Linux: >> Linux Kernel >> 4.19.285 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
arm64: errata: Mitigate TLBI errata on various Arm CPUs
A number of CPUs developed by Arm suffer from errata whereby a broadcast
TLBI;DSB sequence may complete before the global observation of writes
which are translated by an affected TLB entry.
These errata ONLY affect the completion of memory accesses which have
been translated by an invalidated TLB entry, and these errata DO NOT
affect the actual invalidation of TLB entries. TLB entries are removed
correctly.
This issue has been assigned CVE ID CVE-2025-10263.
To mitigate this issue, Arm recommends that software follows any
affected TLBI;DSB sequence with an additional TLBI;DSB, which will
ensure that all memory write effects affected by the first TLBI have
been globally observed. The additional TLBI can use any operation that
is broadcast to affected CPUs, and the additional DSB can use any option
that is sufficient to complete the additional TLBI.
The ARM64_WORKAROUND_REPEAT_TLBI workaround is sufficient to mitigate
the issue. Enable this workaround for affected CPUs, and update the
silicon errata documentation accordingly.
Note that due to the manner in which Arm develops IP and tracks errata,
some CPUs share a common erratum number.
CVSS Score
8.8
EPSS Score
0.001
Published
2026-07-01
In the Linux kernel, the following vulnerability has been resolved:
net: rds: clear i_sends on setup unwind
The RDS IB connection teardown path is written so it can run during
partial startup and on repeated shutdown attempts. It uses NULL
pointers to distinguish resources that are still owned from resources
that have already been released.
When rds_ib_setup_qp() fails after allocating i_sends but before
allocating i_recvs, the sends_out path frees i_sends without clearing
the pointer. A later shutdown pass can still treat that stale pointer
as a live send ring allocation.
Clear i_sends after vfree() in the error unwind path so the existing
shutdown logic continues to use the correct ownership state.
CVSS Score
9.8
EPSS Score
0.004
Published
2026-07-01
In the Linux kernel, the following vulnerability has been resolved:
slimbus: qcom-ngd-ctrl: Register callbacks after creating the ngd
When the remoteproc starts in parallel with the NGD driver being probed,
or the remoteproc is already up when the PDR lookup is being registered,
or in the theoretical event that we get an interrupt from the hardware,
these callbacks will operate on uninitialized data. This result in
issues to boot the affected boards.
One such example can be seen in the following fault, where
qcom_slim_ngd_ssr_pdr_notify() schedules work on the NULL ngd_up_work.
[ 21.858578] ------------[ cut here ]------------
[ 21.858745] WARNING: kernel/workqueue.c:2338 at __queue_work+0x5e0/0x790, CPU#2: kworker/2:2/116
...
[ 21.859251] Call trace:
[ 21.859255] __queue_work+0x5e0/0x790 (P)
[ 21.859265] queue_work_on+0x6c/0xf0
[ 21.859273] qcom_slim_ngd_ssr_pdr_notify+0x110/0x150 [slim_qcom_ngd_ctrl]
[ 21.859304] qcom_slim_ngd_ssr_notify+0x24/0x40 [slim_qcom_ngd_ctrl]
[ 21.859318] notifier_call_chain+0xa4/0x230
[ 21.859329] srcu_notifier_call_chain+0x64/0xb8
[ 21.859338] ssr_notify_start+0x40/0x78 [qcom_common]
[ 21.859355] rproc_start+0x130/0x230
[ 21.859367] rproc_boot+0x3d4/0x518
...
Move the enablement of interrupts, and the registration of SSR and PDR
until after the NGD device has been registered.
This could be further refined by moving initialization to the control
driver probe and by removing the platform driver model from the picture.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-07-01
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Use krealloc_array() in dal_vector_reserve()
[Why & How]
dal_vector_reserve() computes the allocation size as
"capacity * vector->struct_size" using uint32_t arithmetic, which can
silently wrap to a small value on overflow. This would cause krealloc to
return a smaller buffer than expected, leading to heap overflows on
subsequent vector appends.
Replace krealloc() with krealloc_array() which performs an internal
overflow check and returns NULL on wrap, preventing the issue.
(cherry picked from commit 37668568641ccc4cc1dbca4923d0a16609dd5707)
CVSS Score
7.0
EPSS Score
0.001
Published
2026-07-01
In the Linux kernel, the following vulnerability has been resolved:
agp/amd64: Fix broken error propagation in agp_amd64_probe()
A NULL pointer dereference was observed in the AMD64 AGP driver when
running in a virtualized environment (e.g. qemu/kvm) without a physical
AMD northbridge. The crash occurs in amd64_fetch_size() when attempting
to dereference the pointer returned by node_to_amd_nb(0).
The root cause of this crash is broken error propagation in
agp_amd64_probe(): When no AMD northbridges are found, cache_nbs()
correctly returns -ENODEV. However, the probe function erroneously
checks the return value against exactly -1, rather than < 0.
As a result, the hardware absence error is masked, allowing the driver
to improperly proceed with initialization. It eventually calls
agp_add_bridge(), which invokes amd64_fetch_size(). Since the hardware
does not exist, node_to_amd_nb(0) returns NULL, leading to a General
Protection Fault (GPF) when accessing its ->misc member.
Fix the issue by correcting the error check in agp_amd64_probe() to
abort properly when cache_nbs() returns any negative error code. This
prevents the driver from erroneously proceeding without hardware, thereby
avoiding the subsequent NULL pointer dereference at its source.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-06-29
In the Linux kernel, the following vulnerability has been resolved:
nilfs2: reject zero bd_oblocknr in nilfs_ioctl_mark_blocks_dirty()
nilfs_ioctl_mark_blocks_dirty() uses bd_oblocknr to detect dead blocks
by comparing it with the current block number bd_blocknr. If they differ,
the block is considered dead and skipped.
However, bd_oblocknr should never be 0 since block 0 typically stores the
primary superblock and is never a valid GC target block. A corrupted ioctl
request with bd_oblocknr set to 0 causes the comparison to incorrectly
match when the lookup returns -ENOENT and sets bd_blocknr to 0, bypassing
the dead block check and calling nilfs_bmap_mark() on a non-existent
block. This causes nilfs_btree_do_lookup() to return -ENOENT, triggering
the WARN_ON(ret == -ENOENT).
Fix this by rejecting ioctl requests with bd_oblocknr set to 0 at the
beginning of each iteration.
[ryusuke: slightly modified the commit message and comments for accuracy]
CVSS Score
5.5
EPSS Score
0.001
Published
2026-06-26
In the Linux kernel, the following vulnerability has been resolved:
ocfs2/dlm: fix off-by-one in dlm_match_regions() region comparison
The local-vs-remote region comparison loop uses '<=' instead of '<',
causing it to read one entry past the valid range of qr_regions. The
other loops in the same function correctly use '<'.
Fix the loop condition to use '<' for consistency and correctness.
CVSS Score
9.8
EPSS Score
0.004
Published
2026-06-26
In the Linux kernel, the following vulnerability has been resolved:
padata: Put CPU offline callback in ONLINE section to allow failure
syzbot reported the following warning:
DEAD callback error for CPU1
WARNING: kernel/cpu.c:1463 at _cpu_down+0x759/0x1020 kernel/cpu.c:1463, CPU#0: syz.0.1960/14614
at commit 4ae12d8bd9a8 ("Merge tag 'kbuild-fixes-7.0-2' of git://git.kernel.org/pub/scm/linux/kernel/git/kbuild/linux")
which tglx traced to padata_cpu_dead() given it's the only
sub-CPUHP_TEARDOWN_CPU callback that returns an error.
Failure isn't allowed in hotplug states before CPUHP_TEARDOWN_CPU
so move the CPU offline callback to the ONLINE section where failure is
possible.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-06-26
In the Linux kernel, the following vulnerability has been resolved:
f2fs: protect extension_list reading with sb_lock in f2fs_sbi_show()
In f2fs_sbi_show(), the extension_list, extension_count and
hot_ext_count are read without holding sbi->sb_lock. If a concurrent
sysfs store modifies the extension list via f2fs_update_extension_list(),
the show path may read inconsistent count and array contents, potentially
leading to out-of-bounds access or displaying stale data.
Fix this by holding sb_lock around the entire extension list read
and format operation.
CVSS Score
7.1
EPSS Score
0.001
Published
2026-06-26
In the Linux kernel, the following vulnerability has been resolved:
scsi: sg: Resolve soft lockup issue when opening /dev/sgX
The parameter def_reserved_size defines the default buffer size reserved
for each Sg_fd and should be restricted to a range between 0 and 1,048,576
(see https://tldp.org/HOWTO/SCSI-Generic-HOWTO/proc.html). Although the
function sg_proc_write_dressz enforces this limit, it is possible to bypass
it by directly modifying the module parameter as shown below, which then
causes a soft lockup:
echo -1 > /sys/module/sg/parameters/def_reserved_size
exec 4<> /dev/sg0
watchdog: BUG: soft lockup - CPU#5 stuck for 26 seconds! [bash:537]
Modules loaded:
CPU: 5 UID: 0 PID: 537 Command: bash, kernel version 6.19.0-rc3+ #134,
PREEMPT disabled
Hardware: QEMU Standard PC (i440FX + PIIX, 1996), BIOS version
1.16.1-2.fc37 dated 04/01/2014
...
Call Trace:
sg_build_reserve+0x5c/0xa0
sg_add_sfp+0x168/0x270
sg_open+0x16e/0x340
chrdev_open+0xbe/0x230
do_dentry_open+0x175/0x480
vfs_open+0x34/0xf0
do_open+0x265/0x3d0
path_openat+0x110/0x290
do_filp_open+0xc3/0x170
do_sys_openat2+0x71/0xe0
__x64_sys_openat+0x6d/0xa0
do_syscall_64+0x62/0x310
entry_SYSCALL_64_after_hwframe+0x76/0x7e
The fix is to use module_param_cb to validate and reject invalid values
assigned to def_reserved_size.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-06-26