Linux: >> Linux Kernel >> 6.18.8 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
apparmor: Fix & Optimize table creation from possibly unaligned memory
Source blob may come from userspace and might be unaligned.
Try to optize the copying process by avoiding unaligned memory accesses.
- Added Fixes tag
- Added "Fix &" to description as this doesn't just optimize but fixes
a potential unaligned memory access
[jj: remove duplicate word "convert" in comment trigger checkpatch warning]
CVSS Score
7.1
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
iommu/vt-d: Clear Present bit before tearing down PASID entry
The Intel VT-d Scalable Mode PASID table entry consists of 512 bits (64
bytes). When tearing down an entry, the current implementation zeros the
entire 64-byte structure immediately using multiple 64-bit writes.
Since the IOMMU hardware may fetch these 64 bytes using multiple
internal transactions (e.g., four 128-bit bursts), updating or zeroing
the entire entry while it is active (P=1) risks a "torn" read. If a
hardware fetch occurs simultaneously with the CPU zeroing the entry, the
hardware could observe an inconsistent state, leading to unpredictable
behavior or spurious faults.
Follow the "Guidance to Software for Invalidations" in the VT-d spec
(Section 6.5.3.3) by implementing the recommended ownership handshake:
1. Clear only the 'Present' (P) bit of the PASID entry.
2. Use a dma_wmb() to ensure the cleared bit is visible to hardware
before proceeding.
3. Execute the required invalidation sequence (PASID cache, IOTLB, and
Device-TLB flush) to ensure the hardware has released all cached
references.
4. Only after the flushes are complete, zero out the remaining fields
of the PASID entry.
Also, add a dma_wmb() in pasid_set_present() to ensure that all other
fields of the PASID entry are visible to the hardware before the Present
bit is set.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
quota: fix livelock between quotactl and freeze_super
When a filesystem is frozen, quotactl_block() enters a retry loop
waiting for the filesystem to thaw. It acquires s_umount, checks the
freeze state, drops s_umount and uses sb_start_write() - sb_end_write()
pair to wait for the unfreeze.
However, this retry loop can trigger a livelock issue, specifically on
kernels with preemption disabled.
The mechanism is as follows:
1. freeze_super() sets SB_FREEZE_WRITE and calls sb_wait_write().
2. sb_wait_write() calls percpu_down_write(), which initiates
synchronize_rcu().
3. Simultaneously, quotactl_block() spins in its retry loop, immediately
executing the sb_start_write() - sb_end_write() pair.
4. Because the kernel is non-preemptible and the loop contains no
scheduling points, quotactl_block() never yields the CPU. This
prevents that CPU from reaching an RCU quiescent state.
5. synchronize_rcu() in the freezer thread waits indefinitely for the
quotactl_block() CPU to report a quiescent state.
6. quotactl_block() spins indefinitely waiting for the freezer to
advance, which it cannot do as it is blocked on the RCU sync.
This results in a hang of the freezer process and 100% CPU usage by the
quota process.
While this can occur intermittently on multi-core systems, it is
reliably reproducing on a node with the following script, running both
the freezer and the quota toggle on the same CPU:
# mkfs.ext4 -O quota /dev/sda 2g && mkdir a_mount
# mount /dev/sda -o quota,usrquota,grpquota a_mount
# taskset -c 3 bash -c "while true; do xfs_freeze -f a_mount; \
xfs_freeze -u a_mount; done" &
# taskset -c 3 bash -c "while true; do quotaon a_mount; \
quotaoff a_mount; done" &
Adding cond_resched() to the retry loop fixes the issue. It acts as an
RCU quiescent state, allowing synchronize_rcu() in percpu_down_write()
to complete.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
mtd: intel-dg: Fix accessing regions before setting nregions
The regions array is counted by nregions, but it's set only after
accessing it:
[] UBSAN: array-index-out-of-bounds in drivers/mtd/devices/mtd_intel_dg.c:750:15
[] index 0 is out of range for type '<unknown> [*]'
Fix it by also fixing an undesired behavior: the loop silently ignores
ENOMEM and continues setting the other entries.
CVSS Score
7.8
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_counter: serialize reset with spinlock
Add a global static spinlock to serialize counter fetch+reset
operations, preventing concurrent dump-and-reset from underrunning
values.
The lock is taken before fetching the total so that two parallel
resets cannot both read the same counter values and then both
subtract them.
A global lock is used for simplicity since resets are infrequent.
If this becomes a bottleneck, it can be replaced with a per-net
lock later.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
power: supply: pm8916_bms_vm: Fix use-after-free in power_supply_changed()
Using the `devm_` variant for requesting IRQ _before_ the `devm_`
variant for allocating/registering the `power_supply` handle, means that
the `power_supply` handle will be deallocated/unregistered _before_ the
interrupt handler (since `devm_` naturally deallocates in reverse
allocation order). This means that during removal, there is a race
condition where an interrupt can fire just _after_ the `power_supply`
handle has been freed, *but* just _before_ the corresponding
unregistration of the IRQ handler has run.
This will lead to the IRQ handler calling `power_supply_changed()` with
a freed `power_supply` handle. Which usually crashes the system or
otherwise silently corrupts the memory...
Note that there is a similar situation which can also happen during
`probe()`; the possibility of an interrupt firing _before_ registering
the `power_supply` handle. This would then lead to the nasty situation
of using the `power_supply` handle *uninitialized* in
`power_supply_changed()`.
Fix this racy use-after-free by making sure the IRQ is requested _after_
the registration of the `power_supply` handle.
CVSS Score
7.8
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
iio: sca3000: Fix a resource leak in sca3000_probe()
spi->irq from request_threaded_irq() not released when
iio_device_register() fails. Add an return value check and jump to a
common error handler when iio_device_register() fails.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
apparmor: avoid per-cpu hold underflow in aa_get_buffer
When aa_get_buffer() pulls from the per-cpu list it unconditionally
decrements cache->hold. If hold reaches 0 while count is still non-zero,
the unsigned decrement wraps to UINT_MAX. This keeps hold non-zero for a
very long time, so aa_put_buffer() never returns buffers to the global
list, which can starve other CPUs and force repeated kmalloc(aa_g_path_max)
allocations.
Guard the decrement so hold never underflows.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
power: supply: cpcap-battery: Fix use-after-free in power_supply_changed()
Using the `devm_` variant for requesting IRQ _before_ the `devm_`
variant for allocating/registering the `power_supply` handle, means that
the `power_supply` handle will be deallocated/unregistered _before_ the
interrupt handler (since `devm_` naturally deallocates in reverse
allocation order). This means that during removal, there is a race
condition where an interrupt can fire just _after_ the `power_supply`
handle has been freed, *but* just _before_ the corresponding
unregistration of the IRQ handler has run.
This will lead to the IRQ handler calling `power_supply_changed()` with
a freed `power_supply` handle. Which usually crashes the system or
otherwise silently corrupts the memory...
Note that there is a similar situation which can also happen during
`probe()`; the possibility of an interrupt firing _before_ registering
the `power_supply` handle. This would then lead to the nasty situation
of using the `power_supply` handle *uninitialized* in
`power_supply_changed()`.
Fix this racy use-after-free by making sure the IRQ is requested _after_
the registration of the `power_supply` handle.
CVSS Score
7.8
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix bpf_xdp_store_bytes proto for read-only arg
While making some maps in Cilium read-only from the BPF side, we noticed
that the bpf_xdp_store_bytes proto is incorrect. In particular, the
verifier was throwing the following error:
; ret = ctx_store_bytes(ctx, l3_off + offsetof(struct iphdr, saddr),
&nat->address, 4, 0);
635: (79) r1 = *(u64 *)(r10 -144) ; R1=ctx() R10=fp0 fp-144=ctx()
636: (b4) w2 = 26 ; R2=26
637: (b4) w4 = 4 ; R4=4
638: (b4) w5 = 0 ; R5=0
639: (85) call bpf_xdp_store_bytes#190
write into map forbidden, value_size=6 off=0 size=4
nat comes from a BPF_F_RDONLY_PROG map, so R3 is a PTR_TO_MAP_VALUE.
The verifier checks the helper's memory access to R3 in
check_mem_size_reg, as it reaches ARG_CONST_SIZE argument. The third
argument has expected type ARG_PTR_TO_UNINIT_MEM, which includes the
MEM_WRITE flag. The verifier thus checks for a BPF_WRITE access on R3.
Given R3 points to a read-only map, the check fails.
Conversely, ARG_PTR_TO_UNINIT_MEM can also lead to the helper reading
from uninitialized memory.
This patch simply fixes the expected argument type to match that of
bpf_skb_store_bytes.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27