In the Linux kernel, the following vulnerability has been resolved:
tcp_bpf: Fix the sk_mem_uncharge logic in tcp_bpf_sendmsg
The current sk memory accounting logic in __SK_REDIRECT is pre-uncharging
tosend bytes, which is either msg->sg.size or a smaller value apply_bytes.
Potential problems with this strategy are as follows:
- If the actual sent bytes are smaller than tosend, we need to charge some
bytes back, as in line 487, which is okay but seems not clean.
- When tosend is set to apply_bytes, as in line 417, and (ret < 0), we may
miss uncharging (msg->sg.size - apply_bytes) bytes.
[...]
415 tosend = msg->sg.size;
416 if (psock->apply_bytes && psock->apply_bytes < tosend)
417 tosend = psock->apply_bytes;
[...]
443 sk_msg_return(sk, msg, tosend);
444 release_sock(sk);
446 origsize = msg->sg.size;
447 ret = tcp_bpf_sendmsg_redir(sk_redir, redir_ingress,
448 msg, tosend, flags);
449 sent = origsize - msg->sg.size;
[...]
454 lock_sock(sk);
455 if (unlikely(ret < 0)) {
456 int free = sk_msg_free_nocharge(sk, msg);
458 if (!cork)
459 *copied -= free;
460 }
[...]
487 if (eval == __SK_REDIRECT)
488 sk_mem_charge(sk, tosend - sent);
[...]
When running the selftest test_txmsg_redir_wait_sndmem with txmsg_apply,
the following warning will be reported:
------------[ cut here ]------------
WARNING: CPU: 6 PID: 57 at net/ipv4/af_inet.c:156 inet_sock_destruct+0x190/0x1a0
Modules linked in:
CPU: 6 UID: 0 PID: 57 Comm: kworker/6:0 Not tainted 6.12.0-rc1.bm.1-amd64+ #43
Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS 1.12.0-1 04/01/2014
Workqueue: events sk_psock_destroy
RIP: 0010:inet_sock_destruct+0x190/0x1a0
RSP: 0018:ffffad0a8021fe08 EFLAGS: 00010206
RAX: 0000000000000011 RBX: ffff9aab4475b900 RCX: ffff9aab481a0800
RDX: 0000000000000303 RSI: 0000000000000011 RDI: ffff9aab4475b900
RBP: ffff9aab4475b990 R08: 0000000000000000 R09: ffff9aab40050ec0
R10: 0000000000000000 R11: ffff9aae6fdb1d01 R12: ffff9aab49c60400
R13: ffff9aab49c60598 R14: ffff9aab49c60598 R15: dead000000000100
FS: 0000000000000000(0000) GS:ffff9aae6fd80000(0000) knlGS:0000000000000000
CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033
CR2: 00007ffec7e47bd8 CR3: 00000001a1a1c004 CR4: 0000000000770ef0
DR0: 0000000000000000 DR1: 0000000000000000 DR2: 0000000000000000
DR3: 0000000000000000 DR6: 00000000fffe0ff0 DR7: 0000000000000400
PKRU: 55555554
Call Trace:
<TASK>
? __warn+0x89/0x130
? inet_sock_destruct+0x190/0x1a0
? report_bug+0xfc/0x1e0
? handle_bug+0x5c/0xa0
? exc_invalid_op+0x17/0x70
? asm_exc_invalid_op+0x1a/0x20
? inet_sock_destruct+0x190/0x1a0
__sk_destruct+0x25/0x220
sk_psock_destroy+0x2b2/0x310
process_scheduled_works+0xa3/0x3e0
worker_thread+0x117/0x240
? __pfx_worker_thread+0x10/0x10
kthread+0xcf/0x100
? __pfx_kthread+0x10/0x10
ret_from_fork+0x31/0x40
? __pfx_kthread+0x10/0x10
ret_from_fork_asm+0x1a/0x30
</TASK>
---[ end trace 0000000000000000 ]---
In __SK_REDIRECT, a more concise way is delaying the uncharging after sent
bytes are finalized, and uncharge this value. When (ret < 0), we shall
invoke sk_msg_free.
Same thing happens in case __SK_DROP, when tosend is set to apply_bytes,
we may miss uncharging (msg->sg.size - apply_bytes) bytes. The same
warning will be reported in selftest.
[...]
468 case __SK_DROP:
469 default:
470 sk_msg_free_partial(sk, msg, tosend);
471 sk_msg_apply_bytes(psock, tosend);
472 *copied -= (tosend + delta);
473 return -EACCES;
[...]
So instead of sk_msg_free_partial we can do sk_msg_free here.
In the Linux kernel, the following vulnerability has been resolved:
drm/dp_mst: Fix MST sideband message body length check
Fix the MST sideband message body length check, which must be at least 1
byte accounting for the message body CRC (aka message data CRC) at the
end of the message.
This fixes a case where an MST branch device returns a header with a
correct header CRC (indicating a correctly received body length), with
the body length being incorrectly set to 0. This will later lead to a
memory corruption in drm_dp_sideband_append_payload() and the following
errors in dmesg:
UBSAN: array-index-out-of-bounds in drivers/gpu/drm/display/drm_dp_mst_topology.c:786:25
index -1 is out of range for type 'u8 [48]'
Call Trace:
drm_dp_sideband_append_payload+0x33d/0x350 [drm_display_helper]
drm_dp_get_one_sb_msg+0x3ce/0x5f0 [drm_display_helper]
drm_dp_mst_hpd_irq_handle_event+0xc8/0x1580 [drm_display_helper]
memcpy: detected field-spanning write (size 18446744073709551615) of single field "&msg->msg[msg->curlen]" at drivers/gpu/drm/display/drm_dp_mst_topology.c:791 (size 256)
Call Trace:
drm_dp_sideband_append_payload+0x324/0x350 [drm_display_helper]
drm_dp_get_one_sb_msg+0x3ce/0x5f0 [drm_display_helper]
drm_dp_mst_hpd_irq_handle_event+0xc8/0x1580 [drm_display_helper]
In the Linux kernel, the following vulnerability has been resolved:
nilfs2: fix potential out-of-bounds memory access in nilfs_find_entry()
Syzbot reported that when searching for records in a directory where the
inode's i_size is corrupted and has a large value, memory access outside
the folio/page range may occur, or a use-after-free bug may be detected if
KASAN is enabled.
This is because nilfs_last_byte(), which is called by nilfs_find_entry()
and others to calculate the number of valid bytes of directory data in a
page from i_size and the page index, loses the upper 32 bits of the 64-bit
size information due to an inappropriate type of local variable to which
the i_size value is assigned.
This caused a large byte offset value due to underflow in the end address
calculation in the calling nilfs_find_entry(), resulting in memory access
that exceeds the folio/page size.
Fix this issue by changing the type of the local variable causing the bit
loss from "unsigned int" to "u64". The return value of nilfs_last_byte()
is also of type "unsigned int", but it is truncated so as not to exceed
PAGE_SIZE and no bit loss occurs, so no change is required.
In the Linux kernel, the following vulnerability has been resolved:
scsi: ufs: core: sysfs: Prevent div by zero
Prevent a division by 0 when monitoring is not enabled.
In the Linux kernel, the following vulnerability has been resolved:
scsi: qla2xxx: Fix use after free on unload
System crash is observed with stack trace warning of use after
free. There are 2 signals to tell dpc_thread to terminate (UNLOADING
flag and kthread_stop).
On setting the UNLOADING flag when dpc_thread happens to run at the time
and sees the flag, this causes dpc_thread to exit and clean up
itself. When kthread_stop is called for final cleanup, this causes use
after free.
Remove UNLOADING signal to terminate dpc_thread. Use the kthread_stop
as the main signal to exit dpc_thread.
[596663.812935] kernel BUG at mm/slub.c:294!
[596663.812950] invalid opcode: 0000 [#1] SMP PTI
[596663.812957] CPU: 13 PID: 1475935 Comm: rmmod Kdump: loaded Tainted: G IOE --------- - - 4.18.0-240.el8.x86_64 #1
[596663.812960] Hardware name: HP ProLiant DL380p Gen8, BIOS P70 08/20/2012
[596663.812974] RIP: 0010:__slab_free+0x17d/0x360
...
[596663.813008] Call Trace:
[596663.813022] ? __dentry_kill+0x121/0x170
[596663.813030] ? _cond_resched+0x15/0x30
[596663.813034] ? _cond_resched+0x15/0x30
[596663.813039] ? wait_for_completion+0x35/0x190
[596663.813048] ? try_to_wake_up+0x63/0x540
[596663.813055] free_task+0x5a/0x60
[596663.813061] kthread_stop+0xf3/0x100
[596663.813103] qla2x00_remove_one+0x284/0x440 [qla2xxx]
In the Linux kernel, the following vulnerability has been resolved:
af_packet: avoid erroring out after sock_init_data() in packet_create()
After sock_init_data() the allocated sk object is attached to the provided
sock object. On error, packet_create() frees the sk object leaving the
dangling pointer in the sock object on return. Some other code may try
to use this pointer and cause use-after-free.
In the Linux kernel, the following vulnerability has been resolved:
kcsan: Turn report_filterlist_lock into a raw_spinlock
Ran Xiaokai reports that with a KCSAN-enabled PREEMPT_RT kernel, we can see
splats like:
| BUG: sleeping function called from invalid context at kernel/locking/spinlock_rt.c:48
| in_atomic(): 1, irqs_disabled(): 1, non_block: 0, pid: 0, name: swapper/1
| preempt_count: 10002, expected: 0
| RCU nest depth: 0, expected: 0
| no locks held by swapper/1/0.
| irq event stamp: 156674
| hardirqs last enabled at (156673): [<ffffffff81130bd9>] do_idle+0x1f9/0x240
| hardirqs last disabled at (156674): [<ffffffff82254f84>] sysvec_apic_timer_interrupt+0x14/0xc0
| softirqs last enabled at (0): [<ffffffff81099f47>] copy_process+0xfc7/0x4b60
| softirqs last disabled at (0): [<0000000000000000>] 0x0
| Preemption disabled at:
| [<ffffffff814a3e2a>] paint_ptr+0x2a/0x90
| CPU: 1 UID: 0 PID: 0 Comm: swapper/1 Not tainted 6.11.0+ #3
| Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS rel-1.12.0-0-ga698c8995f-prebuilt.qemu.org 04/01/2014
| Call Trace:
| <IRQ>
| dump_stack_lvl+0x7e/0xc0
| dump_stack+0x1d/0x30
| __might_resched+0x1a2/0x270
| rt_spin_lock+0x68/0x170
| kcsan_skip_report_debugfs+0x43/0xe0
| print_report+0xb5/0x590
| kcsan_report_known_origin+0x1b1/0x1d0
| kcsan_setup_watchpoint+0x348/0x650
| __tsan_unaligned_write1+0x16d/0x1d0
| hrtimer_interrupt+0x3d6/0x430
| __sysvec_apic_timer_interrupt+0xe8/0x3a0
| sysvec_apic_timer_interrupt+0x97/0xc0
| </IRQ>
On a detected data race, KCSAN's reporting logic checks if it should
filter the report. That list is protected by the report_filterlist_lock
*non-raw* spinlock which may sleep on RT kernels.
Since KCSAN may report data races in any context, convert it to a
raw_spinlock.
This requires being careful about when to allocate memory for the filter
list itself which can be done via KCSAN's debugfs interface. Concurrent
modification of the filter list via debugfs should be rare: the chosen
strategy is to optimistically pre-allocate memory before the critical
section and discard if unused.