In the Linux kernel, the following vulnerability has been resolved:
f2fs: fix fsck inconsistency caused by FGGC of node block
During FGGC node block migration, fsck may incorrectly treat the
migrated node block as fsync-written data.
The reproduction scenario:
root@vm:/mnt/f2fs# seq 1 2048 | xargs -n 1 ./test_sync // write inline inode and sync
root@vm:/mnt/f2fs# rm -f 1
root@vm:/mnt/f2fs# sync
root@vm:/mnt/f2fs# f2fs_io gc_range // move data block in sync mode and not write CP
SPO, "fsck --dry-run" find inode has already checkpointed but still
with DENT_BIT_SHIFT set
The root cause is that GC does not clear the dentry mark and fsync mark
during node block migration, leading fsck to misinterpret them as
user-issued fsync writes.
In BGGC mode, node block migration is handled by f2fs_sync_node_pages(),
which guarantees the dentry and fsync marks are cleared before writing.
This patch move the set/clear of the fsync|dentry marks into
__write_node_folio to make the logic clearer, and ensures the
fsync|dentry mark is cleared in FGGC.
In the Linux kernel, the following vulnerability has been resolved:
RDMA/mlx5: Fix error path fall-through in mlx5_ib_dev_res_srq_init()
mlx5_ib_dev_res_srq_init() allocates two SRQs, s0 and s1. When
ib_create_srq() fails for s1, the error branch destroys s0 but falls
through and unconditionally assigns the freed s0 and the ERR_PTR s1 to
devr->s0 and devr->s1.
This leads to several problems: the lock-free fast path checks
"if (devr->s1) return 0;" and treats the ERR_PTR as already initialised;
users in mlx5_ib_create_qp() dereference the freed SRQ or ERR_PTR via
to_msrq(devr->s0)->msrq.srqn; and mlx5_ib_dev_res_cleanup() dereferences
the ERR_PTR and double-frees s0 on teardown.
Fix by adding the same `goto unlock` in the s1 failure path.
In the Linux kernel, the following vulnerability has been resolved:
ipmi: Add limits to event and receive message requests
The driver would just fetch events and receive messages until the
BMC said it was done. To avoid issues with BMCs that never say they are
done, add a limit of 10 fetches at a time.
In addition, an si interface has an attn state it can return from the
hardware which is supposed to cause a flag fetch to see if the driver
needs to fetch events or message or a few other things. If the attn
bit gets stuck, it's a similar problem. So allow messages in between
flag fetches so the driver itself doesn't get stuck.
This is a more general fix than the previous fix for the specific bad
BMC, but should fix the more general issue of a BMC that won't stop
saying it has data.
This has been there from the beginning of the driver. It's not a bug
per-se, but it is accounting for bugs in BMCs.
In the Linux kernel, the following vulnerability has been resolved:
RDMA/mlx4: Fix resource leak on error in mlx4_ib_create_srq()
Sashiko points out that mlx4_srq_alloc() was not undone during error
unwind, add the missing call to mlx4_srq_free().
In the Linux kernel, the following vulnerability has been resolved:
ASoC: SOF: Don't allow pointer operations on unconfigured streams
When reporting the pointer for a compressed stream we report the current
I/O frame position by dividing the position by the number of channels
multiplied by the number of container bytes. These values default to 0 and
are only configured as part of setting the stream parameters so this allows
a divide by zero to be configured. Validate that they are non zero,
returning an error if not
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: Fix potential use-after-free issue when stopping watchdog task
Watchdog task might end between send_sig() and kthread_stop() calls, what
results in the use-after-free issue. Fix this by increasing watchdog task
reference count before calling send_sig() and dropping it by switching to
kthread_stop_put().
In the Linux kernel, the following vulnerability has been resolved:
RDMA/mlx4: Fix mis-use of RCU in mlx4_srq_event()
Sashiko points out the radix_tree itself is RCU safe, but nothing ever
frees the mlx4_srq struct with RCU, and it isn't even accessed within the
RCU critical section. It also will crash if an event is delivered before
the srq object is finished initializing.
Use the spinlock since it isn't easy to make RCU work, use
refcount_inc_not_zero() to protect against partially initialized objects,
and order the refcount_set() to be after the srq is fully initialized.
In the Linux kernel, the following vulnerability has been resolved:
pseries/papr-hvpipe: Prevent kernel stack memory leak to userspace
The hdr variable is allocated on the stack and only hdr.version and
hdr.flags are initialized explicitly. Because the struct papr_hvpipe_hdr
contains reserved padding bytes (reserved[3] and reserved2[40]), these
could leak the uninitialized bytes to userspace after copy_to_user().
This patch fixes that by initializing the whole struct to 0.
In the Linux kernel, the following vulnerability has been resolved:
mm/damon/sysfs-schemes: protect path kfree() with damon_sysfs_lock
damon_sysfs_quot_goal->path can be read and written by users, via DAMON
sysfs 'path' file. It can also be indirectly read, for the parameters
{on,off}line committing to DAMON. The reads for parameters committing are
protected by damon_sysfs_lock to avoid the sysfs files being destroyed
while any of the parameters are being read. But the user-driven direct
reads and writes are not protected by any lock, while the write is
deallocating the path-pointing buffer. As a result, the readers could
read the already freed buffer (user-after-free). Note that the user-reads
don't race when the same open file is used by the writer, due to kernfs's
open file locking. Nonetheless, doing the reads and writes with separate
open files would be common. Fix it by protecting both the user-direct
reads and writes with damon_sysfs_lock.
In the Linux kernel, the following vulnerability has been resolved:
btrfs: fix double free in create_space_info_sub_group() error path
When kobject_init_and_add() fails, the call chain is:
create_space_info_sub_group()
-> btrfs_sysfs_add_space_info_type()
-> kobject_init_and_add()
-> failure
-> kobject_put(&sub_group->kobj)
-> space_info_release()
-> kfree(sub_group)
Then control returns to create_space_info_sub_group(), where:
btrfs_sysfs_add_space_info_type() returns error
-> kfree(sub_group)
Thus, sub_group is freed twice.
Keep parent->sub_group[index] = NULL for the failure path, but after
btrfs_sysfs_add_space_info_type() has called kobject_put(), let the
kobject release callback handle the cleanup.