In the Linux kernel, the following vulnerability has been resolved:
net: bridge: fix nd_tbl NULL dereference when IPv6 is disabled
When booting with the 'ipv6.disable=1' parameter, the nd_tbl is never
initialized because inet6_init() exits before ndisc_init() is called
which initializes it. Then, if neigh_suppress is enabled and an ICMPv6
Neighbor Discovery packet reaches the bridge, br_do_suppress_nd() will
dereference ipv6_stub->nd_tbl which is NULL, passing it to
neigh_lookup(). This causes a kernel NULL pointer dereference.
BUG: kernel NULL pointer dereference, address: 0000000000000268
Oops: 0000 [#1] PREEMPT SMP NOPTI
[...]
RIP: 0010:neigh_lookup+0x16/0xe0
[...]
Call Trace:
<IRQ>
? neigh_lookup+0x16/0xe0
br_do_suppress_nd+0x160/0x290 [bridge]
br_handle_frame_finish+0x500/0x620 [bridge]
br_handle_frame+0x353/0x440 [bridge]
__netif_receive_skb_core.constprop.0+0x298/0x1110
__netif_receive_skb_one_core+0x3d/0xa0
process_backlog+0xa0/0x140
__napi_poll+0x2c/0x170
net_rx_action+0x2c4/0x3a0
handle_softirqs+0xd0/0x270
do_softirq+0x3f/0x60
Fix this by replacing IS_ENABLED(IPV6) call with ipv6_mod_enabled() in
the callers. This is in essence disabling NS/NA suppression when IPv6 is
disabled.
In the Linux kernel, the following vulnerability has been resolved:
HID: Add HID_CLAIMED_INPUT guards in raw_event callbacks missing them
In commit 2ff5baa9b527 ("HID: appleir: Fix potential NULL dereference at
raw event handle"), we handle the fact that raw event callbacks
can happen even for a HID device that has not been "claimed" causing a
crash if a broken device were attempted to be connected to the system.
Fix up the remaining in-tree HID drivers that forgot to add this same
check to resolve the same issue.
In the Linux kernel, the following vulnerability has been resolved:
wifi: radiotap: reject radiotap with unknown bits
The radiotap parser is currently only used with the radiotap
namespace (not with vendor namespaces), but if the undefined
field 18 is used, the alignment/size is unknown as well. In
this case, iterator->_next_ns_data isn't initialized (it's
only set for skipping vendor namespaces), and syzbot points
out that we later compare against this uninitialized value.
Fix this by moving the rejection of unknown radiotap fields
down to after the in-namespace lookup, so it will really use
iterator->_next_ns_data only for vendor namespaces, even in
case undefined fields are present.
In the Linux kernel, the following vulnerability has been resolved:
net: phy: register phy led_triggers during probe to avoid AB-BA deadlock
There is an AB-BA deadlock when both LEDS_TRIGGER_NETDEV and
LED_TRIGGER_PHY are enabled:
[ 1362.049207] [<8054e4b8>] led_trigger_register+0x5c/0x1fc <-- Trying to get lock "triggers_list_lock" via down_write(&triggers_list_lock);
[ 1362.054536] [<80662830>] phy_led_triggers_register+0xd0/0x234
[ 1362.060329] [<8065e200>] phy_attach_direct+0x33c/0x40c
[ 1362.065489] [<80651fc4>] phylink_fwnode_phy_connect+0x15c/0x23c
[ 1362.071480] [<8066ee18>] mtk_open+0x7c/0xba0
[ 1362.075849] [<806d714c>] __dev_open+0x280/0x2b0
[ 1362.080384] [<806d7668>] __dev_change_flags+0x244/0x24c
[ 1362.085598] [<806d7698>] dev_change_flags+0x28/0x78
[ 1362.090528] [<807150e4>] dev_ioctl+0x4c0/0x654 <-- Hold lock "rtnl_mutex" by calling rtnl_lock();
[ 1362.094985] [<80694360>] sock_ioctl+0x2f4/0x4e0
[ 1362.099567] [<802e9c4c>] sys_ioctl+0x32c/0xd8c
[ 1362.104022] [<80014504>] syscall_common+0x34/0x58
Here LED_TRIGGER_PHY is registering LED triggers during phy_attach
while holding RTNL and then taking triggers_list_lock.
[ 1362.191101] [<806c2640>] register_netdevice_notifier+0x60/0x168 <-- Trying to get lock "rtnl_mutex" via rtnl_lock();
[ 1362.197073] [<805504ac>] netdev_trig_activate+0x194/0x1e4
[ 1362.202490] [<8054e28c>] led_trigger_set+0x1d4/0x360 <-- Hold lock "triggers_list_lock" by down_read(&triggers_list_lock);
[ 1362.207511] [<8054eb38>] led_trigger_write+0xd8/0x14c
[ 1362.212566] [<80381d98>] sysfs_kf_bin_write+0x80/0xbc
[ 1362.217688] [<8037fcd8>] kernfs_fop_write_iter+0x17c/0x28c
[ 1362.223174] [<802cbd70>] vfs_write+0x21c/0x3c4
[ 1362.227712] [<802cc0c4>] ksys_write+0x78/0x12c
[ 1362.232164] [<80014504>] syscall_common+0x34/0x58
Here LEDS_TRIGGER_NETDEV is being enabled on an LED. It first takes
triggers_list_lock and then RTNL. A classical AB-BA deadlock.
phy_led_triggers_registers() does not require the RTNL, it does not
make any calls into the network stack which require protection. There
is also no requirement the PHY has been attached to a MAC, the
triggers only make use of phydev state. This allows the call to
phy_led_triggers_registers() to be placed elsewhere. PHY probe() and
release() don't hold RTNL, so solving the AB-BA deadlock.
In the Linux kernel, the following vulnerability has been resolved:
nfc: rawsock: cancel tx_work before socket teardown
In rawsock_release(), cancel any pending tx_work and purge the write
queue before orphaning the socket. rawsock_tx_work runs on the system
workqueue and calls nfc_data_exchange which dereferences the NCI
device. Without synchronization, tx_work can race with socket and
device teardown when a process is killed (e.g. by SIGKILL), leading
to use-after-free or leaked references.
Set SEND_SHUTDOWN first so that if tx_work is already running it will
see the flag and skip transmitting, then use cancel_work_sync to wait
for any in-progress execution to finish, and finally purge any
remaining queued skbs.
In the Linux kernel, the following vulnerability has been resolved:
PCI: dwc: ep: Flush MSI-X write before unmapping its ATU entry
Endpoint drivers use dw_pcie_ep_raise_msix_irq() to raise an MSI-X
interrupt to the host using a writel(), which generates a PCI posted write
transaction. There's no completion for posted writes, so the writel() may
return before the PCI write completes. dw_pcie_ep_raise_msix_irq() also
unmaps the outbound ATU entry used for the PCI write, so the write races
with the unmap.
If the PCI write loses the race with the ATU unmap, the write may corrupt
host memory or cause IOMMU errors, e.g., these when running fio with a
larger queue depth against nvmet-pci-epf:
arm-smmu-v3 fc900000.iommu: 0x0000010000000010
arm-smmu-v3 fc900000.iommu: 0x0000020000000000
arm-smmu-v3 fc900000.iommu: 0x000000090000f040
arm-smmu-v3 fc900000.iommu: 0x0000000000000000
arm-smmu-v3 fc900000.iommu: event: F_TRANSLATION client: 0000:01:00.0 sid: 0x100 ssid: 0x0 iova: 0x90000f040 ipa: 0x0
arm-smmu-v3 fc900000.iommu: unpriv data write s1 "Input address caused fault" stag: 0x0
Flush the write by performing a readl() of the same address to ensure that
the write has reached the destination before the ATU entry is unmapped.
The same problem was solved for dw_pcie_ep_raise_msi_irq() in commit
8719c64e76bf ("PCI: dwc: ep: Cache MSI outbound iATU mapping"), but there
it was solved by dedicating an outbound iATU only for MSI. We can't do the
same for MSI-X because each vector can have a different msg_addr and the
msg_addr may be changed while the vector is masked.
[bhelgaas: commit log]
In the Linux kernel, the following vulnerability has been resolved:
net: usb: kalmia: validate USB endpoints
The kalmia driver should validate that the device it is probing has the
proper number and types of USB endpoints it is expecting before it binds
to it. If a malicious device were to not have the same urbs the driver
will crash later on when it blindly accesses these endpoints.
In the Linux kernel, the following vulnerability has been resolved:
drbd: fix "LOGIC BUG" in drbd_al_begin_io_nonblock()
Even though we check that we "should" be able to do lc_get_cumulative()
while holding the device->al_lock spinlock, it may still fail,
if some other code path decided to do lc_try_lock() with bad timing.
If that happened, we logged "LOGIC BUG for enr=...",
but still did not return an error.
The rest of the code now assumed that this request has references
for the relevant activity log extents.
The implcations are that during an active resync, mutual exclusivity of
resync versus application IO is not guaranteed. And a potential crash
at this point may not realizs that these extents could have been target
of in-flight IO and would need to be resynced just in case.
Also, once the request completes, it will give up activity log references it
does not even hold, which will trigger a BUG_ON(refcnt == 0) in lc_put().
Fix:
Do not crash the kernel for a condition that is harmless during normal
operation: also catch "e->refcnt == 0", not only "e == NULL"
when being noisy about "al_complete_io() called on inactive extent %u\n".
And do not try to be smart and "guess" whether something will work, then
be surprised when it does not.
Deal with the fact that it may or may not work. If it does not, remember a
possible "partially in activity log" state (only possible for requests that
cross extent boundaries), and return an error code from
drbd_al_begin_io_nonblock().
A latter call for the same request will then resume from where we left off.