In the Linux kernel, the following vulnerability has been resolved:
start_kernel: Add __no_stack_protector function attribute
Back during the discussion of
commit a9a3ed1eff36 ("x86: Fix early boot crash on gcc-10, third try")
we discussed the need for a function attribute to control the omission
of stack protectors on a per-function basis; at the time Clang had
support for no_stack_protector but GCC did not. This was fixed in
gcc-11. Now that the function attribute is available, let's start using
it.
Callers of boot_init_stack_canary need to use this function attribute
unless they're compiled with -fno-stack-protector, otherwise the canary
stored in the stack slot of the caller will differ upon the call to
boot_init_stack_canary. This will lead to a call to __stack_chk_fail()
then panic.
In the Linux kernel, the following vulnerability has been resolved:
powerpc/rtas_flash: allow user copy to flash block cache objects
With hardened usercopy enabled (CONFIG_HARDENED_USERCOPY=y), using the
/proc/powerpc/rtas/firmware_update interface to prepare a system
firmware update yields a BUG():
kernel BUG at mm/usercopy.c:102!
Oops: Exception in kernel mode, sig: 5 [#1]
LE PAGE_SIZE=64K MMU=Hash SMP NR_CPUS=2048 NUMA pSeries
Modules linked in:
CPU: 0 PID: 2232 Comm: dd Not tainted 6.5.0-rc3+ #2
Hardware name: IBM,8408-E8E POWER8E (raw) 0x4b0201 0xf000004 of:IBM,FW860.50 (SV860_146) hv:phyp pSeries
NIP: c0000000005991d0 LR: c0000000005991cc CTR: 0000000000000000
REGS: c0000000148c76a0 TRAP: 0700 Not tainted (6.5.0-rc3+)
MSR: 8000000000029033 <SF,EE,ME,IR,DR,RI,LE> CR: 24002242 XER: 0000000c
CFAR: c0000000001fbd34 IRQMASK: 0
[ ... GPRs omitted ... ]
NIP usercopy_abort+0xa0/0xb0
LR usercopy_abort+0x9c/0xb0
Call Trace:
usercopy_abort+0x9c/0xb0 (unreliable)
__check_heap_object+0x1b4/0x1d0
__check_object_size+0x2d0/0x380
rtas_flash_write+0xe4/0x250
proc_reg_write+0xfc/0x160
vfs_write+0xfc/0x4e0
ksys_write+0x90/0x160
system_call_exception+0x178/0x320
system_call_common+0x160/0x2c4
The blocks of the firmware image are copied directly from user memory
to objects allocated from flash_block_cache, so flash_block_cache must
be created using kmem_cache_create_usercopy() to mark it safe for user
access.
[mpe: Trim and indent oops]
In the Linux kernel, the following vulnerability has been resolved:
IB/hfi1: Fix possible panic during hotplug remove
During hotplug remove it is possible that the update counters work
might be pending, and may run after memory has been freed.
Cancel the update counters work before freeing memory.
In the Linux kernel, the following vulnerability has been resolved:
ipv6: Add lwtunnel encap size of all siblings in nexthop calculation
In function rt6_nlmsg_size(), the length of nexthop is calculated
by multipling the nexthop length of fib6_info and the number of
siblings. However if the fib6_info has no lwtunnel but the siblings
have lwtunnels, the nexthop length is less than it should be, and
it will trigger a warning in inet6_rt_notify() as follows:
WARNING: CPU: 0 PID: 6082 at net/ipv6/route.c:6180 inet6_rt_notify+0x120/0x130
......
Call Trace:
<TASK>
fib6_add_rt2node+0x685/0xa30
fib6_add+0x96/0x1b0
ip6_route_add+0x50/0xd0
inet6_rtm_newroute+0x97/0xa0
rtnetlink_rcv_msg+0x156/0x3d0
netlink_rcv_skb+0x5a/0x110
netlink_unicast+0x246/0x350
netlink_sendmsg+0x250/0x4c0
sock_sendmsg+0x66/0x70
___sys_sendmsg+0x7c/0xd0
__sys_sendmsg+0x5d/0xb0
do_syscall_64+0x3f/0x90
entry_SYSCALL_64_after_hwframe+0x72/0xdc
This bug can be reproduced by script:
ip -6 addr add 2002::2/64 dev ens2
ip -6 route add 100::/64 via 2002::1 dev ens2 metric 100
for i in 10 20 30 40 50 60 70;
do
ip link add link ens2 name ipv_$i type ipvlan
ip -6 addr add 2002::$i/64 dev ipv_$i
ifconfig ipv_$i up
done
for i in 10 20 30 40 50 60;
do
ip -6 route append 100::/64 encap ip6 dst 2002::$i via 2002::1
dev ipv_$i metric 100
done
ip -6 route append 100::/64 via 2002::1 dev ipv_70 metric 100
This patch fixes it by adding nexthop_len of every siblings using
rt6_nh_nlmsg_size().
In the Linux kernel, the following vulnerability has been resolved:
kobject: Add sanity check for kset->kobj.ktype in kset_register()
When I register a kset in the following way:
static struct kset my_kset;
kobject_set_name(&my_kset.kobj, "my_kset");
ret = kset_register(&my_kset);
A null pointer dereference exception is occurred:
[ 4453.568337] Unable to handle kernel NULL pointer dereference at \
virtual address 0000000000000028
... ...
[ 4453.810361] Call trace:
[ 4453.813062] kobject_get_ownership+0xc/0x34
[ 4453.817493] kobject_add_internal+0x98/0x274
[ 4453.822005] kset_register+0x5c/0xb4
[ 4453.825820] my_kobj_init+0x44/0x1000 [my_kset]
... ...
Because I didn't initialize my_kset.kobj.ktype.
According to the description in Documentation/core-api/kobject.rst:
- A ktype is the type of object that embeds a kobject. Every structure
that embeds a kobject needs a corresponding ktype.
So add sanity check to make sure kset->kobj.ktype is not NULL.
In the Linux kernel, the following vulnerability has been resolved:
iommu: Fix error unwind in iommu_group_alloc()
If either iommu_group_grate_file() fails then the
iommu_group is leaked.
Destroy it on these error paths.
Found by kselftest/iommu/iommufd_fail_nth
In the Linux kernel, the following vulnerability has been resolved:
pwm: lpc32xx: Remove handling of PWM channels
Because LPC32xx PWM controllers have only a single output which is
registered as the only PWM device/channel per controller, it is known in
advance that pwm->hwpwm value is always 0. On basis of this fact
simplify the code by removing operations with pwm->hwpwm, there is no
controls which require channel number as input.
Even though I wasn't aware at the time when I forward ported that patch,
this fixes a null pointer dereference as lpc32xx->chip.pwms is NULL
before devm_pwmchip_add() is called.
In the Linux kernel, the following vulnerability has been resolved:
iw_cxgb4: Fix potential NULL dereference in c4iw_fill_res_cm_id_entry()
This condition needs to match the previous "if (epcp->state == LISTEN) {"
exactly to avoid a NULL dereference of either "listen_ep" or "ep". The
problem is that "epcp" has been re-assigned so just testing
"if (epcp->state == LISTEN) {" a second time is not sufficient.