Linux: >> Linux Kernel >> 6.6.48 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix deadlock between rcu_tasks_trace and event_mutex.
Fix the following deadlock:
CPU A
_free_event()
perf_kprobe_destroy()
mutex_lock(&event_mutex)
perf_trace_event_unreg()
synchronize_rcu_tasks_trace()
There are several paths where _free_event() grabs event_mutex
and calls sync_rcu_tasks_trace. Above is one such case.
CPU B
bpf_prog_test_run_syscall()
rcu_read_lock_trace()
bpf_prog_run_pin_on_cpu()
bpf_prog_load()
bpf_tracing_func_proto()
trace_set_clr_event()
mutex_lock(&event_mutex)
Delegate trace_set_clr_event() to workqueue to avoid
such lock dependency.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-05-09
In the Linux kernel, the following vulnerability has been resolved:
KVM: x86: Reset IRTE to host control if *new* route isn't postable
Restore an IRTE back to host control (remapped or posted MSI mode) if the
*new* GSI route prevents posting the IRQ directly to a vCPU, regardless of
the GSI routing type. Updating the IRTE if and only if the new GSI is an
MSI results in KVM leaving an IRTE posting to a vCPU.
The dangling IRTE can result in interrupts being incorrectly delivered to
the guest, and in the worst case scenario can result in use-after-free,
e.g. if the VM is torn down, but the underlying host IRQ isn't freed.
CVSS Score
7.8
EPSS Score
0.0
Published
2025-05-09
In the Linux kernel, the following vulnerability has been resolved:
pds_core: make wait_context part of q_info
Make the wait_context a full part of the q_info struct rather
than a stack variable that goes away after pdsc_adminq_post()
is done so that the context is still available after the wait
loop has given up.
There was a case where a slow development firmware caused
the adminq request to time out, but then later the FW finally
finished the request and sent the interrupt. The handler tried
to complete_all() the completion context that had been created
on the stack in pdsc_adminq_post() but no longer existed.
This caused bad pointer usage, kernel crashes, and much wailing
and gnashing of teeth.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-05-09
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: prevent hang on link training fail
[Why]
When link training fails, the phy clock will be disabled. However, in
enable_streams, it is assumed that link training succeeded and the
mux selects the phy clock, causing a hang when a register write is made.
[How]
When enable_stream is hit, check if link training failed. If it did, fall
back to the ref clock to avoid a hang and keep the system in a recoverable
state.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-05-09
In the Linux kernel, the following vulnerability has been resolved:
net: ngbe: fix memory leak in ngbe_probe() error path
When ngbe_sw_init() is called, memory is allocated for wx->rss_key
in wx_init_rss_key(). However, in ngbe_probe() function, the subsequent
error paths after ngbe_sw_init() don't free the rss_key. Fix that by
freeing it in error path along with wx->mac_table.
Also change the label to which execution jumps when ngbe_sw_init()
fails, because otherwise, it could lead to a double free for rss_key,
when the mac_table allocation fails in wx_sw_init().
CVSS Score
5.5
EPSS Score
0.0
Published
2025-05-09
In the Linux kernel, the following vulnerability has been resolved:
igc: fix PTM cycle trigger logic
Writing to clear the PTM status 'valid' bit while the PTM cycle is
triggered results in unreliable PTM operation. To fix this, clear the
PTM 'trigger' and status after each PTM transaction.
The issue can be reproduced with the following:
$ sudo phc2sys -R 1000 -O 0 -i tsn0 -m
Note: 1000 Hz (-R 1000) is unrealistically large, but provides a way to
quickly reproduce the issue.
PHC2SYS exits with:
"ioctl PTP_OFFSET_PRECISE: Connection timed out" when the PTM transaction
fails
This patch also fixes a hang in igc_probe() when loading the igc
driver in the kdump kernel on systems supporting PTM.
The igc driver running in the base kernel enables PTM trigger in
igc_probe(). Therefore the driver is always in PTM trigger mode,
except in brief periods when manually triggering a PTM cycle.
When a crash occurs, the NIC is reset while PTM trigger is enabled.
Due to a hardware problem, the NIC is subsequently in a bad busmaster
state and doesn't handle register reads/writes. When running
igc_probe() in the kdump kernel, the first register access to a NIC
register hangs driver probing and ultimately breaks kdump.
With this patch, igc has PTM trigger disabled most of the time,
and the trigger is only enabled for very brief (10 - 100 us) periods
when manually triggering a PTM cycle. Chances that a crash occurs
during a PTM trigger are not 0, but extremely reduced.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-05-09
In the Linux kernel, the following vulnerability has been resolved:
iommu: Clear iommu-dma ops on cleanup
If iommu_device_register() encounters an error, it can end up tearing
down already-configured groups and default domains, however this
currently still leaves devices hooked up to iommu-dma (and even
historically the behaviour in this area was at best inconsistent across
architectures/drivers...) Although in the case that an IOMMU is present
whose driver has failed to probe, users cannot necessarily expect DMA to
work anyway, it's still arguable that we should do our best to put
things back as if the IOMMU driver was never there at all, and certainly
the potential for crashing in iommu-dma itself is undesirable. Make sure
we clean up the dev->dma_iommu flag along with everything else.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-05-09
In the Linux kernel, the following vulnerability has been resolved:
scsi: mpi3mr: Synchronous access b/w reset and tm thread for reply queue
When the task management thread processes reply queues while the reset
thread resets them, the task management thread accesses an invalid queue ID
(0xFFFF), set by the reset thread, which points to unallocated memory,
causing a crash.
Add flag 'io_admin_reset_sync' to synchronize access between the reset,
I/O, and admin threads. Before a reset, the reset handler sets this flag to
block I/O and admin processing threads. If any thread bypasses the initial
check, the reset thread waits up to 10 seconds for processing to finish. If
the wait exceeds 10 seconds, the controller is marked as unrecoverable.
CVSS Score
7.8
EPSS Score
0.0
Published
2025-05-09
In the Linux kernel, the following vulnerability has been resolved:
HID: pidff: Fix null pointer dereference in pidff_find_fields
This function triggered a null pointer dereference if used to search for
a report that isn't implemented on the device. This happened both for
optional and required reports alike.
The same logic was applied to pidff_find_special_field and although
pidff_init_fields should return an error earlier if one of the required
reports is missing, future modifications could change this logic and
resurface this possible null pointer dereference again.
LKML bug report:
https://lore.kernel.org/all/CAL-gK7f5=R0nrrQdPtaZZr1fd-cdAMbDMuZ_NLA8vM0SX+nGSw@mail.gmail.com
CVSS Score
5.5
EPSS Score
0.0
Published
2025-05-09
In the Linux kernel, the following vulnerability has been resolved:
ovl: don't allow datadir only
In theory overlayfs could support upper layer directly referring to a data
layer, but there's no current use case for this.
Originally, when data-only layers were introduced, this wasn't allowed,
only introduced by the "datadir+" feature, but without actually handling
this case, resulting in an Oops.
Fix by disallowing datadir without lowerdir.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-05-09