Linux: >> Linux Kernel >> 6.1.9 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
PCI: dwc: ep: Prevent changing BAR size/flags in pci_epc_set_bar()
In commit 4284c88fff0e ("PCI: designware-ep: Allow pci_epc_set_bar() update
inbound map address") set_bar() was modified to support dynamically
changing the backing physical address of a BAR that was already configured.
This means that set_bar() can be called twice, without ever calling
clear_bar() (as calling clear_bar() would clear the BAR's PCI address
assigned by the host).
This can only be done if the new BAR size/flags does not differ from the
existing BAR configuration. Add these missing checks.
If we allow set_bar() to set e.g. a new BAR size that differs from the
existing BAR size, the new address translation range will be smaller than
the BAR size already determined by the host, which would mean that a read
past the new BAR size would pass the iATU untranslated, which could allow
the host to read memory not belonging to the new struct pci_epf_bar.
While at it, add comments which clarifies the support for dynamically
changing the physical address of a BAR. (Which was also missing.)
CVSS Score
5.5
EPSS Score
0.0
Published
2025-02-27
In the Linux kernel, the following vulnerability has been resolved:
soc: qcom: socinfo: Avoid out of bounds read of serial number
On MSM8916 devices, the serial number exposed in sysfs is constant and does
not change across individual devices. It's always:
db410c:/sys/devices/soc0$ cat serial_number
2644893864
The firmware used on MSM8916 exposes SOCINFO_VERSION(0, 8), which does not
have support for the serial_num field in the socinfo struct. There is an
existing check to avoid exposing the serial number in that case, but it's
not correct: When checking the item_size returned by SMEM, we need to make
sure the *end* of the serial_num is within bounds, instead of comparing
with the *start* offset. The serial_number currently exposed on MSM8916
devices is just an out of bounds read of whatever comes after the socinfo
struct in SMEM.
Fix this by changing offsetof() to offsetofend(), so that the size of the
field is also taken into account.
CVSS Score
7.1
EPSS Score
0.0
Published
2025-02-27
In the Linux kernel, the following vulnerability has been resolved:
binfmt_flat: Fix integer overflow bug on 32 bit systems
Most of these sizes and counts are capped at 256MB so the math doesn't
result in an integer overflow. The "relocs" count needs to be checked
as well. Otherwise on 32bit systems the calculation of "full_data"
could be wrong.
full_data = data_len + relocs * sizeof(unsigned long);
CVSS Score
5.5
EPSS Score
0.0
Published
2025-02-27
In the Linux kernel, the following vulnerability has been resolved:
drm/msm/gem: prevent integer overflow in msm_ioctl_gem_submit()
The "submit->cmd[i].size" and "submit->cmd[i].offset" variables are u32
values that come from the user via the submit_lookup_cmds() function.
This addition could lead to an integer wrapping bug so use size_add()
to prevent that.
Patchwork: https://patchwork.freedesktop.org/patch/624696/
CVSS Score
5.5
EPSS Score
0.0
Published
2025-02-27
In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: Mark inode as bad as soon as error detected in mi_enum_attr()
Extended the `mi_enum_attr()` function interface with an additional
parameter, `struct ntfs_inode *ni`, to allow marking the inode
as bad as soon as an error is detected.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-02-27
In the Linux kernel, the following vulnerability has been resolved:
scsi: ufs: bsg: Set bsg_queue to NULL after removal
Currently, this does not cause any issues, but I believe it is necessary to
set bsg_queue to NULL after removing it to prevent potential use-after-free
(UAF) access.
CVSS Score
7.8
EPSS Score
0.0
Published
2025-02-27
In the Linux kernel, the following vulnerability has been resolved:
media: vidtv: Fix a null-ptr-deref in vidtv_mux_stop_thread
syzbot report a null-ptr-deref in vidtv_mux_stop_thread. [1]
If dvb->mux is not initialized successfully by vidtv_mux_init() in the
vidtv_start_streaming(), it will trigger null pointer dereference about mux
in vidtv_mux_stop_thread().
Adjust the timing of streaming initialization and check it before
stopping it.
[1]
KASAN: null-ptr-deref in range [0x0000000000000128-0x000000000000012f]
CPU: 0 UID: 0 PID: 5842 Comm: syz-executor248 Not tainted 6.13.0-rc4-syzkaller-00012-g9b2ffa6148b1 #0
Hardware name: Google Google Compute Engine/Google Compute Engine, BIOS Google 09/13/2024
RIP: 0010:vidtv_mux_stop_thread+0x26/0x80 drivers/media/test-drivers/vidtv/vidtv_mux.c:471
Code: 90 90 90 90 66 0f 1f 00 55 53 48 89 fb e8 82 2e c8 f9 48 8d bb 28 01 00 00 48 b8 00 00 00 00 00 fc ff df 48 89 fa 48 c1 ea 03 <0f> b6 04 02 84 c0 74 02 7e 3b 0f b6 ab 28 01 00 00 31 ff 89 ee e8
RSP: 0018:ffffc90003f2faa8 EFLAGS: 00010202
RAX: dffffc0000000000 RBX: 0000000000000000 RCX: ffffffff87cfb125
RDX: 0000000000000025 RSI: ffffffff87d120ce RDI: 0000000000000128
RBP: ffff888029b8d220 R08: 0000000000000005 R09: 0000000000000000
R10: 0000000000000000 R11: 0000000000000003 R12: ffff888029b8d188
R13: ffffffff8f590aa0 R14: ffffc9000581c5c8 R15: ffff888029a17710
FS: 00007f7eef5156c0(0000) GS:ffff8880b8600000(0000) knlGS:0000000000000000
CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033
CR2: 00007f7eef5e635c CR3: 0000000076ca6000 CR4: 00000000003526f0
DR0: 0000000000000000 DR1: 0000000000000000 DR2: 0000000000000000
DR3: 0000000000000000 DR6: 00000000fffe0ff0 DR7: 0000000000000400
Call Trace:
<TASK>
vidtv_stop_streaming drivers/media/test-drivers/vidtv/vidtv_bridge.c:209 [inline]
vidtv_stop_feed+0x151/0x250 drivers/media/test-drivers/vidtv/vidtv_bridge.c:252
dmx_section_feed_stop_filtering+0x90/0x160 drivers/media/dvb-core/dvb_demux.c:1000
dvb_dmxdev_feed_stop.isra.0+0x1ee/0x270 drivers/media/dvb-core/dmxdev.c:486
dvb_dmxdev_filter_stop+0x22a/0x3a0 drivers/media/dvb-core/dmxdev.c:559
dvb_dmxdev_filter_free drivers/media/dvb-core/dmxdev.c:840 [inline]
dvb_demux_release+0x92/0x550 drivers/media/dvb-core/dmxdev.c:1246
__fput+0x3f8/0xb60 fs/file_table.c:450
task_work_run+0x14e/0x250 kernel/task_work.c:239
get_signal+0x1d3/0x2610 kernel/signal.c:2790
arch_do_signal_or_restart+0x90/0x7e0 arch/x86/kernel/signal.c:337
exit_to_user_mode_loop kernel/entry/common.c:111 [inline]
exit_to_user_mode_prepare include/linux/entry-common.h:329 [inline]
__syscall_exit_to_user_mode_work kernel/entry/common.c:207 [inline]
syscall_exit_to_user_mode+0x150/0x2a0 kernel/entry/common.c:218
do_syscall_64+0xda/0x250 arch/x86/entry/common.c:89
entry_SYSCALL_64_after_hwframe+0x77/0x7f
CVSS Score
5.5
EPSS Score
0.0
Published
2025-02-27
In the Linux kernel, the following vulnerability has been resolved:
iommufd/iova_bitmap: Fix shift-out-of-bounds in iova_bitmap_offset_to_index()
Resolve a UBSAN shift-out-of-bounds issue in iova_bitmap_offset_to_index()
where shifting the constant "1" (of type int) by bitmap->mapped.pgshift
(an unsigned long value) could result in undefined behavior.
The constant "1" defaults to a 32-bit "int", and when "pgshift" exceeds
31 (e.g., pgshift = 63) the shift operation overflows, as the result
cannot be represented in a 32-bit type.
To resolve this, the constant is updated to "1UL", promoting it to an
unsigned long type to match the operand's type.
CVSS Score
7.8
EPSS Score
0.0
Published
2025-02-27
In the Linux kernel, the following vulnerability has been resolved:
padata: avoid UAF for reorder_work
Although the previous patch can avoid ps and ps UAF for _do_serial, it
can not avoid potential UAF issue for reorder_work. This issue can
happen just as below:
crypto_request crypto_request crypto_del_alg
padata_do_serial
...
padata_reorder
// processes all remaining
// requests then breaks
while (1) {
if (!padata)
break;
...
}
padata_do_serial
// new request added
list_add
// sees the new request
queue_work(reorder_work)
padata_reorder
queue_work_on(squeue->work)
...
<kworker context>
padata_serial_worker
// completes new request,
// no more outstanding
// requests
crypto_del_alg
// free pd
<kworker context>
invoke_padata_reorder
// UAF of pd
To avoid UAF for 'reorder_work', get 'pd' ref before put 'reorder_work'
into the 'serial_wq' and put 'pd' ref until the 'serial_wq' finish.
CVSS Score
7.8
EPSS Score
0.0
Published
2025-02-27
In the Linux kernel, the following vulnerability has been resolved:
padata: fix UAF in padata_reorder
A bug was found when run ltp test:
BUG: KASAN: slab-use-after-free in padata_find_next+0x29/0x1a0
Read of size 4 at addr ffff88bbfe003524 by task kworker/u113:2/3039206
CPU: 0 PID: 3039206 Comm: kworker/u113:2 Kdump: loaded Not tainted 6.6.0+
Workqueue: pdecrypt_parallel padata_parallel_worker
Call Trace:
<TASK>
dump_stack_lvl+0x32/0x50
print_address_description.constprop.0+0x6b/0x3d0
print_report+0xdd/0x2c0
kasan_report+0xa5/0xd0
padata_find_next+0x29/0x1a0
padata_reorder+0x131/0x220
padata_parallel_worker+0x3d/0xc0
process_one_work+0x2ec/0x5a0
If 'mdelay(10)' is added before calling 'padata_find_next' in the
'padata_reorder' function, this issue could be reproduced easily with
ltp test (pcrypt_aead01).
This can be explained as bellow:
pcrypt_aead_encrypt
...
padata_do_parallel
refcount_inc(&pd->refcnt); // add refcnt
...
padata_do_serial
padata_reorder // pd
while (1) {
padata_find_next(pd, true); // using pd
queue_work_on
...
padata_serial_worker crypto_del_alg
padata_put_pd_cnt // sub refcnt
padata_free_shell
padata_put_pd(ps->pd);
// pd is freed
// loop again, but pd is freed
// call padata_find_next, UAF
}
In the padata_reorder function, when it loops in 'while', if the alg is
deleted, the refcnt may be decreased to 0 before entering
'padata_find_next', which leads to UAF.
As mentioned in [1], do_serial is supposed to be called with BHs disabled
and always happen under RCU protection, to address this issue, add
synchronize_rcu() in 'padata_free_shell' wait for all _do_serial calls
to finish.
[1] https://lore.kernel.org/all/20221028160401.cccypv4euxikusiq@parnassus.localdomain/
[2] https://lore.kernel.org/linux-kernel/jfjz5d7zwbytztackem7ibzalm5lnxldi2eofeiczqmqs2m7o6@fq426cwnjtkm/
CVSS Score
7.8
EPSS Score
0.0
Published
2025-02-27