In the Linux kernel, the following vulnerability has been resolved:
iommu/vt-d: Clear Present bit before tearing down context entry
When tearing down a context entry, the current implementation zeros the
entire 128-bit entry using multiple 64-bit writes. This creates a window
where the hardware can fetch a "torn" entry — where some fields are
already zeroed while the 'Present' bit is still set — leading to
unpredictable behavior or spurious faults.
While x86 provides strong write ordering, the compiler may reorder writes
to the two 64-bit halves of the context entry. Even without compiler
reordering, the hardware fetch is not guaranteed to be atomic with
respect to multiple CPU writes.
Align with the "Guidance to Software for Invalidations" in the VT-d spec
(Section 6.5.3.3) by implementing the recommended ownership handshake:
1. Clear only the 'Present' (P) bit of the context entry first to
signal the transition of ownership from hardware to software.
2. Use dma_wmb() to ensure the cleared bit is visible to the IOMMU.
3. Perform the required cache and context-cache invalidation to ensure
hardware no longer has cached references to the entry.
4. Fully zero out the entry only after the invalidation is complete.
Also, add a dma_wmb() to context_set_present() to ensure the entry
is fully initialized before the 'Present' bit becomes visible.
In the Linux kernel, the following vulnerability has been resolved:
net: usb: catc: enable basic endpoint checking
catc_probe() fills three URBs with hardcoded endpoint pipes without
verifying the endpoint descriptors:
- usb_sndbulkpipe(usbdev, 1) and usb_rcvbulkpipe(usbdev, 1) for TX/RX
- usb_rcvintpipe(usbdev, 2) for interrupt status
A malformed USB device can present these endpoints with transfer types
that differ from what the driver assumes.
Add a catc_usb_ep enum for endpoint numbers, replacing magic constants
throughout. Add usb_check_bulk_endpoints() and usb_check_int_endpoints()
calls after usb_set_interface() to verify endpoint types before use,
rejecting devices with mismatched descriptors at probe time.
Similar to
- commit 90b7f2961798 ("net: usb: rtl8150: enable basic endpoint checking")
which fixed the issue in rtl8150.
In the Linux kernel, the following vulnerability has been resolved:
fat: avoid parent link count underflow in rmdir
Corrupted FAT images can leave a directory inode with an incorrect
i_nlink (e.g. 2 even though subdirectories exist). rmdir then
unconditionally calls drop_nlink(dir) and can drive i_nlink to 0,
triggering the WARN_ON in drop_nlink().
Add a sanity check in vfat_rmdir() and msdos_rmdir(): only drop the
parent link count when it is at least 3, otherwise report a filesystem
error.
In the Linux kernel, the following vulnerability has been resolved:
ipvs: do not keep dest_dst if dev is going down
There is race between the netdev notifier ip_vs_dst_event()
and the code that caches dst with dev that is going down.
As the FIB can be notified for the closed device after our
handler finishes, it is possible valid route to be returned
and cached resuling in a leaked dev reference until the dest
is not removed.
To prevent new dest_dst to be attached to dest just after the
handler dropped the old one, add a netif_running() check
to make sure the notifier handler is not currently running
for device that is closing.
In the Linux kernel, the following vulnerability has been resolved:
ext4: fix dirtyclusters double decrement on fs shutdown
fstests test generic/388 occasionally reproduces a warning in
ext4_put_super() associated with the dirty clusters count:
WARNING: CPU: 7 PID: 76064 at fs/ext4/super.c:1324 ext4_put_super+0x48c/0x590 [ext4]
Tracing the failure shows that the warning fires due to an
s_dirtyclusters_counter value of -1. IOW, this appears to be a
spurious decrement as opposed to some sort of leak. Further tracing
of the dirty cluster count deltas and an LLM scan of the resulting
output identified the cause as a double decrement in the error path
between ext4_mb_mark_diskspace_used() and the caller
ext4_mb_new_blocks().
First, note that generic/388 is a shutdown vs. fsstress test and so
produces a random set of operations and shutdown injections. In the
problematic case, the shutdown triggers an error return from the
ext4_handle_dirty_metadata() call(s) made from
ext4_mb_mark_context(). The changed value is non-zero at this point,
so ext4_mb_mark_diskspace_used() does not exit after the error
bubbles up from ext4_mb_mark_context(). Instead, the former
decrements both cluster counters and returns the error up to
ext4_mb_new_blocks(). The latter falls into the !ar->len out path
which decrements the dirty clusters counter a second time, creating
the inconsistency.
To avoid this problem and simplify ownership of the cluster
reservation in this codepath, lift the counter reduction to a single
place in the caller. This makes it more clear that
ext4_mb_new_blocks() is responsible for acquiring cluster
reservation (via ext4_claim_free_clusters()) in the !delalloc case
as well as releasing it, regardless of whether it ends up consumed
or returned due to failure.
In the Linux kernel, the following vulnerability has been resolved:
xfrm: fix ip_rt_bug race in icmp_route_lookup reverse path
icmp_route_lookup() performs multiple route lookups to find a suitable
route for sending ICMP error messages, with special handling for XFRM
(IPsec) policies.
The lookup sequence is:
1. First, lookup output route for ICMP reply (dst = original src)
2. Pass through xfrm_lookup() for policy check
3. If blocked (-EPERM) or dst is not local, enter "reverse path"
4. In reverse path, call xfrm_decode_session_reverse() to get fl4_dec
which reverses the original packet's flow (saddr<->daddr swapped)
5. If fl4_dec.saddr is local (we are the original destination), use
__ip_route_output_key() for output route lookup
6. If fl4_dec.saddr is NOT local (we are a forwarding node), use
ip_route_input() to simulate the reverse packet's input path
7. Finally, pass rt2 through xfrm_lookup() with XFRM_LOOKUP_ICMP flag
The bug occurs in step 6: ip_route_input() is called with fl4_dec.daddr
(original packet's source) as destination. If this address becomes local
between the initial check and ip_route_input() call (e.g., due to
concurrent "ip addr add"), ip_route_input() returns a LOCAL route with
dst.output set to ip_rt_bug.
This route is then used for ICMP output, causing dst_output() to call
ip_rt_bug(), triggering a WARN_ON:
------------[ cut here ]------------
WARNING: net/ipv4/route.c:1275 at ip_rt_bug+0x21/0x30, CPU#1
Call Trace:
<TASK>
ip_push_pending_frames+0x202/0x240
icmp_push_reply+0x30d/0x430
__icmp_send+0x1149/0x24f0
ip_options_compile+0xa2/0xd0
ip_rcv_finish_core+0x829/0x1950
ip_rcv+0x2d7/0x420
__netif_receive_skb_one_core+0x185/0x1f0
netif_receive_skb+0x90/0x450
tun_get_user+0x3413/0x3fb0
tun_chr_write_iter+0xe4/0x220
...
Fix this by checking rt2->rt_type after ip_route_input(). If it's
RTN_LOCAL, the route cannot be used for output, so treat it as an error.
The reproducer requires kernel modification to widen the race window,
making it unsuitable as a selftest. It is available at:
https://gist.github.com/mrpre/eae853b72ac6a750f5d45d64ddac1e81
In the Linux kernel, the following vulnerability has been resolved:
power: supply: wm97xx: Fix NULL pointer dereference in power_supply_changed()
In `probe()`, `request_irq()` is called before allocating/registering a
`power_supply` handle. If an interrupt is fired between the call to
`request_irq()` and `power_supply_register()`, the `power_supply` handle
will be used uninitialized in `power_supply_changed()` in
`wm97xx_bat_update()` (triggered from the interrupt handler). This will
lead to a `NULL` pointer dereference since
Fix this racy `NULL` pointer dereference by making sure the IRQ is
requested _after_ the registration of the `power_supply` handle. Since
the IRQ is the last thing requests in the `probe()` now, remove the
error path for freeing it. Instead add one for unregistering the
`power_supply` handle when IRQ request fails.
In the Linux kernel, the following vulnerability has been resolved:
ipvs: skip ipv6 extension headers for csum checks
Protocol checksum validation fails for IPv6 if there are extension
headers before the protocol header. iph->len already contains its
offset, so use it to fix the problem.
In the Linux kernel, the following vulnerability has been resolved:
smack: /smack/doi: accept previously used values
Writing to /smack/doi a value that has ever been
written there in the past disables networking for
non-ambient labels.
E.g.
# cat /smack/doi
3
# netlabelctl -p cipso list
Configured CIPSO mappings (1)
DOI value : 3
mapping type : PASS_THROUGH
# netlabelctl -p map list
Configured NetLabel domain mappings (3)
domain: "_" (IPv4)
protocol: UNLABELED
domain: DEFAULT (IPv4)
protocol: CIPSO, DOI = 3
domain: DEFAULT (IPv6)
protocol: UNLABELED
# cat /smack/ambient
_
# cat /proc/$$/attr/smack/current
_
# ping -c1 10.1.95.12
64 bytes from 10.1.95.12: icmp_seq=1 ttl=64 time=0.964 ms
# echo foo >/proc/$$/attr/smack/current
# ping -c1 10.1.95.12
64 bytes from 10.1.95.12: icmp_seq=1 ttl=64 time=0.956 ms
unknown option 86
# echo 4 >/smack/doi
# echo 3 >/smack/doi
!> [ 214.050395] smk_cipso_doi:691 cipso add rc = -17
# echo 3 >/smack/doi
!> [ 249.402261] smk_cipso_doi:678 remove rc = -2
!> [ 249.402261] smk_cipso_doi:691 cipso add rc = -17
# ping -c1 10.1.95.12
!!> ping: 10.1.95.12: Address family for hostname not supported
# echo _ >/proc/$$/attr/smack/current
# ping -c1 10.1.95.12
64 bytes from 10.1.95.12: icmp_seq=1 ttl=64 time=0.617 ms
This happens because Smack keeps decommissioned DOIs,
fails to re-add them, and consequently refuses to add
the “default” domain map:
# netlabelctl -p cipso list
Configured CIPSO mappings (2)
DOI value : 3
mapping type : PASS_THROUGH
DOI value : 4
mapping type : PASS_THROUGH
# netlabelctl -p map list
Configured NetLabel domain mappings (2)
domain: "_" (IPv4)
protocol: UNLABELED
!> (no ipv4 map for default domain here)
domain: DEFAULT (IPv6)
protocol: UNLABELED
Fix by clearing decommissioned DOI definitions and
serializing concurrent DOI updates with a new lock.
Also:
- allow /smack/doi to live unconfigured, since
adding a map (netlbl_cfg_cipsov4_map_add) may fail.
CIPSO_V4_DOI_UNKNOWN(0) indicates the unconfigured DOI
- add new DOI before removing the old default map,
so the old map remains if the add fails
(2008-02-04, Casey Schaufler)
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nfnetlink_osf: fix divide-by-zero in OSF_WSS_MODULO
nf_osf_match_one() computes ctx->window % f->wss.val in the
OSF_WSS_MODULO branch with no guard for f->wss.val == 0. A
CAP_NET_ADMIN user can add such a fingerprint via nfnetlink; a
subsequent matching TCP SYN divides by zero and panics the kernel.
Reject the bogus fingerprint in nfnl_osf_add_callback() above the
per-option for-loop. f->wss is per-fingerprint, not per-option, so
the check must run regardless of f->opt_num (including 0). Also
reject wss.wc >= OSF_WSS_MAX; nf_osf_match_one() already treats that
as "should not happen".
Crash:
Oops: divide error: 0000 [#1] SMP KASAN NOPTI
RIP: 0010:nf_osf_match_one (net/netfilter/nfnetlink_osf.c:98)
Call Trace:
<IRQ>
nf_osf_match (net/netfilter/nfnetlink_osf.c:220)
xt_osf_match_packet (net/netfilter/xt_osf.c:32)
ipt_do_table (net/ipv4/netfilter/ip_tables.c:348)
nf_hook_slow (net/netfilter/core.c:622)
ip_local_deliver (net/ipv4/ip_input.c:265)
ip_rcv (include/linux/skbuff.h:1162)
__netif_receive_skb_one_core (net/core/dev.c:6181)
process_backlog (net/core/dev.c:6642)
__napi_poll (net/core/dev.c:7710)
net_rx_action (net/core/dev.c:7945)
handle_softirqs (kernel/softirq.c:622)