In the Linux kernel, the following vulnerability has been resolved:
media: pvrusb2: fix URB leak in pvr2_send_request_ex
When pvr2_send_request_ex() submits a write URB successfully but fails to
submit the read URB (e.g. returns -ENOMEM), it returns immediately without
waiting for the write URB to complete. Since the driver reuses the same
URB structure, a subsequent call to pvr2_send_request_ex() attempts to
submit the still-active write URB, triggering a 'URB submitted while
active' warning in usb_submit_urb().
Fix this by ensuring the write URB is unlinked and waited upon if the read
URB submission fails.
In the Linux kernel, the following vulnerability has been resolved:
clocksource/drivers/sh_tmu: Always leave device running after probe
The TMU device can be used as both a clocksource and a clockevent
provider. The driver tries to be smart and power itself on and off, as
well as enabling and disabling its clock when it's not in operation.
This behavior is slightly altered if the TMU is used as an early
platform device in which case the device is left powered on after probe,
but the clock is still enabled and disabled at runtime.
This has worked for a long time, but recent improvements in PREEMPT_RT
and PROVE_LOCKING have highlighted an issue. As the TMU registers itself
as a clockevent provider, clockevents_register_device(), it needs to use
raw spinlocks internally as this is the context of which the clockevent
framework interacts with the TMU driver. However in the context of
holding a raw spinlock the TMU driver can't really manage its power
state or clock with calls to pm_runtime_*() and clk_*() as these calls
end up in other platform drivers using regular spinlocks to control
power and clocks.
This mix of spinlock contexts trips a lockdep warning.
=============================
[ BUG: Invalid wait context ]
6.18.0-arm64-renesas-09926-gee959e7c5e34 #1 Not tainted
-----------------------------
swapper/0/0 is trying to lock:
ffff000008c9e180 (&dev->power.lock){-...}-{3:3}, at: __pm_runtime_resume+0x38/0x88
other info that might help us debug this:
context-{5:5}
1 lock held by swapper/0/0:
ccree e6601000.crypto: ARM CryptoCell 630P Driver: HW version 0xAF400001/0xDCC63000, Driver version 5.0
#0: ffff8000817ec298
ccree e6601000.crypto: ARM ccree device initialized
(tick_broadcast_lock){-...}-{2:2}, at: __tick_broadcast_oneshot_control+0xa4/0x3a8
stack backtrace:
CPU: 0 UID: 0 PID: 0 Comm: swapper/0 Not tainted 6.18.0-arm64-renesas-09926-gee959e7c5e34 #1 PREEMPT
Hardware name: Renesas Salvator-X 2nd version board based on r8a77965 (DT)
Call trace:
show_stack+0x14/0x1c (C)
dump_stack_lvl+0x6c/0x90
dump_stack+0x14/0x1c
__lock_acquire+0x904/0x1584
lock_acquire+0x220/0x34c
_raw_spin_lock_irqsave+0x58/0x80
__pm_runtime_resume+0x38/0x88
sh_tmu_clock_event_set_oneshot+0x84/0xd4
clockevents_switch_state+0xfc/0x13c
tick_broadcast_set_event+0x30/0xa4
__tick_broadcast_oneshot_control+0x1e0/0x3a8
tick_broadcast_oneshot_control+0x30/0x40
cpuidle_enter_state+0x40c/0x680
cpuidle_enter+0x30/0x40
do_idle+0x1f4/0x280
cpu_startup_entry+0x34/0x40
kernel_init+0x0/0x130
do_one_initcall+0x0/0x230
__primary_switched+0x88/0x90
For non-PREEMPT_RT builds this is not really an issue, but for
PREEMPT_RT builds where normal spinlocks can sleep this might be an
issue. Be cautious and always leave the power and clock running after
probe.
In the Linux kernel, the following vulnerability has been resolved:
net/rds: Clear reconnect pending bit
When canceling the reconnect worker, care must be taken to reset the
reconnect-pending bit. If the reconnect worker has not yet been
scheduled before it is canceled, the reconnect-pending bit will stay
on forever.
In the Linux kernel, the following vulnerability has been resolved:
minix: Add required sanity checking to minix_check_superblock()
The fs/minix implementation of the minix filesystem does not currently
support any other value for s_log_zone_size than 0. This is also the
only value supported in util-linux; see mkfs.minix.c line 511. In
addition, this patch adds some sanity checking for the other minix
superblock fields, and moves the minix_blocks_needed() checks for the
zmap and imap also to minix_check_super_block().
This also closes a related syzbot bug report.
In the Linux kernel, the following vulnerability has been resolved:
atm: fore200e: fix use-after-free in tasklets during device removal
When the PCA-200E or SBA-200E adapter is being detached, the fore200e
is deallocated. However, the tx_tasklet or rx_tasklet may still be running
or pending, leading to use-after-free bug when the already freed fore200e
is accessed again in fore200e_tx_tasklet() or fore200e_rx_tasklet().
One of the race conditions can occur as follows:
CPU 0 (cleanup) | CPU 1 (tasklet)
fore200e_pca_remove_one() | fore200e_interrupt()
fore200e_shutdown() | tasklet_schedule()
kfree(fore200e) | fore200e_tx_tasklet()
| fore200e-> // UAF
Fix this by ensuring tx_tasklet or rx_tasklet is properly canceled before
the fore200e is released. Add tasklet_kill() in fore200e_shutdown() to
synchronize with any pending or running tasklets. Moreover, since
fore200e_reset() could prevent further interrupts or data transfers,
the tasklet_kill() should be placed after fore200e_reset() to prevent
the tasklet from being rescheduled in fore200e_interrupt(). Finally,
it only needs to do tasklet_kill() when the fore200e state is greater
than or equal to FORE200E_STATE_IRQ, since tasklets are uninitialized
in earlier states. In a word, the tasklet_kill() should be placed in
the FORE200E_STATE_IRQ branch within the switch...case structure.
This bug was identified through static analysis.
In the Linux kernel, the following vulnerability has been resolved:
tcp: fix potential race in tcp_v6_syn_recv_sock()
Code in tcp_v6_syn_recv_sock() after the call to tcp_v4_syn_recv_sock()
is done too late.
After tcp_v4_syn_recv_sock(), the child socket is already visible
from TCP ehash table and other cpus might use it.
Since newinet->pinet6 is still pointing to the listener ipv6_pinfo
bad things can happen as syzbot found.
Move the problematic code in tcp_v6_mapped_child_init()
and call this new helper from tcp_v4_syn_recv_sock() before
the ehash insertion.
This allows the removal of one tcp_sync_mss(), since
tcp_v4_syn_recv_sock() will call it with the correct
context.
In the Linux kernel, the following vulnerability has been resolved:
xfs: delete attr leaf freemap entries when empty
Back in commit 2a2b5932db6758 ("xfs: fix attr leaf header freemap.size
underflow"), Brian Foster observed that it's possible for a small
freemap at the end of the end of the xattr entries array to experience
a size underflow when subtracting the space consumed by an expansion of
the entries array. There are only three freemap entries, which means
that it is not a complete index of all free space in the leaf block.
This code can leave behind a zero-length freemap entry with a nonzero
base. Subsequent setxattr operations can increase the base up to the
point that it overlaps with another freemap entry. This isn't in and of
itself a problem because the code in _leaf_add that finds free space
ignores any freemap entry with zero size.
However, there's another bug in the freemap update code in _leaf_add,
which is that it fails to update a freemap entry that begins midway
through the xattr entry that was just appended to the array. That can
result in the freemap containing two entries with the same base but
different sizes (0 for the "pushed-up" entry, nonzero for the entry
that's actually tracking free space). A subsequent _leaf_add can then
allocate xattr namevalue entries on top of the entries array, leading to
data loss. But fixing that is for later.
For now, eliminate the possibility of confusion by zeroing out the base
of any freemap entry that has zero size. Because the freemap is not
intended to be a complete index of free space, a subsequent failure to
find any free space for a new xattr will trigger block compaction, which
regenerates the freemap.
It looks like this bug has been in the codebase for quite a long time.
In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_tcpmss: check remaining length before reading optlen
Quoting reporter:
In net/netfilter/xt_tcpmss.c (lines 53-68), the TCP option parser reads
op[i+1] directly without validating the remaining option length.
If the last byte of the option field is not EOL/NOP (0/1), the code attempts
to index op[i+1]. In the case where i + 1 == optlen, this causes an
out-of-bounds read, accessing memory past the optlen boundary
(either reading beyond the stack buffer _opt or the
following payload).
In the Linux kernel, the following vulnerability has been resolved:
net: usb: kaweth: remove TX queue manipulation in kaweth_set_rx_mode
kaweth_set_rx_mode(), the ndo_set_rx_mode callback, calls
netif_stop_queue() and netif_wake_queue(). These are TX queue flow
control functions unrelated to RX multicast configuration.
The premature netif_wake_queue() can re-enable TX while tx_urb is still
in-flight, leading to a double usb_submit_urb() on the same URB:
kaweth_start_xmit() {
netif_stop_queue();
usb_submit_urb(kaweth->tx_urb);
}
kaweth_set_rx_mode() {
netif_stop_queue();
netif_wake_queue(); // wakes TX queue before URB is done
}
kaweth_start_xmit() {
netif_stop_queue();
usb_submit_urb(kaweth->tx_urb); // URB submitted while active
}
This triggers the WARN in usb_submit_urb():
"URB submitted while active"
This is a similar class of bug fixed in rtl8150 by
- commit 958baf5eaee3 ("net: usb: Remove disruptive netif_wake_queue in rtl8150_set_multicast").
Also kaweth_set_rx_mode() is already functionally broken, the
real set_rx_mode action is performed by kaweth_async_set_rx_mode(),
which in turn is not a no-op only at ndo_open() time.
In the Linux kernel, the following vulnerability has been resolved:
media: cx25821: Fix a resource leak in cx25821_dev_setup()
Add release_mem_region() if ioremap() fails to release the memory
region obtained by cx25821_get_resources().