Vulnerabilities
Vulnerable Software
Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved: zram: do not forget to endio for partial discard requests As reported by Qu Wenruo and Avinesh Kumar, the following getconf PAGESIZE 65536 blkdiscard -p 4k /dev/zram0 takes literally forever to complete. zram doesn't support partial discards and just returns immediately w/o doing any discard work in such cases. The problem is that we forget to endio on our way out, so blkdiscard sleeps forever in submit_bio_wait(). Fix this by jumping to end_bio label, which does bio_endio().
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved: ALSA: aloop: Fix peer runtime UAF during format-change stop loopback_check_format() may stop the capture side when playback starts with parameters that no longer match a running capture stream. Commit 826af7fa62e3 ("ALSA: aloop: Fix racy access at PCM trigger") moved the peer lookup under cable->lock, but the actual snd_pcm_stop() still runs after dropping that lock. A concurrent close can clear the capture entry from cable->streams[] and detach or free its runtime while the playback trigger path still holds a stale peer substream pointer. Keep a per-cable count of in-flight peer stops before dropping cable->lock, and make free_cable() wait for those stops before detaching the runtime. This preserves the existing behavior while making the peer runtime lifetime explicit.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved: media: rc: igorplugusb: heed coherency rules In a control request, the USB request structure can be subject to DMA on some HCs. Hence it must obey the rules for DMA coherency. Allocate it separately.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved: wifi: rtw88: check for PCI upstream bridge existence pci_upstream_bridge() returns NULL if the device is on a root bus. If 8821CE is installed in the system with such a PCI topology, the probing routine will crash. This has probably been unnoticed as 8821CE is mostly supplied in laptops where there is a PCI-to-PCI bridge located upstream from the device. However the card might be installed on a system with different configuration. Check if the bridge does exist for the specific workaround to be applied. Found by Linux Verification Center (linuxtesting.org) with Svace static analysis tool.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved: mm/vmalloc: take vmap_purge_lock in shrinker decay_va_pool_node() can be invoked concurrently from two paths: __purge_vmap_area_lazy() when pools are being purged, and the shrinker via vmap_node_shrink_scan(). However, decay_va_pool_node() is not safe to run concurrently, and the shrinker path currently lacks serialization, leading to races and possible leaks. Protect decay_va_pool_node() by taking vmap_purge_lock in the shrinker path to ensure serialization with purge users.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved: ext4: fix bounds check in check_xattrs() to prevent out-of-bounds access The bounds check for the next xattr entry in check_xattrs() uses (void *)next >= end, which allows next to point within sizeof(u32) bytes of end. On the next loop iteration, IS_LAST_ENTRY() reads 4 bytes via *(__u32 *)(entry), which can overrun the valid xattr region. For example, if next lands at end - 1, the check passes since next < end, but IS_LAST_ENTRY() reads 4 bytes starting at end - 1, accessing 3 bytes beyond the valid region. Fix this by changing the check to (void *)next + sizeof(u32) > end, ensuring there is always enough space for the IS_LAST_ENTRY() read on the subsequent iteration.
CVSS Score
7.1
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved: crypto: atmel-tdes - fix DMA sync direction Before DMA output is consumed by the CPU, ->dma_addr_out must be synced with dma_sync_single_for_cpu() instead of dma_sync_single_for_device(). Using the wrong direction can return stale cache data on non-coherent platforms.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved: erofs: fix the out-of-bounds nameoff handling for trailing dirents Currently we already have boundary-checks for nameoffs, but the trailing dirents are special since the namelens are calculated with strnlen() with unchecked nameoffs. If a crafted EROFS has a trailing dirent with nameoff >= maxsize, maxsize - nameoff can underflow, causing strnlen() to read past the directory block. nameoff0 should also be verified to be a multiple of `sizeof(struct erofs_dirent)` as well [1]. [1] https://sashiko.dev/#/patchset/20260416063511.3173774-1-hsiangkao%40linux.alibaba.com
CVSS Score
7.1
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved: rbd: fix null-ptr-deref when device_add_disk() fails do_rbd_add() publishes the device with device_add() before calling device_add_disk(). If device_add_disk() fails after device_add() succeeds, the error path calls rbd_free_disk() directly and then later falls through to rbd_dev_device_release(), which calls rbd_free_disk() again. This double teardown can leave blk-mq cleanup operating on invalid state and trigger a null-ptr-deref in __blk_mq_free_map_and_rqs(), reached from blk_mq_free_tag_set(). Fix this by following the normal remove ordering: call device_del() before rbd_dev_device_release() when device_add_disk() fails after device_add(). That keeps the teardown sequence consistent and avoids re-entering disk cleanup through the wrong path. The bug was first flagged by an experimental analysis tool we are developing for kernel memory-management bugs while analyzing v6.13-rc1. The tool is still under development and is not yet publicly available. We reproduced the bug on v7.0 with a real Ceph backend and a QEMU x86_64 guest booted with KASAN and CONFIG_FAILSLAB enabled. The reproducer confines failslab injections to the __add_disk() range and injects fail-nth while mapping an RBD image through /sys/bus/rbd/add_single_major. On the unpatched kernel, fail-nth=4 reliably triggered the fault: Oops: general protection fault, probably for non-canonical address 0xdffffc0000000000: 0000 [#1] SMP KASAN NOPTI KASAN: null-ptr-deref in range [0x0000000000000000-0x0000000000000007] CPU: 0 UID: 0 PID: 273 Comm: bash Not tainted 7.0.0-01247-gd60bc1401583 #6 PREEMPT(lazy) Hardware name: QEMU Standard PC (Q35 + ICH9, 2009), BIOS 1.15.0-1 04/01/2014 RIP: 0010:__blk_mq_free_map_and_rqs+0x8c/0x240 Code: 00 00 48 8b 6b 60 41 89 f4 49 c1 e4 03 4c 01 e5 45 85 ed 0f 85 0a 01 00 00 48 b8 00 00 00 00 00 fc ff df 48 89 e9 48 c1 e9 03 <80> 3c 01 00 0f 85 31 01 00 00 4c 8b 6d 00 4d 85 ed 0f 84 e2 00 00 RSP: 0018:ff1100000ab0fac8 EFLAGS: 00000246 RAX: dffffc0000000000 RBX: ff1100000c4806a0 RCX: 0000000000000000 RDX: 0000000000000002 RSI: 0000000000000000 RDI: ff1100000c4806f4 RBP: 0000000000000000 R08: 0000000000000001 R09: ffe21c000189001b R10: ff1100000c4800df R11: ff1100006cf37be0 R12: 0000000000000000 R13: 0000000000000000 R14: ff1100000c480700 R15: ff1100000c480004 FS: 00007f0fbe8fe740(0000) GS:ff110000e5851000(0000) knlGS:0000000000000000 CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033 CR2: 00007fe53473b2e0 CR3: 0000000012eef000 CR4: 00000000007516f0 PKRU: 55555554 Call Trace: <TASK> blk_mq_free_tag_set+0x77/0x460 do_rbd_add+0x1446/0x2b80 ? __pfx_do_rbd_add+0x10/0x10 ? lock_acquire+0x18c/0x300 ? find_held_lock+0x2b/0x80 ? sysfs_file_kobj+0xb6/0x1b0 ? __pfx_sysfs_kf_write+0x10/0x10 kernfs_fop_write_iter+0x2f4/0x4a0 vfs_write+0x98e/0x1000 ? expand_files+0x51f/0x850 ? __pfx_vfs_write+0x10/0x10 ksys_write+0xf2/0x1d0 ? __pfx_ksys_write+0x10/0x10 do_syscall_64+0x115/0x690 entry_SYSCALL_64_after_hwframe+0x77/0x7f RIP: 0033:0x7f0fbea15907 Code: 10 00 f7 d8 64 89 02 48 c7 c0 ff ff ff ff eb b7 0f 1f 00 f3 0f 1e fa 64 8b 04 25 18 00 00 00 85 c0 75 10 b8 01 00 00 00 0f 05 <48> 3d 00 f0 ff ff 77 51 c3 48 83 ec 28 48 89 54 24 18 48 89 74 24 RSP: 002b:00007ffe22346ea8 EFLAGS: 00000246 ORIG_RAX: 0000000000000001 RAX: ffffffffffffffda RBX: 0000000000000058 RCX: 00007f0fbea15907 RDX: 0000000000000058 RSI: 0000563ace6c0ef0 RDI: 0000000000000001 RBP: 0000563ace6c0ef0 R08: 0000563ace6c0ef0 R09: 6b6435726d694141 R10: 5250337279762f78 R11: 0000000000000246 R12: 0000000000000058 R13: 00007f0fbeb1c780 R14: ff1100000c480700 R15: ff1100000c480004 </TASK> With this fix applied, rerunning the reproducer over fail-nth=1..256 yields no KASAN reports. [ idryomov: rename err_out_device_del -> err_out_device ]
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved: ocfs2: split transactions in dio completion to avoid credit exhaustion During ocfs2 dio operations, JBD2 may report warnings via following call trace: ocfs2_dio_end_io_write ocfs2_mark_extent_written ocfs2_change_extent_flag ocfs2_split_extent ocfs2_try_to_merge_extent ocfs2_extend_rotate_transaction ocfs2_extend_trans jbd2__journal_restart start_this_handle output: JBD2: kworker/6:2 wants too many credits credits:5450 rsv_credits:0 max:5449 To prevent exceeding the credits limit, modify ocfs2_dio_end_io_write() to handle extents in a batch of transaction. Additionally, relocate ocfs2_del_inode_from_orphan(). The orphan inode should only be removed from the orphan list after the extent tree update is complete. This ensures that if a crash occurs in the middle of extent tree updates, we won't leave stale blocks beyond EOF. This patch also changes the logic for updating the inode size and removing orphan, making it similar to ext4_dio_write_end_io(). Both operations are performed only when everything looks good. Finally, thanks to Jans and Joseph for providing the bug fix prototype and suggestions.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27


Contact Us

Shodan ® - All rights reserved