Linux: >> Linux Kernel >> 4.14.327 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
RDMA/vmw_pvrdma: Fix double free on pvrdma_alloc_ucontext() error path
Sashiko points out that pvrdma_uar_free() is already called within
pvrdma_dealloc_ucontext(), so calling it before triggers a double free.
CVSS Score
7.8
EPSS Score
0.0
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
fbcon: Avoid OOB font access if console rotation fails
Clear the font buffer if the reallocation during console rotation fails
in fbcon_rotate_font(). The putcs implementations for the rotated buffer
will return early in this case. See [1] for an example.
Currently, fbcon_rotate_font() keeps the old buffer, which is too small
for the rotated font. Printing to the rotated console with a high-enough
character code will overflow the font buffer.
v2:
- fix typos in commit message
CVSS Score
7.1
EPSS Score
0.0
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
xfrm: ah: account for ESN high bits in async callbacks
AH allocates its temporary auth/ICV layout differently when ESN is enabled:
the async ahash setup appends a 4-byte seqhi slot before the ICV or
auth_data area, but the async completion callbacks still reconstruct the
temporary layout as if seqhi were absent.
With an async AH implementation selected, that makes AH copy or compare
the wrong bytes on both the IPv4 and IPv6 paths. In UML repro on IPv4 AH
with ESN and forced async hmac(sha1), ping fails with 100% packet loss,
and the callback logs show the pre-fix drift:
ah4 output_done: esn=1 err=0 icv_off=20 expected_off=24
ah4 input_done: esn=1 auth_off=20 expected_auth_off=24 icv_off=32 expected_icv_off=36
Reconstruct the callback-side layout the same way the setup path built it
by skipping the ESN seqhi slot before locating the saved auth_data or ICV.
Per RFC 4302, the ESN high-order 32 bits participate in the AH ICV
computation, so the async callbacks must account for the seqhi slot.
Post-fix, the same IPv4 AH+ESN+forced-async-hmac(sha1) UML repro shows
the corrected offset (ah4 output_done: esn=1 err=0 icv_off=24
expected_off=24) and ping succeeds; net/ipv4/ah4.o and net/ipv6/ah6.o
build clean at W=1. IPv6 AH+ESN was not exercised at runtime, and the
change has not been tested against a real async hardware AH engine.
CVSS Score
5.5
EPSS Score
0.0
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
x86/CPU/AMD: Prevent improper isolation of shared resources in Zen2's op cache
Make sure resources are not improperly shared in the op cache and
cause instruction corruption this way.
CVSS Score
8.8
EPSS Score
0.0
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
f2fs: fix fsck inconsistency caused by FGGC of node block
During FGGC node block migration, fsck may incorrectly treat the
migrated node block as fsync-written data.
The reproduction scenario:
root@vm:/mnt/f2fs# seq 1 2048 | xargs -n 1 ./test_sync // write inline inode and sync
root@vm:/mnt/f2fs# rm -f 1
root@vm:/mnt/f2fs# sync
root@vm:/mnt/f2fs# f2fs_io gc_range // move data block in sync mode and not write CP
SPO, "fsck --dry-run" find inode has already checkpointed but still
with DENT_BIT_SHIFT set
The root cause is that GC does not clear the dentry mark and fsync mark
during node block migration, leading fsck to misinterpret them as
user-issued fsync writes.
In BGGC mode, node block migration is handled by f2fs_sync_node_pages(),
which guarantees the dentry and fsync marks are cleared before writing.
This patch move the set/clear of the fsync|dentry marks into
__write_node_folio to make the logic clearer, and ensures the
fsync|dentry mark is cleared in FGGC.
CVSS Score
7.1
EPSS Score
0.0
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
ipmi: Add limits to event and receive message requests
The driver would just fetch events and receive messages until the
BMC said it was done. To avoid issues with BMCs that never say they are
done, add a limit of 10 fetches at a time.
In addition, an si interface has an attn state it can return from the
hardware which is supposed to cause a flag fetch to see if the driver
needs to fetch events or message or a few other things. If the attn
bit gets stuck, it's a similar problem. So allow messages in between
flag fetches so the driver itself doesn't get stuck.
This is a more general fix than the previous fix for the specific bad
BMC, but should fix the more general issue of a BMC that won't stop
saying it has data.
This has been there from the beginning of the driver. It's not a bug
per-se, but it is accounting for bugs in BMCs.
CVSS Score
7.5
EPSS Score
0.001
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
RDMA/mlx4: Fix resource leak on error in mlx4_ib_create_srq()
Sashiko points out that mlx4_srq_alloc() was not undone during error
unwind, add the missing call to mlx4_srq_free().
CVSS Score
7.8
EPSS Score
0.0
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: Fix potential use-after-free issue when stopping watchdog task
Watchdog task might end between send_sig() and kthread_stop() calls, what
results in the use-after-free issue. Fix this by increasing watchdog task
reference count before calling send_sig() and dropping it by switching to
kthread_stop_put().
CVSS Score
7.8
EPSS Score
0.0
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
RDMA/mlx4: Fix mis-use of RCU in mlx4_srq_event()
Sashiko points out the radix_tree itself is RCU safe, but nothing ever
frees the mlx4_srq struct with RCU, and it isn't even accessed within the
RCU critical section. It also will crash if an event is delivered before
the srq object is finished initializing.
Use the spinlock since it isn't easy to make RCU work, use
refcount_inc_not_zero() to protect against partially initialized objects,
and order the refcount_set() to be after the srq is fully initialized.
CVSS Score
7.8
EPSS Score
0.0
Published
2026-05-28
In the Linux kernel, the following vulnerability has been resolved:
usb: usblp: fix uninitialized heap leak via LPGETSTATUS ioctl
Just like in a previous problem in this driver, usblp_ctrl_msg() will
collapse the usb_control_msg() return value to 0/-errno, discarding the
actual number of bytes transferred.
Ideally that short command should be detected and error out, but many
printers are known to send "incorrect" responses back so we can't just
do that.
statusbuf is kmalloc(8) at probe time and never filled before the first
LPGETSTATUS ioctl.
usblp_read_status() requests 1 byte. If a malicious printer responds
with zero bytes, *statusbuf is one byte of stale kmalloc heap,
sign-extended into the local int status, which the LPGETSTATUS path then
copy_to_user()s directly to the ioctl caller.
Fix this all by just zapping out the memory buffer when allocated at
probe time. If a later call does a short read, the data will be
identical to what the device sent it the last time, so there is no
"leak" of information happening.
CVSS Score
5.5
EPSS Score
0.0
Published
2026-05-28