Linux: >> Linux Kernel >> 4.4.180 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
ntb_netdev: Use dev_kfree_skb_any() in interrupt context
TX/RX callback handlers (ntb_netdev_tx_handler(),
ntb_netdev_rx_handler()) can be called in interrupt
context via the DMA framework when the respective
DMA operations have completed. As such, any calls
by these routines to free skb's, should use the
interrupt context safe dev_kfree_skb_any() function.
Previously, these callback handlers would call the
interrupt unsafe version of dev_kfree_skb(). This has
not presented an issue on Intel IOAT DMA engines as
that driver utilizes tasklets rather than a hard
interrupt handler, like the AMD PTDMA DMA driver.
On AMD systems, a kernel WARNING message is
encountered, which is being issued from
skb_release_head_state() due to in_hardirq()
being true.
Besides the user visible WARNING from the kernel,
the other symptom of this bug was that TCP/IP performance
across the ntb_netdev interface was very poor, i.e.
approximately an order of magnitude below what was
expected. With the repair to use dev_kfree_skb_any(),
kernel WARNINGs from skb_release_head_state() ceased
and TCP/IP performance, as measured by iperf, was on
par with expected results, approximately 20 Gb/s on
AMD Milan based server. Note that this performance
is comparable with Intel based servers.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-10-04
In the Linux kernel, the following vulnerability has been resolved:
nilfs2: fix shift-out-of-bounds/overflow in nilfs_sb2_bad_offset()
Patch series "nilfs2: fix UBSAN shift-out-of-bounds warnings on mount
time".
The first patch fixes a bug reported by syzbot, and the second one fixes
the remaining bug of the same kind. Although they are triggered by the
same super block data anomaly, I divided it into the above two because the
details of the issues and how to fix it are different.
Both are required to eliminate the shift-out-of-bounds issues at mount
time.
This patch (of 2):
If the block size exponent information written in an on-disk superblock is
corrupted, nilfs_sb2_bad_offset helper function can trigger
shift-out-of-bounds warning followed by a kernel panic (if panic_on_warn
is set):
shift exponent 38983 is too large for 64-bit type 'unsigned long long'
Call Trace:
<TASK>
__dump_stack lib/dump_stack.c:88 [inline]
dump_stack_lvl+0x1b1/0x28e lib/dump_stack.c:106
ubsan_epilogue lib/ubsan.c:151 [inline]
__ubsan_handle_shift_out_of_bounds+0x33d/0x3b0 lib/ubsan.c:322
nilfs_sb2_bad_offset fs/nilfs2/the_nilfs.c:449 [inline]
nilfs_load_super_block+0xdf5/0xe00 fs/nilfs2/the_nilfs.c:523
init_nilfs+0xb7/0x7d0 fs/nilfs2/the_nilfs.c:577
nilfs_fill_super+0xb1/0x5d0 fs/nilfs2/super.c:1047
nilfs_mount+0x613/0x9b0 fs/nilfs2/super.c:1317
...
In addition, since nilfs_sb2_bad_offset() performs multiplication without
considering the upper bound, the computation may overflow if the disk
layout parameters are not normal.
This fixes these issues by inserting preliminary sanity checks for those
parameters and by converting the comparison from one involving
multiplication and left bit-shifting to one using division and right
bit-shifting.
CVSS Score
7.1
EPSS Score
0.0
Published
2025-10-04
In the Linux kernel, the following vulnerability has been resolved:
iommu/vt-d: Clean up si_domain in the init_dmars() error path
A splat from kmem_cache_destroy() was seen with a kernel prior to
commit ee2653bbe89d ("iommu/vt-d: Remove domain and devinfo mempool")
when there was a failure in init_dmars(), because the iommu_domain
cache still had objects. While the mempool code is now gone, there
still is a leak of the si_domain memory if init_dmars() fails. So
clean up si_domain in the init_dmars() error path.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-10-04
In the Linux kernel, the following vulnerability has been resolved:
xen/gntdev: Accommodate VMA splitting
Prior to this commit, the gntdev driver code did not handle the
following scenario correctly with paravirtualized (PV) Xen domains:
* User process sets up a gntdev mapping composed of two grant mappings
(i.e., two pages shared by another Xen domain).
* User process munmap()s one of the pages.
* User process munmap()s the remaining page.
* User process exits.
In the scenario above, the user process would cause the kernel to log
the following messages in dmesg for the first munmap(), and the second
munmap() call would result in similar log messages:
BUG: Bad page map in process doublemap.test pte:... pmd:...
page:0000000057c97bff refcount:1 mapcount:-1 \
mapping:0000000000000000 index:0x0 pfn:...
...
page dumped because: bad pte
...
file:gntdev fault:0x0 mmap:gntdev_mmap [xen_gntdev] readpage:0x0
...
Call Trace:
<TASK>
dump_stack_lvl+0x46/0x5e
print_bad_pte.cold+0x66/0xb6
unmap_page_range+0x7e5/0xdc0
unmap_vmas+0x78/0xf0
unmap_region+0xa8/0x110
__do_munmap+0x1ea/0x4e0
__vm_munmap+0x75/0x120
__x64_sys_munmap+0x28/0x40
do_syscall_64+0x38/0x90
entry_SYSCALL_64_after_hwframe+0x61/0xcb
...
For each munmap() call, the Xen hypervisor (if built with CONFIG_DEBUG)
would print out the following and trigger a general protection fault in
the affected Xen PV domain:
(XEN) d0v... Attempt to implicitly unmap d0's grant PTE ...
(XEN) d0v... Attempt to implicitly unmap d0's grant PTE ...
As of this writing, gntdev_grant_map structure's vma field (referred to
as map->vma below) is mainly used for checking the start and end
addresses of mappings. However, with split VMAs, these may change, and
there could be more than one VMA associated with a gntdev mapping.
Hence, remove the use of map->vma and rely on map->pages_vm_start for
the original start address and on (map->count << PAGE_SHIFT) for the
original mapping size. Let the invalidate() and find_special_page()
hooks use these.
Also, given that there can be multiple VMAs associated with a gntdev
mapping, move the "mmu_interval_notifier_remove(&map->notifier)" call to
the end of gntdev_put_map, so that the MMU notifier is only removed
after the closing of the last remaining VMA.
Finally, use an atomic to prevent inadvertent gntdev mapping re-use,
instead of using the map->live_grants atomic counter and/or the map->vma
pointer (the latter of which is now removed). This prevents the
userspace from mmap()'ing (with MAP_FIXED) a gntdev mapping over the
same address range as a previously set up gntdev mapping. This scenario
can be summarized with the following call-trace, which was valid prior
to this commit:
mmap
gntdev_mmap
mmap (repeat mmap with MAP_FIXED over the same address range)
gntdev_invalidate
unmap_grant_pages (sets 'being_removed' entries to true)
gnttab_unmap_refs_async
unmap_single_vma
gntdev_mmap (maps the shared pages again)
munmap
gntdev_invalidate
unmap_grant_pages
(no-op because 'being_removed' entries are true)
unmap_single_vma (For PV domains, Xen reports that a granted page
is being unmapped and triggers a general protection fault in the
affected domain, if Xen was built with CONFIG_DEBUG)
The fix for this last scenario could be worth its own commit, but we
opted for a single commit, because removing the gntdev_grant_map
structure's vma field requires guarding the entry to gntdev_mmap(), and
the live_grants atomic counter is not sufficient on its own to prevent
the mmap() over a pre-existing mapping.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-10-04
In the Linux kernel, the following vulnerability has been resolved:
macintosh: fix possible memory leak in macio_add_one_device()
Afer commit 1fa5ae857bb1 ("driver core: get rid of struct device's
bus_id string array"), the name of device is allocated dynamically. It
needs to be freed when of_device_register() fails. Call put_device() to
give up the reference that's taken in device_initialize(), so that it
can be freed in kobject_cleanup() when the refcount hits 0.
macio device is freed in macio_release_dev(), so the kfree() can be
removed.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-10-04
In the Linux kernel, the following vulnerability has been resolved:
xhci: Remove device endpoints from bandwidth list when freeing the device
Endpoints are normally deleted from the bandwidth list when they are
dropped, before the virt device is freed.
If xHC host is dying or being removed then the endpoints aren't dropped
cleanly due to functions returning early to avoid interacting with a
non-accessible host controller.
So check and delete endpoints that are still on the bandwidth list when
freeing the virt device.
Solves a list_del corruption kernel crash when unbinding xhci-pci,
caused by xhci_mem_cleanup() when it later tried to delete already freed
endpoints from the bandwidth list.
This only affects hosts that use software bandwidth checking, which
currenty is only the xHC in intel Panther Point PCH (Ivy Bridge)
CVSS Score
7.8
EPSS Score
0.0
Published
2025-10-04
In the Linux kernel, the following vulnerability has been resolved:
wifi: wilc1000: avoid buffer overflow in WID string configuration
Fix the following copy overflow warning identified by Smatch checker.
drivers/net/wireless/microchip/wilc1000/wlan_cfg.c:184 wilc_wlan_parse_response_frame()
error: '__memcpy()' 'cfg->s[i]->str' copy overflow (512 vs 65537)
This patch introduces size check before accessing the memory buffer.
The checks are base on the WID type of received data from the firmware.
For WID string configuration, the size limit is determined by individual
element size in 'struct wilc_cfg_str_vals' that is maintained in 'len' field
of 'struct wilc_cfg_str'.
CVSS Score
7.8
EPSS Score
0.0
Published
2025-10-04
In the Linux kernel, the following vulnerability has been resolved:
cnic: Fix use-after-free bugs in cnic_delete_task
The original code uses cancel_delayed_work() in cnic_cm_stop_bnx2x_hw(),
which does not guarantee that the delayed work item 'delete_task' has
fully completed if it was already running. Additionally, the delayed work
item is cyclic, the flush_workqueue() in cnic_cm_stop_bnx2x_hw() only
blocks and waits for work items that were already queued to the
workqueue prior to its invocation. Any work items submitted after
flush_workqueue() is called are not included in the set of tasks that the
flush operation awaits. This means that after the cyclic work items have
finished executing, a delayed work item may still exist in the workqueue.
This leads to use-after-free scenarios where the cnic_dev is deallocated
by cnic_free_dev(), while delete_task remains active and attempt to
dereference cnic_dev in cnic_delete_task().
A typical race condition is illustrated below:
CPU 0 (cleanup) | CPU 1 (delayed work callback)
cnic_netdev_event() |
cnic_stop_hw() | cnic_delete_task()
cnic_cm_stop_bnx2x_hw() | ...
cancel_delayed_work() | /* the queue_delayed_work()
flush_workqueue() | executes after flush_workqueue()*/
| queue_delayed_work()
cnic_free_dev(dev)//free | cnic_delete_task() //new instance
| dev = cp->dev; //use
Replace cancel_delayed_work() with cancel_delayed_work_sync() to ensure
that the cyclic delayed work item is properly canceled and that any
ongoing execution of the work item completes before the cnic_dev is
deallocated. Furthermore, since cancel_delayed_work_sync() uses
__flush_work(work, true) to synchronously wait for any currently
executing instance of the work item to finish, the flush_workqueue()
becomes redundant and should be removed.
This bug was identified through static analysis. To reproduce the issue
and validate the fix, I simulated the cnic PCI device in QEMU and
introduced intentional delays — such as inserting calls to ssleep()
within the cnic_delete_task() function — to increase the likelihood
of triggering the bug.
CVSS Score
7.8
EPSS Score
0.0
Published
2025-10-04
In the Linux kernel, the following vulnerability has been resolved:
dm-stripe: fix a possible integer overflow
There's a possible integer overflow in stripe_io_hints if we have too
large chunk size. Test if the overflow happened, and if it did, don't set
limits->io_min and limits->io_opt;
CVSS Score
5.5
EPSS Score
0.0
Published
2025-10-04
In the Linux kernel, the following vulnerability has been resolved:
crypto: af_alg - Set merge to zero early in af_alg_sendmsg
If an error causes af_alg_sendmsg to abort, ctx->merge may contain
a garbage value from the previous loop. This may then trigger a
crash on the next entry into af_alg_sendmsg when it attempts to do
a merge that can't be done.
Fix this by setting ctx->merge to zero near the start of the loop.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-10-04