Linux: >> Linux Kernel >> 5.15.125 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
fbcon: check return value of con2fb_acquire_newinfo()
If fbcon_open() fails when called from con2fb_acquire_newinfo() then
info->fbcon_par pointer remains NULL which is later dereferenced.
Add check for return value of the function con2fb_acquire_newinfo() to
avoid it.
Found by Linux Verification Center (linuxtesting.org) with SVACE.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
pstore: ram_core: fix incorrect success return when vmap() fails
In persistent_ram_vmap(), vmap() may return NULL on failure.
If offset is non-zero, adding offset_in_page(start) causes the function
to return a non-NULL pointer even though the mapping failed.
persistent_ram_buffer_map() therefore incorrectly returns success.
Subsequent access to prz->buffer may dereference an invalid address
and cause crashes.
Add proper NULL checking for vmap() failures.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
dlm: validate length in dlm_search_rsb_tree
The len parameter in dlm_dump_rsb_name() is not validated and comes
from network messages. When it exceeds DLM_RESNAME_MAXLEN, it can
cause out-of-bounds write in dlm_search_rsb_tree().
Add length validation to prevent potential buffer overflow.
CVSS Score
9.8
EPSS Score
0.004
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
ALSA: mixer: oss: Add card disconnect checkpoints
ALSA OSS mixer layer calls the kcontrol ops rather individually, and
pending calls might be not always caught at disconnecting the device.
For avoiding the potential UAF scenarios, add sanity checks of the
card disconnection at each entry point of OSS mixer accesses. The
rwsem is taken just before that check, hence the rest context should
be covered by that properly.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: handle attr_set_size() errors when truncating files
If attr_set_size() fails while truncating down, the error is silently
ignored and the inode may be left in an inconsistent state.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
jfs: nlink overflow in jfs_rename
If nlink is maximal for a directory (-1) and inside that directory you
perform a rename for some child directory (not moving from the parent),
then the nlink of the first directory is first incremented and later
decremented. Normally this is fine, but when nlink = -1 this causes a
wrap around to 0, and then drop_nlink issues a warning.
After applying the patch syzbot no longer issues any warnings. I also
ran some basic fs tests to look for any regressions.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
most: core: fix resource leak in most_register_interface error paths
The function most_register_interface() did not correctly release resources
if it failed early (before registering the device). In these cases, it
returned an error code immediately, leaking the memory allocated for the
interface.
Fix this by initializing the device early via device_initialize() and
calling put_device() on all error paths.
The most_register_interface() is expected to call put_device() on
error which frees the resources allocated in the caller. The
put_device() either calls release_mdev() or dim2_release(),
depending on the caller.
Switch to using device_add() instead of device_register() to handle
the split initialization.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
wifi: rtw88: Use devm_kmemdup() in rtw_set_supported_band()
Simplify the code by using device managed memory allocations.
This also fixes a memory leak in rtw_register_hw(). The supported bands
were not freed in the error path.
Copied from commit 145df52a8671 ("wifi: rtw89: Convert
rtw89_core_set_supported_band to use devm_*").
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
rpmsg: core: fix race in driver_override_show() and use core helper
The driver_override_show function reads the driver_override string
without holding the device_lock. However, the store function modifies
and frees the string while holding the device_lock. This creates a race
condition where the string can be freed by the store function while
being read by the show function, leading to a use-after-free.
To fix this, replace the rpmsg_string_attr macro with explicit show and
store functions. The new driver_override_store uses the standard
driver_set_override helper. Since the introduction of
driver_set_override, the comments in include/linux/rpmsg.h have stated
that this helper must be used to set or clear driver_override, but the
implementation was not updated until now.
Because driver_set_override modifies and frees the string while holding
the device_lock, the new driver_override_show now correctly holds the
device_lock during the read operation to prevent the race.
Additionally, since rpmsg_string_attr has only ever been used for
driver_override, removing the macro simplifies the code.
CVSS Score
4.7
EPSS Score
0.001
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
net: qrtr: Drop the MHI auto_queue feature for IPCR DL channels
MHI stack offers the 'auto_queue' feature, which allows the MHI stack to
auto queue the buffers for the RX path (DL channel). Though this feature
simplifies the client driver design, it introduces race between the client
drivers and the MHI stack. For instance, with auto_queue, the 'dl_callback'
for the DL channel may get called before the client driver is fully probed.
This means, by the time the dl_callback gets called, the client driver's
structures might not be initialized, leading to NULL ptr dereference.
Currently, the drivers have to workaround this issue by initializing the
internal structures before calling mhi_prepare_for_transfer_autoqueue().
But even so, there is a chance that the client driver's internal code path
may call the MHI queue APIs before mhi_prepare_for_transfer_autoqueue() is
called, leading to similar NULL ptr dereference. This issue has been
reported on the Qcom X1E80100 CRD machines affecting boot.
So to properly fix all these races, drop the MHI 'auto_queue' feature
altogether and let the client driver (QRTR) manage the RX buffers manually.
In the QRTR driver, queue the RX buffers based on the ring length during
probe and recycle the buffers in 'dl_callback' once they are consumed. This
also warrants removing the setting of 'auto_queue' flag from controller
drivers.
Currently, this 'auto_queue' feature is only enabled for IPCR DL channel.
So only the QRTR client driver requires the modification.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-06