Linux: >> Linux Kernel >> 5.15.192 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
8021q: delete cleared egress QoS mappings
vlan_dev_set_egress_priority() currently keeps cleared egress
priority mappings in the hash as tombstones. Repeated set/clear cycles
with distinct skb priorities therefore accumulate mapping nodes until
device teardown and leak memory.
Delete mappings when vlan_prio is cleared instead of keeping tombstones.
Now that the egress mapping lists are RCU protected, the node can be
unlinked safely and freed after a grace period.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
ntfs3: fix integer overflow in run_unpack() volume boundary check
The volume boundary check `lcn + len > sbi->used.bitmap.nbits` uses raw
addition which can wrap around for large lcn and len values, bypassing
the validation. Use check_add_overflow() as is already done for the
adjacent prev_lcn + dlcn and vcn64 + len checks added by commit
3ac37e100385 ("ntfs3: Fix integer overflow in run_unpack()").
Found by fuzzing with a source-patched harness (LibAFL + QEMU).
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
selinux: fix overlayfs mmap() and mprotect() access checks
The existing SELinux security model for overlayfs is to allow access if
the current task is able to access the top level file (the "user" file)
and the mounter's credentials are sufficient to access the lower
level file (the "backing" file). Unfortunately, the current code does
not properly enforce these access controls for both mmap() and mprotect()
operations on overlayfs filesystems.
This patch makes use of the newly created security_mmap_backing_file()
LSM hook to provide the missing backing file enforcement for mmap()
operations, and leverages the backing file API and new LSM blob to
provide the necessary information to properly enforce the mprotect()
access controls.
CVSS Score
7.1
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_event: fix potential UAF in SSP passkey handlers
hci_conn lookup and field access must be covered by hdev lock in
hci_user_passkey_notify_evt() and hci_keypress_notify_evt(), otherwise
the connection can be freed concurrently.
Extend the hci_dev_lock critical section to cover all conn usage in both
handlers.
Keep the existing keypress notification behavior unchanged by routing
the early exits through a common unlock path.
CVSS Score
8.8
EPSS Score
0.003
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
KVM: nSVM: Always use NextRIP as vmcb02's NextRIP after first L2 VMRUN
For guests with NRIPS disabled, L1 does not provide NextRIP when running
an L2 with an injected soft interrupt, instead it advances the current RIP
before running it. KVM uses the current RIP as the NextRIP in vmcb02 to
emulate a CPU without NRIPS.
However, after L2 runs the first time, NextRIP will be updated by the CPU
and/or KVM, and the current RIP is no longer the correct value to use in
vmcb02. Hence, after save/restore, use the current RIP if and only if a
nested run is pending, otherwise use NextRIP. Give soft_int_next_rip the
same treatment, as it's the same logic, just for a narrower use case.
[sean: give soft_int_next_rip the same treatment]
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
ext4: fix missing brelse() in ext4_xattr_inode_dec_ref_all()
The commit c8e008b60492 ("ext4: ignore xattrs past end")
introduced a refcount leak in when block_csum is false.
ext4_xattr_inode_dec_ref_all() calls ext4_get_inode_loc() to
get iloc.bh, but never releases it with brelse().
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
net: qrtr: ns: Fix use-after-free in driver remove()
In the remove callback, if a packet arrives after destroy_workqueue() is
called, but before sock_release(), the qrtr_ns_data_ready() callback will
try to queue the work, causing use-after-free issue.
Fix this issue by saving the default 'sk_data_ready' callback during
qrtr_ns_init() and use it to replace the qrtr_ns_data_ready() callback at
the start of remove(). This ensures that even if a packet arrives after
destroy_workqueue(), the work struct will not be dereferenced.
Note that it is also required to ensure that the RX threads are completed
before destroying the workqueue, because the threads could be using the
qrtr_ns_data_ready() callback.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
ALSA: ctxfi: Add fallback to default RSR for S/PDIF
spdif_passthru_playback_get_resources() uses atc->pll_rate as the RSR
for the MSR calculation loop. However, pll_rate is only updated in
atc_pll_init() and not in hw_pll_init(), so it remains 0 after the
card init.
When spdif_passthru_playback_setup() skips atc_pll_init() for
32000 Hz, (rsr * desc.msr) always becomes 0, causing the loop to spin
indefinitely.
Add fallback to use atc->rsr when atc->pll_rate is 0. This reflects
the hardware state, since hw_card_init() already configures the PLL
to the default RSR.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
md/raid10: fix deadlock with check operation and nowait requests
When an array check is running it will raise the barrier at which point
normal requests will become blocked and increment the nr_pending value to
signal there is work pending inside of wait_barrier(). NOWAIT requests
do not block and so will return immediately with an error, and additionally
do not increment nr_pending in wait_barrier(). Upstream change commit
43806c3d5b9b ("raid10: cleanup memleak at raid10_make_request") added a
call to raid_end_bio_io() to fix a memory leak when NOWAIT requests hit
this condition. raid_end_bio_io() eventually calls allow_barrier() and
it will unconditionally do an atomic_dec_and_test(&conf->nr_pending) even
though the corresponding increment on nr_pending didn't happen in the
NOWAIT case.
This can be easily seen by starting a check operation while an application
is doing nowait IO on the same array. This results in a deadlocked state
due to nr_pending value underflowing and so the md resync thread gets stuck
waiting for nr_pending to == 0.
Output of r10conf state of the array when we hit this condition:
crash> struct r10conf
barrier = 1,
nr_pending = {
counter = -41
},
nr_waiting = 15,
nr_queued = 0,
Example of md_sync thread stuck waiting on raise_barrier() and other
requests stuck in wait_barrier():
md1_resync
[<0>] raise_barrier+0xce/0x1c0
[<0>] raid10_sync_request+0x1ca/0x1ed0
[<0>] md_do_sync+0x779/0x1110
[<0>] md_thread+0x90/0x160
[<0>] kthread+0xbe/0xf0
[<0>] ret_from_fork+0x34/0x50
[<0>] ret_from_fork_asm+0x1a/0x30
kworker/u1040:2+flush-253:4
[<0>] wait_barrier+0x1de/0x220
[<0>] regular_request_wait+0x30/0x180
[<0>] raid10_make_request+0x261/0x1000
[<0>] md_handle_request+0x13b/0x230
[<0>] __submit_bio+0x107/0x1f0
[<0>] submit_bio_noacct_nocheck+0x16f/0x390
[<0>] ext4_io_submit+0x24/0x40
[<0>] ext4_do_writepages+0x254/0xc80
[<0>] ext4_writepages+0x84/0x120
[<0>] do_writepages+0x7a/0x260
[<0>] __writeback_single_inode+0x3d/0x300
[<0>] writeback_sb_inodes+0x1dd/0x470
[<0>] __writeback_inodes_wb+0x4c/0xe0
[<0>] wb_writeback+0x18b/0x2d0
[<0>] wb_workfn+0x2a1/0x400
[<0>] process_one_work+0x149/0x330
[<0>] worker_thread+0x2d2/0x410
[<0>] kthread+0xbe/0xf0
[<0>] ret_from_fork+0x34/0x50
[<0>] ret_from_fork_asm+0x1a/0x30
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
md/raid5: fix soft lockup in retry_aligned_read()
When retry_aligned_read() encounters an overlapped stripe, it releases
the stripe via raid5_release_stripe() which puts it on the lockless
released_stripes llist. In the next raid5d loop iteration,
release_stripe_list() drains the stripe onto handle_list (since
STRIPE_HANDLE is set by the original IO), but retry_aligned_read()
runs before handle_active_stripes() and removes the stripe from
handle_list via find_get_stripe() -> list_del_init(). This prevents
handle_stripe() from ever processing the stripe to resolve the
overlap, causing an infinite loop and soft lockup.
Fix this by using __release_stripe() with temp_inactive_list instead
of raid5_release_stripe() in the failure path, so the stripe does not
go through the released_stripes llist. This allows raid5d to break out
of its loop, and the overlap will be resolved when the stripe is
eventually processed by handle_stripe().
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27