Linux: >> Linux Kernel >> 2.6.32.22 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
fbdev: defio: Disconnect deferred I/O from the lifetime of struct fb_info
Hold state of deferred I/O in struct fb_deferred_io_state. Allocate an
instance as part of initializing deferred I/O and remove it only after
the final mapping has been closed. If the fb_info and the contained
deferred I/O meanwhile goes away, clear struct fb_deferred_io_state.info
to invalidate the mapping. Any access will then result in a SIGBUS
signal.
Fixes a long-standing problem, where a device hot-unplug happens while
user space still has an active mapping of the graphics memory. The hot-
unplug frees the instance of struct fb_info. Accessing the memory will
operate on undefined state.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
ibmasm: fix heap over-read in ibmasm_send_i2o_message()
The ibmasm_send_i2o_message() function uses get_dot_command_size() to
compute the byte count for memcpy_toio(), but this value is derived from
user-controlled fields in the dot_command_header (command_size: u8,
data_size: u16) and is never validated against the actual allocation size.
A root user can write a small buffer with inflated header fields, causing
memcpy_toio() to read up to ~65 KB past the end of the allocation into
adjacent kernel heap, which is then forwarded to the service processor
over MMIO.
Silently clamping the copy size is not sufficient: if the header fields
claim a larger size than the buffer, the SP receives a dot command whose
own header is inconsistent with the I2O message length, which can cause
the SP to desynchronize. Reject such commands outright by returning
failure.
Validate command_size before calling get_mfa_inbound() to avoid leaking
an I2O message frame: reading INBOUND_QUEUE_PORT dequeues a hardware
frame from the controller's free pool, and returning without a
corresponding set_mfa_inbound() call would permanently exhaust it.
Additionally, clamp command_size to I2O_COMMAND_SIZE before the
memcpy_toio() so the MMIO write stays within the I2O message frame,
consistent with the clamping already performed by outgoing_message_size()
for the header field.
CVSS Score
7.1
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
ALSA: ctxfi: Add fallback to default RSR for S/PDIF
spdif_passthru_playback_get_resources() uses atc->pll_rate as the RSR
for the MSR calculation loop. However, pll_rate is only updated in
atc_pll_init() and not in hw_pll_init(), so it remains 0 after the
card init.
When spdif_passthru_playback_setup() skips atc_pll_init() for
32000 Hz, (rsr * desc.msr) always becomes 0, causing the loop to spin
indefinitely.
Add fallback to use atc->rsr when atc->pll_rate is 0. This reflects
the hardware state, since hw_card_init() already configures the PLL
to the default RSR.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
mm: fix deferred split queue races during migration
migrate_folio_move() records the deferred split queue state from src and
replays it on dst. Replaying it after remove_migration_ptes(src, dst, 0)
makes dst visible before it is requeued, so a concurrent rmap-removal path
can mark dst partially mapped and trip the WARN in deferred_split_folio().
Move the requeue before remove_migration_ptes() so dst is back on the
deferred split queue before it becomes visible again.
Because migration still holds dst locked at that point, teach
deferred_split_scan() to requeue a folio when folio_trylock() fails.
Otherwise a fully mapped underused folio can be dequeued by the shrinker
and silently lost from split_queue.
[ziy@nvidia.com: move the comment]
CVSS Score
4.7
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
misc: ibmasm: fix OOB MMIO read in ibmasm_handle_mouse_interrupt()
ibmasm_handle_mouse_interrupt() performs an out-of-bounds MMIO read
when the queue reader or writer index from hardware exceeds
REMOTE_QUEUE_SIZE (60).
A compromised service processor can trigger this by writing an
out-of-range value to the reader or writer MMIO register before
asserting an interrupt. Since writer is re-read from hardware on
every loop iteration, it can also be set to an out-of-range value
after the loop has already started.
The root cause is that get_queue_reader() and get_queue_writer() return
raw readl() values that are passed directly into get_queue_entry(),
which computes:
queue_begin + reader * sizeof(struct remote_input)
with no bounds check. This unchecked MMIO address is then passed to
memcpy_fromio(), reading 8 bytes from unintended device registers.
For sufficiently large values the address falls outside the PCI BAR
mapping entirely, triggering a machine check exception.
Fix by checking both indices against REMOTE_QUEUE_SIZE at the top of
the loop body, before any call to get_queue_entry(). On an out-of-range
value, reset the reader register to 0 via set_queue_reader() before
breaking, so that normal queue operation can resume if the corrupted
hardware state is transient.
CVSS Score
7.1
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
dm mirror: fix integer overflow in create_dirty_log()
The argument count calculation in create_dirty_log() performs
`*args_used = 2 + param_count` before validating against argc. When a
user provides a param_count close to UINT_MAX via the device mapper
table string, this unsigned addition wraps around to a small value,
causing the subsequent `argc < *args_used` check to be bypassed.
The overflowed param_count is then passed as argc to dm_dirty_log_create(),
where it can cause out-of-bounds reads on the argv array.
Fix by comparing param_count against argc - 2 before performing the
addition, following the same pattern used by parse_features() in the
same file. Since argc >= 2 is already guaranteed, the subtraction is
safe.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
KVM: SVM: Add missing save/restore handling of LBR MSRs
MSR_IA32_DEBUGCTLMSR and LBR MSRs are currently not enumerated by
KVM_GET_MSR_INDEX_LIST, and LBR MSRs cannot be set with KVM_SET_MSRS. So
save/restore is completely broken.
Fix it by adding the MSRs to msrs_to_save_base, and allowing writes to
LBR MSRs from userspace only (as they are read-only MSRs) if LBR
virtualization is enabled. Additionally, to correctly restore L1's LBRs
while L2 is running, make sure the LBRs are copied from the captured
VMCB01 save area in svm_copy_vmrun_state().
Note, for VMX, this also fixes a flaw where MSR_IA32_DEBUGCTLMSR isn't
reported as an MSR to save/restore.
Note #2, over-reporting MSR_IA32_LASTxxx on Intel is ok, as KVM already
handles unsupported reads and writes thanks to commit b5e2fec0ebc3 ("KVM:
Ignore DEBUGCTL MSRs with no effect") (kvm_do_msr_access() will morph the
unsupported userspace write into a nop).
[sean: guard with lbrv checks, massage changelog]
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
ALSA: caiaq: Handle probe errors properly
The probe procedure of setup_card() in caiaq driver doesn't treat the
error cases gracefully, e.g. the error from snd_card_register() calls
snd_card_free() but continues. This would lead to a UAF for the
further calls like snd_usb_caiaq_control_init(), as Berk suggested in
another patch in the link below.
However, the problem is not only that; in general, this function drops
the all error handlings (as it's a void function) although its caller
can propagate an error to snd_probe(), which eventually calls
snd_card_free() as a proper error path. That said, we should treat
each error case in setup_card(), and just return the error code
promptly, which is then handled later as a fatal error in snd_probe().
This patch achieves it by changing the setup_card() to return an error
code. Also, the superfluous snd_card_free() call is removed, too.
Note that card->private_free can be set still safely at returning an
error. All called functions in card_free() have checks of the
unassigned resources or NULL checks.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
rxrpc: Fix conn-level packet handling to unshare RESPONSE packets
The security operations that verify the RESPONSE packets decrypt bits of it
in place - however, the sk_buff may be shared with a packet sniffer, which
would lead to the sniffer seeing an apparently corrupt packet (actually
decrypted).
Fix this by handing a copy of the packet off to the specific security
handler if the packet was cloned.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
ext2: reject inodes with zero i_nlink and valid mode in ext2_iget()
ext2_iget() already rejects inodes with i_nlink == 0 when i_mode is
zero or i_dtime is set, treating them as deleted. However, the case of
i_nlink == 0 with a non-zero mode and zero dtime slips through. Since
ext2 has no orphan list, such a combination can only result from
filesystem corruption - a legitimate inode deletion always sets either
i_dtime or clears i_mode before freeing the inode.
A crafted image can exploit this gap to present such an inode to the
VFS, which then triggers WARN_ON inside drop_nlink() (fs/inode.c) via
ext2_unlink(), ext2_rename() and ext2_rmdir():
WARNING: CPU: 3 PID: 609 at fs/inode.c:336 drop_nlink+0xad/0xd0 fs/inode.c:336
CPU: 3 UID: 0 PID: 609 Comm: syz-executor Not tainted 6.12.77+ #1
Call Trace:
<TASK>
inode_dec_link_count include/linux/fs.h:2518 [inline]
ext2_unlink+0x26c/0x300 fs/ext2/namei.c:295
vfs_unlink+0x2fc/0x9b0 fs/namei.c:4477
do_unlinkat+0x53e/0x730 fs/namei.c:4541
__x64_sys_unlink+0xc6/0x110 fs/namei.c:4587
do_syscall_64+0xf5/0x220 arch/x86/entry/common.c:78
entry_SYSCALL_64_after_hwframe+0x77/0x7f
</TASK>
WARNING: CPU: 0 PID: 646 at fs/inode.c:336 drop_nlink+0xad/0xd0 fs/inode.c:336
CPU: 0 UID: 0 PID: 646 Comm: syz.0.17 Not tainted 6.12.77+ #1
Call Trace:
<TASK>
inode_dec_link_count include/linux/fs.h:2518 [inline]
ext2_rename+0x35e/0x850 fs/ext2/namei.c:374
vfs_rename+0xf2f/0x2060 fs/namei.c:5021
do_renameat2+0xbe2/0xd50 fs/namei.c:5178
__x64_sys_rename+0x7e/0xa0 fs/namei.c:5223
do_syscall_64+0xf5/0x220 arch/x86/entry/common.c:78
entry_SYSCALL_64_after_hwframe+0x77/0x7f
</TASK>
WARNING: CPU: 0 PID: 634 at fs/inode.c:336 drop_nlink+0xad/0xd0 fs/inode.c:336
CPU: 0 UID: 0 PID: 634 Comm: syz-executor Not tainted 6.12.77+ #1
Call Trace:
<TASK>
inode_dec_link_count include/linux/fs.h:2518 [inline]
ext2_rmdir+0xca/0x110 fs/ext2/namei.c:311
vfs_rmdir+0x204/0x690 fs/namei.c:4348
do_rmdir+0x372/0x3e0 fs/namei.c:4407
__x64_sys_unlinkat+0xf0/0x130 fs/namei.c:4577
do_syscall_64+0xf5/0x220 arch/x86/entry/common.c:78
entry_SYSCALL_64_after_hwframe+0x77/0x7f
</TASK>
Extend the existing i_nlink == 0 check to also catch this case,
reporting the corruption via ext2_error() and returning -EFSCORRUPTED.
This rejects the inode at load time and prevents it from reaching any
of the namei.c paths.
Found by Linux Verification Center (linuxtesting.org) with Syzkaller.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27