In the Linux kernel, the following vulnerability has been resolved:
nfsd: don't ignore the return code of svc_proc_register()
Currently, nfsd_proc_stat_init() ignores the return value of
svc_proc_register(). If the procfile creation fails, then the kernel
will WARN when it tries to remove the entry later.
Fix nfsd_proc_stat_init() to return the same type of pointer as
svc_proc_register(), and fix up nfsd_net_init() to check that and fail
the nfsd_net construction if it occurs.
svc_proc_register() can fail if the dentry can't be allocated, or if an
identical dentry already exists. The second case is pretty unlikely in
the nfsd_net construction codepath, so if this happens, return -ENOMEM.
In the Linux kernel, the following vulnerability has been resolved:
media: streamzap: fix race between device disconnection and urb callback
Syzkaller has reported a general protection fault at function
ir_raw_event_store_with_filter(). This crash is caused by a NULL pointer
dereference of dev->raw pointer, even though it is checked for NULL in
the same function, which means there is a race condition. It occurs due
to the incorrect order of actions in the streamzap_disconnect() function:
rc_unregister_device() is called before usb_kill_urb(). The dev->raw
pointer is freed and set to NULL in rc_unregister_device(), and only
after that usb_kill_urb() waits for in-progress requests to finish.
If rc_unregister_device() is called while streamzap_callback() handler is
not finished, this can lead to accessing freed resources. Thus
rc_unregister_device() should be called after usb_kill_urb().
Found by Linux Verification Center (linuxtesting.org) with Syzkaller.
In the Linux kernel, the following vulnerability has been resolved:
jfs: add check read-only before truncation in jfs_truncate_nolock()
Added a check for "read-only" mode in the `jfs_truncate_nolock`
function to avoid errors related to writing to a read-only
filesystem.
Call stack:
block_write_begin() {
jfs_write_failed() {
jfs_truncate() {
jfs_truncate_nolock() {
txEnd() {
...
log = JFS_SBI(tblk->sb)->log;
// (log == NULL)
If the `isReadOnly(ip)` condition is triggered in
`jfs_truncate_nolock`, the function execution will stop, and no
further data modification will occur. Instead, the `xtTruncate`
function will be called with the "COMMIT_WMAP" flag, preventing
modifications in "read-only" mode.
In the Linux kernel, the following vulnerability has been resolved:
jfs: add check read-only before txBeginAnon() call
Added a read-only check before calling `txBeginAnon` in `extAlloc`
and `extRecord`. This prevents modification attempts on a read-only
mounted filesystem, avoiding potential errors or crashes.
Call trace:
txBeginAnon+0xac/0x154
extAlloc+0xe8/0xdec fs/jfs/jfs_extent.c:78
jfs_get_block+0x340/0xb98 fs/jfs/inode.c:248
__block_write_begin_int+0x580/0x166c fs/buffer.c:2128
__block_write_begin fs/buffer.c:2177 [inline]
block_write_begin+0x98/0x11c fs/buffer.c:2236
jfs_write_begin+0x44/0x88 fs/jfs/inode.c:299
In the Linux kernel, the following vulnerability has been resolved:
netfilter: socket: Lookup orig tuple for IPv6 SNAT
nf_sk_lookup_slow_v4 does the conntrack lookup for IPv4 packets to
restore the original 5-tuple in case of SNAT, to be able to find the
right socket (if any). Then socket_match() can correctly check whether
the socket was transparent.
However, the IPv6 counterpart (nf_sk_lookup_slow_v6) lacks this
conntrack lookup, making xt_socket fail to match on the socket when the
packet was SNATed. Add the same logic to nf_sk_lookup_slow_v6.
IPv6 SNAT is used in Kubernetes clusters for pod-to-world packets, as
pods' addresses are in the fd00::/8 ULA subnet and need to be replaced
with the node's external address. Cilium leverages Envoy to enforce L7
policies, and Envoy uses transparent sockets. Cilium inserts an iptables
prerouting rule that matches on `-m socket --transparent` and redirects
the packets to localhost, but it fails to match SNATed IPv6 packets due
to that missing conntrack lookup.
In the Linux kernel, the following vulnerability has been resolved:
usb: xhci: Apply the link chain quirk on NEC isoc endpoints
Two clearly different specimens of NEC uPD720200 (one with start/stop
bug, one without) were seen to cause IOMMU faults after some Missed
Service Errors. Faulting address is immediately after a transfer ring
segment and patched dynamic debug messages revealed that the MSE was
received when waiting for a TD near the end of that segment:
[ 1.041954] xhci_hcd: Miss service interval error for slot 1 ep 2 expected TD DMA ffa08fe0
[ 1.042120] xhci_hcd: AMD-Vi: Event logged [IO_PAGE_FAULT domain=0x0005 address=0xffa09000 flags=0x0000]
[ 1.042146] xhci_hcd: AMD-Vi: Event logged [IO_PAGE_FAULT domain=0x0005 address=0xffa09040 flags=0x0000]
It gets even funnier if the next page is a ring segment accessible to
the HC. Below, it reports MSE in segment at ff1e8000, plows through a
zero-filled page at ff1e9000 and starts reporting events for TRBs in
page at ff1ea000 every microframe, instead of jumping to seg ff1e6000.
[ 7.041671] xhci_hcd: Miss service interval error for slot 1 ep 2 expected TD DMA ff1e8fe0
[ 7.041999] xhci_hcd: Miss service interval error for slot 1 ep 2 expected TD DMA ff1e8fe0
[ 7.042011] xhci_hcd: WARN: buffer overrun event for slot 1 ep 2 on endpoint
[ 7.042028] xhci_hcd: All TDs skipped for slot 1 ep 2. Clear skip flag.
[ 7.042134] xhci_hcd: WARN: buffer overrun event for slot 1 ep 2 on endpoint
[ 7.042138] xhci_hcd: ERROR Transfer event TRB DMA ptr not part of current TD ep_index 2 comp_code 31
[ 7.042144] xhci_hcd: Looking for event-dma 00000000ff1ea040 trb-start 00000000ff1e6820 trb-end 00000000ff1e6820
[ 7.042259] xhci_hcd: WARN: buffer overrun event for slot 1 ep 2 on endpoint
[ 7.042262] xhci_hcd: ERROR Transfer event TRB DMA ptr not part of current TD ep_index 2 comp_code 31
[ 7.042266] xhci_hcd: Looking for event-dma 00000000ff1ea050 trb-start 00000000ff1e6820 trb-end 00000000ff1e6820
At some point completion events change from Isoch Buffer Overrun to
Short Packet and the HC finally finds cycle bit mismatch in ff1ec000.
[ 7.098130] xhci_hcd: ERROR Transfer event TRB DMA ptr not part of current TD ep_index 2 comp_code 13
[ 7.098132] xhci_hcd: Looking for event-dma 00000000ff1ecc50 trb-start 00000000ff1e6820 trb-end 00000000ff1e6820
[ 7.098254] xhci_hcd: ERROR Transfer event TRB DMA ptr not part of current TD ep_index 2 comp_code 13
[ 7.098256] xhci_hcd: Looking for event-dma 00000000ff1ecc60 trb-start 00000000ff1e6820 trb-end 00000000ff1e6820
[ 7.098379] xhci_hcd: Overrun event on slot 1 ep 2
It's possible that data from the isochronous device were written to
random buffers of pending TDs on other endpoints (either IN or OUT),
other devices or even other HCs in the same IOMMU domain.
Lastly, an error from a different USB device on another HC. Was it
caused by the above? I don't know, but it may have been. The disk
was working without any other issues and generated PCIe traffic to
starve the NEC of upstream BW and trigger those MSEs. The two HCs
shared one x1 slot by means of a commercial "PCIe splitter" board.
[ 7.162604] usb 10-2: reset SuperSpeed USB device number 3 using xhci_hcd
[ 7.178990] sd 9:0:0:0: [sdb] tag#0 UNKNOWN(0x2003) Result: hostbyte=0x07 driverbyte=DRIVER_OK cmd_age=0s
[ 7.179001] sd 9:0:0:0: [sdb] tag#0 CDB: opcode=0x28 28 00 04 02 ae 00 00 02 00 00
[ 7.179004] I/O error, dev sdb, sector 67284480 op 0x0:(READ) flags 0x80700 phys_seg 5 prio class 0
Fortunately, it appears that this ridiculous bug is avoided by setting
the chain bit of Link TRBs on isochronous rings. Other ancient HCs are
known which also expect the bit to be set and they ignore Link TRBs if
it's not. Reportedly, 0.95 spec guaranteed that the bit is set.
The bandwidth-starved NEC HC running a 32KB/uframe UVC endpoint reports
tens of MSEs per second and runs into the bug within seconds. Chaining
Link TRBs allows the same workload to run for many minutes, many times.
No ne
---truncated---
In the Linux kernel, the following vulnerability has been resolved:
regulator: check that dummy regulator has been probed before using it
Due to asynchronous driver probing there is a chance that the dummy
regulator hasn't already been probed when first accessing it.
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: Fix error code in chan_alloc_skb_cb()
The chan_alloc_skb_cb() function is supposed to return error pointers on
error. Returning NULL will lead to a NULL dereference.
In the Linux kernel, the following vulnerability has been resolved:
drm/radeon: fix uninitialized size issue in radeon_vce_cs_parse()
On the off chance that command stream passed from userspace via
ioctl() call to radeon_vce_cs_parse() is weirdly crafted and
first command to execute is to encode (case 0x03000001), the function
in question will attempt to call radeon_vce_cs_reloc() with size
argument that has not been properly initialized. Specifically, 'size'
will point to 'tmp' variable before the latter had a chance to be
assigned any value.
Play it safe and init 'tmp' with 0, thus ensuring that
radeon_vce_cs_reloc() will catch an early error in cases like these.
Found by Linux Verification Center (linuxtesting.org) with static
analysis tool SVACE.
(cherry picked from commit 2d52de55f9ee7aaee0e09ac443f77855989c6b68)