In the Linux kernel, the following vulnerability has been resolved:
media: ipu-bridge: Fix null pointer deref on SSDB/PLD parsing warnings
When ipu_bridge_parse_rotation() and ipu_bridge_parse_orientation() run
sensor->adev is not set yet.
So if either of the dev_warn() calls about unknown values are hit this
will lead to a NULL pointer deref.
Set sensor->adev earlier, with a borrowed ref to avoid making unrolling
on errors harder, to fix this.
In the Linux kernel, the following vulnerability has been resolved:
nilfs2: do not write dirty data after degenerating to read-only
According to syzbot's report, mark_buffer_dirty() called from
nilfs_segctor_do_construct() outputs a warning with some patterns after
nilfs2 detects metadata corruption and degrades to read-only mode.
After such read-only degeneration, page cache data may be cleared through
nilfs_clear_dirty_page() which may also clear the uptodate flag for their
buffer heads. However, even after the degeneration, log writes are still
performed by unmount processing etc., which causes mark_buffer_dirty() to
be called for buffer heads without the "uptodate" flag and causes the
warning.
Since any writes should not be done to a read-only file system in the
first place, this fixes the warning in mark_buffer_dirty() by letting
nilfs_segctor_do_construct() abort early if in read-only mode.
This also changes the retry check of nilfs_segctor_write_out() to avoid
unnecessary log write retries if it detects -EROFS that
nilfs_segctor_do_construct() returned.
In the Linux kernel, the following vulnerability has been resolved:
lwt: Fix return values of BPF xmit ops
BPF encap ops can return different types of positive values, such like
NET_RX_DROP, NET_XMIT_CN, NETDEV_TX_BUSY, and so on, from function
skb_do_redirect and bpf_lwt_xmit_reroute. At the xmit hook, such return
values would be treated implicitly as LWTUNNEL_XMIT_CONTINUE in
ip(6)_finish_output2. When this happens, skbs that have been freed would
continue to the neighbor subsystem, causing use-after-free bug and
kernel crashes.
To fix the incorrect behavior, skb_do_redirect return values can be
simply discarded, the same as tc-egress behavior. On the other hand,
bpf_lwt_xmit_reroute returns useful errors to local senders, e.g. PMTU
information. Thus convert its return values to avoid the conflict with
LWTUNNEL_XMIT_CONTINUE.
In the Linux kernel, the following vulnerability has been resolved:
pstore/ram: Check start of empty przs during init
After commit 30696378f68a ("pstore/ram: Do not treat empty buffers as
valid"), initialization would assume a prz was valid after seeing that
the buffer_size is zero (regardless of the buffer start position). This
unchecked start value means it could be outside the bounds of the buffer,
leading to future access panics when written to:
sysdump_panic_event+0x3b4/0x5b8
atomic_notifier_call_chain+0x54/0x90
panic+0x1c8/0x42c
die+0x29c/0x2a8
die_kernel_fault+0x68/0x78
__do_kernel_fault+0x1c4/0x1e0
do_bad_area+0x40/0x100
do_translation_fault+0x68/0x80
do_mem_abort+0x68/0xf8
el1_da+0x1c/0xc0
__raw_writeb+0x38/0x174
__memcpy_toio+0x40/0xac
persistent_ram_update+0x44/0x12c
persistent_ram_write+0x1a8/0x1b8
ramoops_pstore_write+0x198/0x1e8
pstore_console_write+0x94/0xe0
...
To avoid this, also check if the prz start is 0 during the initialization
phase. If not, the next prz sanity check case will discover it (start >
size) and zap the buffer back to a sane state.
[kees: update commit log with backtrace and clarifications]
In the Linux kernel, the following vulnerability has been resolved:
netfilter: conntrack: dccp: copy entire header to stack buffer, not just basic one
Eric Dumazet says:
nf_conntrack_dccp_packet() has an unique:
dh = skb_header_pointer(skb, dataoff, sizeof(_dh), &_dh);
And nothing more is 'pulled' from the packet, depending on the content.
dh->dccph_doff, and/or dh->dccph_x ...)
So dccp_ack_seq() is happily reading stuff past the _dh buffer.
BUG: KASAN: stack-out-of-bounds in nf_conntrack_dccp_packet+0x1134/0x11c0
Read of size 4 at addr ffff000128f66e0c by task syz-executor.2/29371
[..]
Fix this by increasing the stack buffer to also include room for
the extra sequence numbers and all the known dccp packet type headers,
then pull again after the initial validation of the basic header.
While at it, mark packets invalid that lack 48bit sequence bit but
where RFC says the type MUST use them.
Compile tested only.
v2: first skb_header_pointer() now needs to adjust the size to
only pull the generic header. (Eric)
Heads-up: I intend to remove dccp conntrack support later this year.
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211_hwsim: drop short frames
While technically some control frames like ACK are shorter and
end after Address 1, such frames shouldn't be forwarded through
wmediumd or similar userspace, so require the full 3-address
header to avoid accessing invalid memory if shorter frames are
passed in.
In the Linux kernel, the following vulnerability has been resolved:
scsi: qla2xxx: Wait for io return on terminate rport
System crash due to use after free.
Current code allows terminate_rport_io to exit before making
sure all IOs has returned. For FCP-2 device, IO's can hang
on in HW because driver has not tear down the session in FW at
first sign of cable pull. When dev_loss_tmo timer pops,
terminate_rport_io is called and upper layer is about to
free various resources. Terminate_rport_io trigger qla to do
the final cleanup, but the cleanup might not be fast enough where it
leave qla still holding on to the same resource.
Wait for IO's to return to upper layer before resources are freed.
In the Linux kernel, the following vulnerability has been resolved:
ext2/dax: Fix ext2_setsize when len is page aligned
PAGE_ALIGN(x) macro gives the next highest value which is multiple of
pagesize. But if x is already page aligned then it simply returns x.
So, if x passed is 0 in dax_zero_range() function, that means the
length gets passed as 0 to ->iomap_begin().
In ext2 it then calls ext2_get_blocks -> max_blocks as 0 and hits bug_on
here in ext2_get_blocks().
BUG_ON(maxblocks == 0);
Instead we should be calling dax_truncate_page() here which takes
care of it. i.e. it only calls dax_zero_range if the offset is not
page/block aligned.
This can be easily triggered with following on fsdax mounted pmem
device.
dd if=/dev/zero of=file count=1 bs=512
truncate -s 0 file
[79.525838] EXT2-fs (pmem0): DAX enabled. Warning: EXPERIMENTAL, use at your own risk
[79.529376] ext2 filesystem being mounted at /mnt1/test supports timestamps until 2038 (0x7fffffff)
[93.793207] ------------[ cut here ]------------
[93.795102] kernel BUG at fs/ext2/inode.c:637!
[93.796904] invalid opcode: 0000 [#1] PREEMPT SMP PTI
[93.798659] CPU: 0 PID: 1192 Comm: truncate Not tainted 6.3.0-rc2-xfstests-00056-g131086faa369 #139
[93.806459] RIP: 0010:ext2_get_blocks.constprop.0+0x524/0x610
<...>
[93.835298] Call Trace:
[93.836253] <TASK>
[93.837103] ? lock_acquire+0xf8/0x110
[93.838479] ? d_lookup+0x69/0xd0
[93.839779] ext2_iomap_begin+0xa7/0x1c0
[93.841154] iomap_iter+0xc7/0x150
[93.842425] dax_zero_range+0x6e/0xa0
[93.843813] ext2_setsize+0x176/0x1b0
[93.845164] ext2_setattr+0x151/0x200
[93.846467] notify_change+0x341/0x4e0
[93.847805] ? lock_acquire+0xf8/0x110
[93.849143] ? do_truncate+0x74/0xe0
[93.850452] ? do_truncate+0x84/0xe0
[93.851739] do_truncate+0x84/0xe0
[93.852974] do_sys_ftruncate+0x2b4/0x2f0
[93.854404] do_syscall_64+0x3f/0x90
[93.855789] entry_SYSCALL_64_after_hwframe+0x72/0xdc
In the Linux kernel, the following vulnerability has been resolved:
drm/msm/mdp5: Don't leak some plane state
Apparently no one noticed that mdp5 plane states leak like a sieve
ever since we introduced plane_state->commit refcount a few years ago
in 21a01abbe32a ("drm/atomic: Fix freeing connector/plane state too
early by tracking commits, v3.")
Fix it by using the right helpers.
Patchwork: https://patchwork.freedesktop.org/patch/551236/