In the Linux kernel, the following vulnerability has been resolved:
firewire: net: fix use after free in fwnet_finish_incoming_packet()
The netif_rx() function frees the skb so we can't dereference it to
save the skb->len.
In the Linux kernel, the following vulnerability has been resolved:
x86/MCE: Always save CS register on AMD Zen IF Poison errors
The Instruction Fetch (IF) units on current AMD Zen-based systems do not
guarantee a synchronous #MC is delivered for poison consumption errors.
Therefore, MCG_STATUS[EIPV|RIPV] will not be set. However, the
microarchitecture does guarantee that the exception is delivered within
the same context. In other words, the exact rIP is not known, but the
context is known to not have changed.
There is no architecturally-defined method to determine this behavior.
The Code Segment (CS) register is always valid on such IF unit poison
errors regardless of the value of MCG_STATUS[EIPV|RIPV].
Add a quirk to save the CS register for poison consumption from the IF
unit banks.
This is needed to properly determine the context of the error.
Otherwise, the severity grading function will assume the context is
IN_KERNEL due to the m->cs value being 0 (the initialized value). This
leads to unnecessary kernel panics on data poison errors due to the
kernel believing the poison consumption occurred in kernel context.
In the Linux kernel, the following vulnerability has been resolved:
btrfs: don't check PageError in __extent_writepage
__extent_writepage currenly sets PageError whenever any error happens,
and the also checks for PageError to decide if to call error handling.
This leads to very unclear responsibility for cleaning up on errors.
In the VM and generic writeback helpers the basic idea is that once
I/O is fired off all error handling responsibility is delegated to the
end I/O handler. But if that end I/O handler sets the PageError bit,
and the submitter checks it, the bit could in some cases leak into the
submission context for fast enough I/O.
Fix this by simply not checking PageError and just using the local
ret variable to check for submission errors. This also fundamentally
solves the long problem documented in a comment in __extent_writepage
by never leaking the error bit into the submission context.
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath11k: mhi: fix potential memory leak in ath11k_mhi_register()
mhi_alloc_controller() allocates a memory space for mhi_ctrl. When gets
some error, mhi_ctrl should be freed with mhi_free_controller(). But
when ath11k_mhi_read_addr_from_dt() fails, the function returns without
calling mhi_free_controller(), which will lead to a memory leak.
We can fix it by calling mhi_free_controller() when
ath11k_mhi_read_addr_from_dt() fails.
In the Linux kernel, the following vulnerability has been resolved:
blk-cgroup: Reinit blkg_iostat_set after clearing in blkcg_reset_stats()
When blkg_alloc() is called to allocate a blkcg_gq structure
with the associated blkg_iostat_set's, there are 2 fields within
blkg_iostat_set that requires proper initialization - blkg & sync.
The former field was introduced by commit 3b8cc6298724 ("blk-cgroup:
Optimize blkcg_rstat_flush()") while the later one was introduced by
commit f73316482977 ("blk-cgroup: reimplement basic IO stats using
cgroup rstat").
Unfortunately those fields in the blkg_iostat_set's are not properly
re-initialized when they are cleared in v1's blkcg_reset_stats(). This
can lead to a kernel panic due to NULL pointer access of the blkg
pointer. The missing initialization of sync is less problematic and
can be a problem in a debug kernel due to missing lockdep initialization.
Fix these problems by re-initializing them after memory clearing.
In the Linux kernel, the following vulnerability has been resolved:
NFSD: Protect against send buffer overflow in NFSv2 READ
Since before the git era, NFSD has conserved the number of pages
held by each nfsd thread by combining the RPC receive and send
buffers into a single array of pages. This works because there are
no cases where an operation needs a large RPC Call message and a
large RPC Reply at the same time.
Once an RPC Call has been received, svc_process() updates
svc_rqst::rq_res to describe the part of rq_pages that can be
used for constructing the Reply. This means that the send buffer
(rq_res) shrinks when the received RPC record containing the RPC
Call is large.
A client can force this shrinkage on TCP by sending a correctly-
formed RPC Call header contained in an RPC record that is
excessively large. The full maximum payload size cannot be
constructed in that case.
In the Linux kernel, the following vulnerability has been resolved:
drm: bridge: adv7511: unregister cec i2c device after cec adapter
cec_unregister_adapter() assumes that the underlying adapter ops are
callable. For example, if the CEC adapter currently has a valid physical
address, then the unregistration procedure will invalidate the physical
address by setting it to f.f.f.f. Whence the following kernel oops
observed after removing the adv7511 module:
Unable to handle kernel execution of user memory at virtual address 0000000000000000
Internal error: Oops: 86000004 [#1] PREEMPT_RT SMP
Call trace:
0x0
adv7511_cec_adap_log_addr+0x1ac/0x1c8 [adv7511]
cec_adap_unconfigure+0x44/0x90 [cec]
__cec_s_phys_addr.part.0+0x68/0x230 [cec]
__cec_s_phys_addr+0x40/0x50 [cec]
cec_unregister_adapter+0xb4/0x118 [cec]
adv7511_remove+0x60/0x90 [adv7511]
i2c_device_remove+0x34/0xe0
device_release_driver_internal+0x114/0x1f0
driver_detach+0x54/0xe0
bus_remove_driver+0x60/0xd8
driver_unregister+0x34/0x60
i2c_del_driver+0x2c/0x68
adv7511_exit+0x1c/0x67c [adv7511]
__arm64_sys_delete_module+0x154/0x288
invoke_syscall+0x48/0x100
el0_svc_common.constprop.0+0x48/0xe8
do_el0_svc+0x28/0x88
el0_svc+0x1c/0x50
el0t_64_sync_handler+0xa8/0xb0
el0t_64_sync+0x15c/0x160
Code: bad PC value
---[ end trace 0000000000000000 ]---
Protect against this scenario by unregistering i2c_cec after
unregistering the CEC adapter. Duly disable the CEC clock afterwards
too.
In the Linux kernel, the following vulnerability has been resolved:
crypto: hisilicon/qm - increase the memory of local variables
Increase the buffer to prevent stack overflow by fuzz test. The maximum
length of the qos configuration buffer is 256 bytes. Currently, the value
of the 'val buffer' is only 32 bytes. The sscanf does not check the dest
memory length. So the 'val buffer' may stack overflow.
In the Linux kernel, the following vulnerability has been resolved:
USB: dwc3: fix memory leak with using debugfs_lookup()
When calling debugfs_lookup() the result must have dput() called on it,
otherwise the memory will leak over time. To make things simpler, just
call debugfs_lookup_and_remove() instead which handles all of the logic
at once.
Note, the root dentry for the debugfs directory for the device needs to
be saved so we don't have to keep looking it up, which required a bit
more refactoring to properly create and remove it when needed.