An issue was discovered in Xen through 4.14.x. Some OSes (such as Linux, FreeBSD, and NetBSD) are processing watch events using a single thread. If the events are received faster than the thread is able to handle, they will get queued. As the queue is unbounded, a guest may be able to trigger an OOM in the backend. All systems with a FreeBSD, Linux, or NetBSD (any version) dom0 are vulnerable.
An issue was discovered in the Linux kernel through 5.10.1, as used with Xen through 4.14.x. The Linux kernel PV block backend expects the kernel thread handler to reset ring->xenblkd to NULL when stopped. However, the handler may not have time to run if the frontend quickly toggles between the states connect and disconnect. As a consequence, the block backend may re-use a pointer after it was freed. A misbehaving guest can trigger a dom0 crash by continuously connecting / disconnecting a block frontend. Privilege escalation and information leaks cannot be ruled out. This only affects systems with a Linux blkback.
An issue was discovered in Xen through 4.14.x allowing x86 HVM guest OS users to cause a denial of service (stack corruption), cause a data leak, or possibly gain privileges because of an off-by-one error. NOTE: this issue is caused by an incorrect fix for CVE-2020-27671.
Xen through 4.14.x allows guest OS administrators to obtain sensitive information (such as AES keys from outside the guest) via a side-channel attack on a power/energy monitoring interface, aka a "Platypus" attack. NOTE: there is only one logically independent fix: to change the access control for each such interface in Xen.
An issue was discovered in the Linux kernel through 5.9.1, as used with Xen through 4.14.x. Guest OS users can cause a denial of service (host OS hang) via a high rate of events to dom0, aka CID-e99502f76271.
An issue was discovered in Xen through 4.14.x. There is a lack of preemption in evtchn_reset() / evtchn_destroy(). In particular, the FIFO event channel model allows guests to have a large number of event channels active at a time. Closing all of these (when resetting all event channels or when cleaning up after the guest) may take extended periods of time. So far, there was no arrangement for preemption at suitable intervals, allowing a CPU to spend an almost unbounded amount of time in the processing of these operations. Malicious or buggy guest kernels can mount a Denial of Service (DoS) attack affecting the entire system. All Xen versions are vulnerable in principle. Whether versions 4.3 and older are vulnerable depends on underlying hardware characteristics.
An issue was discovered in Xen through 4.14.x. There are missing memory barriers when accessing/allocating an event channel. Event channels control structures can be accessed lockless as long as the port is considered to be valid. Such a sequence is missing an appropriate memory barrier (e.g., smp_*mb()) to prevent both the compiler and CPU from re-ordering access. A malicious guest may be able to cause a hypervisor crash resulting in a Denial of Service (DoS). Information leak and privilege escalation cannot be excluded. Systems running all versions of Xen are affected. Whether a system is vulnerable will depend on the CPU and compiler used to build Xen. For all systems, the presence and the scope of the vulnerability depend on the precise re-ordering performed by the compiler used to build Xen. We have not been able to survey compilers; consequently we cannot say which compiler(s) might produce vulnerable code (with which code generation options). GCC documentation clearly suggests that re-ordering is possible. Arm systems will also be vulnerable if the CPU is able to re-order memory access. Please consult your CPU vendor. x86 systems are only vulnerable if a compiler performs re-ordering.
An issue was discovered in Xen through 4.14.x. There is a race condition when migrating timers between x86 HVM vCPUs. When migrating timers of x86 HVM guests between its vCPUs, the locking model used allows for a second vCPU of the same guest (also operating on the timers) to release a lock that it didn't acquire. The most likely effect of the issue is a hang or crash of the hypervisor, i.e., a Denial of Service (DoS). All versions of Xen are affected. Only x86 systems are vulnerable. Arm systems are not vulnerable. Only x86 HVM guests can leverage the vulnerability. x86 PV and PVH cannot leverage the vulnerability. Only guests with more than one vCPU can exploit the vulnerability.
An issue was discovered in Xen through 4.14.x. The PCI passthrough code improperly uses register data. Code paths in Xen's MSI handling have been identified that act on unsanitized values read back from device hardware registers. While devices strictly compliant with PCI specifications shouldn't be able to affect these registers, experience shows that it's very common for devices to have out-of-spec "backdoor" operations that can affect the result of these reads. A not fully trusted guest may be able to crash Xen, leading to a Denial of Service (DoS) for the entire system. Privilege escalation and information leaks cannot be excluded. All versions of Xen supporting PCI passthrough are affected. Only x86 systems are vulnerable. Arm systems are not vulnerable. Only guests with passed through PCI devices may be able to leverage the vulnerability. Only systems passing through devices with out-of-spec ("backdoor") functionality can cause issues. Experience shows that such out-of-spec functionality is common; unless you have reason to believe that your device does not have such functionality, it's better to assume that it does.
An issue was discovered in Xen through 4.13.x, allowing Intel guest OS users to gain privileges or cause a denial of service because of non-atomic modification of a live EPT PTE. When mapping guest EPT (nested paging) tables, Xen would in some circumstances use a series of non-atomic bitfield writes. Depending on the compiler version and optimisation flags, Xen might expose a dangerous partially written PTE to the hardware, which an attacker might be able to race to exploit. A guest administrator or perhaps even an unprivileged guest user might be able to cause denial of service, data corruption, or privilege escalation. Only systems using Intel CPUs are vulnerable. Systems using AMD CPUs, and Arm systems, are not vulnerable. Only systems using nested paging (hap, aka nested paging, aka in this case Intel EPT) are vulnerable. Only HVM and PVH guests can exploit the vulnerability. The presence and scope of the vulnerability depends on the precise optimisations performed by the compiler used to build Xen. If the compiler generates (a) a single 64-bit write, or (b) a series of read-modify-write operations in the same order as the source code, the hypervisor is not vulnerable. For example, in one test build using GCC 8.3 with normal settings, the compiler generated multiple (unlocked) read-modify-write operations in source-code order, which did not constitute a vulnerability. We have not been able to survey compilers; consequently we cannot say which compiler(s) might produce vulnerable code (with which code-generation options). The source code clearly violates the C rules, and thus should be considered vulnerable.