In the Linux kernel, the following vulnerability has been resolved:
xen/privcmd: restrict usage in unprivileged domU
The Xen privcmd driver allows to issue arbitrary hypercalls from
user space processes. This is normally no problem, as access is
usually limited to root and the hypervisor will deny any hypercalls
affecting other domains.
In case the guest is booted using secure boot, however, the privcmd
driver would be enabling a root user process to modify e.g. kernel
memory contents, thus breaking the secure boot feature.
The only known case where an unprivileged domU is really needing to
use the privcmd driver is the case when it is acting as the device
model for another guest. In this case all hypercalls issued via the
privcmd driver will target that other guest.
Fortunately the privcmd driver can already be locked down to allow
only hypercalls targeting a specific domain, but this mode can be
activated from user land only today.
The target domain can be obtained from Xenstore, so when not running
in dom0 restrict the privcmd driver to that target domain from the
beginning, resolving the potential problem of breaking secure boot.
This is XSA-482
---
V2:
- defer reading from Xenstore if Xenstore isn't ready yet (Jan Beulich)
- wait in open() if target domain isn't known yet
- issue message in case no target domain found (Jan Beulich)
In the Linux kernel, the following vulnerability has been resolved:
pinctrl: cirrus: cs42l43: Fix double-put in cs42l43_pin_probe()
devm_add_action_or_reset() already invokes the action on failure,
so the explicit put causes a double-put.
In the Linux kernel, the following vulnerability has been resolved:
Squashfs: check metadata block offset is within range
Syzkaller reports a "general protection fault in squashfs_copy_data"
This is ultimately caused by a corrupted index look-up table, which
produces a negative metadata block offset.
This is subsequently passed to squashfs_copy_data (via
squashfs_read_metadata) where the negative offset causes an out of bounds
access.
The fix is to check that the offset is within range in
squashfs_read_metadata. This will trap this and other cases.
In the Linux kernel, the following vulnerability has been resolved:
ice: Fix memory leak in ice_set_ringparam()
In ice_set_ringparam, tx_rings and xdp_rings are allocated before
rx_rings. If the allocation of rx_rings fails, the code jumps to
the done label leaking both tx_rings and xdp_rings. Furthermore, if
the setup of an individual Rx ring fails during the loop, the code jumps
to the free_tx label which releases tx_rings but leaks xdp_rings.
Fix this by introducing a free_xdp label and updating the error paths to
ensure both xdp_rings and tx_rings are properly freed if rx_rings
allocation or setup fails.
Compile tested only. Issue found using a prototype static analysis tool
and code review.
In the Linux kernel, the following vulnerability has been resolved:
tracing/dma: Cap dma_map_sg tracepoint arrays to prevent buffer overflow
The dma_map_sg tracepoint can trigger a perf buffer overflow when
tracing large scatter-gather lists. With devices like virtio-gpu
creating large DRM buffers, nents can exceed 1000 entries, resulting
in:
phys_addrs: 1000 * 8 bytes = 8,000 bytes
dma_addrs: 1000 * 8 bytes = 8,000 bytes
lengths: 1000 * 4 bytes = 4,000 bytes
Total: ~20,000 bytes
This exceeds PERF_MAX_TRACE_SIZE (8192 bytes), causing:
WARNING: CPU: 0 PID: 5497 at kernel/trace/trace_event_perf.c:405
perf buffer not large enough, wanted 24620, have 8192
Cap all three dynamic arrays at 128 entries using min() in the array
size calculation. This ensures arrays are only as large as needed
(up to the cap), avoiding unnecessary memory allocation for small
operations while preventing overflow for large ones.
The tracepoint now records the full nents/ents counts and a truncated
flag so users can see when data has been capped.
Changes in v2:
- Use min(nents, DMA_TRACE_MAX_ENTRIES) for dynamic array sizing
instead of fixed DMA_TRACE_MAX_ENTRIES allocation (feedback from
Steven Rostedt)
- This allocates only what's needed up to the cap, avoiding waste
for small operations
Reviwed-by: Sean Anderson <sean.anderson@linux.dev>
In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_CT: drop pending enqueued packets on template removal
Templates refer to objects that can go away while packets are sitting in
nfqueue refer to:
- helper, this can be an issue on module removal.
- timeout policy, nfnetlink_cttimeout might remove it.
The use of templates with zone and event cache filter are safe, since
this just copies values.
Flush these enqueued packets in case the template rule gets removed.
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_tables: release flowtable after rcu grace period on error
Call synchronize_rcu() after unregistering the hooks from error path,
since a hook that already refers to this flowtable can be already
registered, exposing this flowtable to packet path and nfnetlink_hook
control plane.
This error path is rare, it should only happen by reaching the maximum
number hooks or by failing to set up to hardware offload, just call
synchronize_rcu().
There is a check for already used device hooks by different flowtable
that could result in EEXIST at this late stage. The hook parser can be
updated to perform this check earlier to this error path really becomes
rarely exercised.
Uncovered by KASAN reported as use-after-free from nfnetlink_hook path
when dumping hooks.
In the Linux kernel, the following vulnerability has been resolved:
tracing: Fix WARN_ON in tracing_buffers_mmap_close
When a process forks, the child process copies the parent's VMAs but the
user_mapped reference count is not incremented. As a result, when both the
parent and child processes exit, tracing_buffers_mmap_close() is called
twice. On the second call, user_mapped is already 0, causing the function to
return -ENODEV and triggering a WARN_ON.
Normally, this isn't an issue as the memory is mapped with VM_DONTCOPY set.
But this is only a hint, and the application can call
madvise(MADVISE_DOFORK) which resets the VM_DONTCOPY flag. When the
application does that, it can trigger this issue on fork.
Fix it by incrementing the user_mapped reference count without re-mapping
the pages in the VMA's open callback.
In the Linux kernel, the following vulnerability has been resolved:
net: bridge: fix nd_tbl NULL dereference when IPv6 is disabled
When booting with the 'ipv6.disable=1' parameter, the nd_tbl is never
initialized because inet6_init() exits before ndisc_init() is called
which initializes it. Then, if neigh_suppress is enabled and an ICMPv6
Neighbor Discovery packet reaches the bridge, br_do_suppress_nd() will
dereference ipv6_stub->nd_tbl which is NULL, passing it to
neigh_lookup(). This causes a kernel NULL pointer dereference.
BUG: kernel NULL pointer dereference, address: 0000000000000268
Oops: 0000 [#1] PREEMPT SMP NOPTI
[...]
RIP: 0010:neigh_lookup+0x16/0xe0
[...]
Call Trace:
<IRQ>
? neigh_lookup+0x16/0xe0
br_do_suppress_nd+0x160/0x290 [bridge]
br_handle_frame_finish+0x500/0x620 [bridge]
br_handle_frame+0x353/0x440 [bridge]
__netif_receive_skb_core.constprop.0+0x298/0x1110
__netif_receive_skb_one_core+0x3d/0xa0
process_backlog+0xa0/0x140
__napi_poll+0x2c/0x170
net_rx_action+0x2c4/0x3a0
handle_softirqs+0xd0/0x270
do_softirq+0x3f/0x60
Fix this by replacing IS_ENABLED(IPV6) call with ipv6_mod_enabled() in
the callers. This is in essence disabling NS/NA suppression when IPv6 is
disabled.
In the Linux kernel, the following vulnerability has been resolved:
HID: Add HID_CLAIMED_INPUT guards in raw_event callbacks missing them
In commit 2ff5baa9b527 ("HID: appleir: Fix potential NULL dereference at
raw event handle"), we handle the fact that raw event callbacks
can happen even for a HID device that has not been "claimed" causing a
crash if a broken device were attempted to be connected to the system.
Fix up the remaining in-tree HID drivers that forgot to add this same
check to resolve the same issue.