Linux: >> Linux Kernel >> 3.0.71 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
ext4: avoid allocating blocks from corrupted group in ext4_mb_try_best_found()
Determine if the group block bitmap is corrupted before using ac_b_ex in
ext4_mb_try_best_found() to avoid allocating blocks from a group with a
corrupted block bitmap in the following concurrency and making the
situation worse.
ext4_mb_regular_allocator
ext4_lock_group(sb, group)
ext4_mb_good_group
// check if the group bbitmap is corrupted
ext4_mb_complex_scan_group
// Scan group gets ac_b_ex but doesn't use it
ext4_unlock_group(sb, group)
ext4_mark_group_bitmap_corrupted(group)
// The block bitmap was corrupted during
// the group unlock gap.
ext4_mb_try_best_found
ext4_lock_group(ac->ac_sb, group)
ext4_mb_use_best_found
mb_mark_used
// Allocating blocks in block bitmap corrupted group
CVSS Score
5.5
EPSS Score
0.0
Published
2024-04-03
In the Linux kernel, the following vulnerability has been resolved:
ext4: avoid dividing by 0 in mb_update_avg_fragment_size() when block bitmap corrupt
Determine if bb_fragments is 0 instead of determining bb_free to eliminate
the risk of dividing by zero when the block bitmap is corrupted.
CVSS Score
5.5
EPSS Score
0.0
Published
2024-04-03
In the Linux kernel, the following vulnerability has been resolved:
aoe: avoid potential deadlock at set_capacity
Move set_capacity() outside of the section procected by (&d->lock).
To avoid possible interrupt unsafe locking scenario:
CPU0 CPU1
---- ----
[1] lock(&bdev->bd_size_lock);
local_irq_disable();
[2] lock(&d->lock);
[3] lock(&bdev->bd_size_lock);
<Interrupt>
[4] lock(&d->lock);
*** DEADLOCK ***
Where [1](&bdev->bd_size_lock) hold by zram_add()->set_capacity().
[2]lock(&d->lock) hold by aoeblk_gdalloc(). And aoeblk_gdalloc()
is trying to acquire [3](&bdev->bd_size_lock) at set_capacity() call.
In this situation an attempt to acquire [4]lock(&d->lock) from
aoecmd_cfg_rsp() will lead to deadlock.
So the simplest solution is breaking lock dependency
[2](&d->lock) -> [3](&bdev->bd_size_lock) by moving set_capacity()
outside.
CVSS Score
5.5
EPSS Score
0.0
Published
2024-04-03
In the Linux kernel, the following vulnerability has been resolved:
spi: hisi-sfc-v3xx: Return IRQ_NONE if no interrupts were detected
Return IRQ_NONE from the interrupt handler when no interrupt was
detected. Because an empty interrupt will cause a null pointer error:
Unable to handle kernel NULL pointer dereference at virtual
address 0000000000000008
Call trace:
complete+0x54/0x100
hisi_sfc_v3xx_isr+0x2c/0x40 [spi_hisi_sfc_v3xx]
__handle_irq_event_percpu+0x64/0x1e0
handle_irq_event+0x7c/0x1cc
CVSS Score
5.5
EPSS Score
0.0
Published
2024-04-03
In the Linux kernel, the following vulnerability has been resolved:
fbdev: sis: Error out if pixclock equals zero
The userspace program could pass any values to the driver through
ioctl() interface. If the driver doesn't check the value of pixclock,
it may cause divide-by-zero error.
In sisfb_check_var(), var->pixclock is used as a divisor to caculate
drate before it is checked against zero. Fix this by checking it
at the beginning.
This is similar to CVE-2022-3061 in i740fb which was fixed by
commit 15cf0b8.
CVSS Score
5.5
EPSS Score
0.0
Published
2024-04-03
In the Linux kernel, the following vulnerability has been resolved:
fbdev: savage: Error out if pixclock equals zero
The userspace program could pass any values to the driver through
ioctl() interface. If the driver doesn't check the value of pixclock,
it may cause divide-by-zero error.
Although pixclock is checked in savagefb_decode_var(), but it is not
checked properly in savagefb_probe(). Fix this by checking whether
pixclock is zero in the function savagefb_check_var() before
info->var.pixclock is used as the divisor.
This is similar to CVE-2022-3061 in i740fb which was fixed by
commit 15cf0b8.
CVSS Score
5.5
EPSS Score
0.0
Published
2024-04-03
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: fix race condition on enabling fast-xmit
fast-xmit must only be enabled after the sta has been uploaded to the driver,
otherwise it could end up passing the not-yet-uploaded sta via drv_tx calls
to the driver, leading to potential crashes because of uninitialized drv_priv
data.
Add a missing sta->uploaded check and re-check fast xmit after inserting a sta.
CVSS Score
5.5
EPSS Score
0.0
Published
2024-04-03
In the Linux kernel, the following vulnerability has been resolved:
md: Don't register sync_thread for reshape directly
Currently, if reshape is interrupted, then reassemble the array will
register sync_thread directly from pers->run(), in this case
'MD_RECOVERY_RUNNING' is set directly, however, there is no guarantee
that md_do_sync() will be executed, hence stop_sync_thread() will hang
because 'MD_RECOVERY_RUNNING' can't be cleared.
Last patch make sure that md_do_sync() will set MD_RECOVERY_DONE,
however, following hang can still be triggered by dm-raid test
shell/lvconvert-raid-reshape.sh occasionally:
[root@fedora ~]# cat /proc/1982/stack
[<0>] stop_sync_thread+0x1ab/0x270 [md_mod]
[<0>] md_frozen_sync_thread+0x5c/0xa0 [md_mod]
[<0>] raid_presuspend+0x1e/0x70 [dm_raid]
[<0>] dm_table_presuspend_targets+0x40/0xb0 [dm_mod]
[<0>] __dm_destroy+0x2a5/0x310 [dm_mod]
[<0>] dm_destroy+0x16/0x30 [dm_mod]
[<0>] dev_remove+0x165/0x290 [dm_mod]
[<0>] ctl_ioctl+0x4bb/0x7b0 [dm_mod]
[<0>] dm_ctl_ioctl+0x11/0x20 [dm_mod]
[<0>] vfs_ioctl+0x21/0x60
[<0>] __x64_sys_ioctl+0xb9/0xe0
[<0>] do_syscall_64+0xc6/0x230
[<0>] entry_SYSCALL_64_after_hwframe+0x6c/0x74
Meanwhile mddev->recovery is:
MD_RECOVERY_RUNNING |
MD_RECOVERY_INTR |
MD_RECOVERY_RESHAPE |
MD_RECOVERY_FROZEN
Fix this problem by remove the code to register sync_thread directly
from raid10 and raid5. And let md_check_recovery() to register
sync_thread.
CVSS Score
5.5
EPSS Score
0.0
Published
2024-04-03
In the Linux kernel, the following vulnerability has been resolved:
md: Don't ignore suspended array in md_check_recovery()
mddev_suspend() never stop sync_thread, hence it doesn't make sense to
ignore suspended array in md_check_recovery(), which might cause
sync_thread can't be unregistered.
After commit f52f5c71f3d4 ("md: fix stopping sync thread"), following
hang can be triggered by test shell/integrity-caching.sh:
1) suspend the array:
raid_postsuspend
mddev_suspend
2) stop the array:
raid_dtr
md_stop
__md_stop_writes
stop_sync_thread
set_bit(MD_RECOVERY_INTR, &mddev->recovery);
md_wakeup_thread_directly(mddev->sync_thread);
wait_event(..., !test_bit(MD_RECOVERY_RUNNING, &mddev->recovery))
3) sync thread done:
md_do_sync
set_bit(MD_RECOVERY_DONE, &mddev->recovery);
md_wakeup_thread(mddev->thread);
4) daemon thread can't unregister sync thread:
md_check_recovery
if (mddev->suspended)
return; -> return directly
md_read_sync_thread
clear_bit(MD_RECOVERY_RUNNING, &mddev->recovery);
-> MD_RECOVERY_RUNNING can't be cleared, hence step 2 hang;
This problem is not just related to dm-raid, fix it by ignoring
suspended array in md_check_recovery(). And follow up patches will
improve dm-raid better to frozen sync thread during suspend.
CVSS Score
5.5
EPSS Score
0.0
Published
2024-04-03
In the Linux kernel, the following vulnerability has been resolved:
dm-crypt: don't modify the data when using authenticated encryption
It was said that authenticated encryption could produce invalid tag when
the data that is being encrypted is modified [1]. So, fix this problem by
copying the data into the clone bio first and then encrypt them inside the
clone bio.
This may reduce performance, but it is needed to prevent the user from
corrupting the device by writing data with O_DIRECT and modifying them at
the same time.
[1] https://lore.kernel.org/all/20240207004723.GA35324@sol.localdomain/T/
CVSS Score
7.1
EPSS Score
0.0
Published
2024-04-03