In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: disable napi on driver removal
A warning on driver removal started occurring after commit 9dd05df8403b
("net: warn if NAPI instance wasn't shut down"). Disable tx napi before
deleting it in mt76_dma_cleanup().
WARNING: CPU: 4 PID: 18828 at net/core/dev.c:7288 __netif_napi_del_locked+0xf0/0x100
CPU: 4 UID: 0 PID: 18828 Comm: modprobe Not tainted 6.15.0-rc4 #4 PREEMPT(lazy)
Hardware name: ASUS System Product Name/PRIME X670E-PRO WIFI, BIOS 3035 09/05/2024
RIP: 0010:__netif_napi_del_locked+0xf0/0x100
Call Trace:
<TASK>
mt76_dma_cleanup+0x54/0x2f0 [mt76]
mt7921_pci_remove+0xd5/0x190 [mt7921e]
pci_device_remove+0x47/0xc0
device_release_driver_internal+0x19e/0x200
driver_detach+0x48/0x90
bus_remove_driver+0x6d/0xf0
pci_unregister_driver+0x2e/0xb0
__do_sys_delete_module.isra.0+0x197/0x2e0
do_syscall_64+0x7b/0x160
entry_SYSCALL_64_after_hwframe+0x76/0x7e
Tested with mt7921e but the same pattern can be actually applied to other
mt76 drivers calling mt76_dma_cleanup() during removal. Tx napi is enabled
in their *_dma_init() functions and only toggled off and on again inside
their suspend/resume/reset paths. So it should be okay to disable tx
napi in such a generic way.
Found by Linux Verification Center (linuxtesting.org).
In the Linux kernel, the following vulnerability has been resolved:
phy: tegra: xusb: Use a bitmask for UTMI pad power state tracking
The current implementation uses bias_pad_enable as a reference count to
manage the shared bias pad for all UTMI PHYs. However, during system
suspension with connected USB devices, multiple power-down requests for
the UTMI pad result in a mismatch in the reference count, which in turn
produces warnings such as:
[ 237.762967] WARNING: CPU: 10 PID: 1618 at tegra186_utmi_pad_power_down+0x160/0x170
[ 237.763103] Call trace:
[ 237.763104] tegra186_utmi_pad_power_down+0x160/0x170
[ 237.763107] tegra186_utmi_phy_power_off+0x10/0x30
[ 237.763110] phy_power_off+0x48/0x100
[ 237.763113] tegra_xusb_enter_elpg+0x204/0x500
[ 237.763119] tegra_xusb_suspend+0x48/0x140
[ 237.763122] platform_pm_suspend+0x2c/0xb0
[ 237.763125] dpm_run_callback.isra.0+0x20/0xa0
[ 237.763127] __device_suspend+0x118/0x330
[ 237.763129] dpm_suspend+0x10c/0x1f0
[ 237.763130] dpm_suspend_start+0x88/0xb0
[ 237.763132] suspend_devices_and_enter+0x120/0x500
[ 237.763135] pm_suspend+0x1ec/0x270
The root cause was traced back to the dynamic power-down changes
introduced in commit a30951d31b25 ("xhci: tegra: USB2 pad power controls"),
where the UTMI pad was being powered down without verifying its current
state. This unbalanced behavior led to discrepancies in the reference
count.
To rectify this issue, this patch replaces the single reference counter
with a bitmask, renamed to utmi_pad_enabled. Each bit in the mask
corresponds to one of the four USB2 PHYs, allowing us to track each pad's
enablement status individually.
With this change:
- The bias pad is powered on only when the mask is clear.
- Each UTMI pad is powered on or down based on its corresponding bit
in the mask, preventing redundant operations.
- The overall power state of the shared bias pad is maintained
correctly during suspend/resume cycles.
The mutex used to prevent race conditions during UTMI pad enable/disable
operations has been moved from the tegra186_utmi_bias_pad_power_on/off
functions to the parent functions tegra186_utmi_pad_power_on/down. This
change ensures that there are no race conditions when updating the bitmask.
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: csa unmap use uninterruptible lock
After process exit to unmap csa and free GPU vm, if signal is accepted
and then waiting to take vm lock is interrupted and return, it causes
memory leaking and below warning backtrace.
Change to use uninterruptible wait lock fix the issue.
WARNING: CPU: 69 PID: 167800 at amd/amdgpu/amdgpu_kms.c:1525
amdgpu_driver_postclose_kms+0x294/0x2a0 [amdgpu]
Call Trace:
<TASK>
drm_file_free.part.0+0x1da/0x230 [drm]
drm_close_helper.isra.0+0x65/0x70 [drm]
drm_release+0x6a/0x120 [drm]
amdgpu_drm_release+0x51/0x60 [amdgpu]
__fput+0x9f/0x280
____fput+0xe/0x20
task_work_run+0x67/0xa0
do_exit+0x217/0x3c0
do_group_exit+0x3b/0xb0
get_signal+0x14a/0x8d0
arch_do_signal_or_restart+0xde/0x100
exit_to_user_mode_loop+0xc1/0x1a0
exit_to_user_mode_prepare+0xf4/0x100
syscall_exit_to_user_mode+0x17/0x40
do_syscall_64+0x69/0xc0
(cherry picked from commit 7dbbfb3c171a6f63b01165958629c9c26abf38ab)
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: Set n_channels after allocating struct cfg80211_scan_request
Make sure that n_channels is set after allocating the
struct cfg80211_registered_device::int_scan_req member. Seen with
syzkaller:
UBSAN: array-index-out-of-bounds in net/mac80211/scan.c:1208:5
index 0 is out of range for type 'struct ieee80211_channel *[] __counted_by(n_channels)' (aka 'struct ieee80211_channel *[]')
This was missed in the initial conversions because I failed to locate
the allocation likely due to the "sizeof(void *)" not matching the
"channels" array type.
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: idxd: Refactor remove call with idxd_cleanup() helper
The idxd_cleanup() helper cleans up perfmon, interrupts, internals and
so on. Refactor remove call with the idxd_cleanup() helper to avoid code
duplication. Note, this also fixes the missing put_device() for idxd
groups, enginces and wqs.
In the Linux kernel, the following vulnerability has been resolved:
net: mctp: Don't access ifa_index when missing
In mctp_dump_addrinfo, ifa_index can be used to filter interfaces, but
only when the struct ifaddrmsg is provided. Otherwise it will be
comparing to uninitialised memory - reproducible in the syzkaller case from
dhcpd, or busybox "ip addr show".
The kernel MCTP implementation has always filtered by ifa_index, so
existing userspace programs expecting to dump MCTP addresses must
already be passing a valid ifa_index value (either 0 or a real index).
BUG: KMSAN: uninit-value in mctp_dump_addrinfo+0x208/0xac0 net/mctp/device.c:128
mctp_dump_addrinfo+0x208/0xac0 net/mctp/device.c:128
rtnl_dump_all+0x3ec/0x5b0 net/core/rtnetlink.c:4380
rtnl_dumpit+0xd5/0x2f0 net/core/rtnetlink.c:6824
netlink_dump+0x97b/0x1690 net/netlink/af_netlink.c:2309
In the Linux kernel, the following vulnerability has been resolved:
HID: uclogic: Add NULL check in uclogic_input_configured()
devm_kasprintf() returns NULL when memory allocation fails. Currently,
uclogic_input_configured() does not check for this case, which results
in a NULL pointer dereference.
Add NULL check after devm_kasprintf() to prevent this issue.
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: add locking for bcm_op runtime updates
The CAN broadcast manager (CAN BCM) can send a sequence of CAN frames via
hrtimer. The content and also the length of the sequence can be changed
resp reduced at runtime where the 'currframe' counter is then set to zero.
Although this appeared to be a safe operation the updates of 'currframe'
can be triggered from user space and hrtimer context in bcm_can_tx().
Anderson Nascimento created a proof of concept that triggered a KASAN
slab-out-of-bounds read access which can be prevented with a spin_lock_bh.
At the rework of bcm_can_tx() the 'count' variable has been moved into
the protected section as this variable can be modified from both contexts
too.
In the Linux kernel, the following vulnerability has been resolved:
can: bcm: add missing rcu read protection for procfs content
When the procfs content is generated for a bcm_op which is in the process
to be removed the procfs output might show unreliable data (UAF).
As the removal of bcm_op's is already implemented with rcu handling this
patch adds the missing rcu_read_lock() and makes sure the list entries
are properly removed under rcu protection.