Linux: >> Linux Kernel >> 6.1.118 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
KVM: arm64: Fix pin leak and publication ordering in __pkvm_init_vcpu()
Two bugs exist in the vCPU initialisation path:
1. If a check fails after hyp_pin_shared_mem() succeeds, the cleanup
path jumps to 'unlock' without calling unpin_host_vcpu() or
unpin_host_sve_state(), permanently leaking pin references on the
host vCPU and SVE state pages.
Extract a register_hyp_vcpu() helper that performs the checks and
the store. When register_hyp_vcpu() returns an error, call
unpin_host_vcpu() and unpin_host_sve_state() inline before falling
through to the existing 'unlock' label.
2. register_hyp_vcpu() publishes the new vCPU pointer into
'hyp_vm->vcpus[]' with a bare store, allowing a concurrent caller
of pkvm_load_hyp_vcpu() to observe a partially initialised vCPU
object.
Ensure the store uses smp_store_release() and the load uses
smp_load_acquire(). While 'vm_table_lock' currently serialises the
store and the load, these barriers ensure the reader sees the fully
initialised 'hyp_vcpu' object even if there were a lockless path or
if the lock's own ordering guarantees were insufficient for nested
object initialization.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
spi: microchip-core-qspi: control built-in cs manually
The coreQSPI IP supports only a single chip select, which is
automagically operated by the hardware - set low when the transmit
buffer first gets written to and set high when the number of bytes
written to the TOTALBYTES field of the FRAMES register have been sent on
the bus. Additional devices must use GPIOs for their chip selects.
It was reported to me that if there are two devices attached to this
QSPI controller that the in-built chip select is set low while linux
tries to access the device attached to the GPIO.
This went undetected as the boards that connected multiple devices to
the SPI controller all exclusively used GPIOs for chip selects, not
relying on the built-in chip select at all. It turns out that this was
because the built-in chip select, when controlled automagically, is set
low when active and high when inactive, thereby ruling out its use for
active-high devices or devices that need to transmit with the chip
select disabled.
Modify the driver so that it controls chip select directly, retaining
the behaviour for mem_ops of setting the chip select active for the
entire duration of the transfer in the exec_op callback. For regular
transfers, implement the set_cs callback for the core to use.
As part of this, the existing setup callback, mchp_coreqspi_setup_op(),
is removed. Modifying the CLKIDLE field is not safe to do during
operation when there are multiple devices, so this code is removed
entirely. Setting the MASTER and ENABLE fields is something that can be
done once at probe, it doesn't need to be re-run for each device.
Instead the new setup callback sets the built-in chip select to its
inactive state for active-low devices, as the reset value of the chip
select in software controlled mode is low.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
scsi: target: configfs: Bound snprintf() return in tg_pt_gp_members_show()
target_tg_pt_gp_members_show() formats LUN paths with snprintf() into a
256-byte stack buffer, then will memcpy() cur_len bytes from that
buffer. snprintf() returns the length the output would have had, which
can exceed the buffer size when the fabric WWN is long because iSCSI IQN
names can be up to 223 bytes. The check at the memcpy() site only
guards the destination page write, not the source read, so memcpy() will
read past the stack buffer and copy adjacent stack contents to the sysfs
reader, which when CONFIG_FORTIFY_SOURCE is enabled, fortify_panic()
will be triggered.
Commit 27e06650a5ea ("scsi: target: target_core_configfs: Add length
check to avoid buffer overflow") added the same bound to the
target_lu_gp_members_show() but the tg_pt_gp variant was missed so
resolve that here.
CVSS Score
7.1
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
fanotify: fix false positive on permission events
fsnotify_get_mark_safe() may return false for a mark on an unrelated group,
which results in bypassing the permission check.
Fix by skipping over detached marks that are not in the current group.
CVSS Score
7.1
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
usb: usblp: fix heap leak in IEEE 1284 device ID via short response
usblp_ctrl_msg() collapses the usb_control_msg() return value to
0/-errno, discarding the actual number of bytes transferred. A broken
printer can complete the GET_DEVICE_ID control transfer short and the
driver has no way to know.
usblp_cache_device_id_string() reads the 2-byte big-endian length prefix
from the response and trusts it (clamped only to the buffer bounds).
The buffer is kmalloc(1024) at probe time. A device that sends exactly
two bytes (e.g. 0x03 0xFF, claiming a 1023-byte ID) leaves
device_id_string[2..1022] holding stale kmalloc heap.
That stale data is then exposed:
- via the ieee1284_id sysfs attribute (sprintf("%s", buf+2), truncated
at the first NUL in the stale heap), and
- via the IOCNR_GET_DEVICE_ID ioctl, which copy_to_user()s the full
claimed length regardless of NULs, up to 1021 bytes of uninitialized
heap, with the leak size chosen by the device.
Fix this up by just zapping the buffer with zeros before each request
sent to the device.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
8021q: delete cleared egress QoS mappings
vlan_dev_set_egress_priority() currently keeps cleared egress
priority mappings in the hash as tombstones. Repeated set/clear cycles
with distinct skb priorities therefore accumulate mapping nodes until
device teardown and leak memory.
Delete mappings when vlan_prio is cleared instead of keeping tombstones.
Now that the egress mapping lists are RCU protected, the node can be
unlinked safely and freed after a grace period.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
ntfs3: fix integer overflow in run_unpack() volume boundary check
The volume boundary check `lcn + len > sbi->used.bitmap.nbits` uses raw
addition which can wrap around for large lcn and len values, bypassing
the validation. Use check_add_overflow() as is already done for the
adjacent prev_lcn + dlcn and vcn64 + len checks added by commit
3ac37e100385 ("ntfs3: Fix integer overflow in run_unpack()").
Found by fuzzing with a source-patched harness (LibAFL + QEMU).
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
selinux: fix overlayfs mmap() and mprotect() access checks
The existing SELinux security model for overlayfs is to allow access if
the current task is able to access the top level file (the "user" file)
and the mounter's credentials are sufficient to access the lower
level file (the "backing" file). Unfortunately, the current code does
not properly enforce these access controls for both mmap() and mprotect()
operations on overlayfs filesystems.
This patch makes use of the newly created security_mmap_backing_file()
LSM hook to provide the missing backing file enforcement for mmap()
operations, and leverages the backing file API and new LSM blob to
provide the necessary information to properly enforce the mprotect()
access controls.
CVSS Score
7.1
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_event: fix potential UAF in SSP passkey handlers
hci_conn lookup and field access must be covered by hdev lock in
hci_user_passkey_notify_evt() and hci_keypress_notify_evt(), otherwise
the connection can be freed concurrently.
Extend the hci_dev_lock critical section to cover all conn usage in both
handlers.
Keep the existing keypress notification behavior unchanged by routing
the early exits through a common unlock path.
CVSS Score
8.8
EPSS Score
0.003
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
media: amphion: Fix race between m2m job_abort and device_run
Fix kernel panic caused by race condition where v4l2_m2m_ctx_release()
frees m2m_ctx while v4l2_m2m_try_run() is about to call device_run
with the same context.
Race sequence:
v4l2_m2m_try_run(): v4l2_m2m_ctx_release():
lock/unlock v4l2_m2m_cancel_job()
job_abort()
v4l2_m2m_job_finish()
kfree(m2m_ctx) <- frees ctx
device_run() <- use-after-free crash at 0x538
Crash trace:
Unable to handle kernel read from unreadable memory at virtual address
0000000000000538
v4l2_m2m_try_run+0x78/0x138
v4l2_m2m_device_run_work+0x14/0x20
The amphion vpu driver does not rely on the m2m framework's device_run
callback to perform encode/decode operations.
Fix the race by preventing m2m framework job scheduling entirely:
- Add job_ready callback returning 0 (no jobs ready for m2m framework)
- Remove job_abort callback to avoid the race condition
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-27