Linux: >> Linux Kernel >> 4.12.10 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
serial: 8250: fix panic due to PSLVERR
When the PSLVERR_RESP_EN parameter is set to 1, the device generates
an error response if an attempt is made to read an empty RBR (Receive
Buffer Register) while the FIFO is enabled.
In serial8250_do_startup(), calling serial_port_out(port, UART_LCR,
UART_LCR_WLEN8) triggers dw8250_check_lcr(), which invokes
dw8250_force_idle() and serial8250_clear_and_reinit_fifos(). The latter
function enables the FIFO via serial_out(p, UART_FCR, p->fcr).
Execution proceeds to the serial_port_in(port, UART_RX).
This satisfies the PSLVERR trigger condition.
When another CPU (e.g., using printk()) is accessing the UART (UART
is busy), the current CPU fails the check (value & ~UART_LCR_SPAR) ==
(lcr & ~UART_LCR_SPAR) in dw8250_check_lcr(), causing it to enter
dw8250_force_idle().
Put serial_port_out(port, UART_LCR, UART_LCR_WLEN8) under the port->lock
to fix this issue.
Panic backtrace:
[ 0.442336] Oops - unknown exception [#1]
[ 0.442343] epc : dw8250_serial_in32+0x1e/0x4a
[ 0.442351] ra : serial8250_do_startup+0x2c8/0x88e
...
[ 0.442416] console_on_rootfs+0x26/0x70
CVSS Score
5.5
EPSS Score
0.0
Published
2025-09-05
In the Linux kernel, the following vulnerability has been resolved:
parisc: Revise __get_user() to probe user read access
Because of the way read access support is implemented, read access
interruptions are only triggered at privilege levels 2 and 3. The
kernel executes at privilege level 0, so __get_user() never triggers
a read access interruption (code 26). Thus, it is currently possible
for user code to access a read protected address via a system call.
Fix this by probing read access rights at privilege level 3 (PRIV_USER)
and setting __gu_err to -EFAULT (-14) if access isn't allowed.
Note the cmpiclr instruction does a 32-bit compare because COND macro
doesn't work inside asm.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-09-05
In the Linux kernel, the following vulnerability has been resolved:
media: rainshadow-cec: fix TOCTOU race condition in rain_interrupt()
In the interrupt handler rain_interrupt(), the buffer full check on
rain->buf_len is performed before acquiring rain->buf_lock. This
creates a Time-of-Check to Time-of-Use (TOCTOU) race condition, as
rain->buf_len is concurrently accessed and modified in the work
handler rain_irq_work_handler() under the same lock.
Multiple interrupt invocations can race, with each reading buf_len
before it becomes full and then proceeding. This can lead to both
interrupts attempting to write to the buffer, incrementing buf_len
beyond its capacity (DATA_SIZE) and causing a buffer overflow.
Fix this bug by moving the spin_lock() to before the buffer full
check. This ensures that the check and the subsequent buffer modification
are performed atomically, preventing the race condition. An corresponding
spin_unlock() is added to the overflow path to correctly release the
lock.
This possible bug was found by an experimental static analysis tool
developed by our team.
CVSS Score
4.7
EPSS Score
0.0
Published
2025-09-05
In the Linux kernel, the following vulnerability has been resolved:
media: usbtv: Lock resolution while streaming
When an program is streaming (ffplay) and another program (qv4l2)
changes the TV standard from NTSC to PAL, the kernel crashes due to trying
to copy to unmapped memory.
Changing from NTSC to PAL increases the resolution in the usbtv struct,
but the video plane buffer isn't adjusted, so it overflows.
[hverkuil: call vb2_is_busy instead of vb2_is_streaming]
CVSS Score
5.5
EPSS Score
0.0
Published
2025-09-05
In the Linux kernel, the following vulnerability has been resolved:
ipv6: sr: Fix MAC comparison to be constant-time
To prevent timing attacks, MACs need to be compared in constant time.
Use the appropriate helper function for this.
CVSS Score
7.0
EPSS Score
0.0
Published
2025-09-05
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Destroy KFD debugfs after destroy KFD wq
Since KFD proc content was moved to kernel debugfs, we can't destroy KFD
debugfs before kfd_process_destroy_wq. Move kfd_process_destroy_wq prior
to kfd_debugfs_fini to fix a kernel NULL pointer problem. It happens
when /sys/kernel/debug/kfd was already destroyed in kfd_debugfs_fini but
kfd_process_destroy_wq calls kfd_debugfs_remove_process. This line
debugfs_remove_recursive(entry->proc_dentry);
tries to remove /sys/kernel/debug/kfd/proc/<pid> while
/sys/kernel/debug/kfd is already gone. It hangs the kernel by kernel
NULL pointer.
(cherry picked from commit 0333052d90683d88531558dcfdbf2525cc37c233)
CVSS Score
5.5
EPSS Score
0.0
Published
2025-09-05
In the Linux kernel, the following vulnerability has been resolved:
comedi: Fix use of uninitialized memory in do_insn_ioctl() and do_insnlist_ioctl()
syzbot reports a KMSAN kernel-infoleak in `do_insn_ioctl()`. A kernel
buffer is allocated to hold `insn->n` samples (each of which is an
`unsigned int`). For some instruction types, `insn->n` samples are
copied back to user-space, unless an error code is being returned. The
problem is that not all the instruction handlers that need to return
data to userspace fill in the whole `insn->n` samples, so that there is
an information leak. There is a similar syzbot report for
`do_insnlist_ioctl()`, although it does not have a reproducer for it at
the time of writing.
One culprit is `insn_rw_emulate_bits()` which is used as the handler for
`INSN_READ` or `INSN_WRITE` instructions for subdevices that do not have
a specific handler for that instruction, but do have an `INSN_BITS`
handler. For `INSN_READ` it only fills in at most 1 sample, so if
`insn->n` is greater than 1, the remaining `insn->n - 1` samples copied
to userspace will be uninitialized kernel data.
Another culprit is `vm80xx_ai_insn_read()` in the "vm80xx" driver. It
never returns an error, even if it fails to fill the buffer.
Fix it in `do_insn_ioctl()` and `do_insnlist_ioctl()` by making sure
that uninitialized parts of the allocated buffer are zeroed before
handling each instruction.
Thanks to Arnaud Lecomte for their fix to `do_insn_ioctl()`. That fix
replaced the call to `kmalloc_array()` with `kcalloc()`, but it is not
always necessary to clear the whole buffer.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-09-05
In the Linux kernel, the following vulnerability has been resolved:
comedi: pcl726: Prevent invalid irq number
The reproducer passed in an irq number(0x80008000) that was too large,
which triggered the oob.
Added an interrupt number check to prevent users from passing in an irq
number that was too large.
If `it->options[1]` is 31, then `1 << it->options[1]` is still invalid
because it shifts a 1-bit into the sign bit (which is UB in C).
Possible solutions include reducing the upper bound on the
`it->options[1]` value to 30 or lower, or using `1U << it->options[1]`.
The old code would just not attempt to request the IRQ if the
`options[1]` value were invalid. And it would still configure the
device without interrupts even if the call to `request_irq` returned an
error. So it would be better to combine this test with the test below.
CVSS Score
7.1
EPSS Score
0.0
Published
2025-09-05
In the Linux kernel, the following vulnerability has been resolved:
comedi: Make insn_rw_emulate_bits() do insn->n samples
The `insn_rw_emulate_bits()` function is used as a default handler for
`INSN_READ` instructions for subdevices that have a handler for
`INSN_BITS` but not for `INSN_READ`. Similarly, it is used as a default
handler for `INSN_WRITE` instructions for subdevices that have a handler
for `INSN_BITS` but not for `INSN_WRITE`. It works by emulating the
`INSN_READ` or `INSN_WRITE` instruction handling with a constructed
`INSN_BITS` instruction. However, `INSN_READ` and `INSN_WRITE`
instructions are supposed to be able read or write multiple samples,
indicated by the `insn->n` value, but `insn_rw_emulate_bits()` currently
only handles a single sample. For `INSN_READ`, the comedi core will
copy `insn->n` samples back to user-space. (That triggered KASAN
kernel-infoleak errors when `insn->n` was greater than 1, but that is
being fixed more generally elsewhere in the comedi core.)
Make `insn_rw_emulate_bits()` either handle `insn->n` samples, or return
an error, to conform to the general expectation for `INSN_READ` and
`INSN_WRITE` handlers.
CVSS Score
7.8
EPSS Score
0.0
Published
2025-09-05
In the Linux kernel, the following vulnerability has been resolved:
ftrace: Also allocate and copy hash for reading of filter files
Currently the reader of set_ftrace_filter and set_ftrace_notrace just adds
the pointer to the global tracer hash to its iterator. Unlike the writer
that allocates a copy of the hash, the reader keeps the pointer to the
filter hashes. This is problematic because this pointer is static across
function calls that release the locks that can update the global tracer
hashes. This can cause UAF and similar bugs.
Allocate and copy the hash for reading the filter files like it is done
for the writers. This not only fixes UAF bugs, but also makes the code a
bit simpler as it doesn't have to differentiate when to free the
iterator's hash between writers and readers.
CVSS Score
7.8
EPSS Score
0.0
Published
2025-09-05