Linux: >> Linux Kernel >> 4.10.5 Security Vulnerabilities
In the Linux kernel, the following vulnerability has been resolved:
jffs2: Prevent rtime decompress memory corruption
The rtime decompression routine does not fully check bounds during the
entirety of the decompression pass and can corrupt memory outside the
decompression buffer if the compressed data is corrupted. This adds the
required check to prevent this failure mode.
CVSS Score
7.8
EPSS Score
0.0
Published
2025-01-11
In the Linux kernel, the following vulnerability has been resolved:
scsi: ufs: pltfrm: Dellocate HBA during ufshcd_pltfrm_remove()
This will ensure that the scsi host is cleaned up properly using
scsi_host_dev_release(). Otherwise, it may lead to memory leaks.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-01-11
In the Linux kernel, the following vulnerability has been resolved:
block: RCU protect disk->conv_zones_bitmap
Ensure that a disk revalidation changing the conventional zones bitmap
of a disk does not cause invalid memory references when using the
disk_zone_is_conv() helper by RCU protecting the disk->conv_zones_bitmap
pointer.
disk_zone_is_conv() is modified to operate under the RCU read lock and
the function disk_set_conv_zones_bitmap() is added to update a disk
conv_zones_bitmap pointer using rcu_replace_pointer() with the disk
zone_wplugs_lock spinlock held.
disk_free_zone_resources() is modified to call
disk_update_zone_resources() with a NULL bitmap pointer to free the disk
conv_zones_bitmap. disk_set_conv_zones_bitmap() is also used in
disk_update_zone_resources() to set the new (revalidated) bitmap and
free the old one.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-01-11
In the Linux kernel, the following vulnerability has been resolved:
PCI: imx6: Fix suspend/resume support on i.MX6QDL
The suspend/resume functionality is currently broken on the i.MX6QDL
platform, as documented in the NXP errata (ERR005723):
https://www.nxp.com/docs/en/errata/IMX6DQCE.pdf
This patch addresses the issue by sharing most of the suspend/resume
sequences used by other i.MX devices, while avoiding modifications to
critical registers that disrupt the PCIe functionality. It targets the
same problem as the following downstream commit:
https://github.com/nxp-imx/linux-imx/commit/4e92355e1f79d225ea842511fcfd42b343b32995
Unlike the downstream commit, this patch also resets the connected PCIe
device if possible. Without this reset, certain drivers, such as ath10k
or iwlwifi, will crash on resume. The device reset is also done by the
driver on other i.MX platforms, making this patch consistent with
existing practices.
Upon resuming, the kernel will hang and display an error. Here's an
example of the error encountered with the ath10k driver:
ath10k_pci 0000:01:00.0: Unable to change power state from D3hot to D0, device inaccessible
Unhandled fault: imprecise external abort (0x1406) at 0x0106f944
Without this patch, suspend/resume will fail on i.MX6QDL devices if a
PCIe device is connected.
[kwilczynski: commit log, added tag for stable releases]
CVSS Score
5.5
EPSS Score
0.0
Published
2025-01-11
In the Linux kernel, the following vulnerability has been resolved:
s390/entry: Mark IRQ entries to fix stack depot warnings
The stack depot filters out everything outside of the top interrupt
context as an uninteresting or irrelevant part of the stack traces. This
helps with stack trace de-duplication, avoiding an explosion of saved
stack traces that share the same IRQ context code path but originate
from different randomly interrupted points, eventually exhausting the
stack depot.
Filtering uses in_irqentry_text() to identify functions within the
.irqentry.text and .softirqentry.text sections, which then become the
last stack trace entries being saved.
While __do_softirq() is placed into the .softirqentry.text section by
common code, populating .irqentry.text is architecture-specific.
Currently, the .irqentry.text section on s390 is empty, which prevents
stack depot filtering and de-duplication and could result in warnings
like:
Stack depot reached limit capacity
WARNING: CPU: 0 PID: 286113 at lib/stackdepot.c:252 depot_alloc_stack+0x39a/0x3c8
with PREEMPT and KASAN enabled.
Fix this by moving the IO/EXT interrupt handlers from .kprobes.text into
the .irqentry.text section and updating the kprobes blacklist to include
the .irqentry.text section.
This is done only for asynchronous interrupts and explicitly not for
program checks, which are synchronous and where the context beyond the
program check is important to preserve. Despite machine checks being
somewhat in between, they are extremely rare, and preserving context
when possible is also of value.
SVCs and Restart Interrupts are not relevant, one being always at the
boundary to user space and the other being a one-time thing.
IRQ entries filtering is also optionally used in ftrace function graph,
where the same logic applies.
CVSS Score
7.1
EPSS Score
0.0
Published
2025-01-11
In the Linux kernel, the following vulnerability has been resolved:
scsi: megaraid_sas: Fix for a potential deadlock
This fixes a 'possible circular locking dependency detected' warning
CPU0 CPU1
---- ----
lock(&instance->reset_mutex);
lock(&shost->scan_mutex);
lock(&instance->reset_mutex);
lock(&shost->scan_mutex);
Fix this by temporarily releasing the reset_mutex.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-01-11
In the Linux kernel, the following vulnerability has been resolved:
drm/dp_mst: Ensure mst_primary pointer is valid in drm_dp_mst_handle_up_req()
While receiving an MST up request message from one thread in
drm_dp_mst_handle_up_req(), the MST topology could be removed from
another thread via drm_dp_mst_topology_mgr_set_mst(false), freeing
mst_primary and setting drm_dp_mst_topology_mgr::mst_primary to NULL.
This could lead to a NULL deref/use-after-free of mst_primary in
drm_dp_mst_handle_up_req().
Avoid the above by holding a reference for mst_primary in
drm_dp_mst_handle_up_req() while it's used.
v2: Fix kfreeing the request if getting an mst_primary reference fails.
CVSS Score
7.8
EPSS Score
0.0
Published
2025-01-11
In the Linux kernel, the following vulnerability has been resolved:
Drivers: hv: util: Avoid accessing a ringbuffer not initialized yet
If the KVP (or VSS) daemon starts before the VMBus channel's ringbuffer is
fully initialized, we can hit the panic below:
hv_utils: Registering HyperV Utility Driver
hv_vmbus: registering driver hv_utils
...
BUG: kernel NULL pointer dereference, address: 0000000000000000
CPU: 44 UID: 0 PID: 2552 Comm: hv_kvp_daemon Tainted: G E 6.11.0-rc3+ #1
RIP: 0010:hv_pkt_iter_first+0x12/0xd0
Call Trace:
...
vmbus_recvpacket
hv_kvp_onchannelcallback
vmbus_on_event
tasklet_action_common
tasklet_action
handle_softirqs
irq_exit_rcu
sysvec_hyperv_stimer0
</IRQ>
<TASK>
asm_sysvec_hyperv_stimer0
...
kvp_register_done
hvt_op_read
vfs_read
ksys_read
__x64_sys_read
This can happen because the KVP/VSS channel callback can be invoked
even before the channel is fully opened:
1) as soon as hv_kvp_init() -> hvutil_transport_init() creates
/dev/vmbus/hv_kvp, the kvp daemon can open the device file immediately and
register itself to the driver by writing a message KVP_OP_REGISTER1 to the
file (which is handled by kvp_on_msg() ->kvp_handle_handshake()) and
reading the file for the driver's response, which is handled by
hvt_op_read(), which calls hvt->on_read(), i.e. kvp_register_done().
2) the problem with kvp_register_done() is that it can cause the
channel callback to be called even before the channel is fully opened,
and when the channel callback is starting to run, util_probe()->
vmbus_open() may have not initialized the ringbuffer yet, so the
callback can hit the panic of NULL pointer dereference.
To reproduce the panic consistently, we can add a "ssleep(10)" for KVP in
__vmbus_open(), just before the first hv_ringbuffer_init(), and then we
unload and reload the driver hv_utils, and run the daemon manually within
the 10 seconds.
Fix the panic by reordering the steps in util_probe() so the char dev
entry used by the KVP or VSS daemon is not created until after
vmbus_open() has completed. This reordering prevents the race condition
from happening.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-01-11
In the Linux kernel, the following vulnerability has been resolved:
drm/modes: Avoid divide by zero harder in drm_mode_vrefresh()
drm_mode_vrefresh() is trying to avoid divide by zero
by checking whether htotal or vtotal are zero. But we may
still end up with a div-by-zero of vtotal*htotal*...
CVSS Score
5.5
EPSS Score
0.0
Published
2025-01-11
In the Linux kernel, the following vulnerability has been resolved:
netfilter: IDLETIMER: Fix for possible ABBA deadlock
Deletion of the last rule referencing a given idletimer may happen at
the same time as a read of its file in sysfs:
| ======================================================
| WARNING: possible circular locking dependency detected
| 6.12.0-rc7-01692-g5e9a28f41134-dirty #594 Not tainted
| ------------------------------------------------------
| iptables/3303 is trying to acquire lock:
| ffff8881057e04b8 (kn->active#48){++++}-{0:0}, at: __kernfs_remove+0x20
|
| but task is already holding lock:
| ffffffffa0249068 (list_mutex){+.+.}-{3:3}, at: idletimer_tg_destroy_v]
|
| which lock already depends on the new lock.
A simple reproducer is:
| #!/bin/bash
|
| while true; do
| iptables -A INPUT -i foo -j IDLETIMER --timeout 10 --label "testme"
| iptables -D INPUT -i foo -j IDLETIMER --timeout 10 --label "testme"
| done &
| while true; do
| cat /sys/class/xt_idletimer/timers/testme >/dev/null
| done
Avoid this by freeing list_mutex right after deleting the element from
the list, then continuing with the teardown.
CVSS Score
5.5
EPSS Score
0.0
Published
2025-01-11