Vulnerabilities
Vulnerable Software
Linux:  >> Linux Kernel  >> 2.0.24  Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved: __legitimize_mnt(): check for MNT_SYNC_UMOUNT should be under mount_lock ... or we risk stealing final mntput from sync umount - raising mnt_count after umount(2) has verified that victim is not busy, but before it has set MNT_SYNC_UMOUNT; in that case __legitimize_mnt() doesn't see that it's safe to quietly undo mnt_count increment and leaves dropping the reference to caller, where it'll be a full-blown mntput(). Check under mount_lock is needed; leaving the current one done before taking that makes no sense - it's nowhere near common enough to bother with.
CVSS Score
5.5
EPSS Score
0.001
Published
2025-06-18
In the Linux kernel, the following vulnerability has been resolved: net: pktgen: fix access outside of user given buffer in pktgen_thread_write() Honour the user given buffer size for the strn_len() calls (otherwise strn_len() will access memory outside of the user given buffer).
CVSS Score
5.5
EPSS Score
0.001
Published
2025-06-18
In the Linux kernel, the following vulnerability has been resolved: wifi: iwlwifi: fix debug actions order The order of actions taken for debug was implemented incorrectly. Now we implemented the dump split and do the FW reset only in the middle of the dump (rather than the FW killing itself on error.) As a result, some of the actions taken when applying the config will now crash the device, so we need to fix the order.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-06-18
In the Linux kernel, the following vulnerability has been resolved: virtio_ring: Fix data race by tagging event_triggered as racy for KCSAN syzbot reports a data-race when accessing the event_triggered, here is the simplified stack when the issue occurred: ================================================================== BUG: KCSAN: data-race in virtqueue_disable_cb / virtqueue_enable_cb_delayed write to 0xffff8881025bc452 of 1 bytes by task 3288 on cpu 0: virtqueue_enable_cb_delayed+0x42/0x3c0 drivers/virtio/virtio_ring.c:2653 start_xmit+0x230/0x1310 drivers/net/virtio_net.c:3264 __netdev_start_xmit include/linux/netdevice.h:5151 [inline] netdev_start_xmit include/linux/netdevice.h:5160 [inline] xmit_one net/core/dev.c:3800 [inline] read to 0xffff8881025bc452 of 1 bytes by interrupt on cpu 1: virtqueue_disable_cb_split drivers/virtio/virtio_ring.c:880 [inline] virtqueue_disable_cb+0x92/0x180 drivers/virtio/virtio_ring.c:2566 skb_xmit_done+0x5f/0x140 drivers/net/virtio_net.c:777 vring_interrupt+0x161/0x190 drivers/virtio/virtio_ring.c:2715 __handle_irq_event_percpu+0x95/0x490 kernel/irq/handle.c:158 handle_irq_event_percpu kernel/irq/handle.c:193 [inline] value changed: 0x01 -> 0x00 ================================================================== When the data race occurs, the function virtqueue_enable_cb_delayed() sets event_triggered to false, and virtqueue_disable_cb_split/packed() reads it as false due to the race condition. Since event_triggered is an unreliable hint used for optimization, this should only cause the driver temporarily suggest that the device not send an interrupt notification when the event index is used. Fix this KCSAN reported data-race issue by explicitly tagging the access as data_racy.
CVSS Score
4.7
EPSS Score
0.0
Published
2025-06-18
In the Linux kernel, the following vulnerability has been resolved: net/mlx5e: Avoid WARN_ON when configuring MQPRIO with HTB offload enabled When attempting to enable MQPRIO while HTB offload is already configured, the driver currently returns `-EINVAL` and triggers a `WARN_ON`, leading to an unnecessary call trace. Update the code to handle this case more gracefully by returning `-EOPNOTSUPP` instead, while also providing a helpful user message.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-06-18
In the Linux kernel, the following vulnerability has been resolved: serial: mctrl_gpio: split disable_ms into sync and no_sync APIs The following splat has been observed on a SAMA5D27 platform using atmel_serial: BUG: sleeping function called from invalid context at kernel/irq/manage.c:738 in_atomic(): 1, irqs_disabled(): 128, non_block: 0, pid: 27, name: kworker/u5:0 preempt_count: 1, expected: 0 INFO: lockdep is turned off. irq event stamp: 0 hardirqs last enabled at (0): [<00000000>] 0x0 hardirqs last disabled at (0): [<c01588f0>] copy_process+0x1c4c/0x7bec softirqs last enabled at (0): [<c0158944>] copy_process+0x1ca0/0x7bec softirqs last disabled at (0): [<00000000>] 0x0 CPU: 0 UID: 0 PID: 27 Comm: kworker/u5:0 Not tainted 6.13.0-rc7+ #74 Hardware name: Atmel SAMA5 Workqueue: hci0 hci_power_on [bluetooth] Call trace: unwind_backtrace from show_stack+0x18/0x1c show_stack from dump_stack_lvl+0x44/0x70 dump_stack_lvl from __might_resched+0x38c/0x598 __might_resched from disable_irq+0x1c/0x48 disable_irq from mctrl_gpio_disable_ms+0x74/0xc0 mctrl_gpio_disable_ms from atmel_disable_ms.part.0+0x80/0x1f4 atmel_disable_ms.part.0 from atmel_set_termios+0x764/0x11e8 atmel_set_termios from uart_change_line_settings+0x15c/0x994 uart_change_line_settings from uart_set_termios+0x2b0/0x668 uart_set_termios from tty_set_termios+0x600/0x8ec tty_set_termios from ttyport_set_flow_control+0x188/0x1e0 ttyport_set_flow_control from wilc_setup+0xd0/0x524 [hci_wilc] wilc_setup [hci_wilc] from hci_dev_open_sync+0x330/0x203c [bluetooth] hci_dev_open_sync [bluetooth] from hci_dev_do_open+0x40/0xb0 [bluetooth] hci_dev_do_open [bluetooth] from hci_power_on+0x12c/0x664 [bluetooth] hci_power_on [bluetooth] from process_one_work+0x998/0x1a38 process_one_work from worker_thread+0x6e0/0xfb4 worker_thread from kthread+0x3d4/0x484 kthread from ret_from_fork+0x14/0x28 This warning is emitted when trying to toggle, at the highest level, some flow control (with serdev_device_set_flow_control) in a device driver. At the lowest level, the atmel_serial driver is using serial_mctrl_gpio lib to enable/disable the corresponding IRQs accordingly. The warning emitted by CONFIG_DEBUG_ATOMIC_SLEEP is due to disable_irq (called in mctrl_gpio_disable_ms) being possibly called in some atomic context (some tty drivers perform modem lines configuration in regions protected by port lock). Split mctrl_gpio_disable_ms into two differents APIs, a non-blocking one and a blocking one. Replace mctrl_gpio_disable_ms calls with the relevant version depending on whether the call is protected by some port lock.
CVSS Score
5.5
EPSS Score
0.001
Published
2025-06-18
In the Linux kernel, the following vulnerability has been resolved: clk: sunxi-ng: h616: Reparent GPU clock during frequency changes The H616 manual does not state that the GPU PLL supports dynamic frequency configuration, so we must take extra care when changing the frequency. Currently any attempt to do device DVFS on the GPU lead to panfrost various ooops, and GPU hangs. The manual describes the algorithm for changing the PLL frequency, which the CPU PLL notifier code already support, so we reuse that to reparent the GPU clock to GPU1 clock during frequency changes.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-06-18
In the Linux kernel, the following vulnerability has been resolved: media: cx231xx: set device_caps for 417 The video_device for the MPEG encoder did not set device_caps. Add this, otherwise the video device can't be registered (you get a WARN_ON instead). Not seen before since currently 417 support is disabled, but I found this while experimenting with it.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-06-18
In the Linux kernel, the following vulnerability has been resolved: btrfs: correct the order of prelim_ref arguments in btrfs__prelim_ref btrfs_prelim_ref() calls the old and new reference variables in the incorrect order. This causes a NULL pointer dereference because oldref is passed as NULL to trace_btrfs_prelim_ref_insert(). Note, trace_btrfs_prelim_ref_insert() is being called with newref as oldref (and oldref as NULL) on purpose in order to print out the values of newref. To reproduce: echo 1 > /sys/kernel/debug/tracing/events/btrfs/btrfs_prelim_ref_insert/enable Perform some writeback operations. Backtrace: BUG: kernel NULL pointer dereference, address: 0000000000000018 #PF: supervisor read access in kernel mode #PF: error_code(0x0000) - not-present page PGD 115949067 P4D 115949067 PUD 11594a067 PMD 0 Oops: Oops: 0000 [#1] SMP NOPTI CPU: 1 UID: 0 PID: 1188 Comm: fsstress Not tainted 6.15.0-rc2-tester+ #47 PREEMPT(voluntary) 7ca2cef72d5e9c600f0c7718adb6462de8149622 Hardware name: QEMU Standard PC (Q35 + ICH9, 2009), BIOS rel-1.16.3-2-gc13ff2cd-prebuilt.qemu.org 04/01/2014 RIP: 0010:trace_event_raw_event_btrfs__prelim_ref+0x72/0x130 Code: e8 43 81 9f ff 48 85 c0 74 78 4d 85 e4 0f 84 8f 00 00 00 49 8b 94 24 c0 06 00 00 48 8b 0a 48 89 48 08 48 8b 52 08 48 89 50 10 <49> 8b 55 18 48 89 50 18 49 8b 55 20 48 89 50 20 41 0f b6 55 28 88 RSP: 0018:ffffce44820077a0 EFLAGS: 00010286 RAX: ffff8c6b403f9014 RBX: ffff8c6b55825730 RCX: 304994edf9cf506b RDX: d8b11eb7f0fdb699 RSI: ffff8c6b403f9010 RDI: ffff8c6b403f9010 RBP: 0000000000000001 R08: 0000000000000001 R09: 0000000000000010 R10: 00000000ffffffff R11: 0000000000000000 R12: ffff8c6b4e8fb000 R13: 0000000000000000 R14: ffffce44820077a8 R15: ffff8c6b4abd1540 FS: 00007f4dc6813740(0000) GS:ffff8c6c1d378000(0000) knlGS:0000000000000000 CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033 CR2: 0000000000000018 CR3: 000000010eb42000 CR4: 0000000000750ef0 PKRU: 55555554 Call Trace: <TASK> prelim_ref_insert+0x1c1/0x270 find_parent_nodes+0x12a6/0x1ee0 ? __entry_text_end+0x101f06/0x101f09 ? srso_alias_return_thunk+0x5/0xfbef5 ? srso_alias_return_thunk+0x5/0xfbef5 ? srso_alias_return_thunk+0x5/0xfbef5 ? srso_alias_return_thunk+0x5/0xfbef5 btrfs_is_data_extent_shared+0x167/0x640 ? fiemap_process_hole+0xd0/0x2c0 extent_fiemap+0xa5c/0xbc0 ? __entry_text_end+0x101f05/0x101f09 btrfs_fiemap+0x7e/0xd0 do_vfs_ioctl+0x425/0x9d0 __x64_sys_ioctl+0x75/0xc0
CVSS Score
5.5
EPSS Score
0.0
Published
2025-06-18
A vulnerability was found in systemd-coredump. This flaw allows an attacker to force a SUID process to crash and replace it with a non-SUID binary to access the original's privileged process coredump, allowing the attacker to read sensitive data, such as /etc/shadow content, loaded by the original process. A SUID binary or process has a special type of permission, which allows the process to run with the file owner's permissions, regardless of the user executing the binary. This allows the process to access more restricted data than unprivileged users or processes would be able to. An attacker can leverage this flaw by forcing a SUID process to crash and force the Linux kernel to recycle the process PID before systemd-coredump can analyze the /proc/pid/auxv file. If the attacker wins the race condition, they gain access to the original's SUID process coredump file. They can read sensitive content loaded into memory by the original binary, affecting data confidentiality.
CVSS Score
4.7
EPSS Score
0.0
Published
2025-05-30


Contact Us

Shodan ® - All rights reserved