In the Linux kernel, the following vulnerability has been resolved:
fbcon: Fix a NULL pointer dereference issue in fbcon_putcs
syzbot has found a NULL pointer dereference bug in fbcon.
Here is the simplified C reproducer:
struct param {
uint8_t type;
struct tiocl_selection ts;
};
int main()
{
struct fb_con2fbmap con2fb;
struct param param;
int fd = open("/dev/fb1", 0, 0);
con2fb.console = 0x19;
con2fb.framebuffer = 0;
ioctl(fd, FBIOPUT_CON2FBMAP, &con2fb);
param.type = 2;
param.ts.xs = 0; param.ts.ys = 0;
param.ts.xe = 0; param.ts.ye = 0;
param.ts.sel_mode = 0;
int fd1 = open("/dev/tty1", O_RDWR, 0);
ioctl(fd1, TIOCLINUX, ¶m);
con2fb.console = 1;
con2fb.framebuffer = 0;
ioctl(fd, FBIOPUT_CON2FBMAP, &con2fb);
return 0;
}
After calling ioctl(fd1, TIOCLINUX, ¶m), the subsequent ioctl(fd, FBIOPUT_CON2FBMAP, &con2fb)
causes the kernel to follow a different execution path:
set_con2fb_map
-> con2fb_init_display
-> fbcon_set_disp
-> redraw_screen
-> hide_cursor
-> clear_selection
-> highlight
-> invert_screen
-> do_update_region
-> fbcon_putcs
-> ops->putcs
Since ops->putcs is a NULL pointer, this leads to a kernel panic.
To prevent this, we need to call set_blitting_type() within set_con2fb_map()
to properly initialize ops->putcs.
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Check null pointer before dereferencing se
[WHAT & HOW]
se is null checked previously in the same function, indicating
it might be null; therefore, it must be checked when used again.
This fixes 1 FORWARD_NULL issue reported by Coverity.
In the Linux kernel, the following vulnerability has been resolved:
driver core: bus: Fix double free in driver API bus_register()
For bus_register(), any error which happens after kset_register() will
cause that @priv are freed twice, fixed by setting @priv with NULL after
the first free.
In the Linux kernel, the following vulnerability has been resolved:
usb: typec: tipd: Free IRQ only if it was requested before
In polling mode, if no IRQ was requested there is no need to free it.
Call devm_free_irq() only if client->irq is set. This fixes the warning
caused by the tps6598x module removal:
WARNING: CPU: 2 PID: 333 at kernel/irq/devres.c:144 devm_free_irq+0x80/0x8c
...
...
Call trace:
devm_free_irq+0x80/0x8c
tps6598x_remove+0x28/0x88 [tps6598x]
i2c_device_remove+0x2c/0x9c
device_remove+0x4c/0x80
device_release_driver_internal+0x1cc/0x228
driver_detach+0x50/0x98
bus_remove_driver+0x6c/0xbc
driver_unregister+0x30/0x60
i2c_del_driver+0x54/0x64
tps6598x_i2c_driver_exit+0x18/0xc3c [tps6598x]
__arm64_sys_delete_module+0x184/0x264
invoke_syscall+0x48/0x110
el0_svc_common.constprop.0+0xc8/0xe8
do_el0_svc+0x20/0x2c
el0_svc+0x28/0x98
el0t_64_sync_handler+0x13c/0x158
el0t_64_sync+0x190/0x194
In the Linux kernel, the following vulnerability has been resolved:
serial: protect uart_port_dtr_rts() in uart_shutdown() too
Commit af224ca2df29 (serial: core: Prevent unsafe uart port access, part
3) added few uport == NULL checks. It added one to uart_shutdown(), so
the commit assumes, uport can be NULL in there. But right after that
protection, there is an unprotected "uart_port_dtr_rts(uport, false);"
call. That is invoked only if HUPCL is set, so I assume that is the
reason why we do not see lots of these reports.
Or it cannot be NULL at this point at all for some reason :P.
Until the above is investigated, stay on the safe side and move this
dereference to the if too.
I got this inconsistency from Coverity under CID 1585130. Thanks.
In the Linux kernel, the following vulnerability has been resolved:
netfilter: xtables: avoid NFPROTO_UNSPEC where needed
syzbot managed to call xt_cluster match via ebtables:
WARNING: CPU: 0 PID: 11 at net/netfilter/xt_cluster.c:72 xt_cluster_mt+0x196/0x780
[..]
ebt_do_table+0x174b/0x2a40
Module registers to NFPROTO_UNSPEC, but it assumes ipv4/ipv6 packet
processing. As this is only useful to restrict locally terminating
TCP/UDP traffic, register this for ipv4 and ipv6 family only.
Pablo points out that this is a general issue, direct users of the
set/getsockopt interface can call into targets/matches that were only
intended for use with ip(6)tables.
Check all UNSPEC matches and targets for similar issues:
- matches and targets are fine except if they assume skb_network_header()
is valid -- this is only true when called from inet layer: ip(6) stack
pulls the ip/ipv6 header into linear data area.
- targets that return XT_CONTINUE or other xtables verdicts must be
restricted too, they are incompatbile with the ebtables traverser, e.g.
EBT_CONTINUE is a completely different value than XT_CONTINUE.
Most matches/targets are changed to register for NFPROTO_IPV4/IPV6, as
they are provided for use by ip(6)tables.
The MARK target is also used by arptables, so register for NFPROTO_ARP too.
While at it, bail out if connbytes fails to enable the corresponding
conntrack family.
This change passes the selftests in iptables.git.
In the Linux kernel, the following vulnerability has been resolved:
net: Fix an unsafe loop on the list
The kernel may crash when deleting a genetlink family if there are still
listeners for that family:
Oops: Kernel access of bad area, sig: 11 [#1]
...
NIP [c000000000c080bc] netlink_update_socket_mc+0x3c/0xc0
LR [c000000000c0f764] __netlink_clear_multicast_users+0x74/0xc0
Call Trace:
__netlink_clear_multicast_users+0x74/0xc0
genl_unregister_family+0xd4/0x2d0
Change the unsafe loop on the list to a safe one, because inside the
loop there is an element removal from this list.
In the Linux kernel, the following vulnerability has been resolved:
net/9p: Fix a potential socket leak in p9_socket_open
Both p9_fd_create_tcp() and p9_fd_create_unix() will call
p9_socket_open(). If the creation of p9_trans_fd fails,
p9_fd_create_tcp() and p9_fd_create_unix() will return an
error directly instead of releasing the cscoket, which will
result in a socket leak.
This patch adds sock_release() to fix the leak issue.