In the Linux kernel, the following vulnerability has been resolved:
wifi: rtw88: check for PCI upstream bridge existence
pci_upstream_bridge() returns NULL if the device is on a root bus. If
8821CE is installed in the system with such a PCI topology, the probing
routine will crash. This has probably been unnoticed as 8821CE is mostly
supplied in laptops where there is a PCI-to-PCI bridge located upstream
from the device. However the card might be installed on a system with
different configuration.
Check if the bridge does exist for the specific workaround to be applied.
Found by Linux Verification Center (linuxtesting.org) with Svace static
analysis tool.
In the Linux kernel, the following vulnerability has been resolved:
ALSA: aloop: Fix peer runtime UAF during format-change stop
loopback_check_format() may stop the capture side when playback starts
with parameters that no longer match a running capture stream. Commit
826af7fa62e3 ("ALSA: aloop: Fix racy access at PCM trigger") moved
the peer lookup under cable->lock, but the actual snd_pcm_stop() still
runs after dropping that lock.
A concurrent close can clear the capture entry from cable->streams[] and
detach or free its runtime while the playback trigger path still holds a
stale peer substream pointer.
Keep a per-cable count of in-flight peer stops before dropping
cable->lock, and make free_cable() wait for those stops before
detaching the runtime. This preserves the existing behavior while
making the peer runtime lifetime explicit.
In the Linux kernel, the following vulnerability has been resolved:
spi: fix resource leaks on device setup failure
Make sure to call controller cleanup() if spi_setup() fails while
registering a device to avoid leaking any resources allocated by
setup().
In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: fix use-after-free in mwifiex_adapter_cleanup()
The mwifiex_adapter_cleanup() function uses timer_delete()
(non-synchronous) for the wakeup_timer before the adapter structure is
freed. This is incorrect because timer_delete() does not wait for any
running timer callback to complete.
If the wakeup_timer callback (wakeup_timer_fn) is executing when
mwifiex_adapter_cleanup() is called, the callback will continue to
access adapter fields (adapter->hw_status, adapter->if_ops.card_reset,
etc.) which may be freed by mwifiex_free_adapter() called later in the
mwifiex_remove_card() path.
Use timer_delete_sync() instead to ensure any running timer callback has
completed before returning.
In the Linux kernel, the following vulnerability has been resolved:
KVM: nSVM: Avoid clearing VMCB_LBR in vmcb12
svm_copy_lbrs() always marks VMCB_LBR dirty in the destination VMCB.
However, nested_svm_vmexit() uses it to copy LBRs to vmcb12, and
clearing clean bits in vmcb12 is not architecturally defined.
Move vmcb_mark_dirty() to callers and drop it for vmcb12.
This also facilitates incoming refactoring that does not pass the entire
VMCB to svm_copy_lbrs().
In the Linux kernel, the following vulnerability has been resolved:
fbdev: defio: Disconnect deferred I/O from the lifetime of struct fb_info
Hold state of deferred I/O in struct fb_deferred_io_state. Allocate an
instance as part of initializing deferred I/O and remove it only after
the final mapping has been closed. If the fb_info and the contained
deferred I/O meanwhile goes away, clear struct fb_deferred_io_state.info
to invalidate the mapping. Any access will then result in a SIGBUS
signal.
Fixes a long-standing problem, where a device hot-unplug happens while
user space still has an active mapping of the graphics memory. The hot-
unplug frees the instance of struct fb_info. Accessing the memory will
operate on undefined state.
In the Linux kernel, the following vulnerability has been resolved:
crypto: nx - fix bounce buffer leaks in nx842_crypto_{alloc,free}_ctx
The bounce buffers are allocated with __get_free_pages() using
BOUNCE_BUFFER_ORDER (order 2 = 4 pages), but both the allocation error
path and nx842_crypto_free_ctx() release the buffers with free_page().
Use free_pages() with the matching order instead.
In the Linux kernel, the following vulnerability has been resolved:
KVM: nSVM: Always use NextRIP as vmcb02's NextRIP after first L2 VMRUN
For guests with NRIPS disabled, L1 does not provide NextRIP when running
an L2 with an injected soft interrupt, instead it advances the current RIP
before running it. KVM uses the current RIP as the NextRIP in vmcb02 to
emulate a CPU without NRIPS.
However, after L2 runs the first time, NextRIP will be updated by the CPU
and/or KVM, and the current RIP is no longer the correct value to use in
vmcb02. Hence, after save/restore, use the current RIP if and only if a
nested run is pending, otherwise use NextRIP. Give soft_int_next_rip the
same treatment, as it's the same logic, just for a narrower use case.
[sean: give soft_int_next_rip the same treatment]
In the Linux kernel, the following vulnerability has been resolved:
ceph: only d_add() negative dentries when they are unhashed
Ceph can call d_add(dentry, NULL) on a negative dentry that is already
present in the primary dcache hash.
In the current VFS that is not safe. d_add() goes through __d_add()
to __d_rehash(), which unconditionally reinserts dentry->d_hash into
the hlist_bl bucket. If the dentry is already hashed, reinserting the
same node can corrupt the bucket, including creating a self-loop.
Once that happens, __d_lookup() can spin forever in the hlist_bl walk,
typically looping only on the d_name.hash mismatch check and
eventually triggering RCU stall reports like this one:
rcu: INFO: rcu_sched self-detected stall on CPU
rcu: 87-....: (2100 ticks this GP) idle=3a4c/1/0x4000000000000000 softirq=25003319/25003319 fqs=829
rcu: (t=2101 jiffies g=79058445 q=698988 ncpus=192)
CPU: 87 UID: 2952868916 PID: 3933303 Comm: php-cgi8.3 Not tainted 6.18.17-i1-amd #950 NONE
Hardware name: Dell Inc. PowerEdge R7615/0G9DHV, BIOS 1.6.6 09/22/2023
RIP: 0010:__d_lookup+0x46/0xb0
Code: c1 e8 07 48 8d 04 c2 48 8b 00 49 89 fc 49 89 f5 48 89 c3 48 83 e3 fe 48 83 f8 01 77 0f eb 2d 0f 1f 44 00 00 48 8b 1b 48 85 db <74> 20 39 6b 18 75 f3 48 8d 7b 78 e8 ba 85 d0 00 4c 39 63 10 74 1f
RSP: 0018:ff745a70c8253898 EFLAGS: 00000282
RAX: ff26e470054cb208 RBX: ff26e470054cb208 RCX: 000000006e958966
RDX: ff26e48267340000 RSI: ff745a70c82539b0 RDI: ff26e458f74655c0
RBP: 000000006e958966 R08: 0000000000000180 R09: 9cd08d909b919a89
R10: ff26e458f74655c0 R11: 0000000000000000 R12: ff26e458f74655c0
R13: ff745a70c82539b0 R14: d0d0d0d0d0d0d0d0 R15: 2f2f2f2f2f2f2f2f
FS: 00007f5770896980(0000) GS:ff26e482c5d88000(0000) knlGS:0000000000000000
CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033
CR2: 00007f5764de50c0 CR3: 000000a72abb5001 CR4: 0000000000771ef0
PKRU: 55555554
Call Trace:
<TASK>
lookup_fast+0x9f/0x100
walk_component+0x1f/0x150
link_path_walk+0x20e/0x3d0
path_lookupat+0x68/0x180
filename_lookup+0xdc/0x1e0
vfs_statx+0x6c/0x140
vfs_fstatat+0x67/0xa0
__do_sys_newfstatat+0x24/0x60
do_syscall_64+0x6a/0x230
entry_SYSCALL_64_after_hwframe+0x76/0x7e
This is reachable with reused cached negative dentries. A Ceph lookup
or atomic_open can be handed a negative dentry that is already hashed,
and fs/ceph/dir.c then hits one of two paths that incorrectly assume
"negative" also means "unhashed":
- ceph_finish_lookup():
MDS reply is -ENOENT with no trace
-> d_add(dentry, NULL)
- ceph_lookup():
local ENOENT fast path for a complete directory with shared caps
-> d_add(dentry, NULL)
Both paths can therefore re-add an already-hashed negative dentry.
Ceph already uses the correct pattern elsewhere: ceph_fill_trace() only
calls d_add(dn, NULL) for a negative null-dentry reply when d_unhashed(dn)
is true.
Fix both fs/ceph/dir.c sites the same way: only call d_add() for a
negative dentry when it is actually unhashed. If the negative dentry
is already hashed, leave it in place and reuse it as-is.
This preserves the existing behavior for unhashed dentries while
avoiding d_hash list corruption for reused hashed negatives.
In the Linux kernel, the following vulnerability has been resolved:
net: qrtr: ns: Free the node during ctrl_cmd_bye()
A node sends the BYE packet when it is about to go down. So the nameserver
should advertise the removal of the node to all remote and local observers
and free the node finally. But currently, the nameserver doesn't free the
node memory even after processing the BYE packet. This causes the node
memory to leak.
Hence, remove the node from Xarray list and free the node memory during
both success and failure case of ctrl_cmd_bye().