Linux: >> Linux Kernel >> 2.6.35.2 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
MIPS: ftrace: Fix memory corruption when kernel is located beyond 32 bits
Since commit e424054000878 ("MIPS: Tracing: Reduce the overhead of
dynamic Function Tracer"), the macro UASM_i_LA_mostly has been used,
and this macro can generate more than 2 instructions. At the same
time, the code in ftrace assumes that no more than 2 instructions can
be generated, which is why it stores them in an int[2] array. However,
as previously noted, the macro UASM_i_LA_mostly (and now UASM_i_LA)
causes a buffer overflow when _mcount is beyond 32 bits. This leads to
corruption of the variables located in the __read_mostly section.
This corruption was observed because the variable
__cpu_primary_thread_mask was corrupted, causing a hang very early
during boot.
This fix prevents the corruption by avoiding the generation of
instructions if they could exceed 2 instructions in
length. Fortunately, insn_la_mcount is only used if the instrumented
code is located outside the kernel code section, so dynamic ftrace can
still be used, albeit in a more limited scope. This is still
preferable to corrupting memory and/or crashing the kernel.
CVSS Score
5.5
EPSS Score
0.0
Published
2026-01-14
In the Linux kernel, the following vulnerability has been resolved:
Input: lkkbd - disable pending work before freeing device
lkkbd_interrupt() schedules lk->tq via schedule_work(), and the work
handler lkkbd_reinit() dereferences the lkkbd structure and its
serio/input_dev fields.
lkkbd_disconnect() and error paths in lkkbd_connect() free the lkkbd
structure without preventing the reinit work from being queued again
until serio_close() returns. This can allow the work handler to run
after the structure has been freed, leading to a potential use-after-free.
Use disable_work_sync() instead of cancel_work_sync() to ensure the
reinit work cannot be re-queued, and call it both in lkkbd_disconnect()
and in lkkbd_connect() error paths after serio_open().
CVSS Score
7.8
EPSS Score
0.0
Published
2026-01-13
In the Linux kernel, the following vulnerability has been resolved:
functionfs: fix the open/removal races
ffs_epfile_open() can race with removal, ending up with file->private_data
pointing to freed object.
There is a total count of opened files on functionfs (both ep0 and
dynamic ones) and when it hits zero, dynamic files get removed.
Unfortunately, that removal can happen while another thread is
in ffs_epfile_open(), but has not incremented the count yet.
In that case open will succeed, leaving us with UAF on any subsequent
read() or write().
The root cause is that ffs->opened is misused; atomic_dec_and_test() vs.
atomic_add_return() is not a good idea, when object remains visible all
along.
To untangle that
* serialize openers on ffs->mutex (both for ep0 and for dynamic files)
* have dynamic ones use atomic_inc_not_zero() and fail if we had
zero ->opened; in that case the file we are opening is doomed.
* have the inodes of dynamic files marked on removal (from the
callback of simple_recursive_removal()) - clear ->i_private there.
* have open of dynamic ones verify they hadn't been already removed,
along with checking that state is FFS_ACTIVE.
CVSS Score
4.7
EPSS Score
0.0
Published
2026-01-13
In the Linux kernel, the following vulnerability has been resolved:
scsi: aic94xx: fix use-after-free in device removal path
The asd_pci_remove() function fails to synchronize with pending tasklets
before freeing the asd_ha structure, leading to a potential
use-after-free vulnerability.
When a device removal is triggered (via hot-unplug or module unload),
race condition can occur.
The fix adds tasklet_kill() before freeing the asd_ha structure,
ensuring all scheduled tasklets complete before cleanup proceeds.
CVSS Score
7.8
EPSS Score
0.0
Published
2026-01-13
In the Linux kernel, the following vulnerability has been resolved:
driver core: fix potential null-ptr-deref in device_add()
I got the following null-ptr-deref report while doing fault injection test:
BUG: kernel NULL pointer dereference, address: 0000000000000058
CPU: 2 PID: 278 Comm: 37-i2c-ds2482 Tainted: G B W N 6.1.0-rc3+
RIP: 0010:klist_put+0x2d/0xd0
Call Trace:
<TASK>
klist_remove+0xf1/0x1c0
device_release_driver_internal+0x196/0x210
bus_remove_device+0x1bd/0x240
device_add+0xd3d/0x1100
w1_add_master_device+0x476/0x490 [wire]
ds2482_probe+0x303/0x3e0 [ds2482]
This is how it happened:
w1_alloc_dev()
// The dev->driver is set to w1_master_driver.
memcpy(&dev->dev, device, sizeof(struct device));
device_add()
bus_add_device()
dpm_sysfs_add() // It fails, calls bus_remove_device.
// error path
bus_remove_device()
// The dev->driver is not null, but driver is not bound.
__device_release_driver()
klist_remove(&dev->p->knode_driver) <-- It causes null-ptr-deref.
// normal path
bus_probe_device() // It's not called yet.
device_bind_driver()
If dev->driver is set, in the error path after calling bus_add_device()
in device_add(), bus_remove_device() is called, then the device will be
detached from driver. But device_bind_driver() is not called yet, so it
causes null-ptr-deref while access the 'knode_driver'. To fix this, set
dev->driver to null in the error path before calling bus_remove_device().
CVSS Score
5.5
EPSS Score
0.0
Published
2025-12-30
In the Linux kernel, the following vulnerability has been resolved:
ksm: use range-walk function to jump over holes in scan_get_next_rmap_item
Currently, scan_get_next_rmap_item() walks every page address in a VMA to
locate mergeable pages. This becomes highly inefficient when scanning
large virtual memory areas that contain mostly unmapped regions, causing
ksmd to use large amount of cpu without deduplicating much pages.
This patch replaces the per-address lookup with a range walk using
walk_page_range(). The range walker allows KSM to skip over entire
unmapped holes in a VMA, avoiding unnecessary lookups. This problem was
previously discussed in [1].
Consider the following test program which creates a 32 TiB mapping in the
virtual address space but only populates a single page:
#include <unistd.h>
#include <stdio.h>
#include <sys/mman.h>
/* 32 TiB */
const size_t size = 32ul * 1024 * 1024 * 1024 * 1024;
int main() {
char *area = mmap(NULL, size, PROT_READ | PROT_WRITE,
MAP_NORESERVE | MAP_PRIVATE | MAP_ANON, -1, 0);
if (area == MAP_FAILED) {
perror("mmap() failed\n");
return -1;
}
/* Populate a single page such that we get an anon_vma. */
*area = 0;
/* Enable KSM. */
madvise(area, size, MADV_MERGEABLE);
pause();
return 0;
}
$ ./ksm-sparse &
$ echo 1 > /sys/kernel/mm/ksm/run
Without this patch ksmd uses 100% of the cpu for a long time (more then 1
hour in my test machine) scanning all the 32 TiB virtual address space
that contain only one mapped page. This makes ksmd essentially deadlocked
not able to deduplicate anything of value. With this patch ksmd walks
only the one mapped page and skips the rest of the 32 TiB virtual address
space, making the scan fast using little cpu.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-12-16
In the Linux kernel, the following vulnerability has been resolved:
scsi: ses: Fix possible desc_ptr out-of-bounds accesses
Sanitize possible desc_ptr out-of-bounds accesses in
ses_enclosure_data_process().
CVSS Score
7.1
EPSS Score
0.0
Published
2025-10-07
In the Linux kernel, the following vulnerability has been resolved:
ALSA: ac97: Fix possible NULL dereference in snd_ac97_mixer
smatch error:
sound/pci/ac97/ac97_codec.c:2354 snd_ac97_mixer() error:
we previously assumed 'rac97' could be null (see line 2072)
remove redundant assignment, return error if rac97 is NULL.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-10-07
In the Linux kernel, the following vulnerability has been resolved:
fbdev: omapfb: lcd_mipid: Fix an error handling path in mipid_spi_probe()
If 'mipid_detect()' fails, we must free 'md' to avoid a memory leak.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-10-07
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath9k: hif_usb: fix memory leak of remain_skbs
hif_dev->remain_skb is allocated and used exclusively in
ath9k_hif_usb_rx_stream(). It is implied that an allocated remain_skb is
processed and subsequently freed (in error paths) only during the next
call of ath9k_hif_usb_rx_stream().
So, if the urbs are deallocated between those two calls due to the device
deinitialization or suspend, it is possible that ath9k_hif_usb_rx_stream()
is not called next time and the allocated remain_skb is leaked. Our local
Syzkaller instance was able to trigger that.
remain_skb makes sense when receiving two consecutive urbs which are
logically linked together, i.e. a specific data field from the first skb
indicates a cached skb to be allocated, memcpy'd with some data and
subsequently processed in the next call to ath9k_hif_usb_rx_stream(). Urbs
deallocation supposedly makes that link irrelevant so we need to free the
cached skb in those cases.
Fix the leak by introducing a function to explicitly free remain_skb (if
it is not NULL) when the rx urbs have been deallocated. remain_skb is NULL
when it has not been allocated at all (hif_dev struct is kzalloced) or
when it has been processed in next call to ath9k_hif_usb_rx_stream().
Found by Linux Verification Center (linuxtesting.org) with Syzkaller.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-10-07