Linux: >> Linux Kernel >> 6.1.141 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
btrfs: adjust subpage bit start based on sectorsize
When running machines with 64k page size and a 16k nodesize we started
seeing tree log corruption in production. This turned out to be because
we were not writing out dirty blocks sometimes, so this in fact affects
all metadata writes.
When writing out a subpage EB we scan the subpage bitmap for a dirty
range. If the range isn't dirty we do
bit_start++;
to move onto the next bit. The problem is the bitmap is based on the
number of sectors that an EB has. So in this case, we have a 64k
pagesize, 16k nodesize, but a 4k sectorsize. This means our bitmap is 4
bits for every node. With a 64k page size we end up with 4 nodes per
page.
To make this easier this is how everything looks
[0 16k 32k 48k ] logical address
[0 4 8 12 ] radix tree offset
[ 64k page ] folio
[ 16k eb ][ 16k eb ][ 16k eb ][ 16k eb ] extent buffers
[ | | | | | | | | | | | | | | | | ] bitmap
Now we use all of our addressing based on fs_info->sectorsize_bits, so
as you can see the above our 16k eb->start turns into radix entry 4.
When we find a dirty range for our eb, we correctly do bit_start +=
sectors_per_node, because if we start at bit 0, the next bit for the
next eb is 4, to correspond to eb->start 16k.
However if our range is clean, we will do bit_start++, which will now
put us offset from our radix tree entries.
In our case, assume that the first time we check the bitmap the block is
not dirty, we increment bit_start so now it == 1, and then we loop
around and check again. This time it is dirty, and we go to find that
start using the following equation
start = folio_start + bit_start * fs_info->sectorsize;
so in the case above, eb->start 0 is now dirty, and we calculate start
as
0 + 1 * fs_info->sectorsize = 4096
4096 >> 12 = 1
Now we're looking up the radix tree for 1, and we won't find an eb.
What's worse is now we're using bit_start == 1, so we do bit_start +=
sectors_per_node, which is now 5. If that eb is dirty we will run into
the same thing, we will look at an offset that is not populated in the
radix tree, and now we're skipping the writeout of dirty extent buffers.
The best fix for this is to not use sectorsize_bits to address nodes,
but that's a larger change. Since this is a fs corruption problem fix
it simply by always using sectors_per_node to increment the start bit.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-05-20
In the Linux kernel, the following vulnerability has been resolved:
xsk: Fix race condition in AF_XDP generic RX path
Move rx_lock from xsk_socket to xsk_buff_pool.
Fix synchronization for shared umem mode in
generic RX path where multiple sockets share
single xsk_buff_pool.
RX queue is exclusive to xsk_socket, while FILL
queue can be shared between multiple sockets.
This could result in race condition where two
CPU cores access RX path of two different sockets
sharing the same umem.
Protect both queues by acquiring spinlock in shared
xsk_buff_pool.
Lock contention may be minimized in the future by some
per-thread FQ buffering.
It's safe and necessary to move spin_lock_bh(rx_lock)
after xsk_rcv_check():
* xs->pool and spinlock_init is synchronized by
xsk_bind() -> xsk_is_bound() memory barriers.
* xsk_rcv_check() may return true at the moment
of xsk_release() or xsk_unbind_dev(),
however this will not cause any data races or
race conditions. xsk_unbind_dev() removes xdp
socket from all maps and waits for completion
of all outstanding rx operations. Packets in
RX path will either complete safely or drop.
CVSS Score
4.7
EPSS Score
0.0
Published
2025-05-20
In the Linux kernel, the following vulnerability has been resolved:
ksmbd: fix use-after-free in session logoff
The sess->user object can currently be in use by another thread, for
example if another connection has sent a session setup request to
bind to the session being free'd. The handler for that connection could
be in the smb2_sess_setup function which makes use of sess->user.
CVSS Score
7.8
EPSS Score
0.0
Published
2025-05-20
In the Linux kernel, the following vulnerability has been resolved:
perf/core: Fix WARN_ON(!ctx) in __free_event() for partial init
Move the get_ctx(child_ctx) call and the child_event->ctx assignment to
occur immediately after the child event is allocated. Ensure that
child_event->ctx is non-NULL before any subsequent error path within
inherit_event calls free_event(), satisfying the assumptions of the
cleanup code.
Details:
There's no clear Fixes tag, because this bug is a side-effect of
multiple interacting commits over time (up to 15 years old), not
a single regression.
The code initially incremented refcount then assigned context
immediately after the child_event was created. Later, an early
validity check for child_event was added before the
refcount/assignment. Even later, a WARN_ON_ONCE() cleanup check was
added, assuming event->ctx is valid if the pmu_ctx is valid.
The problem is that the WARN_ON_ONCE() could trigger after the initial
check passed but before child_event->ctx was assigned, violating its
precondition. The solution is to assign child_event->ctx right after
its initial validation. This ensures the context exists for any
subsequent checks or cleanup routines, resolving the WARN_ON_ONCE().
To resolve it, defer the refcount update and child_event->ctx assignment
directly after child_event->pmu_ctx is set but before checking if the
parent event is orphaned. The cleanup routine depends on
event->pmu_ctx being non-NULL before it verifies event->ctx is
non-NULL. This also maintains the author's original intent of passing
in child_ctx to find_get_pmu_context before its refcount/assignment.
[ mingo: Expanded the changelog from another email by Gabriel Shahrouzi. ]
CVSS Score
5.5
EPSS Score
0.0
Published
2025-05-09
In the Linux kernel, the following vulnerability has been resolved:
um: work around sched_yield not yielding in time-travel mode
sched_yield by a userspace may not actually cause scheduling in
time-travel mode as no time has passed. In the case seen it appears to
be a badly implemented userspace spinlock in ASAN. Unfortunately, with
time-travel it causes an extreme slowdown or even deadlock depending on
the kernel configuration (CONFIG_UML_MAX_USERSPACE_ITERATIONS).
Work around it by accounting time to the process whenever it executes a
sched_yield syscall.
CVSS Score
5.5
EPSS Score
0.001
Published
2025-05-09
In the Linux kernel, the following vulnerability has been resolved:
usb: xhci: Fix isochronous Ring Underrun/Overrun event handling
The TRB pointer of these events points at enqueue at the time of error
occurrence on xHCI 1.1+ HCs or it's NULL on older ones. By the time we
are handling the event, a new TD may be queued at this ring position.
I can trigger this race by rising interrupt moderation to increase IRQ
handling delay. Similar delay may occur naturally due to system load.
If this ever happens after a Missed Service Error, missed TDs will be
skipped and the new TD processed as if it matched the event. It could
be given back prematurely, risking data loss or buffer UAF by the xHC.
Don't complete TDs on xrun events and don't warn if queued TDs don't
match the event's TRB pointer, which can be NULL or a link/no-op TRB.
Don't warn if there are no queued TDs at all.
Now that it's safe, also handle xrun events if the skip flag is clear.
This ensures completion of any TD stuck in 'error mid TD' state right
before the xrun event, which could happen if a driver submits a finite
number of URBs to a buggy HC and then an error occurs on the last TD.
CVSS Score
7.8
EPSS Score
0.0
Published
2025-05-09
In the Linux kernel, the following vulnerability has been resolved:
iommu: Clear iommu-dma ops on cleanup
If iommu_device_register() encounters an error, it can end up tearing
down already-configured groups and default domains, however this
currently still leaves devices hooked up to iommu-dma (and even
historically the behaviour in this area was at best inconsistent across
architectures/drivers...) Although in the case that an IOMMU is present
whose driver has failed to probe, users cannot necessarily expect DMA to
work anyway, it's still arguable that we should do our best to put
things back as if the IOMMU driver was never there at all, and certainly
the potential for crashing in iommu-dma itself is undesirable. Make sure
we clean up the dev->dma_iommu flag along with everything else.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-05-09
In the Linux kernel, the following vulnerability has been resolved:
scsi: mpi3mr: Synchronous access b/w reset and tm thread for reply queue
When the task management thread processes reply queues while the reset
thread resets them, the task management thread accesses an invalid queue ID
(0xFFFF), set by the reset thread, which points to unallocated memory,
causing a crash.
Add flag 'io_admin_reset_sync' to synchronize access between the reset,
I/O, and admin threads. Before a reset, the reset handler sets this flag to
block I/O and admin processing threads. If any thread bypasses the initial
check, the reset thread waits up to 10 seconds for processing to finish. If
the wait exceeds 10 seconds, the controller is marked as unrecoverable.
CVSS Score
7.8
EPSS Score
0.001
Published
2025-05-09
In the Linux kernel, the following vulnerability has been resolved:
net: dsa: clean up FDB, MDB, VLAN entries on unbind
As explained in many places such as commit b117e1e8a86d ("net: dsa:
delete dsa_legacy_fdb_add and dsa_legacy_fdb_del"), DSA is written given
the assumption that higher layers have balanced additions/deletions.
As such, it only makes sense to be extremely vocal when those
assumptions are violated and the driver unbinds with entries still
present.
But Ido Schimmel points out a very simple situation where that is wrong:
https://lore.kernel.org/netdev/ZDazSM5UsPPjQuKr@shredder/
(also briefly discussed by me in the aforementioned commit).
Basically, while the bridge bypass operations are not something that DSA
explicitly documents, and for the majority of DSA drivers this API
simply causes them to go to promiscuous mode, that isn't the case for
all drivers. Some have the necessary requirements for bridge bypass
operations to do something useful - see dsa_switch_supports_uc_filtering().
Although in tools/testing/selftests/net/forwarding/local_termination.sh,
we made an effort to popularize better mechanisms to manage address
filters on DSA interfaces from user space - namely macvlan for unicast,
and setsockopt(IP_ADD_MEMBERSHIP) - through mtools - for multicast, the
fact is that 'bridge fdb add ... self static local' also exists as
kernel UAPI, and might be useful to someone, even if only for a quick
hack.
It seems counter-productive to block that path by implementing shim
.ndo_fdb_add and .ndo_fdb_del operations which just return -EOPNOTSUPP
in order to prevent the ndo_dflt_fdb_add() and ndo_dflt_fdb_del() from
running, although we could do that.
Accepting that cleanup is necessary seems to be the only option.
Especially since we appear to be coming back at this from a different
angle as well. Russell King is noticing that the WARN_ON() triggers even
for VLANs:
https://lore.kernel.org/netdev/Z_li8Bj8bD4-BYKQ@shell.armlinux.org.uk/
What happens in the bug report above is that dsa_port_do_vlan_del() fails,
then the VLAN entry lingers on, and then we warn on unbind and leak it.
This is not a straight revert of the blamed commit, but we now add an
informational print to the kernel log (to still have a way to see
that bugs exist), and some extra comments gathered from past years'
experience, to justify the logic.
CVSS Score
5.5
EPSS Score
0.001
Published
2025-05-09
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: debugfs hang_hws skip GPU with MES
debugfs hang_hws is used by GPU reset test with HWS, for MES this crash
the kernel with NULL pointer access because dqm->packet_mgr is not setup
for MES path.
Skip GPU with MES for now, MES hang_hws debugfs interface will be
supported later.
CVSS Score
5.5
EPSS Score
0.001
Published
2025-05-09