In the Linux kernel, the following vulnerability has been resolved:
ip6_tunnel: clear skb2->cb[] in ip4ip6_err()
Oskar Kjos reported the following problem.
ip4ip6_err() calls icmp_send() on a cloned skb whose cb[] was written
by the IPv6 receive path as struct inet6_skb_parm. icmp_send() passes
IPCB(skb2) to __ip_options_echo(), which interprets that cb[] region
as struct inet_skb_parm (IPv4). The layouts differ: inet6_skb_parm.nhoff
at offset 14 overlaps inet_skb_parm.opt.rr, producing a non-zero rr
value. __ip_options_echo() then reads optlen from attacker-controlled
packet data at sptr[rr+1] and copies that many bytes into dopt->__data,
a fixed 40-byte stack buffer (IP_OPTIONS_DATA_FIXED_SIZE).
To fix this we clear skb2->cb[], as suggested by Oskar Kjos.
Also add minimal IPv4 header validation (version == 4, ihl >= 5).
In the Linux kernel, the following vulnerability has been resolved:
net/x25: Fix potential double free of skb
When alloc_skb fails in x25_queue_rx_frame it calls kfree_skb(skb) at
line 48 and returns 1 (error).
This error propagates back through the call chain:
x25_queue_rx_frame returns 1
|
v
x25_state3_machine receives the return value 1 and takes the else
branch at line 278, setting queued=0 and returning 0
|
v
x25_process_rx_frame returns queued=0
|
v
x25_backlog_rcv at line 452 sees queued=0 and calls kfree_skb(skb)
again
This would free the same skb twice. Looking at x25_backlog_rcv:
net/x25/x25_in.c:x25_backlog_rcv() {
...
queued = x25_process_rx_frame(sk, skb);
...
if (!queued)
kfree_skb(skb);
}
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: u_ether: Fix race between gether_disconnect and eth_stop
A race condition between gether_disconnect() and eth_stop() leads to a
NULL pointer dereference. Specifically, if eth_stop() is triggered
concurrently while gether_disconnect() is tearing down the endpoints,
eth_stop() attempts to access the cleared endpoint descriptor, causing
the following NPE:
Unable to handle kernel NULL pointer dereference
Call trace:
__dwc3_gadget_ep_enable+0x60/0x788
dwc3_gadget_ep_enable+0x70/0xe4
usb_ep_enable+0x60/0x15c
eth_stop+0xb8/0x108
Because eth_stop() crashes while holding the dev->lock, the thread
running gether_disconnect() fails to acquire the same lock and spins
forever, resulting in a hardlockup:
Core - Debugging Information for Hardlockup core(7)
Call trace:
queued_spin_lock_slowpath+0x94/0x488
_raw_spin_lock+0x64/0x6c
gether_disconnect+0x19c/0x1e8
ncm_set_alt+0x68/0x1a0
composite_setup+0x6a0/0xc50
The root cause is that the clearing of dev->port_usb in
gether_disconnect() is delayed until the end of the function.
Move the clearing of dev->port_usb to the very beginning of
gether_disconnect() while holding dev->lock. This cuts off the link
immediately, ensuring eth_stop() will see dev->port_usb as NULL and
safely bail out.
In the Linux kernel, the following vulnerability has been resolved:
gpio: omap: do not register driver in probe()
Commit 11a78b794496 ("ARM: OMAP: MPUIO wake updates") registers the
omap_mpuio_driver from omap_mpuio_init(), which is called from
omap_gpio_probe().
However, it neither makes sense to register drivers from probe()
callbacks of other drivers, nor does the driver core allow registering
drivers with a device lock already being held.
The latter was revealed by commit dc23806a7c47 ("driver core: enforce
device_lock for driver_match_device()") leading to a potential deadlock
condition described in [1].
Additionally, the omap_mpuio_driver is never unregistered from the
driver core, even if the module is unloaded.
Hence, register the omap_mpuio_driver from the module initcall and
unregister it in module_exit().
In the Linux kernel, the following vulnerability has been resolved:
netfilter: ip6t_eui64: reject invalid MAC header for all packets
`eui64_mt6()` derives a modified EUI-64 from the Ethernet source address
and compares it with the low 64 bits of the IPv6 source address.
The existing guard only rejects an invalid MAC header when
`par->fragoff != 0`. For packets with `par->fragoff == 0`, `eui64_mt6()`
can still reach `eth_hdr(skb)` even when the MAC header is not valid.
Fix this by removing the `par->fragoff != 0` condition so that packets
with an invalid MAC header are rejected before accessing `eth_hdr(skb)`.
In the Linux kernel, the following vulnerability has been resolved:
net/sched: sch_netem: fix out-of-bounds access in packet corruption
In netem_enqueue(), the packet corruption logic uses
get_random_u32_below(skb_headlen(skb)) to select an index for
modifying skb->data. When an AF_PACKET TX_RING sends fully non-linear
packets over an IPIP tunnel, skb_headlen(skb) evaluates to 0.
Passing 0 to get_random_u32_below() takes the variable-ceil slow path
which returns an unconstrained 32-bit random integer. Using this
unconstrained value as an offset into skb->data results in an
out-of-bounds memory access.
Fix this by verifying skb_headlen(skb) is non-zero before attempting
to corrupt the linear data area. Fully non-linear packets will silently
bypass the corruption logic.
In the Linux kernel, the following vulnerability has been resolved:
rxrpc: only handle RESPONSE during service challenge
Only process RESPONSE packets while the service connection is still in
RXRPC_CONN_SERVICE_CHALLENGING. Check that state under state_lock before
running response verification and security initialization, then use a local
secured flag to decide whether to queue the secured-connection work after
the state transition. This keeps duplicate or late RESPONSE packets from
re-running the setup path and removes the unlocked post-transition state
test.
In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_multiport: validate range encoding in checkentry
ports_match_v1() treats any non-zero pflags entry as the start of a
port range and unconditionally consumes the next ports[] element as
the range end.
The checkentry path currently validates protocol, flags and count, but
it does not validate the range encoding itself. As a result, malformed
rules can mark the last slot as a range start or place two range starts
back to back, leaving ports_match_v1() to step past the last valid
ports[] element while interpreting the rule.
Reject malformed multiport v1 rules in checkentry by validating that
each range start has a following element and that the following element
is not itself marked as another range start.
In the Linux kernel, the following vulnerability has been resolved:
netfilter: ip6t_rt: reject oversized addrnr in rt_mt6_check()
Reject rt match rules whose addrnr exceeds IP6T_RT_HOPS.
rt_mt6() expects addrnr to stay within the bounds of rtinfo->addrs[].
Validate addrnr during rule installation so malformed rules are rejected
before the match logic can use an out-of-range value.
In the Linux kernel, the following vulnerability has been resolved:
xfrm: clear trailing padding in build_polexpire()
build_expire() clears the trailing padding bytes of struct
xfrm_user_expire after setting the hard field via memset_after(),
but the analogous function build_polexpire() does not do this for
struct xfrm_user_polexpire.
The padding bytes after the __u8 hard field are left
uninitialized from the heap allocation, and are then sent to
userspace via netlink multicast to XFRMNLGRP_EXPIRE listeners,
leaking kernel heap memory contents.
Add the missing memset_after() call, matching build_expire().