Linux: >> Linux Kernel >> 2.6.28 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
net/tcp-md5: Fix MAC comparison to be constant-time
To prevent timing attacks, MACs need to be compared in constant
time. Use the appropriate helper function for this.
CVSS Score
9.4
EPSS Score
0.004
Published
2026-05-08
In the Linux kernel, the following vulnerability has been resolved:
x86/apic: Disable x2apic on resume if the kernel expects so
When resuming from s2ram, firmware may re-enable x2apic mode, which may have
been disabled by the kernel during boot either because it doesn't support IRQ
remapping or for other reasons. This causes the kernel to continue using the
xapic interface, while the hardware is in x2apic mode, which causes hangs.
This happens on defconfig + bare metal + s2ram.
Fix this in lapic_resume() by disabling x2apic if the kernel expects it to be
disabled, i.e. when x2apic_mode = 0.
The ACPI v6.6 spec, Section 16.3 [1] says firmware restores either the
pre-sleep configuration or initial boot configuration for each CPU, including
MSR state:
When executing from the power-on reset vector as a result of waking from an
S2 or S3 sleep state, the platform firmware performs only the hardware
initialization required to restore the system to either the state the
platform was in prior to the initial operating system boot, or to the
pre-sleep configuration state. In multiprocessor systems, non-boot
processors should be placed in the same state as prior to the initial
operating system boot.
(further ahead)
If this is an S2 or S3 wake, then the platform runtime firmware restores
minimum context of the system before jumping to the waking vector. This
includes:
CPU configuration. Platform runtime firmware restores the pre-sleep
configuration or initial boot configuration of each CPU (MSR, MTRR,
firmware update, SMBase, and so on). Interrupts must be disabled (for
IA-32 processors, disabled by CLI instruction).
(and other things)
So at least as per the spec, re-enablement of x2apic by the firmware is
allowed if "x2apic on" is a part of the initial boot configuration.
[1] https://uefi.org/specs/ACPI/6.6/16_Waking_and_Sleeping.html#initialization
[ bp: Massage. ]
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-08
In the Linux kernel, the following vulnerability has been resolved:
ACPI: processor: Fix NULL-pointer dereference in acpi_processor_errata_piix4()
In acpi_processor_errata_piix4(), the pointer dev is first assigned an IDE
device and then reassigned an ISA device:
dev = pci_get_subsys(..., PCI_DEVICE_ID_INTEL_82371AB, ...);
dev = pci_get_subsys(..., PCI_DEVICE_ID_INTEL_82371AB_0, ...);
If the first lookup succeeds but the second fails, dev becomes NULL. This
leads to a potential null-pointer dereference when dev_dbg() is called:
if (errata.piix4.bmisx)
dev_dbg(&dev->dev, ...);
To prevent this, use two temporary pointers and retrieve each device
independently, avoiding overwriting dev with a possible NULL value.
[ rjw: Subject adjustment, added an empty code line ]
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-08
In the Linux kernel, the following vulnerability has been resolved:
hfsplus: pretend special inodes as regular files
Since commit af153bb63a33 ("vfs: catch invalid modes in may_open()")
requires any inode be one of S_IFDIR/S_IFLNK/S_IFREG/S_IFCHR/S_IFBLK/
S_IFIFO/S_IFSOCK type, use S_IFREG for special inodes.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
wifi: libertas: fix WARNING in usb_tx_block
The function usb_tx_block() submits cardp->tx_urb without ensuring that
any previous transmission on this URB has completed. If a second call
occurs while the URB is still active (e.g. during rapid firmware loading),
usb_submit_urb() detects the active state and triggers a warning:
'URB submitted while active'.
Fix this by enforcing serialization: call usb_kill_urb() before
submitting the new request. This ensures the URB is idle and safe to reuse.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
alpha: fix user-space corruption during memory compaction
Alpha systems can suffer sporadic user-space crashes and heap
corruption when memory compaction is enabled.
Symptoms include SIGSEGV, glibc allocator failures (e.g. "unaligned
tcache chunk"), and compiler internal errors. The failures disappear
when compaction is disabled or when using global TLB invalidation.
The root cause is insufficient TLB shootdown during page migration.
Alpha relies on ASN-based MM context rollover for instruction cache
coherency, but this alone is not sufficient to prevent stale data or
instruction translations from surviving migration.
Fix this by introducing a migration-specific helper that combines:
- MM context invalidation (ASN rollover),
- immediate per-CPU TLB invalidation (TBI),
- synchronous cross-CPU shootdown when required.
The helper is used only by migration/compaction paths to avoid changing
global TLB semantics.
Additionally, update flush_tlb_other(), pte_clear(), to use
READ_ONCE()/WRITE_ONCE() for correct SMP memory ordering.
This fixes observed crashes on both UP and SMP Alpha systems.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
media: pvrusb2: fix URB leak in pvr2_send_request_ex
When pvr2_send_request_ex() submits a write URB successfully but fails to
submit the read URB (e.g. returns -ENOMEM), it returns immediately without
waiting for the write URB to complete. Since the driver reuses the same
URB structure, a subsequent call to pvr2_send_request_ex() attempts to
submit the still-active write URB, triggering a 'URB submitted while
active' warning in usb_submit_urb().
Fix this by ensuring the write URB is unlinked and waited upon if the read
URB submission fails.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
minix: Add required sanity checking to minix_check_superblock()
The fs/minix implementation of the minix filesystem does not currently
support any other value for s_log_zone_size than 0. This is also the
only value supported in util-linux; see mkfs.minix.c line 511. In
addition, this patch adds some sanity checking for the other minix
superblock fields, and moves the minix_blocks_needed() checks for the
zmap and imap also to minix_check_super_block().
This also closes a related syzbot bug report.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
atm: fore200e: fix use-after-free in tasklets during device removal
When the PCA-200E or SBA-200E adapter is being detached, the fore200e
is deallocated. However, the tx_tasklet or rx_tasklet may still be running
or pending, leading to use-after-free bug when the already freed fore200e
is accessed again in fore200e_tx_tasklet() or fore200e_rx_tasklet().
One of the race conditions can occur as follows:
CPU 0 (cleanup) | CPU 1 (tasklet)
fore200e_pca_remove_one() | fore200e_interrupt()
fore200e_shutdown() | tasklet_schedule()
kfree(fore200e) | fore200e_tx_tasklet()
| fore200e-> // UAF
Fix this by ensuring tx_tasklet or rx_tasklet is properly canceled before
the fore200e is released. Add tasklet_kill() in fore200e_shutdown() to
synchronize with any pending or running tasklets. Moreover, since
fore200e_reset() could prevent further interrupts or data transfers,
the tasklet_kill() should be placed after fore200e_reset() to prevent
the tasklet from being rescheduled in fore200e_interrupt(). Finally,
it only needs to do tasklet_kill() when the fore200e state is greater
than or equal to FORE200E_STATE_IRQ, since tasklets are uninitialized
in earlier states. In a word, the tasklet_kill() should be placed in
the FORE200E_STATE_IRQ branch within the switch...case structure.
This bug was identified through static analysis.
CVSS Score
7.5
EPSS Score
0.004
Published
2026-05-06
In the Linux kernel, the following vulnerability has been resolved:
tcp: fix potential race in tcp_v6_syn_recv_sock()
Code in tcp_v6_syn_recv_sock() after the call to tcp_v4_syn_recv_sock()
is done too late.
After tcp_v4_syn_recv_sock(), the child socket is already visible
from TCP ehash table and other cpus might use it.
Since newinet->pinet6 is still pointing to the listener ipv6_pinfo
bad things can happen as syzbot found.
Move the problematic code in tcp_v6_mapped_child_init()
and call this new helper from tcp_v4_syn_recv_sock() before
the ehash insertion.
This allows the removal of one tcp_sync_mss(), since
tcp_v4_syn_recv_sock() will call it with the correct
context.
CVSS Score
9.8
EPSS Score
0.004
Published
2026-05-06