In the Linux kernel, the following vulnerability has been resolved:
net: altera-tse: fix skb leak on DMA mapping error in tse_start_xmit()
When dma_map_single() fails in tse_start_xmit(), the function returns
NETDEV_TX_OK without freeing the skb. Since NETDEV_TX_OK tells the
stack the packet was consumed, the skb is never freed, leaking memory
on every DMA mapping failure.
Add dev_kfree_skb_any() before returning to properly free the skb.
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: reject oversized global TT response buffers
batadv_tt_prepare_tvlv_global_data() builds the allocation length for a
global TT response in 16-bit temporaries. When a remote originator
advertises a large enough global TT, the TT payload length plus the VLAN
header offset can exceed 65535 and wrap before kmalloc().
The full-table response path still uses the original TT payload length when
it fills tt_change, so the wrapped allocation is too small and
batadv_tt_prepare_tvlv_global_data() writes past the end of the heap object
before the later packet-size check runs.
Fix this by rejecting TT responses whose TVLV value length cannot fit in
the 16-bit TVLV payload length field.
In the Linux kernel, the following vulnerability has been resolved:
nfc: pn533: allocate rx skb before consuming bytes
pn532_receive_buf() reports the number of accepted bytes to the serdev
core. The current code consumes bytes into recv_skb and may already hand
a complete frame to pn533_recv_frame() before allocating a fresh receive
buffer.
If that alloc_skb() fails, the callback returns 0 even though it has
already consumed bytes, and it leaves recv_skb as NULL for the next
receive callback. That breaks the receive_buf() accounting contract and
can also lead to a NULL dereference on the next skb_put_u8().
Allocate the receive skb lazily before consuming the next byte instead.
If allocation fails, return the number of bytes already accepted.
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmsmac: Fix dma_free_coherent() size
dma_alloc_consistent() may change the size to align it. The new size is
saved in alloced.
Change the free size to match the allocation size.
In the Linux kernel, the following vulnerability has been resolved:
tipc: fix bc_ackers underflow on duplicate GRP_ACK_MSG
The GRP_ACK_MSG handler in tipc_group_proto_rcv() currently decrements
bc_ackers on every inbound group ACK, even when the same member has
already acknowledged the current broadcast round.
Because bc_ackers is a u16, a duplicate ACK received after the last
legitimate ACK wraps the counter to 65535. Once wrapped,
tipc_group_bc_cong() keeps reporting congestion and later group
broadcasts on the affected socket stay blocked until the group is
recreated.
Fix this by ignoring duplicate or stale ACKs before touching bc_acked or
bc_ackers. This makes repeated GRP_ACK_MSG handling idempotent and
prevents the underflow path.
In the Linux kernel, the following vulnerability has been resolved:
xfrm: hold dev ref until after transport_finish NF_HOOK
After async crypto completes, xfrm_input_resume() calls dev_put()
immediately on re-entry before the skb reaches transport_finish.
The skb->dev pointer is then used inside NF_HOOK and its okfn,
which can race with device teardown.
Remove the dev_put from the async resumption entry and instead
drop the reference after the NF_HOOK call in transport_finish,
using a saved device pointer since NF_HOOK may consume the skb.
This covers NF_DROP, NF_QUEUE and NF_STOLEN paths that skip
the okfn.
For non-transport exits (decaps, gro, drop) and secondary
async return points, release the reference inline when
async is set.
In the Linux kernel, the following vulnerability has been resolved:
net: stmmac: fix integer underflow in chain mode
The jumbo_frm() chain-mode implementation unconditionally computes
len = nopaged_len - bmax;
where nopaged_len = skb_headlen(skb) (linear bytes only) and bmax is
BUF_SIZE_8KiB or BUF_SIZE_2KiB. However, the caller stmmac_xmit()
decides to invoke jumbo_frm() based on skb->len (total length including
page fragments):
is_jumbo = stmmac_is_jumbo_frm(priv, skb->len, enh_desc);
When a packet has a small linear portion (nopaged_len <= bmax) but a
large total length due to page fragments (skb->len > bmax), the
subtraction wraps as an unsigned integer, producing a huge len value
(~0xFFFFxxxx). This causes the while (len != 0) loop to execute
hundreds of thousands of iterations, passing skb->data + bmax * i
pointers far beyond the skb buffer to dma_map_single(). On IOMMU-less
SoCs (the typical deployment for stmmac), this maps arbitrary kernel
memory to the DMA engine, constituting a kernel memory disclosure and
potential memory corruption from hardware.
Fix this by introducing a buf_len local variable clamped to
min(nopaged_len, bmax). Computing len = nopaged_len - buf_len is then
always safe: it is zero when the linear portion fits within a single
descriptor, causing the while (len != 0) loop to be skipped naturally,
and the fragment loop in stmmac_xmit() handles page fragments afterward.
In the Linux kernel, the following vulnerability has been resolved:
mmc: vub300: fix NULL-deref on disconnect
Make sure to deregister the controller before dropping the reference to
the driver data on disconnect to avoid NULL-pointer dereferences or
use-after-free.
In the Linux kernel, the following vulnerability has been resolved:
rxrpc: reject undecryptable rxkad response tickets
rxkad_decrypt_ticket() decrypts the RXKAD response ticket and then
parses the buffer as plaintext without checking whether
crypto_skcipher_decrypt() succeeded.
A malformed RESPONSE can therefore use a non-block-aligned ticket
length, make the decrypt operation fail, and still drive the ticket
parser with attacker-controlled bytes.
Check the decrypt result and abort the connection with RXKADBADTICKET
when ticket decryption fails.
In the Linux kernel, the following vulnerability has been resolved:
rxrpc: Fix call removal to use RCU safe deletion
Fix rxrpc call removal from the rxnet->calls list to use list_del_rcu()
rather than list_del_init() to prevent stuffing up reading
/proc/net/rxrpc/calls from potentially getting into an infinite loop.
This, however, means that list_empty() no longer works on an entry that's
been deleted from the list, making it harder to detect prior deletion. Fix
this by:
Firstly, make rxrpc_destroy_all_calls() only dump the first ten calls that
are unexpectedly still on the list. Limiting the number of steps means
there's no need to call cond_resched() or to remove calls from the list
here, thereby eliminating the need for rxrpc_put_call() to check for that.
rxrpc_put_call() can then be fixed to unconditionally delete the call from
the list as it is the only place that the deletion occurs.