In the Linux kernel, the following vulnerability has been resolved:
scsi: lpfc: Handle mailbox timeouts in lpfc_get_sfp_info
The MBX_TIMEOUT return code is not handled in lpfc_get_sfp_info and the
routine unconditionally frees submitted mailbox commands regardless of
return status. The issue is that for MBX_TIMEOUT cases, when firmware
returns SFP information at a later time, that same mailbox memory region
references previously freed memory in its cmpl routine.
Fix by adding checks for the MBX_TIMEOUT return code. During mailbox
resource cleanup, check the mbox flag to make sure that the wait did not
timeout. If the MBOX_WAKE flag is not set, then do not free the resources
because it will be freed when firmware completes the mailbox at a later
time in its cmpl routine.
Also, increase the timeout from 30 to 60 seconds to accommodate boot
scripts requiring longer timeouts.
In the Linux kernel, the following vulnerability has been resolved:
scsi: ufs: core: Remove SCSI host only if added
If host tries to remove ufshcd driver from a UFS device it would cause a
kernel panic if ufshcd_async_scan fails during ufshcd_probe_hba before
adding a SCSI host with scsi_add_host and MCQ is enabled since SCSI host
has been defered after MCQ configuration introduced by commit 0cab4023ec7b
("scsi: ufs: core: Defer adding host to SCSI if MCQ is supported").
To guarantee that SCSI host is removed only if it has been added, set the
scsi_host_added flag to true after adding a SCSI host and check whether it
is set or not before removing it.
In the Linux kernel, the following vulnerability has been resolved:
um: line: always fill *error_out in setup_one_line()
The pointer isn't initialized by callers, but I have
encountered cases where it's still printed; initialize
it in all possible cases in setup_one_line().
In the Linux kernel, the following vulnerability has been resolved:
perf/x86/intel: Limit the period on Haswell
Running the ltp test cve-2015-3290 concurrently reports the following
warnings.
perfevents: irq loop stuck!
WARNING: CPU: 31 PID: 32438 at arch/x86/events/intel/core.c:3174
intel_pmu_handle_irq+0x285/0x370
Call Trace:
<NMI>
? __warn+0xa4/0x220
? intel_pmu_handle_irq+0x285/0x370
? __report_bug+0x123/0x130
? intel_pmu_handle_irq+0x285/0x370
? __report_bug+0x123/0x130
? intel_pmu_handle_irq+0x285/0x370
? report_bug+0x3e/0xa0
? handle_bug+0x3c/0x70
? exc_invalid_op+0x18/0x50
? asm_exc_invalid_op+0x1a/0x20
? irq_work_claim+0x1e/0x40
? intel_pmu_handle_irq+0x285/0x370
perf_event_nmi_handler+0x3d/0x60
nmi_handle+0x104/0x330
Thanks to Thomas Gleixner's analysis, the issue is caused by the low
initial period (1) of the frequency estimation algorithm, which triggers
the defects of the HW, specifically erratum HSW11 and HSW143. (For the
details, please refer https://lore.kernel.org/lkml/87plq9l5d2.ffs@tglx/)
The HSW11 requires a period larger than 100 for the INST_RETIRED.ALL
event, but the initial period in the freq mode is 1. The erratum is the
same as the BDM11, which has been supported in the kernel. A minimum
period of 128 is enforced as well on HSW.
HSW143 is regarding that the fixed counter 1 may overcount 32 with the
Hyper-Threading is enabled. However, based on the test, the hardware
has more issues than it tells. Besides the fixed counter 1, the message
'interrupt took too long' can be observed on any counter which was armed
with a period < 32 and two events expired in the same NMI. A minimum
period of 32 is enforced for the rest of the events.
The recommended workaround code of the HSW143 is not implemented.
Because it only addresses the issue for the fixed counter. It brings
extra overhead through extra MSR writing. No related overcounting issue
has been reported so far.
In the Linux kernel, the following vulnerability has been resolved:
ELF: fix kernel.randomize_va_space double read
ELF loader uses "randomize_va_space" twice. It is sysctl and can change
at any moment, so 2 loads could see 2 different values in theory with
unpredictable consequences.
Issue exactly one load for consistent value across one exec.
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath12k: fix firmware crash due to invalid peer nss
Currently, if the access point receives an association
request containing an Extended HE Capabilities Information
Element with an invalid MCS-NSS, it triggers a firmware
crash.
This issue arises when EHT-PHY capabilities shows support
for a bandwidth and MCS-NSS set for that particular
bandwidth is filled by zeros and due to this, driver obtains
peer_nss as 0 and sending this value to firmware causes
crash.
Address this issue by implementing a validation step for
the peer_nss value before passing it to the firmware. If
the value is greater than zero, proceed with forwarding
it to the firmware. However, if the value is invalid,
reject the association request to prevent potential
firmware crashes.
Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
In the Linux kernel, the following vulnerability has been resolved:
rtmutex: Drop rt_mutex::wait_lock before scheduling
rt_mutex_handle_deadlock() is called with rt_mutex::wait_lock held. In the
good case it returns with the lock held and in the deadlock case it emits a
warning and goes into an endless scheduling loop with the lock held, which
triggers the 'scheduling in atomic' warning.
Unlock rt_mutex::wait_lock in the dead lock case before issuing the warning
and dropping into the schedule for ever loop.
[ tglx: Moved unlock before the WARN(), removed the pointless comment,
massaged changelog, added Fixes tag ]
In the Linux kernel, the following vulnerability has been resolved:
MIPS: cevt-r4k: Don't call get_c0_compare_int if timer irq is installed
This avoids warning:
[ 0.118053] BUG: sleeping function called from invalid context at kernel/locking/mutex.c:283
Caused by get_c0_compare_int on secondary CPU.
We also skipped saving IRQ number to struct clock_event_device *cd as
it's never used by clockevent core, as per comments it's only meant
for "non CPU local devices".
In the Linux kernel, the following vulnerability has been resolved:
net: hns3: void array out of bound when loop tnl_num
When query reg inf of SSU, it loops tnl_num times. However, tnl_num comes
from hardware and the length of array is a fixed value. To void array out
of bound, make sure the loop time is not greater than the length of array
In the Linux kernel, the following vulnerability has been resolved:
ethtool: fail closed if we can't get max channel used in indirection tables
Commit 0d1b7d6c9274 ("bnxt: fix crashes when reducing ring count with
active RSS contexts") proves that allowing indirection table to contain
channels with out of bounds IDs may lead to crashes. Currently the
max channel check in the core gets skipped if driver can't fetch
the indirection table or when we can't allocate memory.
Both of those conditions should be extremely rare but if they do
happen we should try to be safe and fail the channel change.