In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: don't warn when if there is a FW error
iwl_trans_reclaim is warning if it is called when the FW is not alive.
But if it is called when there is a pending restart, i.e. after a FW
error, there is no need to warn, instead - return silently.
In the Linux kernel, the following vulnerability has been resolved:
net: cadence: macb: Fix a possible deadlock in macb_halt_tx.
There is a situation where after THALT is set high, TGO stays high as
well. Because jiffies are never updated, as we are in a context with
interrupts disabled, we never exit that loop and have a deadlock.
That deadlock was noticed on a sama5d4 device that stayed locked for days.
Use retries instead of jiffies so that the timeout really works and we do
not have a deadlock anymore.
In the Linux kernel, the following vulnerability has been resolved:
drivers/rapidio/rio_cm.c: prevent possible heap overwrite
In
riocm_cdev_ioctl(RIO_CM_CHAN_SEND)
-> cm_chan_msg_send()
-> riocm_ch_send()
cm_chan_msg_send() checks that userspace didn't send too much data but
riocm_ch_send() failed to check that userspace sent sufficient data. The
result is that riocm_ch_send() can write to fields in the rio_ch_chan_hdr
which were outside the bounds of the space which cm_chan_msg_send()
allocated.
Address this by teaching riocm_ch_send() to check that the entire
rio_ch_chan_hdr was copied in from userspace.
In the Linux kernel, the following vulnerability has been resolved:
mm/hugetlb: fix huge_pmd_unshare() vs GUP-fast race
huge_pmd_unshare() drops a reference on a page table that may have
previously been shared across processes, potentially turning it into a
normal page table used in another process in which unrelated VMAs can
afterwards be installed.
If this happens in the middle of a concurrent gup_fast(), gup_fast() could
end up walking the page tables of another process. While I don't see any
way in which that immediately leads to kernel memory corruption, it is
really weird and unexpected.
Fix it with an explicit broadcast IPI through tlb_remove_table_sync_one(),
just like we do in khugepaged when removing page tables for a THP
collapse.
In the Linux kernel, the following vulnerability has been resolved:
net: ch9200: fix uninitialised access during mii_nway_restart
In mii_nway_restart() the code attempts to call
mii->mdio_read which is ch9200_mdio_read(). ch9200_mdio_read()
utilises a local buffer called "buff", which is initialised
with control_read(). However "buff" is conditionally
initialised inside control_read():
if (err == size) {
memcpy(data, buf, size);
}
If the condition of "err == size" is not met, then
"buff" remains uninitialised. Once this happens the
uninitialised "buff" is accessed and returned during
ch9200_mdio_read():
return (buff[0] | buff[1] << 8);
The problem stems from the fact that ch9200_mdio_read()
ignores the return value of control_read(), leading to
uinit-access of "buff".
To fix this we should check the return value of
control_read() and return early on error.
In the Linux kernel, the following vulnerability has been resolved:
mm/hugetlb: unshare page tables during VMA split, not before
Currently, __split_vma() triggers hugetlb page table unsharing through
vm_ops->may_split(). This happens before the VMA lock and rmap locks are
taken - which is too early, it allows racing VMA-locked page faults in our
process and racing rmap walks from other processes to cause page tables to
be shared again before we actually perform the split.
Fix it by explicitly calling into the hugetlb unshare logic from
__split_vma() in the same place where THP splitting also happens. At that
point, both the VMA and the rmap(s) are write-locked.
An annoying detail is that we can now call into the helper
hugetlb_unshare_pmds() from two different locking contexts:
1. from hugetlb_split(), holding:
- mmap lock (exclusively)
- VMA lock
- file rmap lock (exclusively)
2. hugetlb_unshare_all_pmds(), which I think is designed to be able to
call us with only the mmap lock held (in shared mode), but currently
only runs while holding mmap lock (exclusively) and VMA lock
Backporting note:
This commit fixes a racy protection that was introduced in commit
b30c14cd6102 ("hugetlb: unshare some PMDs when splitting VMAs"); that
commit claimed to fix an issue introduced in 5.13, but it should actually
also go all the way back.
[jannh@google.com: v2]
In the Linux kernel, the following vulnerability has been resolved:
ALSA: bcd2000: Fix a UAF bug on the error path of probing
When the driver fails in snd_card_register() at probe time, it will free
the 'bcd2k->midi_out_urb' before killing it, which may cause a UAF bug.
The following log can reveal it:
[ 50.727020] BUG: KASAN: use-after-free in bcd2000_input_complete+0x1f1/0x2e0 [snd_bcd2000]
[ 50.727623] Read of size 8 at addr ffff88810fab0e88 by task swapper/4/0
[ 50.729530] Call Trace:
[ 50.732899] bcd2000_input_complete+0x1f1/0x2e0 [snd_bcd2000]
Fix this by adding usb_kill_urb() before usb_free_urb().
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_tables: do not allow SET_ID to refer to another table
When doing lookups for sets on the same batch by using its ID, a set from a
different table can be used.
Then, when the table is removed, a reference to the set may be kept after
the set is freed, leading to a potential use-after-free.
When looking for sets by ID, use the table that was used for the lookup by
name, and only return sets belonging to that same table.
This fixes CVE-2022-2586, also reported as ZDI-CAN-17470.
In the Linux kernel, the following vulnerability has been resolved:
scsi: sg: Allow waiting for commands to complete on removed device
When a SCSI device is removed while in active use, currently sg will
immediately return -ENODEV on any attempt to wait for active commands that
were sent before the removal. This is problematic for commands that use
SG_FLAG_DIRECT_IO since the data buffer may still be in use by the kernel
when userspace frees or reuses it after getting ENODEV, leading to
corrupted userspace memory (in the case of READ-type commands) or corrupted
data being sent to the device (in the case of WRITE-type commands). This
has been seen in practice when logging out of a iscsi_tcp session, where
the iSCSI driver may still be processing commands after the device has been
marked for removal.
Change the policy to allow userspace to wait for active sg commands even
when the device is being removed. Return -ENODEV only when there are no
more responses to read.