actually considered for the depth check since commit
28d82dc1c4ed ("epoll: limit paths").
Essentially, the current recursion depth check in ep_loop_check_proc() just
serves to prevent it from recursing too deeply while checking for loops.
A more thorough check is done in reverse_path_check() after the new graph
edge has already been created; this checks, among other things, that no
paths going upwards from any non-epoll file with a length of more than 5
edges exist. However, this check does not apply to non-epoll files.
As a result, it is possible to recurse to a depth of at least roughly 500,
tested on v6.15. (I am unsure if deeper recursion is possible; and this may
have changed with commit 8c44dac8add7 ("eventpoll: Fix priority inversion
problem").)
To fix it:
1. In ep_loop_check_proc(), note the subtree depth of each visited node,
and use subtree depths for the total depth calculation even when a subtree
has already been visited.
2. Add ep_get_upwards_depth_proc() for similarly determining the maximum
depth of an upwards walk.
3. In ep_loop_check(), use these values to limit the total path length
between epoll nodes to EP_MAX_NESTS edges.
In the Linux kernel, the following vulnerability has been resolved:
bpf, ktls: Fix data corruption when using bpf_msg_pop_data() in ktls
When sending plaintext data, we initially calculated the corresponding
ciphertext length. However, if we later reduced the plaintext data length
via socket policy, we failed to recalculate the ciphertext length.
This results in transmitting buffers containing uninitialized data during
ciphertext transmission.
This causes uninitialized bytes to be appended after a complete
"Application Data" packet, leading to errors on the receiving end when
parsing TLS record.
In the Linux kernel, the following vulnerability has been resolved:
staging: fbtft: fix potential memory leak in fbtft_framebuffer_alloc()
In the error paths after fb_info structure is successfully allocated,
the memory allocated in fb_deferred_io_init() for info->pagerefs is not
freed. Fix that by adding the cleanup function on the error path.
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath11k: clear initialized flag for deinit-ed srng lists
In a number of cases we see kernel panics on resume due
to ath11k kernel page fault, which happens under the
following circumstances:
1) First ath11k_hal_dump_srng_stats() call
Last interrupt received for each group:
ath11k_pci 0000:01:00.0: group_id 0 22511ms before
ath11k_pci 0000:01:00.0: group_id 1 14440788ms before
[..]
ath11k_pci 0000:01:00.0: failed to receive control response completion, polling..
ath11k_pci 0000:01:00.0: Service connect timeout
ath11k_pci 0000:01:00.0: failed to connect to HTT: -110
ath11k_pci 0000:01:00.0: failed to start core: -110
ath11k_pci 0000:01:00.0: firmware crashed: MHI_CB_EE_RDDM
ath11k_pci 0000:01:00.0: already resetting count 2
ath11k_pci 0000:01:00.0: failed to wait wlan mode request (mode 4): -110
ath11k_pci 0000:01:00.0: qmi failed to send wlan mode off: -110
ath11k_pci 0000:01:00.0: failed to reconfigure driver on crash recovery
[..]
2) At this point reconfiguration fails (we have 2 resets) and
ath11k_core_reconfigure_on_crash() calls ath11k_hal_srng_deinit()
which destroys srng lists. However, it does not reset per-list
->initialized flag.
3) Second ath11k_hal_dump_srng_stats() call sees stale ->initialized
flag and attempts to dump srng stats:
Last interrupt received for each group:
ath11k_pci 0000:01:00.0: group_id 0 66785ms before
ath11k_pci 0000:01:00.0: group_id 1 14485062ms before
ath11k_pci 0000:01:00.0: group_id 2 14485062ms before
ath11k_pci 0000:01:00.0: group_id 3 14485062ms before
ath11k_pci 0000:01:00.0: group_id 4 14780845ms before
ath11k_pci 0000:01:00.0: group_id 5 14780845ms before
ath11k_pci 0000:01:00.0: group_id 6 14485062ms before
ath11k_pci 0000:01:00.0: group_id 7 66814ms before
ath11k_pci 0000:01:00.0: group_id 8 68997ms before
ath11k_pci 0000:01:00.0: group_id 9 67588ms before
ath11k_pci 0000:01:00.0: group_id 10 69511ms before
BUG: unable to handle page fault for address: ffffa007404eb010
#PF: supervisor read access in kernel mode
#PF: error_code(0x0000) - not-present page
PGD 100000067 P4D 100000067 PUD 10022d067 PMD 100b01067 PTE 0
Oops: 0000 [#1] PREEMPT SMP NOPTI
RIP: 0010:ath11k_hal_dump_srng_stats+0x2b4/0x3b0 [ath11k]
Call Trace:
<TASK>
? __die_body+0xae/0xb0
? page_fault_oops+0x381/0x3e0
? exc_page_fault+0x69/0xa0
? asm_exc_page_fault+0x22/0x30
? ath11k_hal_dump_srng_stats+0x2b4/0x3b0 [ath11k (HASH:6cea 4)]
ath11k_qmi_driver_event_work+0xbd/0x1050 [ath11k (HASH:6cea 4)]
worker_thread+0x389/0x930
kthread+0x149/0x170
Clear per-list ->initialized flag in ath11k_hal_srng_deinit().
In the Linux kernel, the following vulnerability has been resolved:
iwlwifi: Add missing check for alloc_ordered_workqueue
Add check for the return value of alloc_ordered_workqueue since it may
return NULL pointer.
In the Linux kernel, the following vulnerability has been resolved:
wifi: rtl818x: Kill URBs before clearing tx status queue
In rtl8187_stop() move the call of usb_kill_anchored_urbs() before clearing
b_tx_status.queue. This change prevents callbacks from using already freed
skb due to anchor was not killed before freeing such skb.
BUG: kernel NULL pointer dereference, address: 0000000000000080
#PF: supervisor read access in kernel mode
#PF: error_code(0x0000) - not-present page
PGD 0 P4D 0
Oops: Oops: 0000 [#1] SMP NOPTI
CPU: 7 UID: 0 PID: 0 Comm: swapper/7 Not tainted 6.15.0 #8 PREEMPT(voluntary)
Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS 0.0.0 02/06/2015
RIP: 0010:ieee80211_tx_status_irqsafe+0x21/0xc0 [mac80211]
Call Trace:
<IRQ>
rtl8187_tx_cb+0x116/0x150 [rtl8187]
__usb_hcd_giveback_urb+0x9d/0x120
usb_giveback_urb_bh+0xbb/0x140
process_one_work+0x19b/0x3c0
bh_worker+0x1a7/0x210
tasklet_action+0x10/0x30
handle_softirqs+0xf0/0x340
__irq_exit_rcu+0xcd/0xf0
common_interrupt+0x85/0xa0
</IRQ>
Tested on RTL8187BvE device.
Found by Linux Verification Center (linuxtesting.org) with SVACE.
In the Linux kernel, the following vulnerability has been resolved:
xen: fix UAF in dmabuf_exp_from_pages()
[dma_buf_fd() fixes; no preferences regarding the tree it goes through -
up to xen folks]
As soon as we'd inserted a file reference into descriptor table, another
thread could close it. That's fine for the case when all we are doing is
returning that descriptor to userland (it's a race, but it's a userland
race and there's nothing the kernel can do about it). However, if we
follow fd_install() with any kind of access to objects that would be
destroyed on close (be it the struct file itself or anything destroyed
by its ->release()), we have a UAF.
dma_buf_fd() is a combination of reserving a descriptor and fd_install().
gntdev dmabuf_exp_from_pages() calls it and then proceeds to access the
objects destroyed on close - starting with gntdev_dmabuf itself.
Fix that by doing reserving descriptor before anything else and do
fd_install() only when everything had been set up.