In the Linux kernel, the following vulnerability has been resolved:
wifi: wlcore: ensure skb headroom before skb_push
This avoids occasional skb_under_panic Oops from wl1271_tx_work. In this case, headroom is
less than needed (typically 110 - 94 = 16 bytes).
In the Linux kernel, the following vulnerability has been resolved:
smb/server: fix refcount leak in smb2_open()
When ksmbd_vfs_getattr() fails, the reference count of ksmbd_file
must be released.
In the Linux kernel, the following vulnerability has been resolved:
flex_proportions: make fprop_new_period() hardirq safe
Bernd has reported a lockdep splat from flexible proportions code that is
essentially complaining about the following race:
<timer fires>
run_timer_softirq - we are in softirq context
call_timer_fn
writeout_period
fprop_new_period
write_seqcount_begin(&p->sequence);
<hardirq is raised>
...
blk_mq_end_request()
blk_update_request()
ext4_end_bio()
folio_end_writeback()
__wb_writeout_add()
__fprop_add_percpu_max()
if (unlikely(max_frac < FPROP_FRAC_BASE)) {
fprop_fraction_percpu()
seq = read_seqcount_begin(&p->sequence);
- sees odd sequence so loops indefinitely
Note that a deadlock like this is only possible if the bdi has configured
maximum fraction of writeout throughput which is very rare in general but
frequent for example for FUSE bdis. To fix this problem we have to make
sure write section of the sequence counter is irqsafe.
In the Linux kernel, the following vulnerability has been resolved:
mptcp: fix race in mptcp_pm_nl_flush_addrs_doit()
syzbot and Eulgyu Kim reported crashes in mptcp_pm_nl_get_local_id()
and/or mptcp_pm_nl_is_backup()
Root cause is list_splice_init() in mptcp_pm_nl_flush_addrs_doit()
which is not RCU ready.
list_splice_init_rcu() can not be called here while holding pernet->lock
spinlock.
Many thanks to Eulgyu Kim for providing a repro and testing our patches.
In the Linux kernel, the following vulnerability has been resolved:
drm/imx/tve: fix probe device leak
Make sure to drop the reference taken to the DDC device during probe on
probe failure (e.g. probe deferral) and on driver unbind.
In the Linux kernel, the following vulnerability has been resolved:
bonding: fix use-after-free due to enslave fail after slave array update
Fix a use-after-free which happens due to enslave failure after the new
slave has been added to the array. Since the new slave can be used for Tx
immediately, we can use it after it has been freed by the enslave error
cleanup path which frees the allocated slave memory. Slave update array is
supposed to be called last when further enslave failures are not expected.
Move it after xdp setup to avoid any problems.
It is very easy to reproduce the problem with a simple xdp_pass prog:
ip l add bond1 type bond mode balance-xor
ip l set bond1 up
ip l set dev bond1 xdp object xdp_pass.o sec xdp_pass
ip l add dumdum type dummy
Then run in parallel:
while :; do ip l set dumdum master bond1 1>/dev/null 2>&1; done;
mausezahn bond1 -a own -b rand -A rand -B 1.1.1.1 -c 0 -t tcp "dp=1-1023, flags=syn"
The crash happens almost immediately:
[ 605.602850] Oops: general protection fault, probably for non-canonical address 0xe0e6fc2460000137: 0000 [#1] SMP KASAN NOPTI
[ 605.602916] KASAN: maybe wild-memory-access in range [0x07380123000009b8-0x07380123000009bf]
[ 605.602946] CPU: 0 UID: 0 PID: 2445 Comm: mausezahn Kdump: loaded Tainted: G B 6.19.0-rc6+ #21 PREEMPT(voluntary)
[ 605.602979] Tainted: [B]=BAD_PAGE
[ 605.602998] Hardware name: QEMU Standard PC (Q35 + ICH9, 2009), BIOS 1.16.3-debian-1.16.3-2 04/01/2014
[ 605.603032] RIP: 0010:netdev_core_pick_tx+0xcd/0x210
[ 605.603063] Code: 48 89 fa 48 c1 ea 03 80 3c 02 00 0f 85 3e 01 00 00 48 b8 00 00 00 00 00 fc ff df 4c 8b 6b 08 49 8d 7d 30 48 89 fa 48 c1 ea 03 <80> 3c 02 00 0f 85 25 01 00 00 49 8b 45 30 4c 89 e2 48 89 ee 48 89
[ 605.603111] RSP: 0018:ffff88817b9af348 EFLAGS: 00010213
[ 605.603145] RAX: dffffc0000000000 RBX: ffff88817d28b420 RCX: 0000000000000000
[ 605.603172] RDX: 00e7002460000137 RSI: 0000000000000008 RDI: 07380123000009be
[ 605.603199] RBP: ffff88817b541a00 R08: 0000000000000001 R09: fffffbfff3ed8c0c
[ 605.603226] R10: ffffffff9f6c6067 R11: 0000000000000001 R12: 0000000000000000
[ 605.603253] R13: 073801230000098e R14: ffff88817d28b448 R15: ffff88817b541a84
[ 605.603286] FS: 00007f6570ef67c0(0000) GS:ffff888221dfa000(0000) knlGS:0000000000000000
[ 605.603319] CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033
[ 605.603343] CR2: 00007f65712fae40 CR3: 000000011371b000 CR4: 0000000000350ef0
[ 605.603373] Call Trace:
[ 605.603392] <TASK>
[ 605.603410] __dev_queue_xmit+0x448/0x32a0
[ 605.603434] ? __pfx_vprintk_emit+0x10/0x10
[ 605.603461] ? __pfx_vprintk_emit+0x10/0x10
[ 605.603484] ? __pfx___dev_queue_xmit+0x10/0x10
[ 605.603507] ? bond_start_xmit+0xbfb/0xc20 [bonding]
[ 605.603546] ? _printk+0xcb/0x100
[ 605.603566] ? __pfx__printk+0x10/0x10
[ 605.603589] ? bond_start_xmit+0xbfb/0xc20 [bonding]
[ 605.603627] ? add_taint+0x5e/0x70
[ 605.603648] ? add_taint+0x2a/0x70
[ 605.603670] ? end_report.cold+0x51/0x75
[ 605.603693] ? bond_start_xmit+0xbfb/0xc20 [bonding]
[ 605.603731] bond_start_xmit+0x623/0xc20 [bonding]
In the Linux kernel, the following vulnerability has been resolved:
net: wwan: t7xx: fix potential skb->frags overflow in RX path
When receiving data in the DPMAIF RX path,
the t7xx_dpmaif_set_frag_to_skb() function adds
page fragments to an skb without checking if the number of
fragments has exceeded MAX_SKB_FRAGS. This could lead to a buffer overflow
in skb_shinfo(skb)->frags[] array, corrupting adjacent memory and
potentially causing kernel crashes or other undefined behavior.
This issue was identified through static code analysis by comparing with a
similar vulnerability fixed in the mt76 driver commit b102f0c522cf ("mt76:
fix array overflow on receiving too many fragments for a packet").
The vulnerability could be triggered if the modem firmware sends packets
with excessive fragments. While under normal protocol conditions (MTU 3080
bytes, BAT buffer 3584 bytes),
a single packet should not require additional
fragments, the kernel should not blindly trust firmware behavior.
Malicious, buggy, or compromised firmware could potentially craft packets
with more fragments than the kernel expects.
Fix this by adding a bounds check before calling skb_add_rx_frag() to
ensure nr_frags does not exceed MAX_SKB_FRAGS.
The check must be performed before unmapping to avoid a page leak
and double DMA unmap during device teardown.
In the Linux kernel, the following vulnerability has been resolved:
perf: sched: Fix perf crash with new is_user_task() helper
In order to do a user space stacktrace the current task needs to be a user
task that has executed in user space. It use to be possible to test if a
task is a user task or not by simply checking the task_struct mm field. If
it was non NULL, it was a user task and if not it was a kernel task.
But things have changed over time, and some kernel tasks now have their
own mm field.
An idea was made to instead test PF_KTHREAD and two functions were used to
wrap this check in case it became more complex to test if a task was a
user task or not[1]. But this was rejected and the C code simply checked
the PF_KTHREAD directly.
It was later found that not all kernel threads set PF_KTHREAD. The io-uring
helpers instead set PF_USER_WORKER and this needed to be added as well.
But checking the flags is still not enough. There's a very small window
when a task exits that it frees its mm field and it is set back to NULL.
If perf were to trigger at this moment, the flags test would say its a
user space task but when perf would read the mm field it would crash with
at NULL pointer dereference.
Now there are flags that can be used to test if a task is exiting, but
they are set in areas that perf may still want to profile the user space
task (to see where it exited). The only real test is to check both the
flags and the mm field.
Instead of making this modification in every location, create a new
is_user_task() helper function that does all the tests needed to know if
it is safe to read the user space memory or not.
[1] https://lore.kernel.org/all/20250425204120.639530125@goodmis.org/
In the Linux kernel, the following vulnerability has been resolved:
octeon_ep: Fix memory leak in octep_device_setup()
In octep_device_setup(), if octep_ctrl_net_init() fails, the function
returns directly without unmapping the mapped resources and freeing the
allocated configuration memory.
Fix this by jumping to the unsupported_dev label, which performs the
necessary cleanup. This aligns with the error handling logic of other
paths in this function.
Compile tested only. Issue found using a prototype static analysis tool
and code review.