In the Linux kernel, the following vulnerability has been resolved:
HID: ignore non-functional sensor in HP 5MP Camera
The HP 5MP Camera (USB ID 0408:5473) reports a HID sensor interface that
is not actually implemented. Attempting to access this non-functional
sensor via iio_info causes system hangs as runtime PM tries to wake up
an unresponsive sensor.
[453] hid-sensor-hub 0003:0408:5473.0003: Report latency attributes: ffffffff:ffffffff
[453] hid-sensor-hub 0003:0408:5473.0003: common attributes: 5:1, 2:1, 3:1 ffffffff:ffffffff
Add this device to the HID ignore list since the sensor interface is
non-functional by design and should not be exposed to userspace.
In the Linux kernel, the following vulnerability has been resolved:
iscsi_ibft: Fix UBSAN shift-out-of-bounds warning in ibft_attr_show_nic()
When performing an iSCSI boot using IPv6, iscsistart still reads the
/sys/firmware/ibft/ethernetX/subnet-mask entry. Since the IPv6 prefix
length is 64, this causes the shift exponent to become negative,
triggering a UBSAN warning. As the concept of a subnet mask does not
apply to IPv6, the value is set to ~0 to suppress the warning message.
In the Linux kernel, the following vulnerability has been resolved:
net: switchdev: Convert blocking notification chain to a raw one
A blocking notification chain uses a read-write semaphore to protect the
integrity of the chain. The semaphore is acquired for writing when
adding / removing notifiers to / from the chain and acquired for reading
when traversing the chain and informing notifiers about an event.
In case of the blocking switchdev notification chain, recursive
notifications are possible which leads to the semaphore being acquired
twice for reading and to lockdep warnings being generated [1].
Specifically, this can happen when the bridge driver processes a
SWITCHDEV_BRPORT_UNOFFLOADED event which causes it to emit notifications
about deferred events when calling switchdev_deferred_process().
Fix this by converting the notification chain to a raw notification
chain in a similar fashion to the netdev notification chain. Protect
the chain using the RTNL mutex by acquiring it when modifying the chain.
Events are always informed under the RTNL mutex, but add an assertion in
call_switchdev_blocking_notifiers() to make sure this is not violated in
the future.
Maintain the "blocking" prefix as events are always emitted from process
context and listeners are allowed to block.
[1]:
WARNING: possible recursive locking detected
6.14.0-rc4-custom-g079270089484 #1 Not tainted
--------------------------------------------
ip/52731 is trying to acquire lock:
ffffffff850918d8 ((switchdev_blocking_notif_chain).rwsem){++++}-{4:4}, at: blocking_notifier_call_chain+0x58/0xa0
but task is already holding lock:
ffffffff850918d8 ((switchdev_blocking_notif_chain).rwsem){++++}-{4:4}, at: blocking_notifier_call_chain+0x58/0xa0
other info that might help us debug this:
Possible unsafe locking scenario:
CPU0
----
lock((switchdev_blocking_notif_chain).rwsem);
lock((switchdev_blocking_notif_chain).rwsem);
*** DEADLOCK ***
May be due to missing lock nesting notation
3 locks held by ip/52731:
#0: ffffffff84f795b0 (rtnl_mutex){+.+.}-{4:4}, at: rtnl_newlink+0x727/0x1dc0
#1: ffffffff8731f628 (&net->rtnl_mutex){+.+.}-{4:4}, at: rtnl_newlink+0x790/0x1dc0
#2: ffffffff850918d8 ((switchdev_blocking_notif_chain).rwsem){++++}-{4:4}, at: blocking_notifier_call_chain+0x58/0xa0
stack backtrace:
...
? __pfx_down_read+0x10/0x10
? __pfx_mark_lock+0x10/0x10
? __pfx_switchdev_port_attr_set_deferred+0x10/0x10
blocking_notifier_call_chain+0x58/0xa0
switchdev_port_attr_notify.constprop.0+0xb3/0x1b0
? __pfx_switchdev_port_attr_notify.constprop.0+0x10/0x10
? mark_held_locks+0x94/0xe0
? switchdev_deferred_process+0x11a/0x340
switchdev_port_attr_set_deferred+0x27/0xd0
switchdev_deferred_process+0x164/0x340
br_switchdev_port_unoffload+0xc8/0x100 [bridge]
br_switchdev_blocking_event+0x29f/0x580 [bridge]
notifier_call_chain+0xa2/0x440
blocking_notifier_call_chain+0x6e/0xa0
switchdev_bridge_port_unoffload+0xde/0x1a0
...
In the Linux kernel, the following vulnerability has been resolved:
drm/hyperv: Fix address space leak when Hyper-V DRM device is removed
When a Hyper-V DRM device is probed, the driver allocates MMIO space for
the vram, and maps it cacheable. If the device removed, or in the error
path for device probing, the MMIO space is released but no unmap is done.
Consequently the kernel address space for the mapping is leaked.
Fix this by adding iounmap() calls in the device removal path, and in the
error path during device probing.
In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: cancel wiphy_work before freeing wiphy
A wiphy_work can be queued from the moment the wiphy is allocated and
initialized (i.e. wiphy_new_nm). When a wiphy_work is queued, the
rdev::wiphy_work is getting queued.
If wiphy_free is called before the rdev::wiphy_work had a chance to run,
the wiphy memory will be freed, and then when it eventally gets to run
it'll use invalid memory.
Fix this by canceling the work before freeing the wiphy.
In the Linux kernel, the following vulnerability has been resolved:
sched: address a potential NULL pointer dereference in the GRED scheduler.
If kzalloc in gred_init returns a NULL pointer, the code follows the
error handling path, invoking gred_destroy. This, in turn, calls
gred_offload, where memset could receive a NULL pointer as input,
potentially leading to a kernel crash.
When table->opt is NULL in gred_init(), gred_change_table_def()
is not called yet, so it is not necessary to call ->ndo_setup_tc()
in gred_offload().
In the Linux kernel, the following vulnerability has been resolved:
ice: fix memory leak in aRFS after reset
Fix aRFS (accelerated Receive Flow Steering) structures memory leak by
adding a checker to verify if aRFS memory is already allocated while
configuring VSI. aRFS objects are allocated in two cases:
- as part of VSI initialization (at probe), and
- as part of reset handling
However, VSI reconfiguration executed during reset involves memory
allocation one more time, without prior releasing already allocated
resources. This led to the memory leak with the following signature:
[root@os-delivery ~]# cat /sys/kernel/debug/kmemleak
unreferenced object 0xff3c1ca7252e6000 (size 8192):
comm "kworker/0:0", pid 8, jiffies 4296833052
hex dump (first 32 bytes):
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................
backtrace (crc 0):
[<ffffffff991ec485>] __kmalloc_cache_noprof+0x275/0x340
[<ffffffffc0a6e06a>] ice_init_arfs+0x3a/0xe0 [ice]
[<ffffffffc09f1027>] ice_vsi_cfg_def+0x607/0x850 [ice]
[<ffffffffc09f244b>] ice_vsi_setup+0x5b/0x130 [ice]
[<ffffffffc09c2131>] ice_init+0x1c1/0x460 [ice]
[<ffffffffc09c64af>] ice_probe+0x2af/0x520 [ice]
[<ffffffff994fbcd3>] local_pci_probe+0x43/0xa0
[<ffffffff98f07103>] work_for_cpu_fn+0x13/0x20
[<ffffffff98f0b6d9>] process_one_work+0x179/0x390
[<ffffffff98f0c1e9>] worker_thread+0x239/0x340
[<ffffffff98f14abc>] kthread+0xcc/0x100
[<ffffffff98e45a6d>] ret_from_fork+0x2d/0x50
[<ffffffff98e083ba>] ret_from_fork_asm+0x1a/0x30
...
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Fix out-of-bound accesses
[WHAT & HOW]
hpo_stream_to_link_encoder_mapping has size MAX_HPO_DP2_ENCODERS(=4),
but location can have size up to 6. As a result, it is necessary to
check location against MAX_HPO_DP2_ENCODERS.
Similiarly, disp_cfg_stream_location can be used as an array index which
should be 0..5, so the ASSERT's conditions should be less without equal.
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Fix slab-use-after-free on hdcp_work
[Why]
A slab-use-after-free is reported when HDCP is destroyed but the
property_validate_dwork queue is still running.
[How]
Cancel the delayed work when destroying workqueue.
(cherry picked from commit 725a04ba5a95e89c89633d4322430cfbca7ce128)