Linux: >> Linux Kernel >> 6.18.8 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
xfrm: fix ip_rt_bug race in icmp_route_lookup reverse path
icmp_route_lookup() performs multiple route lookups to find a suitable
route for sending ICMP error messages, with special handling for XFRM
(IPsec) policies.
The lookup sequence is:
1. First, lookup output route for ICMP reply (dst = original src)
2. Pass through xfrm_lookup() for policy check
3. If blocked (-EPERM) or dst is not local, enter "reverse path"
4. In reverse path, call xfrm_decode_session_reverse() to get fl4_dec
which reverses the original packet's flow (saddr<->daddr swapped)
5. If fl4_dec.saddr is local (we are the original destination), use
__ip_route_output_key() for output route lookup
6. If fl4_dec.saddr is NOT local (we are a forwarding node), use
ip_route_input() to simulate the reverse packet's input path
7. Finally, pass rt2 through xfrm_lookup() with XFRM_LOOKUP_ICMP flag
The bug occurs in step 6: ip_route_input() is called with fl4_dec.daddr
(original packet's source) as destination. If this address becomes local
between the initial check and ip_route_input() call (e.g., due to
concurrent "ip addr add"), ip_route_input() returns a LOCAL route with
dst.output set to ip_rt_bug.
This route is then used for ICMP output, causing dst_output() to call
ip_rt_bug(), triggering a WARN_ON:
------------[ cut here ]------------
WARNING: net/ipv4/route.c:1275 at ip_rt_bug+0x21/0x30, CPU#1
Call Trace:
<TASK>
ip_push_pending_frames+0x202/0x240
icmp_push_reply+0x30d/0x430
__icmp_send+0x1149/0x24f0
ip_options_compile+0xa2/0xd0
ip_rcv_finish_core+0x829/0x1950
ip_rcv+0x2d7/0x420
__netif_receive_skb_one_core+0x185/0x1f0
netif_receive_skb+0x90/0x450
tun_get_user+0x3413/0x3fb0
tun_chr_write_iter+0xe4/0x220
...
Fix this by checking rt2->rt_type after ip_route_input(). If it's
RTN_LOCAL, the route cannot be used for output, so treat it as an error.
The reproducer requires kernel modification to widen the race window,
making it unsuitable as a selftest. It is available at:
https://gist.github.com/mrpre/eae853b72ac6a750f5d45d64ddac1e81
CVSS Score
4.7
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
xen-netback: reject zero-queue configuration from guest
A malicious or buggy Xen guest can write "0" to the xenbus key
"multi-queue-num-queues". The connect() function in the backend only
validates the upper bound (requested_num_queues > xenvif_max_queues)
but not zero, allowing requested_num_queues=0 to reach
vzalloc(array_size(0, sizeof(struct xenvif_queue))), which triggers
WARN_ON_ONCE(!size) in __vmalloc_node_range().
On systems with panic_on_warn=1, this allows a guest-to-host denial
of service.
The Xen network interface specification requires
the queue count to be "greater than zero".
Add a zero check to match the validation already present
in xen-blkback, which has included this
guard since its multi-queue support was added.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
net: hns3: fix double free issue for tx spare buffer
In hns3_set_ringparam(), a temporary copy (tmp_rings) of the ring structure
is created for rollback. However, the tx_spare pointer in the original
ring handle is incorrectly left pointing to the old backup memory.
Later, if memory allocation fails in hns3_init_all_ring() during the setup,
the error path attempts to free all newly allocated rings. Since tx_spare
contains a stale (non-NULL) pointer from the backup, it is mistaken for
a newly allocated buffer and is erroneously freed, leading to a double-free
of the backup memory.
The root cause is that the tx_spare field was not cleared after its value
was saved in tmp_rings, leaving a dangling pointer.
Fix this by setting tx_spare to NULL in the original ring structure
when the creation of the new `tx_spare` fails. This ensures the
error cleanup path only frees genuinely newly allocated buffers.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
apparmor: Fix & Optimize table creation from possibly unaligned memory
Source blob may come from userspace and might be unaligned.
Try to optize the copying process by avoiding unaligned memory accesses.
- Added Fixes tag
- Added "Fix &" to description as this doesn't just optimize but fixes
a potential unaligned memory access
[jj: remove duplicate word "convert" in comment trigger checkpatch warning]
CVSS Score
7.1
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
iommu/vt-d: Clear Present bit before tearing down PASID entry
The Intel VT-d Scalable Mode PASID table entry consists of 512 bits (64
bytes). When tearing down an entry, the current implementation zeros the
entire 64-byte structure immediately using multiple 64-bit writes.
Since the IOMMU hardware may fetch these 64 bytes using multiple
internal transactions (e.g., four 128-bit bursts), updating or zeroing
the entire entry while it is active (P=1) risks a "torn" read. If a
hardware fetch occurs simultaneously with the CPU zeroing the entry, the
hardware could observe an inconsistent state, leading to unpredictable
behavior or spurious faults.
Follow the "Guidance to Software for Invalidations" in the VT-d spec
(Section 6.5.3.3) by implementing the recommended ownership handshake:
1. Clear only the 'Present' (P) bit of the PASID entry.
2. Use a dma_wmb() to ensure the cleared bit is visible to hardware
before proceeding.
3. Execute the required invalidation sequence (PASID cache, IOTLB, and
Device-TLB flush) to ensure the hardware has released all cached
references.
4. Only after the flushes are complete, zero out the remaining fields
of the PASID entry.
Also, add a dma_wmb() in pasid_set_present() to ensure that all other
fields of the PASID entry are visible to the hardware before the Present
bit is set.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
quota: fix livelock between quotactl and freeze_super
When a filesystem is frozen, quotactl_block() enters a retry loop
waiting for the filesystem to thaw. It acquires s_umount, checks the
freeze state, drops s_umount and uses sb_start_write() - sb_end_write()
pair to wait for the unfreeze.
However, this retry loop can trigger a livelock issue, specifically on
kernels with preemption disabled.
The mechanism is as follows:
1. freeze_super() sets SB_FREEZE_WRITE and calls sb_wait_write().
2. sb_wait_write() calls percpu_down_write(), which initiates
synchronize_rcu().
3. Simultaneously, quotactl_block() spins in its retry loop, immediately
executing the sb_start_write() - sb_end_write() pair.
4. Because the kernel is non-preemptible and the loop contains no
scheduling points, quotactl_block() never yields the CPU. This
prevents that CPU from reaching an RCU quiescent state.
5. synchronize_rcu() in the freezer thread waits indefinitely for the
quotactl_block() CPU to report a quiescent state.
6. quotactl_block() spins indefinitely waiting for the freezer to
advance, which it cannot do as it is blocked on the RCU sync.
This results in a hang of the freezer process and 100% CPU usage by the
quota process.
While this can occur intermittently on multi-core systems, it is
reliably reproducing on a node with the following script, running both
the freezer and the quota toggle on the same CPU:
# mkfs.ext4 -O quota /dev/sda 2g && mkdir a_mount
# mount /dev/sda -o quota,usrquota,grpquota a_mount
# taskset -c 3 bash -c "while true; do xfs_freeze -f a_mount; \
xfs_freeze -u a_mount; done" &
# taskset -c 3 bash -c "while true; do quotaon a_mount; \
quotaoff a_mount; done" &
Adding cond_resched() to the retry loop fixes the issue. It acts as an
RCU quiescent state, allowing synchronize_rcu() in percpu_down_write()
to complete.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
mtd: intel-dg: Fix accessing regions before setting nregions
The regions array is counted by nregions, but it's set only after
accessing it:
[] UBSAN: array-index-out-of-bounds in drivers/mtd/devices/mtd_intel_dg.c:750:15
[] index 0 is out of range for type '<unknown> [*]'
Fix it by also fixing an undesired behavior: the loop silently ignores
ENOMEM and continues setting the other entries.
CVSS Score
7.8
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_counter: serialize reset with spinlock
Add a global static spinlock to serialize counter fetch+reset
operations, preventing concurrent dump-and-reset from underrunning
values.
The lock is taken before fetching the total so that two parallel
resets cannot both read the same counter values and then both
subtract them.
A global lock is used for simplicity since resets are infrequent.
If this becomes a bottleneck, it can be replaced with a per-net
lock later.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
power: supply: pm8916_bms_vm: Fix use-after-free in power_supply_changed()
Using the `devm_` variant for requesting IRQ _before_ the `devm_`
variant for allocating/registering the `power_supply` handle, means that
the `power_supply` handle will be deallocated/unregistered _before_ the
interrupt handler (since `devm_` naturally deallocates in reverse
allocation order). This means that during removal, there is a race
condition where an interrupt can fire just _after_ the `power_supply`
handle has been freed, *but* just _before_ the corresponding
unregistration of the IRQ handler has run.
This will lead to the IRQ handler calling `power_supply_changed()` with
a freed `power_supply` handle. Which usually crashes the system or
otherwise silently corrupts the memory...
Note that there is a similar situation which can also happen during
`probe()`; the possibility of an interrupt firing _before_ registering
the `power_supply` handle. This would then lead to the nasty situation
of using the `power_supply` handle *uninitialized* in
`power_supply_changed()`.
Fix this racy use-after-free by making sure the IRQ is requested _after_
the registration of the `power_supply` handle.
CVSS Score
7.8
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
iio: sca3000: Fix a resource leak in sca3000_probe()
spi->irq from request_threaded_irq() not released when
iio_device_register() fails. Add an return value check and jump to a
common error handler when iio_device_register() fails.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27