Linux: >> Linux Kernel >> 3.16.77 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix use-after-free in cifs_oplock_break
A race condition can occur in cifs_oplock_break() leading to a
use-after-free of the cinode structure when unmounting:
cifs_oplock_break()
_cifsFileInfo_put(cfile)
cifsFileInfo_put_final()
cifs_sb_deactive()
[last ref, start releasing sb]
kill_sb()
kill_anon_super()
generic_shutdown_super()
evict_inodes()
dispose_list()
evict()
destroy_inode()
call_rcu(&inode->i_rcu, i_callback)
spin_lock(&cinode->open_file_lock) <- OK
[later] i_callback()
cifs_free_inode()
kmem_cache_free(cinode)
spin_unlock(&cinode->open_file_lock) <- UAF
cifs_done_oplock_break(cinode) <- UAF
The issue occurs when umount has already released its reference to the
superblock. When _cifsFileInfo_put() calls cifs_sb_deactive(), this
releases the last reference, triggering the immediate cleanup of all
inodes under RCU. However, cifs_oplock_break() continues to access the
cinode after this point, resulting in use-after-free.
Fix this by holding an extra reference to the superblock during the
entire oplock break operation. This ensures that the superblock and
its inodes remain valid until the oplock break completes.
CVSS Score
7.8
EPSS Score
0.0
Published
2025-08-16
In the Linux kernel, the following vulnerability has been resolved:
comedi: pcl812: Fix bit shift out of bounds
When checking for a supported IRQ number, the following test is used:
if ((1 << it->options[1]) & board->irq_bits) {
However, `it->options[i]` is an unchecked `int` value from userspace, so
the shift amount could be negative or out of bounds. Fix the test by
requiring `it->options[1]` to be within bounds before proceeding with
the original test. Valid `it->options[1]` values that select the IRQ
will be in the range [1,15]. The value 0 explicitly disables the use of
interrupts.
CVSS Score
7.1
EPSS Score
0.0
Published
2025-08-16
In the Linux kernel, the following vulnerability has been resolved:
iio: common: st_sensors: Fix use of uninitialize device structs
Throughout the various probe functions &indio_dev->dev is used before it
is initialized. This caused a kernel panic in st_sensors_power_enable()
when the call to devm_regulator_bulk_get_enable() fails and then calls
dev_err_probe() with the uninitialized device.
This seems to only cause a panic with dev_err_probe(), dev_err(),
dev_warn() and dev_info() don't seem to cause a panic, but are fixed
as well.
The issue is reported and traced here: [1]
CVSS Score
5.5
EPSS Score
0.0
Published
2025-08-16
In the Linux kernel, the following vulnerability has been resolved:
wifi: zd1211rw: Fix potential NULL pointer dereference in zd_mac_tx_to_dev()
There is a potential NULL pointer dereference in zd_mac_tx_to_dev(). For
example, the following is possible:
T0 T1
zd_mac_tx_to_dev()
/* len == skb_queue_len(q) */
while (len > ZD_MAC_MAX_ACK_WAITERS) {
filter_ack()
spin_lock_irqsave(&q->lock, flags);
/* position == skb_queue_len(q) */
for (i=1; i<position; i++)
skb = __skb_dequeue(q)
if (mac->type == NL80211_IFTYPE_AP)
skb = __skb_dequeue(q);
spin_unlock_irqrestore(&q->lock, flags);
skb_dequeue() -> NULL
Since there is a small gap between checking skb queue length and skb being
unconditionally dequeued in zd_mac_tx_to_dev(), skb_dequeue() can return NULL.
Then the pointer is passed to zd_mac_tx_status() where it is dereferenced.
In order to avoid potential NULL pointer dereference due to situations like
above, check if skb is not NULL before passing it to zd_mac_tx_status().
Found by Linux Verification Center (linuxtesting.org) with SVACE.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-08-16
In the Linux kernel, the following vulnerability has been resolved:
pinctrl: qcom: msm: mark certain pins as invalid for interrupts
On some platforms, the UFS-reset pin has no interrupt logic in TLMM but
is nevertheless registered as a GPIO in the kernel. This enables the
user-space to trigger a BUG() in the pinctrl-msm driver by running, for
example: `gpiomon -c 0 113` on RB2.
The exact culprit is requesting pins whose intr_detection_width setting
is not 1 or 2 for interrupts. This hits a BUG() in
msm_gpio_irq_set_type(). Potentially crashing the kernel due to an
invalid request from user-space is not optimal, so let's go through the
pins and mark those that would fail the check as invalid for the irq chip
as we should not even register them as available irqs.
This function can be extended if we determine that there are more
corner-cases like this.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-08-16
In the Linux kernel, the following vulnerability has been resolved:
do_change_type(): refuse to operate on unmounted/not ours mounts
Ensure that propagation settings can only be changed for mounts located
in the caller's mount namespace. This change aligns permission checking
with the rest of mount(2).
CVSS Score
5.5
EPSS Score
0.0
Published
2025-07-30
In the Linux kernel, the following vulnerability has been resolved:
HID: core: ensure the allocated report buffer can contain the reserved report ID
When the report ID is not used, the low level transport drivers expect
the first byte to be 0. However, currently the allocated buffer not
account for that extra byte, meaning that instead of having 8 guaranteed
bytes for implement to be working, we only have 7.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-07-28
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: configfs: Fix OOB read on empty string write
When writing an empty string to either 'qw_sign' or 'landingPage'
sysfs attributes, the store functions attempt to access page[l - 1]
before validating that the length 'l' is greater than zero.
This patch fixes the vulnerability by adding a check at the beginning
of os_desc_qw_sign_store() and webusb_landingPage_store() to handle
the zero-length input case gracefully by returning immediately.
CVSS Score
7.1
EPSS Score
0.0
Published
2025-07-28
In the Linux kernel, the following vulnerability has been resolved:
comedi: das6402: Fix bit shift out of bounds
When checking for a supported IRQ number, the following test is used:
/* IRQs 2,3,5,6,7, 10,11,15 are valid for "enhanced" mode */
if ((1 << it->options[1]) & 0x8cec) {
However, `it->options[i]` is an unchecked `int` value from userspace, so
the shift amount could be negative or out of bounds. Fix the test by
requiring `it->options[1]` to be within bounds before proceeding with
the original test. Valid `it->options[1]` values that select the IRQ
will be in the range [1,15]. The value 0 explicitly disables the use of
interrupts.
CVSS Score
7.1
EPSS Score
0.0
Published
2025-07-28
In the Linux kernel, the following vulnerability has been resolved:
comedi: das16m1: Fix bit shift out of bounds
When checking for a supported IRQ number, the following test is used:
/* only irqs 2, 3, 4, 5, 6, 7, 10, 11, 12, 14, and 15 are valid */
if ((1 << it->options[1]) & 0xdcfc) {
However, `it->options[i]` is an unchecked `int` value from userspace, so
the shift amount could be negative or out of bounds. Fix the test by
requiring `it->options[1]` to be within bounds before proceeding with
the original test.
CVSS Score
7.1
EPSS Score
0.0
Published
2025-07-28