Linux: >> Linux Kernel >> 5.4.268 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
ipvs: do not keep dest_dst if dev is going down
There is race between the netdev notifier ip_vs_dst_event()
and the code that caches dst with dev that is going down.
As the FIB can be notified for the closed device after our
handler finishes, it is possible valid route to be returned
and cached resuling in a leaked dev reference until the dest
is not removed.
To prevent new dest_dst to be attached to dest just after the
handler dropped the old one, add a netif_running() check
to make sure the notifier handler is not currently running
for device that is closing.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
sched/rt: Skip currently executing CPU in rto_next_cpu()
CPU0 becomes overloaded when hosting a CPU-bound RT task, a non-CPU-bound
RT task, and a CFS task stuck in kernel space. When other CPUs switch from
RT to non-RT tasks, RT load balancing (LB) is triggered; with
HAVE_RT_PUSH_IPI enabled, they send IPIs to CPU0 to drive the execution
of rto_push_irq_work_func. During push_rt_task on CPU0,
if next_task->prio < rq->donor->prio, resched_curr() sets NEED_RESCHED
and after the push operation completes, CPU0 calls rto_next_cpu().
Since only CPU0 is overloaded in this scenario, rto_next_cpu() should
ideally return -1 (no further IPI needed).
However, multiple CPUs invoking tell_cpu_to_push() during LB increments
rd->rto_loop_next. Even when rd->rto_cpu is set to -1, the mismatch between
rd->rto_loop and rd->rto_loop_next forces rto_next_cpu() to restart its
search from -1. With CPU0 remaining overloaded (satisfying rt_nr_migratory
&& rt_nr_total > 1), it gets reselected, causing CPU0 to queue irq_work to
itself and send self-IPIs repeatedly. As long as CPU0 stays overloaded and
other CPUs run pull_rt_tasks(), it falls into an infinite self-IPI loop,
which triggers a CPU hardlockup due to continuous self-interrupts.
The trigging scenario is as follows:
cpu0 cpu1 cpu2
pull_rt_task
tell_cpu_to_push
<------------irq_work_queue_on
rto_push_irq_work_func
push_rt_task
resched_curr(rq) pull_rt_task
rto_next_cpu tell_cpu_to_push
<-------------------------- atomic_inc(rto_loop_next)
rd->rto_loop != next
rto_next_cpu
irq_work_queue_on
rto_push_irq_work_func
Fix redundant self-IPI by filtering the initiating CPU in rto_next_cpu().
This solution has been verified to effectively eliminate spurious self-IPIs
and prevent CPU hardlockup scenarios.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
ext4: fix dirtyclusters double decrement on fs shutdown
fstests test generic/388 occasionally reproduces a warning in
ext4_put_super() associated with the dirty clusters count:
WARNING: CPU: 7 PID: 76064 at fs/ext4/super.c:1324 ext4_put_super+0x48c/0x590 [ext4]
Tracing the failure shows that the warning fires due to an
s_dirtyclusters_counter value of -1. IOW, this appears to be a
spurious decrement as opposed to some sort of leak. Further tracing
of the dirty cluster count deltas and an LLM scan of the resulting
output identified the cause as a double decrement in the error path
between ext4_mb_mark_diskspace_used() and the caller
ext4_mb_new_blocks().
First, note that generic/388 is a shutdown vs. fsstress test and so
produces a random set of operations and shutdown injections. In the
problematic case, the shutdown triggers an error return from the
ext4_handle_dirty_metadata() call(s) made from
ext4_mb_mark_context(). The changed value is non-zero at this point,
so ext4_mb_mark_diskspace_used() does not exit after the error
bubbles up from ext4_mb_mark_context(). Instead, the former
decrements both cluster counters and returns the error up to
ext4_mb_new_blocks(). The latter falls into the !ar->len out path
which decrements the dirty clusters counter a second time, creating
the inconsistency.
To avoid this problem and simplify ownership of the cluster
reservation in this codepath, lift the counter reduction to a single
place in the caller. This makes it more clear that
ext4_mb_new_blocks() is responsible for acquiring cluster
reservation (via ext4_claim_free_clusters()) in the !delalloc case
as well as releasing it, regardless of whether it ends up consumed
or returned due to failure.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
ext4: don't cache extent during splitting extent
Caching extents during the splitting process is risky, as it may result
in stale extents remaining in the status tree. Moreover, in most cases,
the corresponding extent block entries are likely already cached before
the split happens, making caching here not particularly useful.
Assume we have an unwritten extent, and then DIO writes the first half.
[UUUUUUUUUUUUUUUU] on-disk extent U: unwritten extent
[UUUUUUUUUUUUUUUU] extent status tree
|<- ->| ----> dio write this range
First, when ext4_split_extent_at() splits this extent, it truncates the
existing extent and then inserts a new one. During this process, this
extent status entry may be shrunk, and calls to ext4_find_extent() and
ext4_cache_extents() may occur, which could potentially insert the
truncated range as a hole into the extent status tree. After the split
is completed, this hole is not replaced with the correct status.
[UUUUUUU|UUUUUUUU] on-disk extent U: unwritten extent
[UUUUUUU|HHHHHHHH] extent status tree H: hole
Then, the outer calling functions will not correct this remaining hole
extent either. Finally, if we perform a delayed buffer write on this
latter part, it will re-insert the delayed extent and cause an error in
space accounting.
In adition, if the unwritten extent cache is not shrunk during the
splitting, ext4_cache_extents() also conflicts with existing extents
when caching extents. In the future, we will add checks when caching
extents, which will trigger a warning. Therefore, Do not cache extents
that are being split.
CVSS Score
5.5
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
xfrm: fix ip_rt_bug race in icmp_route_lookup reverse path
icmp_route_lookup() performs multiple route lookups to find a suitable
route for sending ICMP error messages, with special handling for XFRM
(IPsec) policies.
The lookup sequence is:
1. First, lookup output route for ICMP reply (dst = original src)
2. Pass through xfrm_lookup() for policy check
3. If blocked (-EPERM) or dst is not local, enter "reverse path"
4. In reverse path, call xfrm_decode_session_reverse() to get fl4_dec
which reverses the original packet's flow (saddr<->daddr swapped)
5. If fl4_dec.saddr is local (we are the original destination), use
__ip_route_output_key() for output route lookup
6. If fl4_dec.saddr is NOT local (we are a forwarding node), use
ip_route_input() to simulate the reverse packet's input path
7. Finally, pass rt2 through xfrm_lookup() with XFRM_LOOKUP_ICMP flag
The bug occurs in step 6: ip_route_input() is called with fl4_dec.daddr
(original packet's source) as destination. If this address becomes local
between the initial check and ip_route_input() call (e.g., due to
concurrent "ip addr add"), ip_route_input() returns a LOCAL route with
dst.output set to ip_rt_bug.
This route is then used for ICMP output, causing dst_output() to call
ip_rt_bug(), triggering a WARN_ON:
------------[ cut here ]------------
WARNING: net/ipv4/route.c:1275 at ip_rt_bug+0x21/0x30, CPU#1
Call Trace:
<TASK>
ip_push_pending_frames+0x202/0x240
icmp_push_reply+0x30d/0x430
__icmp_send+0x1149/0x24f0
ip_options_compile+0xa2/0xd0
ip_rcv_finish_core+0x829/0x1950
ip_rcv+0x2d7/0x420
__netif_receive_skb_one_core+0x185/0x1f0
netif_receive_skb+0x90/0x450
tun_get_user+0x3413/0x3fb0
tun_chr_write_iter+0xe4/0x220
...
Fix this by checking rt2->rt_type after ip_route_input(). If it's
RTN_LOCAL, the route cannot be used for output, so treat it as an error.
The reproducer requires kernel modification to widen the race window,
making it unsuitable as a selftest. It is available at:
https://gist.github.com/mrpre/eae853b72ac6a750f5d45d64ddac1e81
CVSS Score
4.7
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
ext4: drop extent cache when splitting extent fails
When the split extent fails, we might leave some extents still being
processed and return an error directly, which will result in stale
extent entries remaining in the extent status tree. So drop all of the
remaining potentially stale extents if the splitting fails.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
xen-netback: reject zero-queue configuration from guest
A malicious or buggy Xen guest can write "0" to the xenbus key
"multi-queue-num-queues". The connect() function in the backend only
validates the upper bound (requested_num_queues > xenvif_max_queues)
but not zero, allowing requested_num_queues=0 to reach
vzalloc(array_size(0, sizeof(struct xenvif_queue))), which triggers
WARN_ON_ONCE(!size) in __vmalloc_node_range().
On systems with panic_on_warn=1, this allows a guest-to-host denial
of service.
The Xen network interface specification requires
the queue count to be "greater than zero".
Add a zero check to match the validation already present
in xen-blkback, which has included this
guard since its multi-queue support was added.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
apparmor: Fix & Optimize table creation from possibly unaligned memory
Source blob may come from userspace and might be unaligned.
Try to optize the copying process by avoiding unaligned memory accesses.
- Added Fixes tag
- Added "Fix &" to description as this doesn't just optimize but fixes
a potential unaligned memory access
[jj: remove duplicate word "convert" in comment trigger checkpatch warning]
CVSS Score
7.1
EPSS Score
0.002
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
iommu/vt-d: Clear Present bit before tearing down PASID entry
The Intel VT-d Scalable Mode PASID table entry consists of 512 bits (64
bytes). When tearing down an entry, the current implementation zeros the
entire 64-byte structure immediately using multiple 64-bit writes.
Since the IOMMU hardware may fetch these 64 bytes using multiple
internal transactions (e.g., four 128-bit bursts), updating or zeroing
the entire entry while it is active (P=1) risks a "torn" read. If a
hardware fetch occurs simultaneously with the CPU zeroing the entry, the
hardware could observe an inconsistent state, leading to unpredictable
behavior or spurious faults.
Follow the "Guidance to Software for Invalidations" in the VT-d spec
(Section 6.5.3.3) by implementing the recommended ownership handshake:
1. Clear only the 'Present' (P) bit of the PASID entry.
2. Use a dma_wmb() to ensure the cleared bit is visible to hardware
before proceeding.
3. Execute the required invalidation sequence (PASID cache, IOTLB, and
Device-TLB flush) to ensure the hardware has released all cached
references.
4. Only after the flushes are complete, zero out the remaining fields
of the PASID entry.
Also, add a dma_wmb() in pasid_set_present() to ensure that all other
fields of the PASID entry are visible to the hardware before the Present
bit is set.
CVSS Score
7.8
EPSS Score
0.001
Published
2026-05-27
In the Linux kernel, the following vulnerability has been resolved:
iio: sca3000: Fix a resource leak in sca3000_probe()
spi->irq from request_threaded_irq() not released when
iio_device_register() fails. Add an return value check and jump to a
common error handler when iio_device_register() fails.
CVSS Score
5.5
EPSS Score
0.002
Published
2026-05-27