In the Linux kernel, the following vulnerability has been resolved:
module: Fix kernel panic when a symbol st_shndx is out of bounds
The module loader doesn't check for bounds of the ELF section index in
simplify_symbols():
for (i = 1; i < symsec->sh_size / sizeof(Elf_Sym); i++) {
const char *name = info->strtab + sym[i].st_name;
switch (sym[i].st_shndx) {
case SHN_COMMON:
[...]
default:
/* Divert to percpu allocation if a percpu var. */
if (sym[i].st_shndx == info->index.pcpu)
secbase = (unsigned long)mod_percpu(mod);
else
/** HERE --> **/ secbase = info->sechdrs[sym[i].st_shndx].sh_addr;
sym[i].st_value += secbase;
break;
}
}
A symbol with an out-of-bounds st_shndx value, for example 0xffff
(known as SHN_XINDEX or SHN_HIRESERVE), may cause a kernel panic:
BUG: unable to handle page fault for address: ...
RIP: 0010:simplify_symbols+0x2b2/0x480
...
Kernel panic - not syncing: Fatal exception
This can happen when module ELF is legitimately using SHN_XINDEX or
when it is corrupted.
Add a bounds check in simplify_symbols() to validate that st_shndx is
within the valid range before using it.
This issue was discovered due to a bug in llvm-objcopy, see relevant
discussion for details [1].
[1] https://lore.kernel.org/linux-modules/20251224005752.201911-1-ihor.solodrai@linux.dev/
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btintel: serialize btintel_hw_error() with hci_req_sync_lock
btintel_hw_error() issues two __hci_cmd_sync() calls (HCI_OP_RESET
and Intel exception-info retrieval) without holding
hci_req_sync_lock(). This lets it race against
hci_dev_do_close() -> btintel_shutdown_combined(), which also runs
__hci_cmd_sync() under the same lock. When both paths manipulate
hdev->req_status/req_rsp concurrently, the close path may free the
response skb first, and the still-running hw_error path hits a
slab-use-after-free in kfree_skb().
Wrap the whole recovery sequence in hci_req_sync_lock/unlock so it
is serialized with every other synchronous HCI command issuer.
Below is the data race report and the kasan report:
BUG: data-race in __hci_cmd_sync_sk / btintel_shutdown_combined
read of hdev->req_rsp at net/bluetooth/hci_sync.c:199
by task kworker/u17:1/83:
__hci_cmd_sync_sk+0x12f2/0x1c30 net/bluetooth/hci_sync.c:200
__hci_cmd_sync+0x55/0x80 net/bluetooth/hci_sync.c:223
btintel_hw_error+0x114/0x670 drivers/bluetooth/btintel.c:254
hci_error_reset+0x348/0xa30 net/bluetooth/hci_core.c:1030
write/free by task ioctl/22580:
btintel_shutdown_combined+0xd0/0x360
drivers/bluetooth/btintel.c:3648
hci_dev_close_sync+0x9ae/0x2c10 net/bluetooth/hci_sync.c:5246
hci_dev_do_close+0x232/0x460 net/bluetooth/hci_core.c:526
BUG: KASAN: slab-use-after-free in
sk_skb_reason_drop+0x43/0x380 net/core/skbuff.c:1202
Read of size 4 at addr ffff888144a738dc
by task kworker/u17:1/83:
__hci_cmd_sync_sk+0x12f2/0x1c30 net/bluetooth/hci_sync.c:200
__hci_cmd_sync+0x55/0x80 net/bluetooth/hci_sync.c:223
btintel_hw_error+0x186/0x670 drivers/bluetooth/btintel.c:260
In the Linux kernel, the following vulnerability has been resolved:
team: fix header_ops type confusion with non-Ethernet ports
Similar to commit 950803f72547 ("bonding: fix type confusion in
bond_setup_by_slave()") team has the same class of header_ops type
confusion.
For non-Ethernet ports, team_setup_by_port() copies port_dev->header_ops
directly. When the team device later calls dev_hard_header() or
dev_parse_header(), these callbacks can run with the team net_device
instead of the real lower device, so netdev_priv(dev) is interpreted as
the wrong private type and can crash.
The syzbot report shows a crash in bond_header_create(), but the root
cause is in team: the topology is gre -> bond -> team, and team calls
the inherited header_ops with its own net_device instead of the lower
device, so bond_header_create() receives a team device and interprets
netdev_priv() as bonding private data, causing a type confusion crash.
Fix this by introducing team header_ops wrappers for create/parse,
selecting a team port under RCU, and calling the lower device callbacks
with port->dev, so each callback always sees the correct net_device
context.
Also pass the selected lower device to the lower parse callback, so
recursion is bounded in stacked non-Ethernet topologies and parse
callbacks always run with the correct device context.
In the Linux kernel, the following vulnerability has been resolved:
udp: Fix wildcard bind conflict check when using hash2
When binding a udp_sock to a local address and port, UDP uses
two hashes (udptable->hash and udptable->hash2) for collision
detection. The current code switches to "hash2" when
hslot->count > 10.
"hash2" is keyed by local address and local port.
"hash" is keyed by local port only.
The issue can be shown in the following bind sequence (pseudo code):
bind(fd1, "[fd00::1]:8888")
bind(fd2, "[fd00::2]:8888")
bind(fd3, "[fd00::3]:8888")
bind(fd4, "[fd00::4]:8888")
bind(fd5, "[fd00::5]:8888")
bind(fd6, "[fd00::6]:8888")
bind(fd7, "[fd00::7]:8888")
bind(fd8, "[fd00::8]:8888")
bind(fd9, "[fd00::9]:8888")
bind(fd10, "[fd00::10]:8888")
/* Correctly return -EADDRINUSE because "hash" is used
* instead of "hash2". udp_lib_lport_inuse() detects the
* conflict.
*/
bind(fail_fd, "[::]:8888")
/* After one more socket is bound to "[fd00::11]:8888",
* hslot->count exceeds 10 and "hash2" is used instead.
*/
bind(fd11, "[fd00::11]:8888")
bind(fail_fd, "[::]:8888") /* succeeds unexpectedly */
The same issue applies to the IPv4 wildcard address "0.0.0.0"
and the IPv4-mapped wildcard address "::ffff:0.0.0.0". For
example, if there are existing sockets bound to
"192.168.1.[1-11]:8888", then binding "0.0.0.0:8888" or
"[::ffff:0.0.0.0]:8888" can also miss the conflict when
hslot->count > 10.
TCP inet_csk_get_port() already has the correct check in
inet_use_bhash2_on_bind(). Rename it to
inet_use_hash2_on_bind() and move it to inet_hashtables.h
so udp.c can reuse it in this fix.
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_conntrack_expect: skip expectations in other netns via proc
Skip expectations that do not reside in this netns.
Similar to e77e6ff502ea ("netfilter: conntrack: do not dump other netns's
conntrack entries via proc").
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/core) Protect regulator operations with mutex
The regulator operations pmbus_regulator_get_voltage(),
pmbus_regulator_set_voltage(), and pmbus_regulator_list_voltage()
access PMBus registers and shared data but were not protected by
the update_lock mutex. This could lead to race conditions.
However, adding mutex protection directly to these functions causes
a deadlock because pmbus_regulator_notify() (which calls
regulator_notifier_call_chain()) is often called with the mutex
already held (e.g., from pmbus_fault_handler()). If a regulator
callback then calls one of the now-protected voltage functions,
it will attempt to acquire the same mutex.
Rework pmbus_regulator_notify() to utilize a worker function to
send notifications outside of the mutex protection. Events are
stored as atomics in a per-page bitmask and processed by the worker.
Initialize the worker and its associated data during regulator
registration, and ensure it is cancelled on device removal using
devm_add_action_or_reset().
While at it, remove the unnecessary include of linux/of.h.
In the Linux kernel, the following vulnerability has been resolved:
spi: use generic driver_override infrastructure
When a driver is probed through __driver_attach(), the bus' match()
callback is called without the device lock held, thus accessing the
driver_override field without a lock, which can cause a UAF.
Fix this by using the driver-core driver_override infrastructure taking
care of proper locking internally.
Note that calling match() from __driver_attach() without the device lock
held is intentional. [1]
Also note that we do not enable the driver_override feature of struct
bus_type, as SPI - in contrast to most other buses - passes "" to
sysfs_emit() when the driver_override pointer is NULL. Thus, printing
"\n" instead of "(null)\n".
In the Linux kernel, the following vulnerability has been resolved:
spi: meson-spicc: Fix double-put in remove path
meson_spicc_probe() registers the controller with
devm_spi_register_controller(), so teardown already drops the
controller reference via devm cleanup.
Calling spi_controller_put() again in meson_spicc_remove()
causes a double-put.
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: prevent immediate PASID reuse case
PASID resue could cause interrupt issue when process
immediately runs into hw state left by previous
process exited with the same PASID, it's possible that
page faults are still pending in the IH ring buffer when
the process exits and frees up its PASID. To prevent the
case, it uses idr cyclic allocator same as kernel pid's.
(cherry picked from commit 8f1de51f49be692de137c8525106e0fce2d1912d)
In the Linux kernel, the following vulnerability has been resolved:
ext4: replace BUG_ON with proper error handling in ext4_read_inline_folio
Replace BUG_ON() with proper error handling when inline data size
exceeds PAGE_SIZE. This prevents kernel panic and allows the system to
continue running while properly reporting the filesystem corruption.
The error is logged via ext4_error_inode(), the buffer head is released
to prevent memory leak, and -EFSCORRUPTED is returned to indicate
filesystem corruption.