In the Linux kernel, the following vulnerability has been resolved:
btrfs: clean up our handling of refs == 0 in snapshot delete
In reada we BUG_ON(refs == 0), which could be unkind since we aren't
holding a lock on the extent leaf and thus could get a transient
incorrect answer. In walk_down_proc we also BUG_ON(refs == 0), which
could happen if we have extent tree corruption. Change that to return
-EUCLEAN. In do_walk_down() we catch this case and handle it correctly,
however we return -EIO, which -EUCLEAN is a more appropriate error code.
Finally in walk_up_proc we have the same BUG_ON(refs == 0), so convert
that to proper error handling. Also adjust the error message so we can
actually do something with the information.
In the Linux kernel, the following vulnerability has been resolved:
btrfs: don't BUG_ON on ENOMEM from btrfs_lookup_extent_info() in walk_down_proc()
We handle errors here properly, ENOMEM isn't fatal, return the error.
In the Linux kernel, the following vulnerability has been resolved:
scsi: lpfc: Handle mailbox timeouts in lpfc_get_sfp_info
The MBX_TIMEOUT return code is not handled in lpfc_get_sfp_info and the
routine unconditionally frees submitted mailbox commands regardless of
return status. The issue is that for MBX_TIMEOUT cases, when firmware
returns SFP information at a later time, that same mailbox memory region
references previously freed memory in its cmpl routine.
Fix by adding checks for the MBX_TIMEOUT return code. During mailbox
resource cleanup, check the mbox flag to make sure that the wait did not
timeout. If the MBOX_WAKE flag is not set, then do not free the resources
because it will be freed when firmware completes the mailbox at a later
time in its cmpl routine.
Also, increase the timeout from 30 to 60 seconds to accommodate boot
scripts requiring longer timeouts.
In the Linux kernel, the following vulnerability has been resolved:
scsi: ufs: core: Remove SCSI host only if added
If host tries to remove ufshcd driver from a UFS device it would cause a
kernel panic if ufshcd_async_scan fails during ufshcd_probe_hba before
adding a SCSI host with scsi_add_host and MCQ is enabled since SCSI host
has been defered after MCQ configuration introduced by commit 0cab4023ec7b
("scsi: ufs: core: Defer adding host to SCSI if MCQ is supported").
To guarantee that SCSI host is removed only if it has been added, set the
scsi_host_added flag to true after adding a SCSI host and check whether it
is set or not before removing it.
In the Linux kernel, the following vulnerability has been resolved:
um: line: always fill *error_out in setup_one_line()
The pointer isn't initialized by callers, but I have
encountered cases where it's still printed; initialize
it in all possible cases in setup_one_line().
In the Linux kernel, the following vulnerability has been resolved:
ELF: fix kernel.randomize_va_space double read
ELF loader uses "randomize_va_space" twice. It is sysctl and can change
at any moment, so 2 loads could see 2 different values in theory with
unpredictable consequences.
Issue exactly one load for consistent value across one exec.
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath12k: fix firmware crash due to invalid peer nss
Currently, if the access point receives an association
request containing an Extended HE Capabilities Information
Element with an invalid MCS-NSS, it triggers a firmware
crash.
This issue arises when EHT-PHY capabilities shows support
for a bandwidth and MCS-NSS set for that particular
bandwidth is filled by zeros and due to this, driver obtains
peer_nss as 0 and sending this value to firmware causes
crash.
Address this issue by implementing a validation step for
the peer_nss value before passing it to the firmware. If
the value is greater than zero, proceed with forwarding
it to the firmware. However, if the value is invalid,
reject the association request to prevent potential
firmware crashes.
Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
In the Linux kernel, the following vulnerability has been resolved:
MIPS: cevt-r4k: Don't call get_c0_compare_int if timer irq is installed
This avoids warning:
[ 0.118053] BUG: sleeping function called from invalid context at kernel/locking/mutex.c:283
Caused by get_c0_compare_int on secondary CPU.
We also skipped saving IRQ number to struct clock_event_device *cd as
it's never used by clockevent core, as per comments it's only meant
for "non CPU local devices".
In the Linux kernel, the following vulnerability has been resolved:
net: hns3: void array out of bound when loop tnl_num
When query reg inf of SSU, it loops tnl_num times. However, tnl_num comes
from hardware and the length of array is a fixed value. To void array out
of bound, make sure the loop time is not greater than the length of array
In the Linux kernel, the following vulnerability has been resolved:
ethtool: fail closed if we can't get max channel used in indirection tables
Commit 0d1b7d6c9274 ("bnxt: fix crashes when reducing ring count with
active RSS contexts") proves that allowing indirection table to contain
channels with out of bounds IDs may lead to crashes. Currently the
max channel check in the core gets skipped if driver can't fetch
the indirection table or when we can't allocate memory.
Both of those conditions should be extremely rare but if they do
happen we should try to be safe and fail the channel change.