In the Linux kernel, the following vulnerability has been resolved:
kcsan: Turn report_filterlist_lock into a raw_spinlock
Ran Xiaokai reports that with a KCSAN-enabled PREEMPT_RT kernel, we can see
splats like:
| BUG: sleeping function called from invalid context at kernel/locking/spinlock_rt.c:48
| in_atomic(): 1, irqs_disabled(): 1, non_block: 0, pid: 0, name: swapper/1
| preempt_count: 10002, expected: 0
| RCU nest depth: 0, expected: 0
| no locks held by swapper/1/0.
| irq event stamp: 156674
| hardirqs last enabled at (156673): [<ffffffff81130bd9>] do_idle+0x1f9/0x240
| hardirqs last disabled at (156674): [<ffffffff82254f84>] sysvec_apic_timer_interrupt+0x14/0xc0
| softirqs last enabled at (0): [<ffffffff81099f47>] copy_process+0xfc7/0x4b60
| softirqs last disabled at (0): [<0000000000000000>] 0x0
| Preemption disabled at:
| [<ffffffff814a3e2a>] paint_ptr+0x2a/0x90
| CPU: 1 UID: 0 PID: 0 Comm: swapper/1 Not tainted 6.11.0+ #3
| Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS rel-1.12.0-0-ga698c8995f-prebuilt.qemu.org 04/01/2014
| Call Trace:
| <IRQ>
| dump_stack_lvl+0x7e/0xc0
| dump_stack+0x1d/0x30
| __might_resched+0x1a2/0x270
| rt_spin_lock+0x68/0x170
| kcsan_skip_report_debugfs+0x43/0xe0
| print_report+0xb5/0x590
| kcsan_report_known_origin+0x1b1/0x1d0
| kcsan_setup_watchpoint+0x348/0x650
| __tsan_unaligned_write1+0x16d/0x1d0
| hrtimer_interrupt+0x3d6/0x430
| __sysvec_apic_timer_interrupt+0xe8/0x3a0
| sysvec_apic_timer_interrupt+0x97/0xc0
| </IRQ>
On a detected data race, KCSAN's reporting logic checks if it should
filter the report. That list is protected by the report_filterlist_lock
*non-raw* spinlock which may sleep on RT kernels.
Since KCSAN may report data races in any context, convert it to a
raw_spinlock.
This requires being careful about when to allocate memory for the filter
list itself which can be done via KCSAN's debugfs interface. Concurrent
modification of the filter list via debugfs should be rare: the chosen
strategy is to optimistically pre-allocate memory before the critical
section and discard if unused.
In the Linux kernel, the following vulnerability has been resolved:
mm/mempolicy: fix migrate_to_node() assuming there is at least one VMA in a MM
We currently assume that there is at least one VMA in a MM, which isn't
true.
So we might end up having find_vma() return NULL, to then de-reference
NULL. So properly handle find_vma() returning NULL.
This fixes the report:
Oops: general protection fault, probably for non-canonical address 0xdffffc0000000000: 0000 [#1] PREEMPT SMP KASAN PTI
KASAN: null-ptr-deref in range [0x0000000000000000-0x0000000000000007]
CPU: 1 UID: 0 PID: 6021 Comm: syz-executor284 Not tainted 6.12.0-rc7-syzkaller-00187-gf868cd251776 #0
Hardware name: Google Google Compute Engine/Google Compute Engine, BIOS Google 10/30/2024
RIP: 0010:migrate_to_node mm/mempolicy.c:1090 [inline]
RIP: 0010:do_migrate_pages+0x403/0x6f0 mm/mempolicy.c:1194
Code: ...
RSP: 0018:ffffc9000375fd08 EFLAGS: 00010246
RAX: 0000000000000000 RBX: ffffc9000375fd78 RCX: 0000000000000000
RDX: ffff88807e171300 RSI: dffffc0000000000 RDI: ffff88803390c044
RBP: ffff88807e171428 R08: 0000000000000014 R09: fffffbfff2039ef1
R10: ffffffff901cf78f R11: 0000000000000000 R12: 0000000000000003
R13: ffffc9000375fe90 R14: ffffc9000375fe98 R15: ffffc9000375fdf8
FS: 00005555919e1380(0000) GS:ffff8880b8700000(0000) knlGS:0000000000000000
CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033
CR2: 00005555919e1ca8 CR3: 000000007f12a000 CR4: 00000000003526f0
DR0: 0000000000000000 DR1: 0000000000000000 DR2: 0000000000000000
DR3: 0000000000000000 DR6: 00000000fffe0ff0 DR7: 0000000000000400
Call Trace:
<TASK>
kernel_migrate_pages+0x5b2/0x750 mm/mempolicy.c:1709
__do_sys_migrate_pages mm/mempolicy.c:1727 [inline]
__se_sys_migrate_pages mm/mempolicy.c:1723 [inline]
__x64_sys_migrate_pages+0x96/0x100 mm/mempolicy.c:1723
do_syscall_x64 arch/x86/entry/common.c:52 [inline]
do_syscall_64+0xcd/0x250 arch/x86/entry/common.c:83
entry_SYSCALL_64_after_hwframe+0x77/0x7f
[akpm@linux-foundation.org: add unlikely()]
In the Linux kernel, the following vulnerability has been resolved:
jfs: fix shift-out-of-bounds in dbSplit
When dmt_budmin is less than zero, it causes errors
in the later stages. Added a check to return an error beforehand
in dbAllocCtl itself.
In the Linux kernel, the following vulnerability has been resolved:
jfs: array-index-out-of-bounds fix in dtReadFirst
The value of stbl can be sometimes out of bounds due
to a bad filesystem. Added a check with appopriate return
of error code in that case.
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath10k: avoid NULL pointer error during sdio remove
When running 'rmmod ath10k', ath10k_sdio_remove() will free sdio
workqueue by destroy_workqueue(). But if CONFIG_INIT_ON_FREE_DEFAULT_ON
is set to yes, kernel panic will happen:
Call trace:
destroy_workqueue+0x1c/0x258
ath10k_sdio_remove+0x84/0x94
sdio_bus_remove+0x50/0x16c
device_release_driver_internal+0x188/0x25c
device_driver_detach+0x20/0x2c
This is because during 'rmmod ath10k', ath10k_sdio_remove() will call
ath10k_core_destroy() before destroy_workqueue(). wiphy_dev_release()
will finally be called in ath10k_core_destroy(). This function will free
struct cfg80211_registered_device *rdev and all its members, including
wiphy, dev and the pointer of sdio workqueue. Then the pointer of sdio
workqueue will be set to NULL due to CONFIG_INIT_ON_FREE_DEFAULT_ON.
After device release, destroy_workqueue() will use NULL pointer then the
kernel panic happen.
Call trace:
ath10k_sdio_remove
->ath10k_core_unregister
……
->ath10k_core_stop
->ath10k_hif_stop
->ath10k_sdio_irq_disable
->ath10k_hif_power_down
->del_timer_sync(&ar_sdio->sleep_timer)
->ath10k_core_destroy
->ath10k_mac_destroy
->ieee80211_free_hw
->wiphy_free
……
->wiphy_dev_release
->destroy_workqueue
Need to call destroy_workqueue() before ath10k_core_destroy(), free
the work queue buffer first and then free pointer of work queue by
ath10k_core_destroy(). This order matches the error path order in
ath10k_sdio_probe().
No work will be queued on sdio workqueue between it is destroyed and
ath10k_core_destroy() is called. Based on the call_stack above, the
reason is:
Only ath10k_sdio_sleep_timer_handler(), ath10k_sdio_hif_tx_sg() and
ath10k_sdio_irq_disable() will queue work on sdio workqueue.
Sleep timer will be deleted before ath10k_core_destroy() in
ath10k_hif_power_down().
ath10k_sdio_irq_disable() only be called in ath10k_hif_stop().
ath10k_core_unregister() will call ath10k_hif_power_down() to stop hif
bus, so ath10k_sdio_hif_tx_sg() won't be called anymore.
Tested-on: QCA6174 hw3.2 SDIO WLAN.RMH.4.4.1-00189
In the Linux kernel, the following vulnerability has been resolved:
net: inet6: do not leave a dangling sk pointer in inet6_create()
sock_init_data() attaches the allocated sk pointer to the provided sock
object. If inet6_create() fails later, the sk object is released, but the
sock object retains the dangling sk pointer, which may cause use-after-free
later.
Clear the sock sk pointer on error.
In the Linux kernel, the following vulnerability has been resolved:
net: inet: do not leave a dangling sk pointer in inet_create()
sock_init_data() attaches the allocated sk object to the provided sock
object. If inet_create() fails later, the sk object is freed, but the
sock object retains the dangling pointer, which may create use-after-free
later.
Clear the sk pointer in the sock object on error.